Impact of carbon dioxide pressurization on liquid phase organic reactions: A case study on Heck and Diels-Alder reactions

Heck coupling reactions of methyl acrylate with various aryl bromides have been investigated using a Pd/TPP catalyst in toluene under pressurized CO2 conditions up to 13 MPa. Although CO2 is not a reactant, the pressurization of the reaction liquid phase with CO2 has positive and negative impacts on the rate of Heck coupling depending on the structures of the substrates examined. In the case of either 2-bromoacetophenone or 2-bromocinnamate, the conversion has a maximum at a CO2 pressure of about 3 MPa; for the former, it is much larger by a factor of 3 compared with that under ambient pressure. For 2-bromobenzene, in contrast, the conversion is minimized at a similar CO2 pressure, being half compared with that at ambient pressure

Impact of Carbon Dioxide Pressurization on Liquid Phase Organic Reactions: A Case Study on Heck and Diels–Alder Reactions

Heck coupling reactions of methyl acrylate with various aryl bromides have been investigated using a Pd/TPP catalyst in toluene under pressurized CO2 conditions up to 13 MPa. Although CO2 is not a reactant, the pressurization of the reaction liquid phase with CO2 has positive and negative impacts on the rate of Heck coupling depending on the structures of the substrates examined. In the case of either 2-bromoacetophenone or 2-bromocinnamate, the conversion has a maximum at a CO2 pressure of about 3 MPa;

Direct synthesis of ordered N-methylimidazolium functionalized mesoporous silica as highly efficient anion exchanger of Cr(VI)

Ordered N-methylimidazolium functionalized mesoporous silica (SBA-15) anion exchangers were directly synthesized by co-condensation of tetraethoxysilane with 1-methyl-3(triethoxysilylpropyl)imidazolium chloride. The prepared samples with rod-like morphology showed high surface areas (> 400 m(2) g(-1)), well-ordered pores (> 58 angstrom), and excellent thermal stability up to 387 degrees C. The adsorption behaviors of Cr(VI) from aqueous solution on the anion exchangers were studied using the batch method. The anion exchangers had high adsorption capacity ranging from 50.8 to 90.5 mg g(-1), over a wider pH range (1-8) than amino functionalized mesoporous silica. The adsorption rate was fast, and the maximum adsorption was obtained at pH 4.6. The adsorption data for the anion exchangers were consistent with the Langmuir isotherm equation. Most active sites of the anion exchangers were easily accessible. The mixed solution of 0.1 mol L-1 NH3 center dot H2O and 0.5 mol L-1 NH4Cl was effective desorption solution, and 95% of Cr(VI) could be desorbed.

Analysis of chemical calorific effect during reactive extrusion processes for free radical polymerization

In the reactive extrusion process for polymerization, the chemical calorific effect has a great influence on the temperature. In order to quantitatively analyze the polymerization trend and optimize the processing conditions, the phenomena of the chemical calorific effect during reactive extrusion processes for free radical polymerization were analyzed. Numerical computation expressions of the heat of chemical reaction and the reactive calorific intensity were deduced, and then a numerical simulation of the reactive extrusion process for the polymerization of n-butyl methacrylate was carried out. The evolutions of the heat of chemical reaction and the reactive calorific intensity along the! axial direction of the extruder are presented, on the basis of which reactive processing conditions can be optimized.

LIFETIMES OF RYDBERG LEVELS IN THE PERTURBED 6SNP 3P2 SERIES OF YTTERBIUM-I

Using three-step laser excitation in an atomic beam and a time-resolved spectroscopy technique, we measured both the lifetimes of the Rydberg levels of Yb I belonging to the perturbed series 6nsp 3P2 and the lifetimes of the perturbing 4f(13)5d(2)6s 3P2, 1D2 levels. An expected shortening has been observed for the lifetimes of those levels which are strongly mixed with the perturbers.

新型双碳桥联二环戊二烯基稀土氯化物的合成与表征

桥联双环戊二烯基稀土化合物的合成已有不少报道。但双碳桥联双环戊二烯基稀土化合物至今未见任何报道。我们以(CH_3)_4C_2(C_5H_4MgCl)_2·4THF(Ⅰ)与无水三氯化稀土反应,通过控制两者的比例合成了两类双碳桥联二环戊二烯基稀土氯化物,(CH_3)_4C_2(C_5H_4)_2LnCl_2·Mg_2Cl_3·nTHF(Ⅱ)和(CH_3)_4C_2(C_5H_4LnCl_2·MgCl_2)_2·nTHF(Ⅲ),并对这两类化合物进行了表征,证实了这两类化合物的存在。

Chaetopyranin, a benzaldehyde derivative, and other related metabolites from Chaetomium globosum, an endophytic fungus derived from the marine red alga Polysiphonia urceolata

