Ab initio investigation of the elasticity and stability of aluminium

On the basis of the pseudopotential plane-wave (PP-PW) method in combination with the local density functional theory (LDFT), complete stress-strain curves for the uniaxial loading and uniaxial deformation along the [001] and [111] directions, and the biaxial proportional extension along [010] and [001] for aluminium are obtained. During the uniaxial loading, certain general behaviours of the energy versus the stretch and the load versus the stretch are confirmed; in each case, there exist three special unstressed structures: f.c.c., b.c.c., and f.c.t. for [001]; f.c.c., s.c., and b.c.c. for [111]. Using stability criteria, we find that all of these states are unstable, and always occur together with shear instability, except the natural f.c.c. structure. A Pain transformation from the stable f.c.c. structure to the stable b.c.c. configuration cannot be obtained by uniaxial compression along any equivalent [001] and [111] direction. The tensile strengths are similar for the two directions. For the higher energy barrier of the [111] direction, the compressive strength is greater than that for the [001] direction. With increase in the ratio of the biaxial proportional extension, the stress and tensile strength increase; however, the critical strain does not change significantly. Our results add to the existing ab initio database for use in fitting and testing interatomic potentials.

Pyrex玻璃/铝多层阳极键合界面结构与力学分析

采用公共阳极法实现了Pyrex玻璃与铝多层晶片的静电键合,对玻璃/铝/玻璃阳极接合界面的组织结构及其连接机理和力学特征进行了重点研究。分别利用微拉伸测试设备和ANSYS软件分析了连接区的力学性能和残余应力分布特征。分析认为键合区由玻璃-过渡层-铝组成,过渡层为Al_2O_3-SiO_2复合氧化物。玻璃/铝界面的微观组织和元素分布均以铝为对称轴呈对称分布。在玻璃/铝/玻璃多层连接区,键合界面附近的残余应力和应变呈对称分布,多层结构的对称性有利于缓解接头应变和应力,表明应用公共阳极法可实现多层玻璃/铝/玻璃的良好键合。

Tunable phase-stabilized infrared parametric laser source

This paper reports that the tunable self-phase-stabilized infrared laser pulses have been generated from a two-stage optical parametric amplifier. With an 800 nm pump source, the output idler pulses are tunable from 1.3 mu m to 2.3 mu m, and the maximum output energy of the idler pulses is higher than 1 mJ at 1.6 mu m by using 6 mJ pump laser. A carrier-envelope phase fluctuation of similar to 0.15 rad (rms) for the idler pulses is measured for longer than one hour by using a home build f-to-2f interferometer.

