Investigation on Depth of Heat Affected Zone of Discharge Spot by High Repetitive Rate YAG Laser-Induced Discharge Texturing

It is known that the press formability and the elongation of laser textured sheet are improved, and the service life of textured roll is longer than that of the un-textured roll due to hardening of the treated surface. One of the goals to develop high repetitive rate YAG laser-induced discharge texturing (LIDT) is to get deeper hardening zone. By observing and measuring cross-section of LIDT spots in different discharge conditions, it is found that the single-crater, which is formed by the discharge conditions of anode, which is covered by an oil film and with rectangular current waveform, has the most depth of heat affected zone (HAZ) comparing with other crater shapes when discharge energy is the same. The depth of HAZ is mainly depends on pulse duration when the discharge spot is single-crater. The results are analyzed.

A Semi-Empirical Equation of Penetration Depth on Concrete Target Impacted by Ogive-Nose Projectiles

In this paper, the penetration process of ogive-nose projectiles into the semi-infinite concrete target is investigated by the dimensional analysis method and FEM simulation. With the dimensional analysis, main non-dimensional parameters which control the penetration depth are obtained with some reasonable hypothesis. Then, a new semi-empirical equation is present based on the original work of Forrestal et al., has only two non-dimensional combined variables with definite physical meanings. To verify this equation, prediction results are compared with experiments in a wide variation region of velocity. Then, a commercial FEM code, LS-DYNA, is used to simulate the complex penetration process, that also show the novel semi-empirical equation is reasonable for determining the penetration depth in a concrete target.

简单金属在流体静负载下的力学稳定性与理论拉伸强度

本文根据经典力学的稳定性条件,用膺势方法导出了立方晶体在流体静负载下的经典稳定性判据:B(P)>0,C′(P)>0和C(P)>0。然后计算了七种简单金属(Li,Na,K,Rb,Cs,Al和Pb)在零温和流体静负载下的稳定性范围与理论拉伸强度。

强CO_2激光照射靶面的现象

在强激光对靶材的作用中,以连续及脉冲CO_2激光为主光源,首先研究了发生于靶前区的现象,用高速干涉摄影术来诊断,判别出连续激光引起烧坑形成的时间及蒸汽羽喷向的扭转过程,并观察了脉冲激光引起等离子体的发展、空气击穿及产生冲击波运动和蒸汽羽等非自发光现象,使用了脉冲He-Ne激光高速干涉摄影装置。

圆管内流场显示法

本文对圆管内流场的显示研究提出了一种近似光学补偿法,在超音速风洞中纪录到了管内超音速流场的冲击波形象。

The non-axisymmetrical configuration of a large-scale solar and stellar magnetic field

in the corona, consisting of an eruptive prominence and/or a magnetic flux region (loop or arcade, or blob) in front of the prominence. Ahead of the piston, there is a compressed flow, which produces a shock front. This high-density region corresponds to the bright feature of the transient. Behind the piston, there is a rarefaction region, which corresponds to the dark feature of the transient. Therefore, both the bright and dark features of the transient may be explained at the same time by the dynamical process of the moving piston.

A Semi-Empirical Equation of Penetration Depth on Concrete Target Impacted by Ogive-Nose Projectiles

In this paper, the penetration process of ogive-nose projectiles into the semi-infinite concrete target is investigated by the dimensional analysis method and FEM simulation. With the dimensional analysis, main non-dimensional parameters which control the penetration depth are obtained with some reasonable hypothesis. Then, a new semi-empirical equation is present based on the original work of Forrestal et al., has only two non-dimensional combined variables with definite physical meanings. To verify this equation, prediction results are compared with experiments in a wide variation region of velocity. Then, a commercial FEM code, LS-DYNA, is used to simulate the complex penetration process, that also show the novel semi-empirical equation is reasonable for determining the penetration depth in a concrete target.

爆炸处理水下海淤软基

<正>前言爆炸处理水下海淤软基是一项新技术。国家经委、国家教委、中国科学院等单位列为国家第一批100项与企业横向联合的重点科技项目。连云港建港指挥部,中国科学院力学研究所,锦屏磷矿、交通部第三航务勘探设计院等四单位组织科研组联合攻关。经过四年的工程实践、工程性试验、模型和机理试验等,取得了大量系统的数据,写出了近20篇科学技术报告,并由交通部和中国科学院组织了(钅监)定。这些科技报告经由本文作者审定。为了对这项新技术有一个全面的介绍,作者将科研组所提供的报告作一综述,并阐明了自己的一些观点。科研组各单位先后参加工作达40余人,他们在很艰苦条件下取得了这些宝贵的资料(见本文所引文献),作者对于参加这项工作的所有同志,和本文所参考报告的作者们表示感谢!

