Epitaxy-Assisted Creation of PCBM Nanocrystals and Its Application in Constructing Optimized Morphology for Bulk-Heterojunction Polymer Solar Cells

PCBM (a C-60 derivative) is so far the most successful electron acceptor for bulk-heterojunction polymer photovoltaic (PV) cells. Here we present a novel method epitaxy-assisted creation of PCBM nanocrystals and their homogeneous distribution in the matrix using freshly cleaved mica sheet as the substrate. The highly matched epitaxy relationship between the unit cell of PCBM crystal and crystallographic (001) surface of mica induces abundant PCBM nuclei, which subsequently develop into nanoscale crystals with homogeneous dispersion in the composite film.

The effect of annealing treatment on performance of interdiffused organic photovoltaic devices

We fabricated the interdiffused organic photovoltaic devices, which composed of poly (2-methoxy-5-(2'-ethylhexyloxy)-1, 4-phenylenevinylene) (MEH-PPV) and buckminsterfullerene (C-60), by annealing treatment. After annealing, C60 diffused into the MEH-PPV layer, in consequence, MEH-PPV/C-60 interfacial area was increased and their interface became closer proximity. The results lead to reduce reverse-bias saturation current (J(s)), and increase the open-circuit voltage (V-OC) and the short-circuit current (J(SC)).

Organic photovoltaic cell employing organic heterojunction as buffer layer

Hexadecafluorophthalocyaninatocopper (F16CuPc)/zine phthalocyanine (ZnPc) heterojunction layer has been used as buffer layer in organic photovoltaic (OPV) cells based on ZnPc and C-60. The F16CuPc/ZnPc heterojunction with highly conductive property decreased the contact resistance between the indium-tin-oxide anode and the organic layer. As a result, the short-circuit current density and fill factor were increased, and the power-conversion efficiency was improved by over 60%. Therefore, the method provides an effective path to improve the performance of OPV cells.

Organic photovoltaic cells with near infrared absorption spectrum

Organic photovoltaic cells with a strong absorption spectrum in the near infrared region were fabricated with the structure of indium tin oxide (ITO)/zinc phthalocynine (ZnPc)/lead phthalocynine (PbPc)/C-60/Al. PbPc has a broad and strong absorption, while the organic films of PbPc/C-60 showed an additional new absorption peak at 900 nm. The absorption in the near infrared region can harvest more photons to invert into photocurrent. Moreover, the introduction of ZnPc thin layer between ITO and PbPc further improved the new absorption peak and the collection of hole carriers at the electrode ITO, which increased the power conversion efficiencies to 1.95% and short-circuit current density to 9.1 mA/cm(2) under AM 1.5 solar spectrum.

Mass spectrometric studies of metallofullerene

The endrohel metallofullerene, Gd@C-82, Gd@C-80, Gd-2@C-80 were synthesized by using K-H method. The technique of two-step of high pressure and high temperature extraction with 1, 3, 5-trimethylbenzene (first step) and pyridine(second step) has been successfully utilized to extract metallofullerene of Gd@C-82 The gas-phase negative ions of fullerenes C-n(n= 60, 70, 78, 82, 84...) and metallofullerene (Gd@C-82) have been studied by the ESI-MS, REC-MS and MALDI-TOF-MS. The differences among the mass spectra of ESI-MS, REC-MS and MALDI-TOF-MS have been observed and explained. In contrast to the empty fullerene C-82 , the metallofullerene Gd@C-82 should have a larger HOMO-LUMO gap. Experimental results suggest that Gd@C-82 is polarized and Gd3+ located in the off-center position of C-82 cage after Gd3+ is trapped into C-82 cage.

A simple method for the selective enrichment of endohedral metallofullerenes

The concentration of a polar solvent DMF extract was found to be very effective for the selective enrichment of endohedral metallofullerenes against empty fullerenes. As the solvent evaporated, endohedral metallofullerenes were effectively enriched in the solution, while most of empty fullerenes (especially C-60 and C-70) were precipitated because of their scant solubility in DMF. Matrix-assisted laser-desorption-ionization time-of-fligh mass spectrometry analysis indicated that the purity of endohedral metallofullerenes increased dramatically after concentration of the DMF extract solution. Upon transferring the extract into toluene, a solution containing significantly enriched endohedral metallofullerenes was obtained. The different solubilities of endohedral metallofullerenes versus empty fullerenes are considered to account for this selective enrichment of endohedral metallofullerenes.

