最近130ka来黄土物质化学风化强度的空间格局

Chemical weathering intensity of loess deposits is largely determined by three factors: chemical weathering in source regions, grain size and post-depositional weathering. The third factor is influenced by climatic conditions such as precipitation and temperature, and the dust sedimentation rate in the area of deposition. Previous studies have shown that the (CaO+MgO+Na2O)/TiO2 ratio of decarbonated residue from loess is independent of grain size changes and thus is a reliable proxy for chemical weathering. However, the validity of (CaO+MgO+Na2O)/TiO2 to describe changes in monsoon intensity requires further study. In this study, 48 sections over the last glacial-interglacial cycle on the Chinese Loess Plateau were sampled, and the major elemental concentrations of 248 decarbonated residue samples were measured to investigate the utility of the (CaO+MgO+Na2O)/TiO2 ratio as a proxy for changes in monsoon intensity. Results show that the (CaO+MgO+Na2O)/TiO2 ratio, is relatively more sensitive to climate change than other indexes independent of grain size, and is not affected substantially by sedimentation rate. Assuming the weathering regime is relatively stable in the loess source regions, the (CaO+MgO+Na2O)/TiO2 ratio is a reliable proxy for the intensity of summer monsoon. A decreasing (CaO+MgO+Na2O)/TiO2 ratio from northwest to southeast both in loess and paleosols indicates that the Chinese Loess Plateau is in the control of the East Asian summer monsoon during both interglacial and glacial times. In addition, the spatial distributions of (CaO+MgO+Na2O)/TiO2 ratios show a greater north-south gradient during interglacial periods than during glacial periods. This may suggest that the spatial precipitation gradient, controlled by the summer monsoon, is steeper during interglacials than in glacials.

扬子板块西部大陆地幔地球化学特征及壳幔演化－有关基性岩超基性岩的地球化学研究

The continental mantle geochemical characteristics and crust-mantle evolution in the west of Yangtze Plate was discussed through the study of some within-plate basic-ultrabasic rocks from Lower Proterozoic to Later Paleozoic in this paper. In the Lower Proterozoic, the plate subduction between the pre-Tethys Proterozoic Ocean Plate and paleo-Yangtze Plate induced some basic volcanic formed in the island arc-back arc surrounding, which were represented by Ailaoshan Group-Dibadu Formation-Dahongshan Group, and there existed EM I component in the mantle source. The Middle Proterozoic Caiziyuan peridotite was formed in the epicontinental basin at the ocean-land boundary or within-continent rift basin. Its mantle source could be metasomatized by the dehydration fluid of subducted plate, and much initial radioactive ~(143)Nd was added to the source. In the Later Proterozoic, some rifts at the epicontinent or within-continent was formed due to the pre-Tethys oceanic plate subduction, and within-plate hot-spot Dahongshan diabase came into being. The whole-rock isochronal age of diabase is 1066±110Ma, and its mantle source was enriched Nd isotope and trace element which was related to the primary volatile component from asthenosphere and mantle plume. Its mantle source was included "FOZO" component representing mantle plume. The layer ultramafic rocks located at the Panxi Rift in the Middle-Later Paleozoic were resulted from different period and source. The early ultramafic indicated the incipient action of Panxi Rift, which is residue of continental lithospheric partial melting. Its mantle source involved subducted material and had distinct EM II component. The Emeishan basalt in the Later Paleozoic was typical continental flood basalt and its source also contained EM II component. The subduction of paleo-Tethys Ocean Plate provided essential dynamic condition for the large-scale opening of Panxi Rift, while the mantle plume supplied much material for Emeishan basalt. However, the plume was contaminated by the metasomatized continental mantle lithosphere in its upwelling process, which resulted in the Sr isotopic and incompatible elemental enrichment, and the Nd isotope kept down the weak-depleted character of mantle plume. The magmatic history in the west of Yangtze Plate is the tectonic process between pre-Tethys, paleo-Tethys Oceanic Plate and Yangtze Plate in a long history. Due to the subduction of oceanic plate, the crustal source material took part in the crust-mantle evolution widely. the continental mantle lithosphere in the west of Yangtze Plate was metasomatized by the fluid released by the subducted plate and the primary volatile from deeper mantle, and the mantle source include obvious enriched component.