溶胶-凝胶光波导环形谐振腔的挥发性有机化合物传感特性

采用溶胶-凝胶法制作波导环形谐振腔, 讨论了环形谐振腔器件的传输特性。测量了在不同物质、不同体积分数的挥发性有机化合物(VOC)蒸气气氛下器件的传输光谱的敏感性。结果表明, 谐振波长随甲醇、乙醇、丙醇等醇类化合物, 以及丙酮、甲醛等蒸气体积分数的上升而向长波方向移动, 具有高的灵敏度, 且两者基本呈线性关系。其中, 对丙醇最敏感, 灵敏度达到1.403 pm/10-6。对甲烷和二甲苯也有微弱反应, 但是其灵敏度很低。也测量了水蒸气对传输谱特性的影响。观察到传输谱衬比度对不同挥发性有机化合物物质蒸气的不同敏

Parallel optical negabinary signed-digit computing: algorithm and optical implementation

Negabinary is a component of the positional number system. A complete set of negabinary arithmetic operations are presented, including the basic addition/subtraction logic, the two-step carry-free addition/subtraction algorithm based on negabinary signed-digit (NSD) representation, parallel multiplication, and the fast conversion from NSD to the normal negabinary in the carry-look-ahead mode. All the arithmetic operations can be performed with binary logic. By programming the binary reference bits, addition and subtraction can be realized in parallel with the same binary logic functions. This offers a technique to perform space-variant arithmetic-logic functions with space-invariant instructions. Multiplication can be performed in the tree structure and it is simpler than the modified signed-digit (MSD) counterpart. The parallelism of the algorithms is very suitable for optical implementation. Correspondingly, a general-purpose optical logic system using an electron trapping device is suggested. Various complex logic functions can be performed by programming the illumination of the data arrays without additional temporal latency of the intermediate results. The system can be compact. These properties make the proposed negabinary arithmetic-logic system a strong candidate for future applications in digital optical computing with the development of smart pixel arrays. (C) 1999 Society of Photo-Optical Instrumentation Engineers. [S0091-3286(99)00803-X].

一种高性能硅片曝光场分布优化算法

以提高光刻机应用性能为目的，提出了一种高性能硅片曝光场分布优化算法。由芯片尺寸计算得到最佳曝光场尺寸，使其最接近于光刻机提供的曝光场最大尺寸，提高了曝光系统的利用率；引入曝光场交错分布，减少了硅片边缘曝光场的交叠，提高了光刻产率；建立产率优先和良率优先两种优化方案，实现了产率和良率的共优。以实际芯片产品的参量为例，将本算法用于曝光过程，采用产率优先标准，曝光场数量减少了10％，而内场数量基本不变，提高了光刻的产率也确保了良率；采用良率优先标准，内场数量增长了10％，总的场数也有所减少，提高了光刻良率的可靠

一种基于PSD器件的改进型角度测量方法

提出一种基于平行平板干涉仪的改进型角度测量方法。为了实现较大的偏转角度测量，该平行平板干涉仪引入了一位置探测系统。平面反射镜的引入提高了角度测量的分辨率。实验验证了可在近3度的范围内实现被测偏转角度的高精度测量。并且作为一位相调制型干涉仪，其小角位移测量实验的重复精度可达5.5×10^(-8)rad。

Large three-photon absorption cross-section in a novel class of bis-(N-carbazolyl) fluorene derivatives

Two novel symmetrical charge transfer fluorene derivatives (abbreviated as BCZF and BVCZF) with carbazole end-group as the donor moieties have been synthesized. Three-photon absorption cross-sections of these two compounds have been determined by using a Q-switched Nd:YAG laser pumped with 38 ps pulses at 1064 nm in DMF. The measured 3PA cross-sections are 140 x 10(-78) and 400 x 10(-78) cm(6) s(2) for BCZF and BVCZF, respectively. The geometries, electronic structures and electronic spectra of these two compounds are systematically studied by AM1 and ZINDO/S methods. On the basis of correct UV-vis spectra, the influence of different molecular structure on three-photon absorption cross-sections is discussed micromechanically. (C) 2005 Elsevier B.V. All rights reserved.

铒离子浓度对掺Er^3＋碲酸盐玻璃的Judd-Ofelt理论参数的影响

制备了四种不同铒离子掺杂浓度的碲酸盐玻璃，通过测定吸收光谱计算了吸收谱线的振子强度，根据Judd-Ofelt理论计算了不同浓度下Er^3＋离子发光光谱的强度参数Ω（i=2，4，6），计算了自发辐射电偶和磁偶跃迁概率、辐射寿命、荧光分支比等参数，讨论了Er^3＋离子浓度变化对以上这些参数的影响。测试了Er^3＋：^4I13／2→^4I15／2跃迁对应的荧光光谱和Er^3＋：^4I13／2能级荧光寿命。最后应用McCumber理论计算了玻璃中Er^3＋：^4I13／2→^4I15／2跃迁对应的受激发射截面大小