Large-scale isolation and purification of R-phycoerythrin from red alga Palmaria palmata using the expanded bed adsorption method

R-phycoerythrin, a light-harvesting protein in some marine algae, and can be widely used in medicine, was isolated and purified from a red alga, Palmaria palmata (Lannaeus) Kuntze, using the streamline column (expanded bed adsorption) combined with ion-exchange chromatography. Because the crude extract was applied to the column upwardly, the column would not be blocked by polysaccharides usually very abundant in the extract of marine alga, this kind of blockage could hardly lie overcome in ordinary chromatographic column. After applying the crude extract containing 0.5 mol/L (NH4)(2)SO4, (NH4)(2)SO4 solution of different concentrations (0.2 mol/L, 0.1 mol/L and 0.05 mol/L) was used to elute the column downwardly and the eluates were collected and desalted. The desalted eluates were then applied onto all ion-exchange chromatographic column loaded with Q-sepharose for further purification of the R-phycoerythrin. Through these two steps, the purity (OD565/OD280) of the R-phycoerythrin from P. palmata was up to 3.5, more than 3.2, the commonly accepted criterion for purity, and the yield of the purified R-phycoerythrin could reach 0.122 mg/g of frozen P. palmata, much higher than that of phycobiliproteins purified with the previous methods. The result indicated that the cost of R-phycoerythrin will drop down with the method reported in this article.

In vitro assembly of R-phycoerythrin from marine red alga Polysiphonia urceolata

Scanning tunneling microscope was used to investigate the in vitro assembly of R-phycoerythrin (R-PE) from the marine red alga Polysiphonia urceolata. The results showed that R-PE molecules assembled together by disc-to-disc while absorbing on HOPG surface, which just looked like the rods in the phycobilisomes. When the water-soluble R-PE was dissolved in 2% ethanol/water spreading solution, they could form monolayer film at the air/water interface. Similar disc-to-disc array of R-PE was constituted in the two-dimensional Langmuir-Blodgett film by the external force. It could be concluded that, apart from the key role of time linker polypeptides, the in vivo assembly of phycobiliproteins into phycobilisomes is also dependent on the endogenous properties of phycobiliprotein themselves.

Biological effect of R-phycoerythrin-mediated photosensitization on DNA.

R-phycoerythrin (R-PE) is one of important proteins involved in capturing light during photosynthesis in red algae, and it is highly fluorescent, and water-soluble chromophores. In vivo, it can transfer the light energy into photosynthetic center, however, it can deliver the captured light energy captured to the surrounding oxygen in vitro and produce reactive oxygen species such as singlet oxygen, which is toxic to tumor cells. R-PE was added to the culture medium of tumor cells, subsequently with irradiation of 488 nm, Argon laser of 25.6 J/cm(2). The result by MTT assay showed that the survival rate decreased with the increase of R-PE concentration from 1 to 100 mg/L. The result from H-3-TdR incorporation demonstrated that the synthesis of DNA reduced when the concentration of R-PE increased from 0.01 to 0.32 mg/L. Besides, pUC18 DNA showed a conversion from supercoiled into linear conformation. The conclusion comes that R-PE mediated PDT can influence the conformation of DNA, and it may be one of the mechanisms of R-PE mediated photodynamic therapy.

Isolation, properties and spatial site analysis of gamma subunits of B-phycoerythrin and R-phycoerythrin

Polysiphonia urceolata R-phycoerythrin and Porphyridium cruentum B-phycoerythrin were degraded with proteinaseK, and then the nearly native gamma subunits were isolated from the reaction mixture. The process of degradation of phycoerythrin with proteinaseK showed that the gamma subunit is located in the central cavity of (alpha beta)(6) hexamer of phycoerythrin. Comparative analysis of the spectra of the native phycoerythrin, the phycoerythrin at pH 12 and the isolated gamma subunit showed that the absorption peaks of phycoerythrobilins on alpha or beta subunit are at 535 nm (or 545 nm) and 565 nm, the fluorescence emission maximum at 580 nm; the absorption peak of phycoerythrobilins on the isolated gamma subunit is at 589 nm, the fluorescence emission peak at 620 nm which overlaps the absorption maximum of C-phycocyanin and perhaps contributes to the energy transfer with high efficiency between phycoerythrin and phycocyanin in phycobilisome; the absorption maximum of phycourobilin on the isolated gamma subunit is at 498 nm, which is the same as that in native phycoerythrin, and the fluorescence emission maximum at 575 nm.