攀西地区红格、新街岩体的岩石地球化学特征

The mafic-ultramafic layered intrusions in the Panxi, China contain large V-Ti-magnetite deposits. These layered intrusions are related with the Emeishan continental flood basalts in space and time. Two layered intrusions, Hongge and Xinjie have clear PGE mineralization at the base of the intrusions. Thus the detailed investigations of these two intrusions not only have a geological but also have an economic significance. This thesis aims to characterize the elemental and Sr-Nd isotopic features of diverse rock zones within the intrusion on the basis of systematic studies of the major, trace element and isotope ratios, therefore to constrain the petrogenesis, mantle source and evolution of the Hongge and Xinjie intrusions. Generally, both Hongge and Xinjie intrusions show the same Fe-Ti-rich and Si-M-poor characteristics. They are also enriched in rare-earth elements (REE) and large-ion lithophile elements (LILE) as well as in Sr-Nd isotope ratios (Hongge: initial Sr = 0.7056-0.7076, ε_(Nd)(t) and (Nd/Sm)_N-ε_(Nd)(t) plots, the Hongge intrusion has a similar elemental and isotopic features to the Emeishan low-Ti (LT) basalts, whereas the Xinjie intrusion was close to the Emeishan high-Ti (HT) basalt. Therefore, the Hongge intrusion may be co-genetic with the LT basalt, formed by the partial melting of the spinel-garnet transition mantle that had a slight enriched isotope character. In contrast, the Xinjie intrusion and the HT basalts are probably derived from the garnet-phases mantle with a primitive isotope character. The involvement of the components of mantle wedge into the source is considered to be the major reason of the REE and LILE enrichment and Nd isotope depletion in the Xinjie intrusion. In contrast with the systematic variations in TiO_2 content, Mg#, transition elements (Ni, Cu, Co), REE concentrations, and La/Yb, La/Sm ratios from the lower zone to upper zone, the different rock zones of the Hongge intrusion have no clear Sr-Nd isotope variations. This suggests that the Hongge intrusions were formed by the crystal fractionation from the same magma source. The rhythm may be formed by slow injection of the co-genetic magma during the crystal fractionation. The increase in K_2O and Al_2O_3 contents, REE abundance, and the degree of the REE fractionation in the base of the intrusion, together with the relatively low ε_(Nd)(t) value, may imply that the base of the Hongge intrusion was contaminated with the local crust rocks. Xinjie intrusion shows the clearly elemental and isotopic differences in diverse cumulus cycles. The observation of the systematic variations in TiO_2 content, Mg# value, transition elements (Ni, Cu, Co), REE concentrations, and La/Yb, La/Sm ratios in first cycle was not occurred in second cumulus cycle. In addition, the ε_(Nd)(t) value in second cumulus cycle is apparently higher than that of the first one. Thus the abruptly elemental and isotopic changes at the base of second cycle demonstrate that there is considerable new and depleted magma addition to the residue magma after the crystallization of the first cycle. These features are very similar to those of the well-known PGE-rich Bushveld and Stillwater layered intrusions. The PGE mineralization in Xinjie intrusion is much better than in Hongge intrusion. Therefore, the layered intrusion similar to the Xinjie in Panxi area posses the better prospects for the PGE deposits.

Factors influencing the catalytic activity of SBA-15-supported copper nanoparticles in CO oxidation

Copper nanoparticles were deposited onto mesoporous SBA-15 support via two different routes: post-grafting method and incipient wet impregnation method. Both XRD and TEM reveal that the post-grafting can make Cu particles very small in size and highly dispersed into channels of SBA-15, while the impregnation method mainly forms large Cu particles on the external surface of SBA-15. TPR experiments show that CuO species formed by the post-grafting method is more reducible than that prepared by the impregnation method. The catalytic activity tests for CO oxidation manifests that the sample prepared by the post-grafting method has a much higher activity than that prepared by the impregnation method, with a lowering of 50 degrees C for T-50, showing a strong dependence of catalytic activity on the size and dispersion of Cu particles. Besides the preparation procedure, other factors including calcination temperature, reduction treatment, copper loading as well as the feed composition, have an important effect on the catalytic activity. The best performance was obtained when the catalyst was calcined at 500 degrees C and reduced at 550 degrees C. The calcination and reduction treatment at high temperature have been found to be necessary to completely remove the organic residue and to generate active metallic copper particles. (c) 2005 Elsevier B.V. All rights reserved.