Pt和Ir催化剂在中性电解液中对NH_3电氧化性能

比较了Pt和Ir催化剂在中性NaClO4电解液中对NH3氧化的电催化活性和选择性。发现NH3和NH4OH在Pt和Ir催化剂上的电氧化性能相似,因而可用NH4OH代替NH3进行研究。NH4OH在Pt和Ir催化剂上氧化峰峰电流密度与NH4OH浓度呈很好的线性关系,因而Pt和Ir均能作为控制电位电解型NH3传感器的催化剂。当NH4OH浓度为0.013 mol/L时,NH3在Pt和Ir催化剂上的氧化峰分别位于0.4和0.8 V,NH4OH在Pt催化剂上的氧化峰峰电位负于在Ir催化剂上的,这是Pt催化剂的优点,但NH4OH在Ir催化剂上的氧化峰峰电流密度为Pt催化剂上的2.5倍以上,说明NH4OH在Ir催化剂上的检测灵敏度远高于在Pt催化剂上的。

Preparation and physical properties of enhanced radiation induced crosslinking of ethylene-vinyl alcohol copolymer (EVOH)

Preparation and physical properties of ethylene-vinyl alcohol copolymer (EVOH) crosslinked by enhanced radiation have been studied through various methods. It was found that the most effective agent for irradiation-crosslinking was triallyl isocyanurate (TAIC) among four kinds of polyfunctional monomers. Gel content (65.6%) was formed for EVOH-44 (content of ethylene is 44 mol%) at 200 kGy with 5% TAIC, but for EVOH-32 (content of ethylene is 32 mol%), only 37.4% gel content was formed under the same conditions. This result showed that the more the content of ethylene units comprised in EVOH, the easier the chemical bonds could be formed between different molecular chains. Tensile strength and elastic modulus increased after crosslinking at high test temperature and elongation at break decreased at the same time. Hygroscopicity of EVOH showed noticeable decrease after enhancement radiation-crosslinking.

疏水性二氧化硅气凝胶性能表征

目前S iO2气凝胶是世界上最轻、隔热性最好、孔隙率较高且声传播速率较低的固体材料,由于其特殊的网络结构使其具有很多独特的性能,而制备疏水性气凝胶是解决常压干燥过程中体积收缩和开裂的关键.采用溶胶-凝胶法以三甲基氯硅烷（TMCS）为化学表面修饰剂通过衍生法制备了疏水性二氧化硅气凝胶,并利用X射线衍射光谱、扫描电镜、能量色散谱、透射电镜、红外光谱、差热-热重分析等测试方法对其结构、形貌及化学组成进行了分析.研究表明：该样品是表面连有疏水基团—CH3的疏水性S iO2气凝胶,且组成其连续网络结构的球状纳米粒子纯度较高、粒径均匀,是热稳定性较高的非晶、多孔、轻质纳米材料.

Luminescence and energy transfer properties of Ca2Gd8(SiO4)(6)O-2 : A(A = Pb2+, Tm3+) phosphors

Ca2Gd8(SiO4)(6)O-2: A(A = Ph2+, Tm3+) phosphors were prepared through the sol-gel process. X-ray diffraction (XRD), scanning electron microseopy(SEM) and photoluminescence spectra were used to characterize the resulting phosphors. The results of XRD indicate that the phosphors crystallized completely at 1000 degreesC. SEM study reveals that the average grain size is 300 similar to 1000 nm. In Ca2Gd8(SiO4)(6)O-2: Tm3+ phosphors, the Tm3+ shows its characteristic blue emission at 456 nm (D-1(2)-F-3(4)) upon excitation into its H-3(6)-D-1(2)(361 nm), with an optimum doping concentration of 1 mol% of Gd3+ in the host lattices. In Ca2Gd8(SiO4)(6)O-2: Pb2+, Tm3+ phosphors, excitation into the Ph2+ at 266 nm (S-1(0)-P-3(1)) yields the emissions of Gd3+ at 311 nm (P-6-S-8) and Tm3+ at 367 nm (D-1(2)-H-3(6)) and 456 our (D-1(2)-F-3(4)), indicating that energy transfer processes of Pb2+-Gd3+ and Ph2+-Tm3+ have occur-red in the host lattices.