Cultivation of the endophytic fungus Chaetomium globosum, which was isolated from the inner tissue of the marine red alga Polysiphonia urceolata, resulted in the isolation of chaetopyranin (1), a new benzaldehyde secondary metabolite. Ten known compounds were also isolated, including two benzaldehyde congeners, 2-(2 ',3-epoxy-1 ',3 '-heptadienyl)-6-hydroxy- 5-(3-methyl-2-butenyl) benzaldehyde (2) and isotetrahydroauroglaucin (3), two anthraquinone derivatives, erythroglaucin (4) and parietin (5), five asperentin derivatives including asperentin ( 6, also known as cladosporin), 5 '-hydroxy-asperentin-8-methylether (7), asperentin-8-methyl ether (8), 4 '-hydroxyasperentin (9), and 5 '-hydroxyasperentin (10), and the prenylated diketopiperazine congener neoechinulin A (11). The structures of these compounds were determined on the basis of their spectroscopic data analysis (H-1, C-13, H-1-H-1 COSY, HMQC, and HMBC NMR, as well as low- and high-resolution mass experiments). To our knowledge, compound 1 represents the first example of a 2H-benzopyran derivative of marine algal-derived fungi as well as of the fungal genus Chaetomium. Each isolate was tested for its DPPH (1,1-diphenyl-2-picrylhydrazyl) radical-scavenging property. Compounds 1-4 were found to have moderate activity. Chaetopyranin (1) also exhibited moderate to weak cytotoxic activity toward several tumor cell lines.

Substrate induction and statistical optimization for the production of chitosanase from Microbacterium sp OU01

The chitosanase production was markedly enhanced by substrate induction, statistical optimization of medium composition and culture conditions by Microbacteritan sp. OU01 in shake-flask. A significant influence of (NH4)(2)SO4, MgSO4 center dot 7H(2)O and initial pH on chitosanase production was noted with Plackett-Burman design. It was then revealed with the method of steepest ascent and response surface methodology (RSM) that 19.0 g/L (NH4)(2)SO4, 1.3 g/L MgSO4 and an initial pH of 2.0 were optimum for the production of chitosanase; colloidal chitosan appeared to be the best inducer for chitosanase production by Microbacterium sp. OU01. This optimization strategy led to the enhancement of chitosanase from 3.6 U/mL to 118 U/mL. (c) 2006 Elsevier Ltd. All rights reserved.

SIZE STRUCTURES OF MICROPLANKTON BIOMASS AND PRODUCTION IN JIAOZHOU BAY, CHINA

Seasonal investigations of size-fractionated biomass and production were carried out from February 1992 to May 1993 in Jiaozhou Bay, China. Microplankton assemblages were separated into three fractions: pico-(0.7-2 mu m), nano- (2-20 mu m) and netplankton (20-200 mu m). The biomass was measured as chlorophyll a (Chl a), particulate organic carbon (POC) and particulate organic nitrogen (PON). The production was determined by C-14 and N-15 tracer techniques. The seasonal patterns in biomass, though variable, were characterized by higher values in spring and lower values in autumn and summer (for Chl a only). The seasonal patterns in production, on the other hand, were more clear with higher values occurring in summer and spring, and lower values occurring in autumn and winter. Averaged over the whole study period, the respective proportions of total biomass accounted for by net-, nano- and picoplankton were 26, 45 and 29% for Chl a, 32, 33 and 35% for POC, and 26, 32 and 42% for PON. The contributions to total primary production by net-, nano- and picoplankton were 31, 35 and 34%, respectively. The respective proportions of total NH4+-N uptake accounted for by net-, nano- and picoplankton were 28, 33 and 39% in the daytime, and 10, 29 and 61% at night. The respective contributions to total NO3--N uptake by net-, nano- and picoplankton were 37, 40 and 23% in the daytime, and 13, 23 and 64% at night. Some comprehensive ratios, including C/N biomass ratio, Chl a/C ratio, C uptake/Chl a ratio, C:N uptake ratio and the f-ratio, were also calculated size separately, and their biological and ecological meanings are discussed.

藏药蕨麻油脂化合物的GC-MS分析

蕨麻,藏医谓之卓老沙曾,原植物为蔷薇科委陵菜属鹅绒委陵菜Potentilla anserine L.,为多年生草本.在高海拔地区蕨麻根的中下部形成块根,在温暖低平地区不形成膨大的块根[1].蕨麻全草入药,收敛止血,止咳利痰,治各种出血及下痢.块根入药,有健脾益胃、生津止渴、益气补血功效;治脾虚、腹泻、产后贫血、营养不良等症[2].

CIMS环境下单元的柔性计划生产方法

本文研究了ＣＩＭＳ环境下的生产计划问题．考虑了两种市场需求驱动生产方式，一种是在计划周期内各阶段市场需求由预先订货决定，另一种是市场需求不是由预先订货决定，而是一个随机变量．但可根据统计，确认它服从某种分布规律，对于这两种生产方式，本文可给出最优的生产计划。

智能控制系统的信息集成与建模

本文从智能化角度，以信息与控制的分层递阶结构作为信息集成与建模基础，用概率模型描述和控制智能机器人系统或智能控制系统的各种功能，用熵作为处理多种信息（活动）不确定性的测度，探究信息集成和概率建模的通用模式，用实际应用的几个事例简要说明文中方法的有效性。