1.5μm n 型调制掺杂量子阱材料和相关器件研究

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

Si0.75Ge0.25/Si/Si0.5Ge0.5 超晶格平面内光学各向异性及电光效应

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

5.5μm 应变补偿量子级联激光器研究

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

2.5维光子晶体面发射激光器

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-06-04T08:36:34Z No. of bitstreams: 1 dspace.cfg: 33388 bytes, checksum: ac9630d3fdb36a155287a049e8b34eb7 (MD5)

砷化镓基1.5微米量子阱结构及其外延生长方法

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-06-04T08:36:34Z No. of bitstreams: 1 dspace.cfg: 33388 bytes, checksum: ac9630d3fdb36a155287a049e8b34eb7 (MD5)

High temperature operation of 5.5 mu m strain-compensated quantum cascaded lasers

We develop 5.5-mu m InxGa1-xAs/InyAl1-yAs strain-compensated quantum cascade lasers with InP and InGaAs cladding layers by using solid-source molecular-beam epitaxy. Pulse operation has been achieved up to 323 K (50 degrees C) for uncoated 20-mu m-wide and 2-mm-long devices. These devices display an output power of 36 mW with a duty cycle of 1% at room temperature. In continuous wave operation a record peak optical power of 10 mW per facet has been measured at 83 K.

In_(0.5)Ga_(0.50As/In_(0.5)Al_(0.5)As应变耦合量子点的形貌和光学性质

提出了利用分子束外延方法生长In_(0.5)Ga_(0.5)As/In_(0.5)Al_(0.5)As应变耦合量子点,并分析量子点的形貌和光学性质随GaAs隔离层厚度变化的特点.实验结果表明,随着耦合量子点中的GaAs隔离层厚度从2 nm增加到10 nm,In_(0.5)Ga_(0.5)As量子点的密度增大、均匀性提高,Al原子扩散和浸润层对量子点PL谱的影响被消除,而且InAlAs材料的宽禁带特征使其成为InGaAs量子点红外探测器中的暗电流阻挡层.由此可见,选择合适的GaAs隔离层厚度形成InGaAs/InAlAs应变耦合量子点将有益于InGaAs量子点红外探测器的研究.

Hzsm-5和Y沸石中Se链的吸收和喇曼光谱

用扩散的方法,在HZSM-5和Y沸石中制备了具有不同Se组分的Se链样品,并对样品进行了吸收和喇曼光谱测试.结果表明:制备的样品均为非晶Se链结构,随制备条件的不同,非晶Se链的混乱度有所不同.

1.5 mu m DFB integrated with vertical tapered spotsize converter fabricated by selective MOVPE

1.5 mu m DFB LD butt-joint integrated with vertical tapered spotsize converter was fabricated by LP-MOVPE. The vertical far field angle (FWHM) was decreased from 34degrees to 10degrees the threshold currents was as low as 19.8mA, the output power was 9.6mw at 100mA without HR coating and the SMSR was 35.8dB. The 1-dBm misalignment tolerance was 3.2 mu m, while the counterpart of the device without SSC was 2.2 mu m.

35MeV/u~(36)Ar+~(124)Sn反应中类弹产物的同位素分布特性

测量了 35MeV u36Ar +12 4 Sn反应中 5 .3°处类弹产物的同位素分布 ,观察到随着出射动能的增加 ,产物的平均中质比逐渐减小而接近弹核的平均中质比 .同位旋相关的量子分子动力学计算表明 ,随着反应时间的增加 ,类弹产物的平均出射动能逐渐减小而平均N Z值则逐渐增大 .另外 ,碰撞参数也影响类弹产物的同位素组成 :随着碰撞参数的减小 ,类弹产物的平均N Z值减小 .

35MeV/u~(36,40)Ar+~(112,124)Sn反应中同位旋自由度的弛豫

35MeV/u 36 ,40　Ar+ 112 ,12 4Sn反应中 ,在前角 5°和 2 0°观测到丰中子核与稳定核的产额比随粒子出射动能的增加而减小 ,而缺中子核与稳定核的产额比随动能的增加而增加 .对于某种元素 ,随着动能的减小 ,其平均中质比逐渐由弹核N/Z向靶核N/Z过渡 .这些现象表明在这样的入射能量下 ,周边或近周边碰撞过程中同位旋自由度没有完全达到平衡 .这种行为对两个靶核系统是相似的 ,但是同位素产额比的绝对值在 5°没有靶核相关性 ,而在 2 0°处却表现出明显的靶核相关性 .