Separation of scandium, yttrium and lanthanum in high-performance centrifugal partition chromatography with S-octyl phenyloxy acetic acid

Separation of scandium(III), yttrium(III) and lanthanum(III) was performed by high-performance centrifugal partition chromatography (HPCPC) employing the stationary phase of S-octyl phenyloxy acetic acid (CA-12). The liquid-liquid extraction behavior of CA-12 for Sc(III), Y(III) and La(III), the acidity of aqueous phase, and the operation conditions of HPCPC were examined. The retention volume (V-R) increased with the order of Y(III), La(III) and Sc(III) accompanied with the elution of the mobile phase in different pH, which is lowered from 4.6 to 2.1.

Initiation and termination of crazes in high impact polystyrene

Initiation and termination of crazes in high impact polystyrene (HIPS) were studied by transmission electron microscope. Instead of the first initiation of crazes in the vicinity of the equator or rubber particles, ribbon-shaped crazes beyond the region were observed on the TEM photos. The starting point and the end point of each ribbon were noticed not to be randomly located on the surface of the cellar particles in HIPS. The spots connecting to the ligaments between the PS rigid inclusions in the cellar particle are found to be the locations where crazes were initiated and terminated preferentially. In addition, the crazes generated at those spots were much thicker and longer. The thoughness of high impact polystyrene was enhanced by the multiple crazes formed in the matrices, through the reduction of the craze stress at room temperature with increasing the volume fraction of polybutadiene at these spots in the dispersed phase. These results conducted that not only the cell structure of the domains in HIPS was not homogeneous but also the polybutadiene ligaments between PS rigid inclusions in the domains were inhomogeneous. Therefore, the responsibility of those polybutadiene ligaments with different thickness to the stresses was different and it forced the crazing initiation and growing preferentially. The crazes were created in some regions in the matrices; On the contrary, rare crazes were formed in the other regions in spite of these regions surrounded around the same dispersed particles. The relation between the spots on the surface and the inner structure of the cellar particle was discussed in this paper.

The crystallization of poly (3-dodecylthiophene) in an oriented solidification environment

The crystallization behaviors of poly (3-dodecylthiophene) (P3DDT) under two different oriented solidification conditions, i.e.. two different relative relations (90 degrees and 180 degrees) between the directions of gravity and solidification, were investigated. X-ray diffraction results reveal that although similar layered structures are formed, under the condition of the relative relation 180 degrees. temperature gradient has greater effects on the perfect degree of the layered structures of P3DDT. It also can be concluded that after recrystallization, the layered structures of P3DDT can be improved at relative relation 90 degrees, but the orderly degree of the arrangements of alkyl side chains are not improved yet, even is reduced for both of the oriented solidification conditions.

Synthesis, structure characterization and biological activity of a novel amino acid salt (HAla)(8)(H3O)(10)[PMo12O40](6) center dot 22H(2)O

A novel compound was synthesized and characterized by means of elemental analysis, IR and UV spectra, TG, CV and single crystal X-ray diffraction. The compound crystallized in an orthorhombic space group C222 with a=1. 622 4(3) nm, b=3. 498 4(7) nm, c=1. 301 5(3) nm, V=7. 387 (3) nm(3), Z=6, R-1= 0. 037 3, wR(2)=0. 114 0. The Ala (Ala = alanine) molecules were protonated at the amino nitrogen N (1) and the C (2) of Ala group with the terminal oxygen atom O(15), O(14), O(26) and O(27) of the polyoxometalates participating in the hydrogen bond network. The anti-tumor activity of the title compound was estimated against Hela and Pc-3m cancer cells.

