Photoluminescence spectroscopy and positron annihilation spectroscopy probe of alloying and annealing effects in nonpolar m-plane ZnMgO thin films

Temperature-dependent photoluminescence characteristics of non-polar m-plane ZnO and ZnMgO alloy films grown by metal organic chemical vapor deposition have been studied. The enhancement in emission intensity caused by localized excitons in m-plane ZnMgO alloy films was directly observed and it can be further improved after annealing in nitrogen. The concentration of Zn vacancies in the films was increased by alloying with Mg, which was detected by positron annihilation spectroscopy. This result is very important to directly explain why undoped Zn1-xMgxO thin films can show p-type conduction by controlling Mg content, as discussed by Li [Appl. Phys. Lett. 91, 232115 (2007)].

Deep electron states in n-type Al-doped ZnS1-xTex grown by molecular beam epitaxy

Capacitance-voltage, photoluminescence (PL), and deep level transient spectroscopy techniques were used to investigate deep electron states in n-type Al-doped ZnS1-xTex epilayers grown by molecular beam epitaxy. The integrated intensity of the PL spectra obtained from Al-doped ZnS0.977Te0.023 is lower than that of undoped ZnS0.977Te0.023, indicating that some of the Al atoms form nonradiative deep traps. Deep level transient Fourier spectroscopy (DLTFS) spectra of the Al-doped ZnS1-xTex (x=0, 0.017, 0.04, and 0.046, respectively) epilayers reveal that Al doping leads to the formation of two electron traps 0.21 and 0.39 eV below the conduction band. DLTFS results suggest that in addition to the roles of Te as a component of the alloy as well as isoelectronic centers, Te is also involved in the formation of an electron trap, whose energy level with respect to the conduction band decreases as Te composition increases. Our results show that only a small fraction of Al atoms forms nonradiative deep defects, indicating clearly that Al is indeed a very good donor impurity for ZnS1-xTex epilayers in the range of Te composition being studied in this work. (C) 1997 American Institute of Physics. [S0021-8979(97)08421-1].

Observation of deep electron states in n-type Al-doped ZnS1-xTex grown by molecular beam epitaxy

Deep level transient spectroscopy (DLTS) technique was used to investigate deep electron states in n-type Al-doped ZnS1-xTex epilayers grown by molecular fiction epitaxy (MBE), Deep level transient Fourier spectroscopy (DLTFS) spectra of the Al-doped ZnS1-xTex (x = 0. 0.017, 0.04 and 0.046. respectively) epilayers reveal that At doping leads to the formation of two electron traps at 0.21 and 0.39 eV below the conduction hand. 1)DLTFS results suggest that in addition to the rules of Te as a component of [lie alloy as well as isoelectronic centers, Te is also involved in the formation of all electron trip, whose energy level relative to the conduction hand decreases a, Te composition increases.

~(19)F+~(27)Al耗散反应产物截面测量中的不重复性

在中国原子能科学研究院的HI-13串列静电加速器上完成了114MeV和118．75MeV的19F+27Al 耗散反应产物B,C,N,O,F,Ne,Na和Mg的微分截面测量．条形27Al同位素靶的大小尺寸为 10mm×50mm,平均厚度约67μg／cm2．固定入射束流19F的能量,通过移动靶位,先后轰击了靶上20个不同的位置．实验结果表明,在弹靶系统、入射能量以及探测系统都相同的多次独立的微分截面测量中,截面的涨落不呈现高斯型几率分布．截面测量的这种不重复现象难以用有限计数率的统计性质来解释．

~(19)F+~(27)Al反应产物的角分布、角分散与耗散机制

完成了114MeV19F+27Al深部非弹性碰撞产物的角分布测量.分析了反应产物B,C,N,O,F,Ne,Na,Mg和Al的实验室系角分布,讨论了反应形成的中间双核系统随时间演化过程中角分布所表现出的耗散特点.从实验上提取了反应产物各元素的角分散参数并作了角分散参数的理论拟合,讨论了角分散参数的物理意义以及角分散参数与耗散反应产物的电荷数Z之间的依赖关系.

~(19)F+~(27)Al深部非弹性碰撞产物的角分布

完成了19F+27Al深部非弹性碰撞产物的角分布测量.初步分析了反应产物B,C,N,O,F,Ne,Na,Mg和Al的实验室系角分布,展现出深部非弹性反应机制的特点,显示了反应系统随时间的演化过程.

Hyperfine quenching of the 3s3p P-3(0) level in Mg-like ions

Hyperfine quenching rates of the 3s3p P-3(0) level in Mg-like ions were calculated using the GRASP2K package based on the multi-configuration Dirac-Hartree-Fock method. Valence and core-valence correlation effects were accounted for in a systematic way. Breit interactions and QED effects were included in the subsequent relativistic CI calculations. Calculated rates were compared with other theoretical values and with experiment, and a good agreement with the latest experimental value for the Al-27(+) ion (Rosenband et al 2007 Phys. Rev. Lett. 98 220801) was found. Furthermore, we showed in detail the contributions from Breit interaction and QED effects to concerned physical properties. Finally, electronic data were presented in terms of a general scaling law in Z that, given isotopic nuclear spin and magnetic moment, allows hyperfine-induced decay rates to be estimated for any isotope along the isoelectronic sequence.

