山地红枣林地滴灌水分运移规律试验研究

在米脂山地微灌枣树示范基地研究了一定流量范围、不同灌水量条件下,地表滴灌水分在水平和垂直方向上的运移规律及滴灌结束后的水分再分布特征。试验结果表明:在流量稳定条件下,湿润体的水平和垂直扩散距离均与时间有显著的幂函数关系;在4.6~5.0 L/h的流量范围内,湿润体的水平和垂直扩散距离与灌水量也存在显著的幂函数关系;滴灌停止后24 h内的土壤湿润体扩散很大,湿润体平均含水量降低很快,24 h后的扩散较小,平均含水量下降较小,确定滴灌停止后24 h时的湿润体特征值可作为滴灌系统设计的依据。

Effect of cryoprotectants on hatching rate of red seabream (Pagrus major) embryos

The objectives were to investigate the effect of cryoprotectants on the hatching rate of red seabream embryos. Heart-beat embryos were immersed in: five permeable cryoprotectants, dimethyl sulfoxide (DMSO), glycerol (Gly), methanol (MeOH), 1,2-propylene glycol (PG), and ethylene glycol (EG). in concentrations of 5-30% for 10, 30, or 60 min; and two non-permeable cryoprotectants: polyvinylpyrrolidone (PVP), and sucrose (in concentrations of 5-20% for 10 or 30 min). The embryos were then washed and incubated in filtered seawater until hatching occurred. The hatching rate of the embryos treated with permeable cryoprotectants decreased (P < 0.05) with increased concentration and duration of exposure. In addition, PG was the least toxic permeable cryoprotectant, followed by DMSO and EG, whereas Gly and MeOH were the most toxic. At a concentration of 15% and 30 min exposure, the hatching rate of the embryos immersed in PG was 93.3 +/- 7.0% (mean +/- S.D.), however. in DMSO. EG, Gly. and MeOH, it was 82.7 +/- 10.4, 22.0 +/- 5.7, 0.0 +/- 0.0, and 0.0 +/- 0.0%, respectively. Hatching rate of embryos treated with PVP decreased (P < 0.05) with the increase of concentration and exposure time, whereas for embryos treated with sucrose, there was no significant decrease in comparison with the control at the concentrations used. (C) 2008 Elsevier Inc. All rights reserved.

ON THE RATE-EQUATIONS OF SEMICONDUCTOR-LASERS FOR MEASURING SPONTANEOUS EMISSION FACTOR

The rate equations used for measuring spontaneous emission factor beta is examined through the comparison of numerical results, The results show that beta obtained by using total spontaneous emission rate R(sp) = N/tau sp is about double of that using R(sp) = BN2, The magnitude difference between the measured beta and that predicted by classical theory [8] will disappear by using more reasonable R(sp) = BN2. The results also show that the magnitude of beta may be underestimated by ignoring the nonradiative recombination rates.

Dependence of wet etch rate on deposition, annealing conditions and etchants for PECVD silicon nitride film

The influence of deposition, annealing conditions, and etchants on the wet etch rate of plasma enhanced chemical vapor deposition (PECVD) silicon nitride thin film is studied. The deposition source gas flow rate and annealing temperature were varied to decrease the etch rate of SiN_x:H by HF solution. A low etch rate was achieved by increasing the SiH_4 gas flow rate or annealing temperature, or decreasing the NH_3 and N_2 gas flow rate. Concen-trated, buffered, and dilute hydrofluoric acid were utilized as etchants for SiO_2 and SiN_x:H. A high etching selectivity of SiO_2 over SiN_x:H was obtained using highly concentrated buffered HF.

1 GHz Repetition Rate CW Mode-locked Nd∶YVO_4 Laser

A diode-pumped CW mode-locked Nd

森林流域单元水文模型的构建与应用

目前全球缺水、水污染、洪涝灾害以及水土流失仍然非常严重，尤其在我国北方地区。流域水文模型可用来进行不同需水管理的情景分析，为解决我国水问题提供科学依据。分布式水文模型是流域水文模型的发展方向，具有显著特点：1）应用前景广泛，不仅可以模拟流域水文过程，还可以协助模拟泥沙或污染物的运移过程，为水利工程设计、水土保持、环境保护等领域提供技术支持；2）能够预测流域土地利用或气候变化下的流域水文响应过程变化，为管理部门提供决策支持；3）模型所需要的参数全部具有物理意义，可通过实际测量确定，适合模拟实测系列较短或是无观测流域的水文过程；4）对于目前国际水文界的前沿问题—水文尺度转换提供了一种有效的解决途径。 然而分布式水文模型还不完善，如1)真实性问题。对一些水文过程和边界条件还不确定。2)尺度转换问题。目前很少考虑尺度对参数有效性的影响。3)检验问题。还无法判断对有些难以测量的水文状态变量的模拟正确与否。4)计算时间和数据存储的问题。有些分布式水文模型虽然具有很强的水文物理基础和完善的模型结构，但是计算时间过长和(或)数据存储过大，难以应用。上述问题的核心就是对分布式水文模型的核心—单元水文模型的研究不够，需要为进一步完善单元水文模型进行研究。 本文采用饱和入渗理论、Saint-Venant方程、Richards方程、Penman-Monteith方程等等构建了以有限差分法求解的适用于森林流域的单元水文模型，并通过实验室模拟试验和坡地径流场资料进行了验证，主要结论为： 通过不同坡度和不同雨强下的室内坡面产汇流实验模拟，表明：该模型模拟的坡面流和壤中流过程与实测过程基本一致，峰现时间、径流历时、峰值流量、出流总量模拟值与实测值的相对误差均较小，基本小于10%。模型的模拟精度较高，实用性较强，为深入研究壤中流机制和改进流域降雨-径流模型提供了理论依据。 通过坡地径流观测场实测资料的验证，表明：该模型模拟的坡面流过程精度较高，累计流量的精度更高于小时过程的精度，离差系数、效率系数、确定系数均较理想，具有应用价值，有助于改善分布式水文模型在森林流域的模拟效果。