Amplification of antigen-antibody interactions based on biotin labeled protein-streptavidin network complex using impedance spectroscopy

Antibody was covalently immobilized by amine coupling method to gold surfaces modified with a self-assembled monolayer of thioctic acid. The electrochemical measurements of cyclic voltammetry and impedance spectroscopy showed that the hexacyanoferrate redox reactions on the gold surface were blocked due to the procedures of self-assembly of thioctic acid and antibody immobilization. The binding of a specific antigen to antibody recognition layer could be detected by measurements of the impedance change. A new amplification strategy was introduced for improving the sensitivity of impedance measurements using biotin labeled protein- streptavidin network complex. This amplification strategy is based on the construction of a molecular complex between streptavidin and biotin labeled protein. This complex can be formed in a cross-linking network of molecules so that the amplification of response signal will be realized due to the big molecular size of complex. The results show that this amplification strategy causes dramatic improvement of the detection sensitivity of hIgG and has good correlation for detection of hIgG in the range of 2-10 mug/ml. (C) 2001 Elsevier Science B.V. All rights reserved.

Energy transfer from Ce3+ to Eu2+ and electron transfer from Ce3+ to Eu3+ in BaY2F8 : Ce, Eu systems

Phorsphors of BaY2F8 : Ce3+, BaY2F8: EU2+ and BaY2F8 : Ce, Eu were prepared by higher temperature solid reaction and their excitation, emission and diffuse reflection spectra were made. We firstly found that the competition of energy transfer from Ce3+ to Eu2+ and electron transfer from Ce3+ to EU3+ existed in CeF3 and EuF3-co-doped BaY2F8 systems. The f-f transition emission of EU2+ was increased with increasing x in systems BaY2F8 : 0. 03Ce, xEU. Ce4+ ions coexist,with Ce3+ ions and substitute Y3+ for Ce4+ in the systems BaY2F8 : Eu, Cc.

BaY_2F_8∶Ce,Eu中Ce~(3+)→Eu~(2+)的能量传递和Ce~(3+)→Eu~(3+)的电子转移

采用高温固相反应法制备了 Ba Y2 F8∶ Ce3 + ,Ba Y2 F8∶ Eu2 + 和 Ba Y2 F8∶ Ce,Eu,测定了它们的激发、发射和漫反射光谱 .首次发现并研究了在 Ba Y2 F8共掺 Ce F3 和 Eu F3 体系中存在 Ce3 + → Eu2 + 的能量传递和Ce3 +→ Eu3 +的电子转移两种过程及其竞争 .根据光谱数据 ,讨论了 Ce4 +的可能取代格位

CIAC-综合结构信息系统

介绍了CIAC-综合结构信息系统， 它由两个部分组成， 即CIAC-13CNMR谱图数据库和结构解析专家系统ESESOC ESESOC可从未知化合物的分子式、光谱数据(IR,MS,1HNMR,2D-NMR等)及其它化学信息自动地推衍出与已知信息相一致的候选化合物结构。

甲烷与二氧化碳重整制取合成气反应的研究ⅢSr(La)NiAl11O19积炭动力学

用热重（ＴＧＡ）方法，研究了ＬａＮｉＡｌ１１Ｏ１９和ＳｒＮｉＡｌ１１Ｏ１９催化剂上甲烷与二氧化碳重整反应的积炭动力学．实验结果表明，甲烷裂解是ＣＨ４＋ＣＯ２反应中主要的积炭反应；甲烷与二氧化碳重整反应的积炭速率随反应温度升高而增大，但其衰减速度也较快；ＣＨ４＋ＣＯ２反应的积炭速率相对甲烷分压的反应级数是１，相对二氧化碳分压的反应级数是－０．５；在ＳｒＮｉＡｌ１１Ｏ１９中掺入Ｌａ３＋离子，提高了催化剂上甲烷裂解反应的活化能，降低了ＣＯ２消炭反应的活化能，从而提高了催化剂的抗积炭能力.