聚丙烯酸钠对黄土坡面产流产沙的影响研究

通过野外模拟降雨试验,研究了施用SP对黄土坡面产流、产沙的影响,并对实验数据进行数学模拟,建立了SP施用量与产流、产沙强度间的关系模型。结果表明:SP施用量与产流时间、平均产流强度呈二次函数相关关系,与产沙强度呈线性负相关关系。SP用量在0~2.42 g/m2之间时,能够延缓坡面产流,用量为1.21 g/m2时延缓产流效果最明显;用量介于0~3.31 g/m2之间时,能够增加土壤入渗,减少坡面产流量,用量1.65 g/m2的增渗减流效果最佳;施用SP后,能够减少坡面输沙强度,且用量越大,减沙效果越明显。SP可影响坡面产流过程,用量1.8 g/m2时,能够减小产流初期径流强度增幅,用量为3.6 g/m2时,其产流过程线与对照极接近,而施用量增加到5.4 g/m2时,产流强度明显增大。SP对坡面产沙过程的影响表现为:随施用量增大,产沙强度峰值呈逐步减小的变化趋势。

全球气候变暖对西沙、南沙海域珊瑚生长的潜在威胁

利用近50年来西沙、南沙海域SST及全球温度资料，分析西沙、南沙海域SST的

高响应度GaN肖特基势垒紫外探测器的性能与分析

制作了反向饱和电流为5.5×10~(-14) A/cm~2,势垒高度为1.18eV的GaN肖特基势垒紫外探测器.测量了探测器分别在零偏压及反向偏压下的光谱响应度,响应度随反向偏压无显著变化,零偏压下峰值响应度在波长358.2nm处达到了0.214A/W.利用波长359nm光束横向扫描探测器的光敏面,测量了探测器在不同偏压下的空间响应均匀性,相应偏压下的光响应在光敏面中央范围内响应幅值变化不超过0.6%.光子能量在禁带边沿附近的光束照射下,GaN肖特基势垒紫外探测器存在势垒高度显著降低现象,这种现象在肖特基透明电极边沿及其压焊电极附近表现得更为突出.探测器在368和810nm波长光一起照射时的开路电压比只有368nm光照射时的开路电压大,而零偏压下两者的光电流近似相等.利用这种开路电压变化效应估算了探测器在368nm光照射下,表面被俘获空穴的面密度变化量约为8.4×10~(10) cm~(-2).

The content calculation of hexagonal phase inclusions in cubic GaN films on GaAs(001) substrates grown by metalorganic chemical vapor deposition

Cubic GaN(c-GaN) films are grown on GaAs(001) substrates by metalorganic chemical vapor deposition (MOCVD). Two GaN samples were grown with different buffer layer, the deposition time of each was 1 and 3 min, respectively. 4-circle X-ray double crystal diffraction (XRDCD) was used to study the secondary crystallographic phases presented in the c-GaN films. The phase composition of the epilayers was determined by X-ray reciprocal space mapping. The intensities of the c-GaN(002) and h-GaN(10 (1) over bar 1) planes detected in the mapping were investigated by omega scans. The content of the hexagonal phase inclusions in the c-GaN films was calculated to about 1.6 and 7.9%, respectively. The thicker buffer layer is not preferable for growing high quality pure c-GaN films. (C) 2000 Elsevier Science S.A. All rights reserved.

Epitaxial growth of GaNAs/GaAs heterostructure materials

A series of systematic experiments on the growth of high quality GaNAs strained layers on GaAs (001) substrate have been carried out by using DC active Nz plasma, assisted molecular beam epitaxy. The samples of GaNAs between 3 and 200 nm thick were evaluated by double crystal X-ray diffraction (XRD) and photoluminescence (PL) measurements. PL and XRD measurements for these samples are in good agreement. Some material growth and structure parameters affecting the properties of GaNAs/GaAs heterostructure were studied; they were: (1) growth temperature of GaNAs epilayer; (2) electrical current of active N-2 plasma; (3) Nz flow rate; (4) GaNAs growth rate; (5) the thickness of GaNAs strained layer. XRD and PL measurements showed that superlattice with distinct satellite peaks up to two orders and quantum well structure with intensity at 22 meV Fourier transform infrared spectroscopy (FWHM) can be achieved in molecular beam epitaxy (MBE) system. (C) 2000 Published by Elsevier Science S.A. All rights reserved.

Influences of initial buffer layer deposition on electrical and optical properties in cubic GaN grown on GaAs(100) by metalorganic chemical vapor deposition

We present some results on the effect of initial buffer layer on the crystalline quality of Cubic GaN epitaxial layers grown on GaAs(100) substrates by metalorganic chemical vapor deposition. Photoluminescence and Hall measurements were performed to characterize the electrical and optical properties of cubic GaN. The crystalline quality subsequently grown high-temperature (HT) cubic GaN layers strongly depended on thermal effects during the temperature ramping process after low temperature (LT) growth of the buffer layers. Atomic force microscope (AFM) and reflection high-energy electron diffraction (RHEED) were employed to investigate this temperature ramping process. Furthermore, the role of thermal treatment during the temperature ramping process was identified. Using the optimum buffer layer, the full width at half maxim (FWHM) at room temperature photoluminescence 5.6 nm was achieved. To our knowledge, this is the best FWHM value for cubic GaN to date. The background carrier concentration was as low as 3 x 10(13) cm(-3). (C) 2000 Published by Elsevier Science S.A. All rights reserved.

Raman study on residual strains in thin 3C-SiC epitaxial layers grown on Si(001)

Raman scattering measurement has been used to study the residual strains in the thin 3C-SiC/Si(001) epilayers with a variation of film thickness from 0.1 to 1.2 mu m. which were prepared by chemical vapor deposition (CVD)growth. Two methods have been exploited to figure our the residual strains and the exact LO bands. The final analyzing results show that residual strains exist in the 3C-SiC epilayers. The average stress is 1.3010 GPa, and the relative change of the lattice constant is 1.36 parts per thousand. Our measurements also show that 3C-SiC phonons are detectable even for the samples with film thickness in the range of 0.1 to 0.2 mu m. (C) 2000 Published by Elsevier Science S.A. All rights reserved.