36-segmented high magnetic field hexapole magnets for electron cyclotron resonance ion source

Two high magnetic field hexapoles for electron cyclotron resonance ion source (ECRIS) have successfully fabricated to provide sufficient radial magnetic confinement to the ECR plasma. The highest magnetic field at the inner pole tip of one of the magnets exceeds 1.5 T, with the inner diameter (i.d.)=74 mm. The other hexapole magnet provides more than 1.35 T magnetic field at the inner pole tip, and the i.d. is 84 mm. In this article, we discuss the necessity to have a good radial magnetic field confinement and the importance of a Halbach hexapole to a high performance ECRIS. The way to design a high magnetic field Halbach structure hexapole and one possible solution to the self-demagnetization problem are both discussed. Based on the above discussions, two high magnetic field hexapoles have been fabricated to be utilized on two high performance ECRISs in Lanzhou. The preliminary results obtained from the two ECR ion sources are given

Experimental study of the U-238(S-36,3-5n)(269-271)Hs reaction leading to the observation of (270)Hs

The deformed doubly magic nucleus (270)Hs has so far only been observed as the four-neutron (4n) evaporation residue of the reaction Mg-26+Cm-248, where a maximum cross section of 3 pb was measured. Theoretical studies on the formation of (270)Hs in the 4n evaporation channel of fusion reactions with different entrance channel asymmetry in the framework of a two-parameter Smoluchowski equation predict that the reactions Ca-48+Ra-226 and S-36+U-238 result in higher cross sections due to lower reaction Q values, in contrast to simple arguments based on the reaction asymmetry, which predict opposite trends. Calculations using HIVAP predict cross sections for the reaction S-36+U-238 that are similar to those of the Mg-26+Cm-248 reaction. Here, we report on the first measurement of evaporation residues formed in the complete nuclear fusion reaction S-36+U-238 and the observation of (270)Hs, which is produced in the 4n evaporation channel, with a measured cross section of 0.8(-0.7)(+2.6) pb at 51-MeV excitation energy. The one-event cross-section limits (68% confidence level) for the 3n, 4n, and 5n evaporation channels at 39-MeV excitation energy are 2.9 pb, while the cross-section limits of the 3n and 5n channel at 51 MeV are 1.5 pb. This is significantly lower than the 5n cross section of the Mg-26+Cm-248 reaction at similar excitation energy.

PROJECTILE FRAGMENTATION OF Ar-36,Ar-40 INDUCED REACTIONS

Fragment yields for Z >= 5 from projectile fragmentation using primary beams of Ar-36,Ar-40 at 50 MeV/nucleon on Ni-64 target have been measured in RIBLL fragment separator. We compare the fragment cross sections with the predictions of the empirical EPAX parametrization of fragmentation cross-sections and Statistical Abration-Ablation model (SAA) by considering the RIBLL separator transmission rate. Isotope yield ratios between these two reactions were calculated and isoscaling parameters alpha and beta are extracted, their dependences on fragment atomic number Z and neutron number N were presented.

30,35MeV/u 36,40Ar＋112,124Sn反应中热核性质同位旋效应的实验研究

针对①中能反应中同位旋自由度是否达到平衡，②同位旋自由度对几中不同方法测量的核温度是否有影响 这两个基本问题，设计了用30和35MeV/u ~(36,40)Ar轰击~(112,124)Sn反应的实验方案。得到如下结果：对于前角5°处的耗散弹核碎裂产物，丰中子同位素与稳定核的产额比随产物出射动能的增加而减小，而丰质子子同位素与稳定核的产额比随动能的增加而增加，呈现明显的剪刀差分布特性。随耗散时间的增大，产物的平均中质比逐渐由弹核的平均中质比向系统的平均中质比过渡。这个结果说明在该反应中，同位旋自由度没有达到完全平衡。而对于20°处的DIC产物，上述剪刀差分布特性变得更不明显，这是同位旋自由度由非平衡向平衡过渡的表现。后角轻粒子的能谱分析表明，初始热核的同位旋会影响斜率核温度的提取，由于丰中子轻粒子~6He在~(40)Ar + ~(112)Sn系统中的蒸发被抑制，相比~(40)Ar + ~(112)Sn而言，其蒸发比较容易发生在衰变链早期，因此提取的温度偏高，同样，丰质子轻粒子~3He的温度在~(40)Ar + ~(112)Sn中略高。但中后角的同位素产额分析表明，反应系统的同位旋对双同位素比核温度几乎没有影响。核温度作为热核的热力学量，是独立于测量方法的，这种不同的方法得出的差异主要来源于同位旋对衰变机制的影响。作为一个尝试，将中高能反应中的熵的提取推广到这个能区，发现两个系统的熵几乎一致。在量子统计模型框架下，考察核温度与熵的关系发现，~(40)Ar + ~(112)Sn反应的挤出时刻密度略高于~(40)Ar + ~(112)Sn。