16 resultados para 310-1
em Chinese Academy of Sciences Institutional Repositories Grid Portal
Resumo:
从理论上计算了厚度为110nm的W_(0.95)Ni_(0.05)金属薄膜应变条在InGaAsP/InP双异质结构中形成的应力场分布,及由应力场分布引起的折射率变化。在W_(0.95)Ni_(0.05)金属薄膜应变条半导体中0.2-2μm深度范围内,由应变引起条形波导轴中央的介电常数ε相应增加2.3×10~(-1)-2.2×10~(-2)(2μm应变条宽)和1.2×10~(-1)-4.1×10~(-2)(4μm应变条宽)。同时,测量了由W_(0.95)Ni_(0.05)金属薄膜应变条所形成的InGaAs/InP双异质结光弹效应波导结构导波的近场光模分布。从理论计算和实验结果两方面证实了InGaAsP/InP双异质结光弹效应波导结构对侧向光具有良好的限制作用。
Resumo:
目的:用新研制的光纤生物传感器FOB-3检测多种病原微生物及细菌毒素.方法:利用双抗体夹心法,优化免疫反应的时间和浓度后,用FOB-3分别检测炭疽芽孢及繁殖体、鼠疫F1抗原和葡萄球菌肠毒素B.为便于结果判定,确定截断(cutoff)值,并以Ssignal与NNnoise差值的形式消除荧光信号中的噪声.结果:使用光纤生物传感器FOB-3,在20 min内可分别检测到50~1000 ng/mL的鼠疫F1抗原、0.1~100μg/mL的葡萄球菌肠毒素B、3×10^1~3×10^6 CFU/mL的炭疽杆菌繁殖体和
Resumo:
Er3+ -doped Gd2SiO5 (Er:GSO) single crystal with dimensions of circle divide 35 x 40 mm(3) has been grown by the Czochralski method. The absorption and fluorescence spectra of the Er:GSO crystal were measured at room temperature. The spectral parameters were calculated based on Judd-Ofelt theory, and the intensity parameters Omega(2), Omega(4) and Omega 6 are obtained to be 6.168 x 10(-20), 1.878 x 10(-20), and 1.255 x 10(-20) cm(2), respectively. The emission cross-section has been calculated by Fuechtbauer-Ladenbury formula. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
采用CI-310便携式光合作用系统及其附件,测定了广东省黑石顶自然保护区南亚热带森林演替系列中的马尾松林和松阔混交林林下土壤的呼吸速率。测定结果显示:在自然条件下,马尾松林土壤呼吸速率在1.650~4.0μmolCO2m-2s-1,松阔混交林土壤呼吸速率在1.70~3.950μmolCO2m-2s-1之间。林下土壤呼吸速率与温度和土壤空气相对湿度可用拟合,据此并结合当地气象资料推算出马尾松林和松阔混交林的年均土壤呼吸量分别为31.027、36.629 tCO2hm-2,后者高于前者。
Resumo:
A new class of polymeric amine, namely, sulfonated cardo poly(arylene ether sulfone) (SPES-NH2) was synthesized and used for the preparation of thin-film composite membrane. The TFC membranes were prepared on a polysulfone supporting film through interfacial polymerization with trimesoyl chloride (TMC) solutions and amine solutions containing SPES-NH2 and m-phenylenediamine (MPDA). The resultant membranes were characterized with water permeation performance, chemical structure, hydrophilicity of active layer and membrane morphology including top surface and cross-section.
Resumo:
Terbium(III) stearoylanthranilate has been prepared as a high property Z-type Langmuir-Blodgett (LB) film on various substrates by a vertical transfer process. The UV-visible absorption spectra and the low angle X-ray diffraction peaks have been collected in order to investigate the molecular arrangement and aggregation in the LB films. The average molecular orientation in multilayer stacking was determined by Attenuated Total Reflection Spectroscopy. The influence of the chemical environment of terbium within the LB films on the luminescence properties has been discussed. (C) 1997 Elsevier Science S.A.
Resumo:
对江河源区人工草地群落特征、多样性及其稳定性的研究结果表明,不同处理草地植物群落的物种丰富度、多样性、均匀度指数因时间和空间的变化而有明显的差异,群落演替从5龄到6龄,各群落丰富度和多样性指数增加,生物生产量降低,群落相似性系数增大.5龄老芒麦+早熟禾混播人工草地(LP5)群落的地上生物量最高(379.6 g/m2),老芒麦单播(ES5)居中(323.4 g/m2),对照组(CKF5和CK5)最低(124.3和118.6 g/m2).6龄植物群落地上生物量依次为原生植被+封育(VP6,310.1 g/m2)>老芒麦+早熟禾混播(LP6,216.3 g/m2)>老芒麦单播(ES6,190.8 g/m2)>对照(CK6,88.7 g/m2).群落间相似性系数的变化说明,单播(ES)与混播(LP)人工草地群落有趋同演化的趋势.人工草地群落随着结构的复杂化,与对照群落间的相似性提高,说明群落处于退化演替阶段,物种丰富度和多样性增大,群落稳定性提高.
Resumo:
ZnO films were fabricated on LiGaO2 (0 0 1), (10 0) and (0 10) planes by RF magnetron sputtering. The structural, morphological and optical properties of as-grown ZnO films were investigated by X-ray diffraction (XRD), atomic force microscopy (AFM), Raman spectra and photoluminescence (PL) spectra. It is found that the orientation of ZnO films is strongly dependent on the substrate plane. [0 0 0 11, [1 (1) over bar 00] and [11 (2) over bar0] oriented ZnO films are deposited on LiGaO2 (001), (100) and (010), respectively. AFM shows the (0001) ZnO film consists of well-aligned regular hexagonal grains. Raman spectra reveal a tensile stress in the (0 0 0 1) ZnO film and a compressive stress in (110 0) and (112 0) ZnO films. PL spectra of all ZnO films exhibit only a near-band-edge UV emission peak. (C) 2008 Elsevier B.V. All rights reserved.
