Computational study on the addition of HCN to methanimine catalyzed by formamidine and formamide

In this paper, we have carried out a theoretical study on the addition of HCN to methanimine with formamidine or formamide using second-order Moller-Plesset perturbation (MP2) method with 6-31 + G(d,p) basis sets. At MP2 level. a high-energy, intermediate has been located for each pathway. The addition of HCN to methanimine with formamidine has the lowest free energy barrier according to the calculations at MP2 level. (C) 2004 Elsevier B.V. All rights reserved.

The effects of CO2 addition on the partial oxidation of heptane for hydrogen generation

The effects of CO2 on the partial oxidation of heptane for hydrogen generation have been studied. Based on the experimental results and thermodynamic equilibrium calculations, the validity of CO2 addition to weaken the hot spots, and the feasibility of the autothermal operation are discussed.

Concise synthesis of novel practical sulfamide-amine alcohols for the enantioselective addition of diethylzinc to aldehydes

Novel sulfamide-amine alcohol ligands were designed using a grafting strategy and synthesized from readily available starting materials via a simple, efficient method. The key features of these ligands for the asymmetric addition of diethylzinc to aldehydes included stability, enhanced effectiveness without using Ti((OPr)-Pr-i)(4), suitability for a variety of aldehydes, the ability to operate at room temperature, and selectability to afford either absolute configuration products with enantiomeric excess up to >99%.

Preparation and characterization of monolithic columns for capillary electrochromatography with weak electroosmotic flow

Monolithic columns of capillary electrochromatography (CEC) with weak electroosmotic flow (EOF) have been prepared by in situ polymerization of butyl methacrylate and ethylene dimethacrylate, without any charged groups in the reaction mixture. The reproducibility of such columns has been proved good no matter whether they are prepared in the same batch or in different batches. In the case of BMA-EDMA monoliths, besides the traditional ternary mixture - 1-propanol, 1,4-butanediol, and water, binary porogenic solvents with only alcohols have also been adopted. Compared with ternary porogenic solvents, the design with binary ones allows for fine control of the pore diameter and the formation of the specific surface of the monolithic polymers. The composition of porogenic reagents has also been shown to have an effect on EOF in the column systems. In addition, the Joule heat effect in such columns has been studied by varying the inner diameter of columns. Through the separation of acidic compounds, monolithic columns with low EOF have shown potential in the analysis of charged samples.

Highly enantioselective conjugate addition of diethylzinc to acyclic enones with fine-tunable phosphite-pyridine ligands

A new series of fine-tunable phosphite-pyridine (P,N) ligands derived from (S)-2-amino-T-hydroxy-6,6'-dimethyl-1,1'-biphenyl and (S)-2-amino-2'-hydroxy-4,4',6,6'-tetramethyl-1,1'-biphenyl was employed in Cu(I)-catalyzed conjugate addition of diethylzinc to acyclic enones. Excellent enantioselectivities (up to 98% ee) and highly catalytic activities were achieved for a variety of acyclic enones.

Structural probing of D-fructose derived ligands for asymmetric addition of diethylzinc to aldehydes

A series of new chiral ligands derived from D-fructose have been synthesized and applied in the enantioselective addition of diethylzinc to aldehydes. Comparison of the enantioselectivities obtained with these ligands demonstrated that the catalytic properties are highly dependent upon the structure of ligands, a rational explanation of the structural effects on the catalytic properties is provided. (C) 2003 Elsevier Science Ltd. All rights reserved.

Effect of addition of Zn on the catalytic activity of a Co/HZSM-5 catalyst for the SCR of NOx with CH4

The selective catalytic reduction (SCR) of NOx by methane in the presence of excess oxygen was studied on a Zn-Co/HZSM-5 catalyst. It was found that the addition of Zn could improve effectively the selectivity of methane towards NOx reduction. When prepared by a coimpregnation method, the Zn-Co/HZSM-5 catalyst showed much higher catalytic activity than the two catalysts of a Zn/Co/HZSM-5 and Co/Zn/HZSM-5 prepared by the successive impregnation method. It is considered that there exists a cooperative effect among the Zn, Co and zeolite, which enhances the reduction of NO to NO2 reaction and the activation of methane. (C) 2002 Elsevier Science B.V. All rights reserved.

A systematic approach to standard addition methods in instrumental analysis

Nine cases of standard addition methods in instrumental analysis, including linear instruments, a non-linear response, the electrochemical Nernst equation, and radiochemical techniques.

A strategy for synthesis of ion-bonded amphiphilic miktoarm star copolymers via supramolecular macro-RAFT agent

Amphiphilic supramolecular miktoarm star copolymers linked by ionic bonds with controlled molecular weight and low polydispersity have been successfully synthesized via reversible addition-fragmentation chain transfer (RAFT) polymerization using an ion-bonded macromolecular RAFT agent (macro-RAFT agent). Firstly, a new tetrafunctional initiator, dimethyl 4,6-bis(bromomethyl)-isophthalate, was synthesized and used as an initiator for atom transfer radical polymerization (ATRP) of styrene to form polystyrene (PSt) containing two ester groups at the middle of polymer chain. Then, the ester groups were converted into tertiary amino groups and the ion-bonded supramolecular macro-RAFT agent was obtained through the interaction between the tertiary amino group and 2-dodecylsulfanylthiocarbonylsulfanyl-2-methyl propionic acid (DMP). Finally, ion-bonded amphiphilic miktoarm star copolymer, (PSt)(2)-poly(N-isopropyl-acrylamide)(2), was prepared by RAFT polymerization of N-isopropylacrylamide (NIPAM) in the presence of the supramolecular macro-RAFT agent. The polymerization kinetics was investigated and the molecular weight and the architecture of the resulting star polymers were characterized by means of H-1-NMR, FTIR, and GPC techniques. (c) 2008 Wiley Periodicals, Inc.