Method for large-scale isolation and purification of R-phycoerythrin from red alga Polysiphonia urceolata Grev

R-phycoerythrin was isolated and purified from a red alga, Polysiphonia urceolata Grev, using Streamline column combined with ion-exchange chromatography or hydroxyapatite chromatography. The purity of R-phycoerythrin isolated by Streamline column was up to 1.66 and the yield of R-phycoerythrin could be as high as 0.68 mg/g frozen P. urceolata. All the eluates from Streamline column were divided into two equivalent parts, respectively. One part was pumped into the ion-exchange column loaded with Q-Sepharose and the other was applied to the adsorption column loaded with hydroxyapatite. The purities of R-phycoerythrin purified using these two methods were both up to 3.26, more than 3.2 the commonly accepted criterion. The yield of purified R-phycoerythrin from the ion-exchange chromatography was 0.40 mg/g frozen P. urceolata and that from the hydroxyapatite chromatography could reach 0.34 mg/g frozen P. urceolata. The purified protein had three absorption peaks at 498, 535, and 565 nm and displayed a fluorescence maximum at 580 nm, which was consistent with the typical spectrum of R-phycoerythrin. The purified R-PE was also identified with electrophoresis. Only one single protein band appeared on native-PAGE with silver staining. SDS-PAGE demonstrated the presence of one 20 kDa major subunit, and one low intensity band corresponding to 33 kDa subunit. The results indicate that using the expanded bed adsorption combined with ion-exchange chromatography or hydroxyapatite chromatography, R-phycoerythrin can be purified from frozen P. urceolata on large scale. (c) 2006 Elsevier Inc. All rights reserved.

Preparation of porous chitosan/agarose microsphere and its R-phycoerythrin release properties

The chitosan microspheres (CS-CL) were prepared by suspension crosslinking method and used as carriers of R-phycoerythrin (R-PE). In this study, R-PE was loaded in the microspheres and released in vitro. The effects of pH value, temperature, ionic strength, and R-PE concentration on loading efficiency and release behavior were discussed. A novel microsphere that contained agarose (CS-AR MP) was prepared and the basic loading and releasing behavior for R-PE of this kind of new micro-spheres were also investigated. The results showed that all these chitosan microspheres have the ability to control-release R-PE. The addition of agarose may somewhat accelerate the release rate of R-PE from microspheres and reduce the capacity of adsorption for R-PE. (c) 2006 Wiley Periodicals, Inc.

退耕弃荒洼地土壤有机碳在生态系统转化过程中的动态变化

在贵州喀斯特区域一块典型的退耕弃荒洼地中央和周边坡面采集了4个土壤剖面,研究土壤有机碳（SOC）含量和δ^13Corg值的变化.结果表明,坡面不同土壤层次SOC的变化范围为6.0-92.3 mg·kg^-1,并沿着土壤层次的加深迅速降低,变化幅度远远大于洼地土壤剖面（6.3-26.7 mg·kg^-1）.坡面土壤δ^13Corg介于-25.103‰和-23.666‰之间,但各剖面土层内部δ^13Corg变化趋势不一致.洼地土壤δ^13Corg介于-23.495‰和-20.809‰之间,并随着土壤层次的加深δ^13Corg逐渐增加.洼地土壤剖面层次内C4-C占SOC的比例随土壤层次的加深逐渐增加,与林-农生态系统转变过程中的变化趋势相反;土壤δ^13Corg与C3-C之间呈显著相关性（R^2=0.7806,n=7）,对δ^13Corg起到主要影响作用的是退耕弃荒后新加入的C3-C.

New progress in R&D of lower olefin synthesis

This paper gives a brief review of R&D researches for light olefin synthesis directly and indirectly from synthesis gas in the Dalian Institute of Chemical Physics (DICP). The first pilot plant test was on methanol to olefin (MTO) reaction and was finished in 1993, which was based on ZSM-5-type catalyst and fixed bed reaction. In the meantime, a new indirect method designated as SDTO (syngas via dimethylether to olefin) was proposed. In this process, metal-acid bifunctional catalyst was applied for synthesis gas to dimethylether(DME) reaction, and modified SAPO-34 catalyst that was synthesized by a new low-cost method with optimal crystal size was used to convert DME to light olefin on a fluidized bed reactor. The pilot plant test on SDTO was performed and finished in 1995. Evaluation of the pilot plant data showed that 190-200 g of DME were yielded by single-pass for each standard cubic meter of synthesis gas. For the second reaction, 1.880 tons of DME or 2.615 tons of methanol produced 1 ton of light olefins, which constitutes of 0.533 ton of ethylene, 0.349 ton of propylene and 0.118 ton of butene. DICP also paid some attention on direct conversion of synthesis gas to light olefins. A semi-pilot plant test (catalyst 1.8 1) was finished in 1995 with a CO conversion > 70% and a C(2)(=)-C(4)(=) olefin selectivity 71-74% in 1000 h. (C) 2000 Published by Elsevier Science B.V. All rights reserved.