120 resultados para 5, G, wireless, new, generation
em Chinese Academy of Sciences Institutional Repositories Grid Portal
Resumo:
Two new highly oxygenated nortriterpenoids with a unique norcycloartane skeleton, micrandilactones B and C (1-2), were isolated from Schisandra micrantha; micrandilactone C ( 2) exhibited an EC50 value of 7.71 mu g/mL (SI > 25.94) against HIV-1 replication with minimal cytotoxicity, and the potent anti-HIV-1 activity and unique structural features of 2 make it a promising lead for therapeutic development of a new generation of anti-HIV drug.
Resumo:
New neutral nickel(II) complexes bearing nonsymmetric bidentate pyrrole-imine chelate ligands (4a-d), [2-(ArNCH)C4H3N]Ni(PPh3)Ph [Ar=2,6-diisopropylphenyl (a), 2-methyl-6-isopropylphenyl (b), 2,6-diethylphenyl (c), 2-tert-butylphenyl (d)], have been prepared in good yields from the sodium salts of the corresponding ligands and trans-Ni(PPh3)(2)(Ph)Cl, and the structure of complex 4a has been confirmed by X-ray crystallographic analysis. These neutral Ni(II) complexes were investigated as catalysts for the vinylic polymerization of norbornene. Using modified methylaluminoxane (MMAO) as a cocatalyst, these complexes display very high activities and produce great mass polymers. Catalyst activity of up to 4.2 x 10(7) g (mol Ni h)(-1) and the viscosity-average molecular weight of polymer of up to 9.2 x 10(5) g mol(-1) were observed. Catalyst activity, polymer yield, and polymer molecular weight can be controlled over a wide range by the variation of reaction parameters such as Al-Ni ratio, norbornene-catalyst ratio, monomer concentration, polymerization reaction temperature and time.
Resumo:
:与其姐妹科(菊头蝠科)相比,蹄蝠科的细胞遗传学研究较少。迄今为止,仅少数蹄蝠科几个物种有高分辨率的G带核型报道,且有关该科核型进化的大多数结论都是基于常规Giemsa染色研究而得。该研究利用三叶小蹄蝠的染色体特异探针,通过比较染色体涂色、G和C显带,建立了5种蹄蝠的染色体同源性图谱,并探讨了它们同源染色体间的G和C带异同。结果表明:罗伯逊易位、臂内倒位以及异染色质的扩增可能是蹄蝠科物种核型进化的主要机制。通过对这5种蹄蝠物种及其外群物种之间的同源染色体片段的比较分析,作者推测蹄蝠科的祖先核型并不像先前认为的全由端着丝粒染色体组成, 而应该含有中着丝粒染色体。
Resumo:
于2010-11-23批量导入
Resumo:
本论文以红薯淀粉的双酶法水解液为碳源,从19 株红色酵母中筛选出一株油脂含量较高的菌株掷孢酵母(Sporobolomyces reseus)As.2.618。为了提高掷孢酵母(S.reseus)As.2.618 的油脂产量,考察了培养基组成对该菌生长情况及油脂积累的影响。用均匀设计法对培养基组成进行了优化,由DPS软件得出的优化结果为:还原糖103g/L、酵母粉11.5g/L、磷酸二氢钾0.3g/L、硫酸镁0.15g/L。生物量可达19.23 g/L,油脂含量为3.875 g/L。研究了添加二价离子对该菌的生长及油脂积累的影响,结果表明Zn2+对该菌生长和油脂积累都有显著促进作用。研究了发酵条件以及添加氧载体正十二烷对该菌发酵的影响,表明添加正十二烷有利用于该菌生长与油脂积累。得出最佳发酵条件是:在还原糖103g/L、酵母粉11.5g/L、磷酸二氢钾0.3g/L、硫酸镁0.15g/L。添加30mg/L 硫酸锌,接种量为5%,在24h 后添加2g/L 的碳酸钙和2%(v/v)正十二烷,pH6.0 培养温度为27℃,转速为200r/min,培养时间为7 天的条件下,该菌生物量干重可达35.05g/L,油脂含量也达11.98g/L。Lipid is one of the basic material for life-sustaining activities andimportant industrial materials. As lipid resources mainly come from the animal andthe plant, the problem of lipid lack is encountered at times. The lipid frommicroorganisms is the substitute and superior to the above lipid with a short period ofproduction and much cheaper fermentation materials such as agricultural and sidelineproducts or wastes of crop.Thus large scale production and broad application ofmicrobial lipid will be efficient not only in substitute of the animal and the plant lipidfor food and industrial field , but also inducing a new way leading to solve the energyproblem.For the purpose of exploring the characteristics of lipid production of redyeasts from sweet potato starch hydrolysates. 19 red yeasts are screened for thecapability of lipid producing and one strain Sporobolomyces reseus As.2.618 withsuperior performance is sellected.To improve the Sporobolomyces reseus As.2.618’s capability of lipidaccumulation , the components of the medium, which may influence the growth of thestrain and the lipid yield have been studied. To get the optimum mediumcomponents ,the “uniform design” was used .The DPS software gave the optimummedium component is: reducing sugar 103 g/L、yeast extract 11.5 g/L、KH2PO4 0.3g/L、MgSO4 0.15 g/L. The biomass could reach up to 19.23 g/L and lipid yield 3.87g/L with the above composition of fermentation medium.Furthermore the fermentation conditions , addition of the divalent metal ionsand the oxygen vector to increase the strain’s lipid producing capability are tested.The optimum condition is : reducing sugar 103 g/L、yeast extract 11.5 g/L、KH2PO40.3 g/L、MgSO4 0.15 g/L,Adding 30mg/L ZnSO4,and adding 2g/L CaCO3 2%(v/v)n-dodecane after 24h’s fermentation. the optimal fermentation condition were asfollow :30ml medium in the 500ml flask with initial pH 6.0,the flasks with 5%inoculation volume were at 200r/min shaking speed for 7d’s fermentation at27 .Under this kind of condition the high biom ¡æ ass which reach to 35.05 g/L could begot ,the yield of lipid also could reach to 11.98g/L.
