A theoretical analysis on stochastic behaviour of short cracks and fatigue damage of metals

In this paper, the closed form of solution to the stochastic differential equation for a fatigue crack evolution system is derived. and the relationship between metal fatigue damage and crack stochastic behaviour is investigated. It is found that the damage extent of metals is independent of crack stochastic behaviour ii the stochastic deviation of the crack growth rate is directly proportional to its mean value. The evolution of stochastic deviation of metal fatigue damage in the stage close to the transition point between short and long crack regimes is also discussed.

爆炸力学实验技术新进展

本文综述了爆炸力学实验和测试技术的最新进展。

用直接散斑技术测量复合材料试件的面内位移

直接散斑法用来测量带中心圆孔复合材料条状试件在拉伸载荷作用下的面内位移分布,采用镜面移植技术,提高复合材料试件表面的反射性能,从而得到高质量的散斑干涉干板,在分析散斑干涉干板时,由于得到的全场位移分布条纹频率的可调性,使此方法测量范围很宽,由弹性应变到塑性应变,直接散斑法测量的结果与云纹法得到的结果相符合。

电离空气环境中碳化材料的烧蚀

本文给出了电离空气环境中碳化材料热化学烧蚀参数的计算方法。由于采用了比较精确的传递系数关联公式和改进了烧蚀表面气体成分的计算方法,因而可以用相当简单的方法得到与耦合(化学反应边界层与烧蚀表面耦合)计算非常符合的结果。本文方法可以得到碳化材料烧蚀表面气体的电离特性;为烧蚀电离边界层计算提供壁面边界条件。也可以用来进行热防护设计。

力学测量方法及其进展

力学测量方法是解决复杂力学问题的重要手段,也是一门自成体系的学科。《力学测量方法及其进展》一文介绍了这门学科的任务,以及力学测量方法的种类、进展和展望。

Molecular Dynamics Simulation of the Bio-Adhesion in Molecular Motors

Molecular dynamics (MD) simulation is employed to study the bio-adhesion in F1 ATP molecular motor. Histidine-peptide is widely used as linkage in micro systems because of its strong binding strength to metals. This paper focuses on the adhesion between a synthetic peptide containing 6xHis-tag (Gly-Gly-Lys-Gly-Gly-Lys-Gly-Gly-His-His-His-His-His-His) and metal substrate, which is used to define the position of the F1 ATP molecular motor on the metal substrate. It is shown that the binding strength between histidine and nickel substrate is the strongest, while that of copper is smaller and that of gold substrate is the smallest. From the result of simulation, we find that the stability of adhesion between histidine and the metal substate result of the ringed structure in histidine.

P-选择素Lectin结构域稳定性的模拟预测

<正>选择素(selectin)与其配体间相互作用介导的细胞粘附在炎症级联反应、肿瘤转移和淋巴细胞归巢等病理、生理过程中起重要作用[1]。X-ray衍射发现P-选择素的最小功

A Simple Model For Predicting The Void Fraction Of Gas/Non-Newtonian Fluid Intermittent Flows In Upward Inclined Pipes

In this work, a simple correlation, which incorporates the mixture velocity, drift velocity, and the correction factor of Farooqi and Richardson, was proposed to predict the void fraction of gas/non-Newtonian intermittent flow in upward inclined pipes. The correlation was based on 352 data points covering a wide range of flow rates for different CMC solutions at diverse angles. A good agreement was obtained between the predicted and experimental results. These results substantiated the general validity of the model presented for gas/non-Newtonian two-phase intermittent flows.

飞秒激光作用下透明介质材料的反射率演化

利用800nm抽运和400nm探针技术，测量了CaF2和MgO的时间分辨反射率，研究了材料的电子激发和弛豫超快动力学过程。采用耦合动力学模型，探讨了飞秒激光对透明介质材料的激发，以及材料的激发对抽运激光在材料中的传输、分布和反射特性的影响。根据这个理论模型计算了时间分辨反射率的演化，计算结果和实验结果相吻合。研究表明，多光子电离（MPI）和碰撞电离（II）在介质材料的导带电子激发中起着重要的作用。

不同氧磷比对磷酸盐包边玻璃性质的影响规律

包边技术是提高大尺寸激光玻璃饱和增益系数的关键技术。采用传统的方法熔制玻璃,研究了 P2O5含量对 P2O5-Al2O3-B2O3-CuCl-Na2O-ZnO磷酸盐包边玻璃的折射率、热膨胀系数、玻璃转变温度、膨胀软化温度以及化学稳定性的影响。结果表明：当 P2O5的摩尔分数为 60%左右,玻璃样品具有最高的折射率（1.522 0）、最低的玻璃转变温度（352.4 ℃）、较好的化学稳定性[0.52 mg/（cm^2·d）]和适宜的热膨胀系数（128.427×10^-7/℃）,是用作钕磷酸盐激光玻璃硬包边的理

Influence of different post-treatments on the structure and optical properties of zinc oxide thin films

Zinc oxide (ZnO) films with c-oriented were grown on fused quartz glass substrates at room temperature using dc reactive magnetron sputtering. The as-grown films were annealed at 700 degrees C in air and bombarded by ion beam, respectively. The effects of post-treatments on the structural and optical properties of the ZnO films were investigated by X-ray diffraction (XRD), photoluminescence (PL), optical transmittance and absorption measurements. The XRD spectra indicate that the crystal quality of ZnO films has been improved by both the post-treatments. Compared with the as-grown sample, both annealed and bombarded samples exhibited blueshift in the UV emission peaks, and a strong green emission was found in the annealed ZnO film. In both optical transmittance and absorption spectra, a blueshift of the band-gap edge was observed in the bombarded film, while a redshift was observed in the annealed film. (c) 2004 Elsevier B.V. All rights reserved.

ZnO : Zn phosphor thin films prepared by face-to-face annealing

ZnO:Zn phosphor thin films were prepared by face-to-face annealing at 450 degrees C in air. The effects of the face-to-face annealing on the structural and optical properties of the ZnO films were investigated by X-ray diffraction (XRD), photoluminescence (PL), optical transmittance and absorption measurements. Measurement results showed that the crystal quality of ZnO films was improved by face-to-face annealing. Both UV light emission and visible light emission were enhanced compared to those of open annealing films. The UV emission peak was observed to have a blueshift towards higher energy. The optical band-gap edge of as-annealed films shifted towards longer wavelength. (c) 2005 Elsevier B.V.. All rights reserved.