内蒙古草原中生物土壤结皮生态学研究

1. 生物土壤结皮是干旱半干旱生态系统中的重要组成部分，它可通过增加土壤肥力和稳定性、影响水分再分配和植物萌发、成活、生长和繁殖而对生态系统结构和功能产生重要影响。为阐明生物结皮在内蒙古草地中的作用，本报告对两个草地生态系统进行了为期三年的调查，对生物结皮的氮素输入、对放牧的响应及其与植物的关系进行了综合研究。 2. 利用乙炔还原法，本研究对内蒙古退化草地中的生物土壤结皮中的蓝藻、地衣和地耳的氮素输入进行了为期30个月的连续测定。研究发现：1) 生物结皮固氮活性主要集中于5-10月，呈单峰型曲线，表明生物土壤结皮的固氮作用主要受温度和降雨影响;2) 生物结皮年固氮量为12.99-129.9 kg N•ha-1，98%的氮素固定于6-9月份;3) 按固氮量排序，蓝藻 (61%) > 地衣 (33%) > 地耳 (6%)，表明物种组成和丰度对生物结皮的氮素输入具重要影响。生物结皮的固氮量和季节变化表明生物结皮可以是影响退化草地中植物生长和促进退化草地恢复的重要影响因子。 3. 本研究选择三个放牧处理（长期放牧、短期围封和近期放牧）对生物结皮固氮活性进行了为期3年的研究。结果表明，与短期围封相比，长期放牧造成生物土壤结皮固氮活性下降了99.5%。固氮活性在放牧时间不足11个月时即可下降至最低水平，因此，放牧持续时间短于4个月的轮牧可能有利于生物土壤结皮的固氮。 4. 本研究选择6个放牧梯度（对照：0.00 羊/公顷, 极轻度放牧：1.33羊/公顷，轻度放牧：2.67羊/公顷，中度放牧：4.00羊/公顷，重度放牧：5.33羊/公顷，极重度放牧：6.67羊/公顷)，研究放牧强度对于生物结皮丰度、物种组成和固氮输入的影响。不同放牧强度对生物结皮丰度、物种组成和固氮输入具有重要影响，表明长期放牧可抑制生物土壤结皮在氮素输入和土壤固定方面的作用。极轻度放牧对生物土壤结皮影响不大;轻度放牧造成氮素输入降低了50%;重度和极重度放牧造成氮素输入降低了90%，并可使移动性较强的物种成为生物土壤结皮的优势组分，从而可抑制其土壤固定作用。因此，极轻度和轻度放牧是有利于生物土壤结皮固氮和固定土壤的草地利用方式。 5. 在处于恢复早期的一个退化草地中，我们对生物结皮和植物之间的关系进行了为期2年的研究。结果表明，生物结皮的丰度和物种组成与植物地上生物量和盖度高度相关。生物结皮丰度和氮素输入随植物生物量和盖度下降。结果还表明生物结皮是退化草地的主要氮素输入来源，尤其是在草地恢复初期。植物组织δ15N 低于土壤，这种差异随植物生产力增高而减小，表明生物结皮所固定氮素首先被植物利用，而后返回土壤。生物结皮的固氮输入变化可能是这种变化模式的主要原因，在分解作用和氮素损失中的同位素分馏，以及菌根真菌对于氮素的转运可能也是这种变化模式的原因。结果还显示生物土壤结皮与植物之间可能存在负反馈关系。这种自我调节的反馈过程可能是影响退化草地生态系统生产力和氮素循环的重要调节机制。

云南省牛胚胎移植技术研究与应用进展

介绍云南省牛胚胎移植研究与应用的现状，分析存在的问题，提出相应对策，探索发展方向。

A 16-term error model based on linear equations of voltage and current variables

Formulation of a 16-term error model, based on the four-port ABCD-matrix and voltage and current variables, is outlined. Matrices A, B, C, and D are each 2 x 2 submatrices of the complete 4 x 4 error matrix. The corresponding equations are linear in terms of the error parameters, which simplifies the calibration process. The parallelism with the network analyzer calibration procedures and the requirement of five two-port calibration measurements are stressed. Principles for robust choice of equations are presented. While the formulation is suitable for any network analyzer measurement, it is expected to be a useful alternative for the nonlinear y-parameter approach used in intrinsic semiconductor electrical and noise parameter measurements and parasitics' deembedding.

Magnetic properties and rectifying behaviour of silicon doped with gadolinium

The magnetic/nonmagnetic p-n junction was prepared by implanting gadolinium into the n-type silicon with low-energy dual-ion-beam epitaxy technology. The magnetic layer GdxSi1-x shows excellent magnetic properties at room temperature. High magnetic moment 10mu(B) per Gd atom is observed, which is interpreted by RKKY mechanism. Magnetic/nonmagnetic p-n junctions show rectifying behaviour, but no magnetoresistance is observed.

Improvement of the photoluminescence from gallium nitride layers grown by MBE with an additional incident indium flux

The effect of using an indium flux during the MBE growth of GaN layers was investigated. The properties of these layers were studied using electron probe microanalysis, secondary ion mass spectroscopy, photoluminescence and cathodoluminescence. The optical properties of the GaN layers are shown to improve as compared with undoped GaN layers grown under nominally the same conditions but without an additional indium flux.

求和生成器的相关性分析

J.Dj,Golic运用线性序列电路逼进的方法来分析具有任意个输入的求和生成器,他猜想可以通过这种方法来获得所有具有最大相关系数的输入和输出线性函数对,但是他未给出证明。利用Walsh变换技术证明了当n是偶数的时候这个猜想成立。另外,还研究了求和生成器的相关系数总和,发现它与带1比特组合器的相关系数总和非常类似。