Martensitic transformation under impact with high strain rate

This paper deals with the quantitative prediction of the volume fraction of martensitic transformation in a austenitic steel that undergoes impact with high strain rate. The coupling relations between strain, stress, strain rate, transformation rate and transformed fraction were derived from the OTC model and modified Bodner-Partom equations, where the impact process was considered as an adiabatic and no entropy-increased process (pressure less than or equal to 20GPa). The one-dimensional results were found to model and predict various experimental results obtained on 304 stainless steel under impact with high strain rate.

Shear Localization In Dynamic Deformation: Microstructural Evolution

Investigations made by the authors and collaborators into the microstructural aspects of adiabatic shear localization are critically reviewed. The materials analyzed are low-carbon steels, 304 stainless steel, monocrystalline Fe-Ni-Cr, Ti and its alloys, Al-Li alloys, Zircaloy, copper, and Al/SiCp composites. The principal findings are the following: (a) there is a strain-rate-dependent critical strain for the development of shear bands; (b) deformed bands and white-etching bands correspond to different stages of deformation; (c) different slip activities occur in different stages of band development; (d) grain refinement and amorphization occur in shear bands; (e) loss of stress-carrying capability is more closely associated with microdefects rather than with localization of strain; (f) both crystalline rotation and slip play important roles; and (g) band development and band structures are material dependent. Additionally, avenues for new research directions are suggested.

在超声速高超声速流中横向喷流的分析计算

计算了在超声速高超声速流中横向喷流轨迹。并对实验研究中菱形后楔面喷流进行了分析计算。给出了各种流动和几何参数的影响。

InAs0.3Sb0.7 films grown on (100) GaSb substrates with a buffer layer by liquid-phase epitaxy

The growth of InAsxSb1-x films on (100) GaSb substrates by liquid-phase epitaxy (LPE) has been investigated and epitaxial InAs0.3Sb0.7 films with InAs0.9Sb0.09 buffer layers have been successfully obtained. The low X-ray rocking curve FHWM values of InAs0.3Sb0.7 layer shows the high quality of crystal-orientation structure. Hall measurements show that the highest electron mobility in the samples obtained is 2.9 x 10(4) cm(2) V-1 s(-1) and the carrier density is 2.78 x 10(16)cm(-3) at room temperature (RT). The In As0.3Sb0.7 films grown on (10 0) GaSb substrates exhibit excellent optical performance with a cut-off wavelength of 12 mu m. (c) 2007 Elsevier B.V. All rights reserved.

流速对高气压电激励CO_2激光器输出功率的影响

<正> 过去我们研究了运转压力为20Torr时,较大流速(20～340m/s)对激光器性能的影响,也探讨了固定流速为70m/s时,运转压力为40Torr～2atm范围内高压CW CO_2激光器特性。本文将进一步在高压(40～760Torr)和更大的流速范围(30～340m/s)内研究流速和气压对CO_2激光器特性的综合影响,以期探索发挥高气压器件的潜力。 所考虑的装置见图1。计算的模型和方程与[1]同。假定电子密度n_e在正柱区内沿x方向均匀分布,将一维理想气体的守恒方程和三振型系统的弛豫方程联立求解,在满足一定的稳

瓦斯煤尘爆炸火焰光谱的实验研究

本文概述了瓦斯煤尘爆炸火焰光谱实验研究的重要性,我们在弱爆炸和探测器小视场角的条件下,利用自己研制的多波道仪,在一端开口的Φ200cm×2900cm大型管道里,得到了CH4、空气和煤尘的混合物在不同状态下,特征波长λ等于0.8875、1.000、1.505、2.801和4.346微米(μ)的绝对辐射强度及其有关的变化规律,对结果进行了分析讨论,并与国外实验结果进行了对比,根据测量λ=4.346μ绝对辐射强度和我们选择的黑体辐射模型,获得了爆炸火焰的温度,该项研究不仅在工业中具有重要意义,而且对燃烧和化学动力学的研究也具有参考价值。

高温空气的输运性质

<正> 气体或气体混合物的粘性系数,热传导系数等的理论计算方法最初是从平均自由程理论开始的,例如Jeans,Kennard等.后来Enskog和Chapman建立了求解Boltzmann方程的严格的动力学理论,其中最具代表性的工作有Chapman&Cowling及Hirschfelder,Curtiss & Bird等。虽然有不少作者提出了各种求解Boltzmann方程的近似办法,例如

Tensile and compressive deformation of a short-glass-fiber-reinforced liquid-crystalline polymer

Results of tensile and compression tests on a short-glass-fiber-reinforced thermotropic liquid crystalline polymer are presented. The effect of strain rate on the compression stress-strain characteristics has been investigated over a wide range of strain rates epsilon between 10(-4) and 350 s-1. The low-strain-rate tests were conducted using a screw-driven universal tensile tester, while the high-strain-rate tests were carried out using the split Hopkinson pressure bar technique. The compression modulus was shown to vary with log10 (epsilon) in a bilinear manner. The compression modulus is insensitive to strain rate in the low-strain-rate regime (epsilon = 10(-4) - 10(-2) s-1), but it increases more rapidly with epsilon at higher epsilon. The compression strength changes linearly with log10 (epsilon) over the entire strain-rate range. The fracture surfaces were examined by scanning electron microscopy.

微重力下不可燃气体对火焰沿薄燃料表面传播的影响

数值模拟研究表明,不可燃气体对火焰传播有重要的影响。当不可燃气体为N_2时,在分析中可不考虑辐射再吸收的影响,热传导是火焰传播的主要驱动力。而当不可燃气体为CO_2时,辐射再吸收对火焰结构和传播速度有较大的影响。在静止微重力下,火焰对燃料表面的热辐射和热传导在火焰传播机理中的作用几乎相同,火焰传播速度具有最大值。随着逆流速度的增大,辐射再吸收对火焰传播的影响逐渐减弱,热传导又成为火焰传播的主要驱动力。

Wave loading on floating platforms by internal solitary waves

Morison's equation is used for estimating internal solitary wave-induced forces exerted on SPAR and semi-submersible platforms. And the results we got have also been compared to ocean surface wave loading. It is shown that Morison's equation is an appropriate approach to estimate internal wave loading even for SPAR and semi-submersible platforms, and the internal solitary wave load on floating platforms is comparable to surface wave counterpart. Moreover, the effects of the layers with different thickness on internal solitary wave force are investigated.

Ultrafast electronic excitation in CaF2 crystals

A new pump and probe experimental system was developed, the pump pulse duration of which is stretched and is much longer than that of the probe pulse. Using this system, time-resolved electronic excitation processes and damage mechanisms in CaF2 crystals were studied. The measured reflectivity of the probe pulse begins to increase at the peak of the pump pulse and increases rapidly in the latter half of the pump pulse, when the pump pulse duration is stretched to 580fs. Our experimental results indicate that both multiphoton ionization and impact ionization play important roles in the generation of conduction band electrons, at least they do so when the pump pulse durations are equal to or longer than 580fs.

飞秒脉冲波列激发的半导体量子阱中再发射场的相位演变

本文研究了在被飞秒脉冲波列激发的半导体量子阱中再发射场的相位性质。再发射场的相位演化受入射脉冲波列的相对相位控制。对于所有的奇数次入射脉冲激发，再发射场与入射场相位演化是：反相到同相再到反相；但是对于所有的偶数次入射脉冲激发，情况发生了反转，即再发射场与入射场相位演化是：同相到反相再到同相。