Intensity exaggeration of endohedral metallofullerenes in laser-desorption-ionization time-of-flight mass spectrometry

The laser-desorption-ionization time-of-flight mass spectrometry and desorption-electron-ionization mass spectrometry were employed for the characterization of metallofullerenes extract. it was found that the relative intensities of metallofullerenes in this positive-ion, negative-ion LD-TOF MS and DEI MS were much different. This phenomenon should have relationship with the peculiar ionization energies and electron affinities of metallofullerenes.

Study on mixed Langmuir-Blodgett film of tri-(2,4-di-t-amylphenoxy)-(8-quinolinolyl)copper phthalocyanine and water-soluble fullerenols

Mixed Langmuir-Blodgett films of tri-(2,4-di-t-amylphenoxy)-(8-quinolinolyl) copper phthalocyanine and water-soluble fullerenols are prepared. Their behavior at the air-water interface and the monolayer morphology are studied. (C) 1998 Elsevier Science Limited. All rights reserved.

Gas phase derivations of endohedral metallofullerenes by ion-molecular reactions

Gas phase ion-molecular reactions of endohedral metallofullerenes with the self-chemical ionization ion system of vinyl acetate, benzene and acetone in the ion source of the mass spectrometer have been studied. Several derivatized endohedral metallofullerene cations [M@C-82-C2H3O](+), [M-2@C-80-C2H3O](+), [M@C-82-C6H6](+) and [M@C-82-CO-CH3](+) are observed as the major products. The experimental results indicate that endohedral metallofullerenes have active gas phase reactivities and can be efficiently derivatized by some small organic cations.

Unusual polymerization behavior of water-soluble fullerenols in laser desorption ionization time-of-flight mass spectrometry

Laser desorption ionization time-of-flight mass spectrometry has been used to study the water-soluble multi-hydroxyl C-60 derivatives - fullerenols. The mass spectra exhibit unusual polymerization behavior of fullerenols. (C) 1997 by John Wiley & Sons, Ltd.

Two-step-method extraction of endohedral metallofullerenes

A new and efficient extraction method of endohedral metallofullerenes, especially of rare-earth elements encapsulated metallofullerenes, has been reported in this paper. Soxhlet-extraction of raw soot with toluene was used in the first step to wash away most accompanying C-60, C-70. Then pyridine was chosen as solvent to obtain high-temperature and high pressure extract. Two kinds of extract were analysed by DEI-MS and LDI-MS, the results indicate that this two-step method can provide the extract which has the highest fraction of endohedral metallofullerenes. So it will greatly simplify the following separation and purification processes of metallofullerenes.

Synthesis and characterization of acetacetic derivatives of flullerene

Acetacetic derivatives of fullerene were obtained by the reaction of C-60 with acetacetic ester, after separation with silica gel column chromatography, in good yields. Fullerenols with 13-15 hydroxyl groups were-isolated as the by-products of this reaction. Detailed experimental conditions and the structural characterizations of these new compounds were discussed.

A new method for the preparation of fullerol

Reaction of C-60 with excessive potassium in toluene at refluxing temperature results in black precipitate KaC60 with high conversion, which can completely be hydrolyzed to prepare the fullerol. Investigations including FT-IR. H-1 NMR C-13 NMR, UV-Vis and FABMS of the product were reported.

Synthesis and extraction of lanthanofullerenes and its DEIMS, ESR characterizations

The synthesis for lanthanofullerenes was studied by activating the La2O3 containing graphite rod in situ and back-burning the carbide-rich cathode deposite, La@C-2n are efficiently extracted in high temperature toluene, among them, La@C-74 as a new species is added into the soluble lanthanofullerenes, The toluene extraction is first characterized by desorption electron impact (DEI) mass spectrometry, The ESR spectrum of the extraction at room temperature is also discussed.