Studies on the exotic structure of Al-23

The longitudinal momentum distribution (P-//) of fragments after one-proton removal from Al-23 and reaction cross sections (sigma(R)) for Al-23,Al-24 on carbon target at 74A MeV have been measured simultaneously. An enhancement in sigma(R) is observed for Al-23 compaxed with Al-24. The full width at half maximum of the P-// distribution for Mg-22 fragments has been determined to be 232 +/- 28 MeV/c. Analysis of P-// using the Few-Body Glauber Model indicates a dominant d-wave configuration for the valence proton in the ground state of Al-23. The exotic structure in Al-23 is discussed.

Non-reproducibility of the cross sections of the products induced from dissipative reaction of F-19+Al-27

The differential cross sections of the dissipative products B, Q N, O, F, Ne, Na and Mg induced from the reactions of F-19+Al-27 at two incident energies have been measured at the HI-13 tandem accelerator, Beijing. In the case of a fixed beam incident energy 114MeV or 118.75MeV respectively, identical reaction system and the same detection system, 20 target points in steps of 2mm on(.)a 10mmx50mm rectangular Al foil have been bombarded. The experimental results indicate that the probability distribution of the cross sections is much wider than a standard Gaussian distribution. This non-reproducibility of the cross sections can't be interpreted by the statistical property of a finite count rate.

Relativistic photoionization cross sections for atomic Mg

The photoionization cross sections of the ground level (3s(2) S-1(0)) of atomic Mg have been studied theoretically in the energy region between the Mg+(3s) and Mg+(3p) threshold using the fully relativistic R-matrix method. The positions and widths of resonances have also been obtained and compared with a recent experiment (Wehlitz et al 2007 J. Phys. B 40 2385). Excellent agreement is shown between our theoretical calculations and experimental measurements. In the present calculations, five Rydberg series of doubly excited states have been exhibited, i.e. 3pns P-1, 3pnd P-1, 3pns P-3, 3pnd D-3 and 3pnd P-3, where 3pnd P-3 are confirmed as the fifth series in contrast to the previous theoretical results.

MEASUREMENT OF TWO-PROTON CORRELATION FROM THE BREAK-UP OF Al-23

Experiments of Al-23 and Mg-22 radioactive beams bombarding a C-12 target at an energy of 60 similar to 70 A MeV have been performed at the projectile fragment separator beamline (RIPS) in the RIKEN Ring Cyclotron Facility to study the two-proton emission from Al-23 and Mg-22 excited states, respectively. The trajectorie of the decay products, namely Na-21 + p + p from Al-23 and Ne-20 + p + p from Mg-22, are clean identified. The relative momentum and opening angle between two protons in the rest frame of three body decay channels are obtained by relativistic-kinematics reconstruction. The results demonstrate that there are some di-proton emission components from He-2 cluster for the excited Al-23 and Mg-22.

Investigation on the microstructure and mechanical properties of a cast Mg–6Zn–5Al–4RE alloy

Mg-6Zn-5Al-4RE (RE = Mischmetal, mass%) alloy was prepared by metal mould casting method. The microstructure and mechanical properties of the as-cast and heat-treated alloys were investigated

Effects of rare earth on the structure and properties of Mg–6Zn–5Al–4Gd–1RE (RE = Ce or Y) alloys

The microstructures and mechanical properties of Mg-6Zn-5Al-4Gd-1RE (RE = Ce or Y) alloys were investigated. The addition of Ce or Y obviously refines the grain size for the Mg-6Zn-5Al-4Gd-based alloy, while the Y element has a better refining effect. The Ce and Y show different grain-refining mechanisms: Ce addition mostly promotes the growth of secondary dendrite, while Y addition mainly increases the heterogeneous nucleation sites.

Effects of cerium on the microstructure and mechanical properties of Mg–20Zn–8Al alloy

Mg-20Zn-8Al-xCe(x=0-2 wt.%) alloys were prepared by metal mould casting method, the effects of Ce on the microstructure and mechanical properties of the alloys were investigated. The results showed that the dendrite as well as gram size were refined by the addition of Ce, and the best refinement was obtained in 1.39% Ce containing alloy.

The microstructure and mechanical properties of Mg-3Al-3RE alloys

The Mg-3Al-3RE alloys (RE, the cerium-rich or the yttrium-rich misch metal) were smelted in a resistance furnace under the protective flux from the Mg-RE master alloys and pure magnesium ingots. The microstructure and mechanical properties of samples prepared by steel mould casting method were investigated.