Resumo:
We report on optimizing the GaAs capping layer growth of 1.3 mu m InAs quantum dots (QDs) by a combined two-temperature and annealing process at low temperatures using metalorganic chemical vapor deposition. The initial part (tnm) of the capping layer is deposited at a low temperature of 500 degrees C, which is the same for the growth of both the QDs and a 5-nm-thick In0.15Ga0.85As strain-reducing capping layer on the QDs, while the remaining part is grown at a higher temperature of 560 degrees C after a rapid temperature rise and subsequent annealing period at this temperature. The capping layer is deposited at the low temperatures (<= 560 degrees C) to avoid postgrowth annealing effect that can blueshift the emission wavelength of the QDs. We demonstrate the existence of an optimum t (=5 nm) and a critical annealing time (>= 450s) during the capping, resulting in significantly enhanced photoluminescence from the QDs. This significant enhancement in photoluminescence is attributed to a dramatic reduction of defects due to the optimized capping growth. The technique reported here has important implications for realizing stacked 1.3 mu m InAs/GaAs QD lasers. (C) 2008 Elsevier B.V. All rights reserved.
Resumo:
1.5 mu m n-type InGaAsP/InGaAsP modulation-doped multiple quantum well (MD-MQW) DFB lasers have been fabricated successfully by low pressure metal organic chemical vapour deposition (LP-MOCVD) technology. The experimental results indicate that n-type MD-MQWs can effectively reduce the threshold Current compared with conventional multiple quantum well DFB lasers. Theoretical analysis indicates that such an effect is due to the much smaller absorption loss and lower Auger recombination, compared with that in an undoped MQW structure. Moreover, the introduction of n-type dopant of suitable levels of concentration in the barrier layers enhances the dynamic characteristics of DFB lasers, due to a coupling between the adjacent quantum well layers and tunnelling-assisted injection, which can reduce the relatively long capture time and increase the effective differential gain 1/X dG/dn .
Resumo:
Among various mutation detection methods, constant denaturant capillary electrophoresis (CDCE) is one of the most common techniques for rapid identification of known or unknown mutations. In this report, a CDCE analysis method with homemade linear polyacrylamide (LPA) kit was developed on ABI 310 genetic analyzer, the effect and relationship of various denaturing factors in CDCE analysis were investigated and K-ras gene mutations of 31 coloerctal cancer patients were detected. Results indicate that, with the increase of chemical danaturant concentration, the optimum temperature was lowered, and when the concentration of urea (formamide) was higher than 7 M (40%), the homoduplex and heteroduplex of mutant samples were separated with difficulty. Detection results of K-ras gene in colorectal samples indicated that mutations were present in eight (26%) of 31 patients; most mutations were localized in codon 12, which is thought to be a critical step and plays an important role in human colorectal carcinogenesisas. Copyright (C) 2004 John Wiley Sons, Ltd.
Resumo:
在合成BCPDA基础上 ,对甲胎蛋白抗体与BCPDA连接及与铕离子螯合条件进行了研究。BCPDA与甲胎蛋白抗体反应后 ,分离纯化最佳淋洗液为pH9.1的0.1mol/L碳酸盐缓冲溶液 ,BCPDA用量为甲胎蛋白抗体量 (mol)的120~160倍;反应时间为30min。讨论了Eu3+ BCPDA AFP抗体螯合物的荧光光谱 ,最佳温育时间为60min,体系pH值为7.8的Tris HCl溶液。当Eu3+ 浓度为10-6mol/L时,BCPDA的检出限为4.3×10-11mol/L。
Resumo:
Full Paper: Two new 1,1'-binaphthyl-2,2'-diyl-based dianhydrides, i.e., 2,2'-bis(3,4-dicarboxybenzamido)-1,1'-binaphthyl dianhydride (BNDADA) and 2,2'-bis(3,4-dicarboxybenzoyloxy)-1,1'-binaphthyl dianhydride (BNDEDA), were synthesized and polymerized with various aromatic diamines to afford polyimides through the traditional two-step method. The polyimides with inherent viscosities ranging from 0.27 to 0.70 dl . g(-1) showed excellent solubilities in polar solvents such as DMAc, DMSO and NMP etc., except of the poly(ester imide) prepared from BNDEDA and benzidine. Poly(ester imide)s based on BNDEDA can also be readily dissolved in weakly polar solvents such as THF, CH2Cl2 and CHCl3. The glass transition temperatures of these polyimides are in the range of 210-310 degrees C; the 5% weight loss temperatures are in the range of 390-465 degrees C in nitrogen and 384-447 degrees c in air. These polymers from light yellow, tough films that were transparent above 365 nm. The effects of different flexible units attached in the 2- and 2'-positions, i.e., amide, ester and ether, on the properties of the polyimides obtained are discussed.
Resumo:
采用多速粘度计和Monsanto试验机联用,在表观剪切速率为3×10~(-8)—2.5×10~8s~(-1)时观察了高1,2-聚丁二烯(PB)生胶与顺式1,4-PB,EPDM,SBR 1500在流变性质上的差异。高1,2-PB虽在中等剪切速率下有较高的粘度,但在低、高剪切速率时的粘度均较低,这一特性有利于它的加工。高1,2-PB在低剪切速率下的流动活化能较其他橡胶高,故抗冷流性能优越,易于存放。