材料损伤开裂的数值模拟方法

针对数值模拟材料损伤开裂的现有方法——空单元技术和嵌入过程区中结点力释放方法，提出了释放空单元内结点力的新模拟方法，既可解决原有空单元技术未曾明确的残余应力的释放问题，又可避免采用嵌入过程区方法时所引入的大量重叠结点。已有算例表明，该方法具有模型简明，操作便利的特点。

Theermal Stress and Fracture in Transparent Optical Materials due to Laser Energy-Absorption by a Defect

利用热弹性理论分析了在光学材料中由于缺陷吸收激光能量引起的温度和热应力分布,并且针对一个简单的裂纹模型分析了热应力产生的应力强度因子,给出了一些主要参数对于应力强度因子的影响的规律。

Enhanced cycling performance and high energy density of LiFePO4 based lithium ion batteries

LiFePO4 attracts a lot of attention as cathode materials for the next generation of lithium ion batteries. However, LiFePO4 has a poor rate capability attributed to low electronic conductivity and low density. There is seldom data reported on lithium ion batteries with LiFePO4 as cathode and graphite as anode. According to our experimental results, the capacity fading on cycling is surprisingly negligible at 1664 cycles for the cell type 042040. It delivers a capacity of 1170 mAh for 18650 cell type at 4.5C discharge rate. It is confirmed that lithium ion batteries with LiFePO4 as cathode are suitable for electric vehicle application. (c) 2007 Elsevier B.V. All rights reserved.

COIL基于小信号增益系数的最佳流量配比选择

氧碘化学激光器（COIL）的混合喷管内发生的是气体动力学、化学反应动力学以及光学等相互耦合的复杂过程，每个过程都对COIL性能有着至关重要的影响。利用3维CFD技术，通过求解层流Navier—Stokes方程与组分输运方程，结合10种组分和21个基元反应的化学反应模型，对简化后的化学氧碘激光RADICI。模型在亚声速段横向射流情况下，不同的主副流流量配比对小信号增益系数的影响情况进行了比较与分析。结果证明：过高或过低的碘分子浓度均不利于产生合理的小信号增益系数；存在最佳流量配比使小信号增益系数得到显著提高且分布均匀。

Solid-state optical parallel morphological processor

Based on birefringence, a building-block stacking technique is suggested in this paper. A solid-state optical morphological processor module is thus developed, which is an integration of a beam array generator submodule, an optical connector submodule, and a Pockels readout optical modulator. It is shown that the technique is compact in construction, simple for fabrication, and insensitive to the environment.

Efficient two-step digit-set-restricted modified signed-digit algorithm based on optoelectronic shared content-addressable memory

A two-step digit-set-restricted modified signed-digit (MSD) adder based on symbolic substitution is presented. In the proposed addition algorithm, carry propagation is avoided by using reference digits to restrict the intermediate MSD carry and sum digits into {(1) over bar ,0} and {0, 1}, respectively. The algorithm requires only 12 minterms to generate the final results, and no complementarity operations for nonzero outputs are involved, which simplifies the system complexity significantly. An optoelectronic shared content-addressable memory based on an incoherent correlator is used for experimental demonstration. (c) 2005 Society of Photo-Optical Instrumentation Engineers.

一种硅微机械谐振器的单光源激振测振方法

提出一种用于硅微机械谐振传感器研究的单光源激振测振新方法，即微谐振器的激励及其谐振信号的测量使用同一光源。该方法采用全光纤斐索干涉仪结构，将干涉信号与光源强度变化信号进行运算后，通过选频技术解调出谐振器的振动信息，同时采用贝塞耳函数比值法扩大了振动幅度的测量范围，省去了一些难以获得准确数值的工作参数的计算。采用该方法实现了微悬臂梁结构形式的谐振器件的单光源激振与测振，获得了器件的谐振频率约为8．81kHz以及谐振状态下的振动幅度约为135nm。实验结果与采用其他双光源激振测振方法基本一致，新方法的可行性得

云南两种雨燕的生态和燕窝利用与保护

雨燕目雨燕科的短嘴金丝燕Collocalia brevirostris和白腰雨燕．apus pacificus所筑之 巢．云南民间有将其作为滋补药品利用的传统。这两种雨燕在云南分布很广．营巢于岩洞或石崖 硝壁上。根据其繁殖时间．应在8月中旬后一次采集育过雏的燕窝。

mRNA 的序列、结构以及翻译速率与蛋白质结构的关系

mRNA 所包含的核苷酸序列通过三联体密码子决定了蛋白质的氨基酸序列。但是, 由于对氨基酸同 义密码使用频率上的差异, 密码子与反密码子相互作用效率上的不同, 以及密码子上下文关系和mRNA 不同区 域二级结构上的差异, 造成了核糖体对mRNA 不同区域翻译速度上的差异, 加之共翻译折叠的作用, 使得mR2 NA 的序列和结构影响着蛋白质空间结构的形成。

