Pressure Drop of Bubbly Two-Phase Flow in a Square Channel at Reduced Gravity

A new set of experimental pressure drop data, collected aboard the Russian IL-76MDK, is reported for bubbly airwater two-phase flow in a square channel with a cross-sectional area of 12x 12mm(2). The present data are compared to several frequently used empirical models, e.g. homogeneous model, Lockhart-Martinelli-Chisholm correlation and Friedel's model. It is shown that the predictions of the models mentioned above are generally not satisfied. A new homogeneous model is developed based on the analysis of the characteristics of bubbly two-phase flow at reduced gravity. It is tested with the present data and other data collected by other researchers in circular pipes. Some questions related to the present model are also discussed. (C) 2002 COSPAR. Published by Elsevier Science Ltd. All rights reserved.

碱金属在[110]单轴应力下的理论强度

<正> 我们知道,晶须的强度远远大于大晶体的强度,很可能接近于理想晶体的理论强度.而晶须的轴线则通常平行于晶体的三个主要方向[100],[110]或[111]。因此当计算理想晶体在单轴应力下的理论强度时,也必须考虑不同的应力方向.七十年代,Milstein等人利用Morse势和Born稳定性判据计算了立方晶体分别在[100],[110]和[111]单轴应力下的理论强度.由于有心力近似受到Cauchy关系的限制,我们在文献

地震应力波的传播与岩石的动态响应

本文用 Split-Hopkinson 压力杆装置研究了应力波通过破裂岩石试件的衰减现象。给出了灰砂岩、石灰岩两种岩石动态的破裂强度与应力应变关系.结合受应力作用的岩样切片的微观观察,对应力裂纹、裂纹的动态分叉现象进行了分析讨论.

Distribution, stability, bifurcations and catastrophe of steady rotation of a symmetrical heavy gyroscope with viscous-liquid-filled cavity

The number, the angles of orientation and the stability in Rumyantsev Movchan's sense of oblique steady rotations of a symmetric heavy gyroscope with a cavity completely filled with a uniform viscous liquid, possessing a fixed point 0 on its symmetric axis. are given for various values of the parameters. By taking the square of the upright component of the angular momentum M2 as a control parameter, three types of bifurcation diagrams of the steady rotations, two types of jumps and two kinds of local catastrophes, one being the symmetric reduced cusp type and the other being of the symmetric reduced butterfly type, are obtained. By taking account of the M2-damping owing to the moment of unavoidable faint friction, two different modes for the gyroscope, initially in a stable quasi-steady upright rotation with a nutation angle theta(s) equal to zero, to topple over are found.

2000年国内期刊力学类论文情况分析

<正>本文以包括《爆炸与冲击》、《工程力学》、《固体力学学报》、《计算力学学报》、《空气动力学学报}}、《力学季刊》、《力学进展}）、《力学学报》、《力学与实践》、《实验力学》和《医用生物力学》等（按拼音顺序排列）国内力学类核心期刊在内的128种国内科技期刊为统计期刊源,统计了2000

离心机中动冰荷载的模拟

前言吸力式基础的应用起源于欧洲,最初用作浮动结构的稳固基础，1994年欧洲Europipe16/-11E第一次将海洋采油平台建在吸力式基础上[1].……

A simple method to simulate shrinkage-induced cracking in cement-based composites by lattice-type modeling

A new numerical procedure is proposed to investigate cracking behaviors induced by mismatch between the matrix phase and aggregates due to matrix shrinkage in cement-based composites. This kind of failure processes is simplified in this investigation as a purely spontaneous mechanical problem, therefore, one main difficulty during simulating the phenomenon lies that no explicit external load serves as the drive to propel development of this physical process. As a result, it is different from classical mechanical problems and seems hard to be solved by using directly the classical finite element method (FEM), a typical kind of "load -> medium -> response" procedures. As a solution, the actual mismatch deformation field is decomposed into two virtual fields, both of which can be obtained by the classical FEM. Then the actual response is obtained by adding together the two virtual displacement fields based on the principle of superposition. Then, critical elements are detected successively by the event-by-event technique. The micro-structure of composites is implemented by employing the generalized beam (GB) lattice model. Numerical examples are given to show the effectiveness of the method, and detailed discussions are conducted on influences of material properties.