Resumo:
By analyzing the formation mechanism of a supersonic gas jet, a set of equations which describe the atomic beam properties were established. The influence of initial temperature, initial pressure, background gas pressure and pumping speed was discussed in detail. A simulation program was developed based on the equations, and the results under different initial conditions were obtained. The results are in good agreement with the experimental data, and suggest that, in order to get much smaller transverse momentum in collision experiments, it is necessary to lower the initial temperature and the initial pressure of the supersonic gas jet, together with increasing the pumping speed. These results are very instructive for construction of a new generation of cold supersonic gas jets.
Resumo:
The commissioning of the cooler storage rings (CSR) was successful, and the facility provides new possibilities for atomic physics with highly charged ions. Bare carbon, argon ions, were successfully stored in the main ring CSRm, cooled by cold electron beam, and accelerated up to 1 GeV/u. Heavier ions as Xe44+ and Kr28+ were also successfully stored in the CSRs. Both of the rings are equipped with new generation of electron coolers which can provide different electron beam density distributions. Electron-ion interactions, high precision X-ray spectroscopy, complete kinematical measurements for relativistic ion-atom collisions will be performed at CSRs. Laser cooling of heavy ions are planned as well. The physics programs and the present status will be summarized.
Resumo:
There has been increasing demand to provide higher beam intensity and high enough beam energy for heavy ion accelerator and some other applications, which has driven electron cyclotron resonance (ECR) ion source to produce higher charge state ions with higher beam intensity. One of development trends for highly charged ECR ion source is to build new generation ECR sources by utilization of superconducting magnet technology. SECRAL (superconducting ECR ion source with advanced design in Lanzhou) was successfully built to produce intense beams of highly charged ion for Heavy Ion Research Facility in Lanzhou (HIRFL). The ion source has been optimized to be operated at 28 GHz for its maximum performance. The superconducting magnet confinement configuration of the ion source consists of three axial solenoid coils and six sextupole coils with a cold iron structure as field booster and clamping. An innovative design of SECRAL is that the three axial solenoid coils are located inside of the sextupole bore in order to reduce the interaction forces between the sextupole coils and the solenoid coils. For 28 GHz operation, the magnet assembly can produce peak mirror fields on axis of 3.6 T at injection, 2.2 T at extraction, and a radial sextupole field of 2.0 T at plasma chamber wall. During the commissioning phase at 18 GHz with a stainless steel chamber, tests with various gases and some metals have been conducted with microwave power less than 3.5 kW by two 18 GHz rf generators. It demonstrates the performance is very promising. Some record ion beam intensities have been produced, for instance, 810 e mu A of O7+, 505 e mu A of Xe20+ 306 e mu A of Xe27+, and so on. The effect of the magnetic field configuration on the ion source performance has been studied experimentally. SECRAL has been put into operation to provide highly charged ion beams for HIRFL facility since May 2007.
Resumo:
Four aromatic tetraamine monomers possessing flexible ether linkages were successfully synthesized by nucleophilic aromatic substitution of hydroquinone, 4,4'-dihydroxybiphenyl, 2,2'-bis(4-hydroxyphenyl)propane, and 2,7-dihydroxynaphthalene with 5-chloro-2-nitroaniline, followed by reduction, respectively. With these monomers, a new class of soluble poly[ bis(benzimidazobenzisoquinolinones)] was prepared by a one-step, high-temperature solution polycondensation. The resulting polymers were completely soluble in phenolic solvents and had high inherent viscosities ranging from 1.2 to 1.5 g dL(-1). These polymers had glass transition temperatures in the range of 427-449 degrees C. Thermogravimetric analysis showed that all polymers were thermally stable, with 5% weight loss recorded above 510 degrees C in nitrogen.
Resumo:
Monodisperse oligo[(1,4-phenyleneethynylene)-alt-(2,5-thiopheneethynylene)]s, new candidates for molecular wires, were rapidly synthesized via an iterative divergent/convergent doubling strategy in solution as well as on Merrifield's resin.