灰盔累枝虫形态学及表膜下纤维系的研究

利用活体观察及蛋白银染色技术对灰盔累枝虫(Epistylisgalea)的形态学及表膜下纤维系进行了研究。该种主要鉴别特征为:活体个员的表膜柔软,虫体充分伸展时呈倒长锥形,体长200—300μm,体宽70—90μm;大核“J”字形,呈纵位。单一伸缩泡,直径21—25μm,背位。纵向纤维细密。口围盘纤维呈网状,与纵向纤维直接相连,并在整体上呈兜网状。与本属其他相近种相比,本种第3咽膜(P3)明显要长,其后1/3超出第1咽膜后继续向下呈弧形弯曲。本文对该种上述特征在分类学上的意义及其与相近种类之间的关系进行了

静止和充气培养条件下短期紫外辐射对钝顶螺旋藻光化学效率的影响

为了研究短期太阳紫外辐射对钝顶螺旋藻的影响,作者将静止和充气培养的藻体,暴露在全波长太阳辐射PAB(PAR+UVA+UVB),去除UVB辐射PA(PAR+UVA)及切断所有紫外辐射的光合有效辐射P(PAR)三种光处理条件下,测定了其光化学效率的变化。结果表明,紫外辐射(UVP)及光合有效辐射(PAR)均能导致钝顶螺旋藻的光化学效率降低,表现出了明显的光抑制,但是,UVR可导致更大程度的光抑制。充气培养条件下,与早晨(07:00)初始值相比,PAR导致了11%~20%的光抑制,而UVR(PAB-P)所产生的

RESPONSES OF Elodea nuttallii AND Ceratophyllum demersum TO HIGH TEMPERATURE

There were large losses of exotic species Elodea nuttallii during summer in eutrophic lakes of the middle and lower reaches of the Yanatze River, China. To investigate the main causes, the heat tolerance of E. nuttallii was studied and compared with that of native species Ceratopkyllum demersum by using an aquaria system in the laboratory. Under 4500 lx light intensity and 12-h L/12-h D cycle, E. nuttallii cultured in 1/5 Hoaglands solution at 39 degrees C showed a positive growth rate during the first 15 days, and the growth rate was higher than that at 35 degrees C. But after 15 days, the growth rates became negative for those cultured both at 39 and 35 degrees C. However, the growth rate was positive for more than 20 days for those cultured at 25 degrees C. Under the same conditions, the growth rate, productivity and chlorophyll content of E. nuttallii were significantly higher than that of C. demersum. Heat tolerance of E. nuttallii was also stronger than that of C. demersum. The optimal temperature for the growth of the two plants depended on the experimental period: both plants grew at an optimal rate at higher temperature if the experimental period was short; nevertheless the plants achieved optimal growth at a lower temperature if the experiment was conducted for a longer period. At the same light intensity, the heat tolerance of C. demersum in tap water with sediment was markedly stronger than that of E. nuttallii at 39 degrees C. Average growth rate of C. demersum was 4.5 times higher than that of E. nuttallii within 25 days. The positive growth period lasted for less than 25 days for E. nuttallii and for more than 25 days for C. demersum. When they were cultured in 1/5 Hoaglands solution and in tap water with sediment, the growth rate of C. demersum increased from 0.4 to 79.4 mg/d.g fresh weight (FW) within 20 days. E. nuttallii increased from 8.3 to 24.4 mg/d-g FW within 20 days. Both grew better in tap water with sediment than in 1/5 Hoaglands solution. The results demonstrated that the nutritional status of the water other than the high temperature affected the heat tolerance of E. nuttallii during summer. E. nuttallii has great ecological safe risk in China.

Genomic organization, gene duplication, and expression analysis of interleukin-1 beta in channel catfish (Ictalurus punctatus)

Interleukin-1 beta (IL-1 beta) is one of the pivotal early response pro-inflammatory cytokines that enables organisms to respond to infection and induces a cascade of reactions leading to inflammation. In spite of its importance and two decades of studies in the mammalian species, genes encoding IL-1 beta were not identified from non-mammalian species until recently. Recent research, particularly with genomic approaches, has led to sequencing of IL-1 beta from many species. Clinical studies also Suggested IL-1 beta as an immunoreagulatory molecule potentially useful for enhancing vaccination. However, no IL-1 beta genes have been identified from channel catfish, the primary aquaculture species from the United States. In this study, we identified two distinct cDNAs encoding catfish IL-1 beta. Their encoding genes were identified, sequenced, and characterized. The catfish IL-1 beta genes were assigned to bacterial artificial chromosome (BAC) clones. Genomic studies indicated that the IL-1 beta genes were tandemly duplicated on the same chromosome. Phylogenetic analysis of various IL-1 beta genes indicated the possibility of recent species-specific gene duplications in channel catfish, and perhaps also in swine and carp. Expression analysis indicated that both IL-1 beta genes were expressed, but exhibited distinct expression profiles in various catfish tissues, and after bacterial infection with Edwardsiella ictaluri. (c) 2005 Elsevier Ltd. All rights reserved.

Unselective regrowth buried heterostructure long-wavelength superluminescent diode realized with MOVPE

A novel unselective regrowth buried heterostructure (BH) long-wavelength superluminescent diode (SLD), which has a grade-strained bulk InGaAs active region, was developed by metalorganic vapor-phase epitaxy (MOVPE). The 3 dB emission spectrum bandwidth of the SLD is about 65 nm with the range from 1596 to 1661 nm at 90 mA and front 1585 to 1650 nm at 150 mA. An output power of 3.5 mW is obtained at 200 mA injection current under CW operation at room temperature. (c) 2006 Elsevier B.V. All rights reserved.