Synthesis Of Plastic Zr-Based Bulk Metallic Glass Matrix Composites By The Copper-Mould Suction Casting And The Bridgman Solidification

Zr-based bulk metallic glass matrix composites with the composition of Zr56.2Ti13.8Nb5.0Cu6.9Ni5.6Be12.(5) were synthesized by the copper-mould suction casting and the Bridgman solidification. The composite, containing a well-developed flowery beta-Zr dendritic phase, was obtained by the Bridgman solidification with the withdrawal velocity of 0.8 mm/s and the temperature gradient of 45 K/mm, and the ultimate strength of 2050 MPa and fracture plastic strain of 14.6% of the composite were achieved, which was mainly interpreted by the homogeneous dispersion of bcc beta-Zr phase in the glass matrix. Crown Copyright (C) 2008 Published by Elsevier B.V. All rights reserved.

Accurate determination of the absolute phase and temporal-pulse phase of few-cycle laser pulses

A Fourier analysis method is used to accurately determine not only the absolute phase but also the temporal-pulse phase of an isolated few-cycle (chirped) laser pulse. This method is independent of the pulse shape and can fully characterize the light wave even though only a few samples per optical cycle are available. It paves the way for investigating the absolute phase-dependent extreme nonlinear optics, and the evolutions of the absolute phase and the temporal-pulse phase of few-cycle laser pulses.

Strong visible up-conversion emission in Tb3+, Tm3+ and Tb3+-Tm3+ co-doped tellurite glasses sensitized by Yb3+

Up-conversion luminescence characteristics under 975 nm excitation have been investigated with Tb3+/Tm3+/Yb3+ triply doped tellurite glasses. Here, green (547 nm: D-5(4) --> F-7(4)) and red (660 nm: D-5(4) --> F-7(2)) up-conversion (UC) luminescence originating from Tb3+ is observed strongly, because of the quadratic dependences of emission intensities on the excitation power. Especially, the UC luminescence was intensified violently with the energy transfer from the Tm3+ ions involves in the Tb3+ excitation. To the Tb3+/Tm3+/Yb3+ triply doped glass system, a novel up-conversion mechanism is proposed as follows: the energy of (3)G(4) level (Tm3+) was transferred to D-5(4) (Tb3+) and the 477-nm UC luminescence of Tm3+ was nearly quenched. (C) 2006 Elsevier B.V. All rights reserved.

高功率激光装置前端系统激光脉冲的时间整形及修正技术

针对激光惯性约束聚变实验研究对高功率激光驱动器前端系统复杂时间形状种子激光脉冲的需求, 应用孔径耦合带状线集成波导整形系统设计了满足需要的前端整形激光脉冲。用一种新方法精确计算了孔径耦合带状线电脉冲整形器的耦合系数和孔径宽度的数值关系, 并针对高衬比度整形激光脉冲的需求, 提出了高衬比度双极型集成波导整形系统方案。由该系统可以得到100 ps脉冲前沿、1～3 ns脉冲宽度可调、高衬比度(大于100∶1)、光滑无纹波调制、可精确满足神光II八路及第九路装置需求的前端整形激光脉冲。

Intense frequency upconversion luminescence in Yb3+/Tm3+-codoped oxychloride germanate glasses

Yb3+/Tm3+-codoped oxychloride germanate glasses for developing potential upconversion lasers have been fabricated and characterized. Structural properties were obtained based on the Raman spectra analysis, indicating that PbCl2 plays an important role in the formation of glass network and has an important influence on the maximum phonon energies of host glasses. Intense blue and weak red emissions centered at 477 and 650 nm, corresponding to the transitions (1)G(4) -> H-3(6) and (1)G(4) -> H-3(4), respectively, were observed at room temperature. With increasing PbCl2 content, the intensity of blue (477 nm) emission increases significantly, while the red (650 nm) emission increases slowly. The results indicate that PbCl2 has more influence on the blue emissions than the red emission in oxychloride germanate glasses. The possible upconversion mechanisms are discussed and estimated. Intense blue upconversion luminescence indicates that these oxychloride germanate glasses can be used as potential host material for upconversion lasers. C (c) 2005 Springer Science + Business Media, Inc.