Cu膜的光学特性尺寸效应及最小连续膜厚研究

采用离子束溅射在K9玻璃基底上沉积了不同厚度的Cu膜，利用Lambda-900分光光度计，测量了波长为310nm到1300nm范围内Cu膜的反射率和透射率．选定波长为310、350、400、430、550、632、800、1200nm时对薄膜的反射率、透射率和吸收率随膜厚变化的关系进行研究．同时，对Cu膜的光学常量也进行了讨论．结果显示，Cu膜的光学特性都有明显的尺寸效应．将波长为550nm时的反射率和透射率随Cu膜厚度变化关系的交点对应厚度作为特征厚度，该厚度可认为是金属Cu膜生长从不连续膜进入连续膜的

High-reflectance 193 nm Al2O3/MgF2 mirrors

Thin-film single layers of Al2O3 and MgF2 were deposited upon super polished fused-silica by electron-beam evaporation. The subsequent optical constants n and k were reported for the spectral range of 180-230 nm. High-reflectance dense multilayer coatings for 193 nm were designed on the basis of the evaluated optical constants and produced. The spectra of the reflectance of HR coatings were compared to the theoretical calculations. HR mirrors of 27 layers with a reflectance of more than 98% were reported. (c) 2004 Elsevier B.V. All rights reserved.

Annealing effects on electron-beam evaporated Al2O3 films

The effects of post-deposited annealing on structure and optical properties of electron-beam evaporated Al2O3 single layers were investigated. The films were annealed in air for 1.5 h at different temperatures from 250 to 400 degrees C. The optical constants and cut-off wavelength were deduced. Microstructure of the samples was characterized by X-ray diffraction (XRD). Profile and surface roughness measurement instrument was used to determine the rms surface roughness. It was found that the cut-off wavelength shifted to short wavelength as the annealing temperature increased and the total optical loss decreased. The film structure remained amorphous even after annealing at 400 degrees C temperature and the samples annealed at higher temperature had the higher rms surface roughness. The decreasing total optical loss with annealing temperature was attributed to the reduction of absorption owing to oxidation of the film by annealing. Guidance to reduce the optical loss of excimer laser mirrors was given. (c) 2004 Elsevier B.V. All rights reserved.

高反射率193nm Al2O3／MgF2反射膜的实验研究

用电子束热蒸发方法在熔融石英基底上沉积了Al2O3和MgF2两种材料的单层膜，研究了两种材料的光学特性，采用光度法计算并给出了薄膜材料在180～230nm的折射率n／和消光系数k的色散曲线。以两种材料作为高低折射率材料组合，采用1／4波长规整膜系设计并镀制了193nm的高反射膜，反射膜在退火后的反射率在193nm达到96％以上。结果表明在一定工艺条件下Al2O3和MgF2两种材料能够在193nm获得较好的光学性能，适用于高反射膜的制备。

Co和Cu薄膜电学特性和连续性特征的判据

采用离子束溅射沉积了不同厚度的Co膜和Cu膜，利用四电极法测量了薄膜的电阻率，从而得到了Co膜和Cu膜的电导率随薄膜厚度的变化关系。实验结果表明，Co膜和Cu膜的电学特性都具有明显的尺寸效应。比较了同时考虑表面散射和晶界散射的电导理论得到的电导率公式与实验结果，不同薄膜厚度电导率的理论结果与实验结果符合较好。提出了厚度作为金属薄膜生长从不连续膜进入连续膜的一个特征判据，并利用原子力显微镜（AFM）观测了膜厚在特征厚度附近的Co膜和Cu膜的表面形貌。

退火对电子束热蒸发Al2O3薄膜性能影响的实验研究

用电子束热蒸发方法镀制了Al2O3材料的单层膜，对它们在空气中进行了250～400℃的高温退火。对样品的透射率光谱曲线进行了测量，计算了样品的消光系数、折射率和截止波长。通过X射线衍射仪(XRD)测量分析了薄膜的微观结构，采用表面轮廓仪测量了样品的表面均方根粗糙度。结果发现随着退火温度的提高光学损耗下降，薄膜结构在退火温度为400℃时仍然为无定形态，样品的表面粗糙度随退火温度的升高而增加。引起光学损耗下降起主导作用的是吸收而不是散射，吸收损耗的下降主要是由于退火使材料吸收空气中的氧而进一步氧化，从而使薄膜

Al2O3和Cr过渡层对Ag膜光学性质及其附着力的影响

研究了在玻璃基底上镀制Al2O3和Cr过渡层对Ag膜反射率及附着力的影响.分光光度计测试了Ag膜的反射率,结果表明,与Cr过渡层相比,Al2O3过渡层对Ag膜反射率的降低相对较小;而且,随着Al2O3厚度的增加,Ag膜的反射率先增大后减小.XRD与AES测试表明,引入Al2O3或Cr可明显细化Ag晶粒,减弱Ag膜（111）织构;Al2O3作过渡层时,Al原子向Ag层中扩散显著;而Cr作过渡层时,只有少量Cr原子扩散进入Ag层.因此,Al2O3作过渡层能显著增强薄膜与玻璃基体之间的附着力.

Working pressure dependence of properties of Al2O3 thin films prepared by electron beam evaporation

The effects of working pressure on properties of Al2O3 thin films are investigated. Transmittance of the Al2O3 thin film is measured by a Lambda 900 spectrometer. Laser-induced damage threshold (LIDT) is measured by a Nd:YAG laser at 355nm with a pulse width of 7ns. Microdefects were observed under a Nomarski microscope. The samples are characterized by optical properties and defect, as well as LIDT under the 355 nm Nd: YAG laser radiation. It is found that the working pressure has fundamental effect on the LIDT. It is the absorption rather than the microdefect that plays an important role on the LID T of Al2O3 thin film.

伊乐藻对Cu Cd污染底泥修复的应用研究

在自然条件下,采用人工模拟水缸培养方法,研究了湖泊底泥不同Cu、Cd处理对沉水植物伊乐藻生长、叶绿素含量以及Cu、Cd吸收和积累的影响。结果表明,较低浓度Cu刺激伊乐藻的生长(生物量、叶绿素),高浓度抑制伊乐藻的生长;随着Cd处理浓度的增加,伊乐藻的生物量、叶绿素含量均一直降低,在底泥Cd含量为168.69mg·kg-1DW(含背景值)时,植株出现死亡。随着Cu处理浓度的增加,伊乐藻体内的Cu含量一直增加,在底泥Cu含量为414mg·kg-1DW(含背景值)时,根部、叶部的富集系数均达到最大(0.21和0

Cd~(2+)和Cu~(2+)对美人蕉的氧化胁迫及抗性机理研究

通过测定植物的丙二醛(MDA)含量、酸溶性SH含量以及两种抗氧化酶(超氧化物歧化酶SOD和愈创木酚过氧化物酶GPX)的酶活,研究了重金属镉(Cd)和铜(Cu)对美人蕉(Cannaindica Linn.)的氧化胁迫。结果表明,20μmol·L~(-1)和100μmol·L~(-1)的Cd~(2+)和Cu~(2+)均使其根部MDA含量显著增加,但除了100μmol·L~(-1)的Cd~(2+),叶部MDA含量无明显变化。与Cu~(2+)相比,Cd~(2+)能引起植物根部GSH的明显提高,并能诱导PCs的产生