ELECTROCHEMICAL FORMATION OF NI-Y INTERMETALLIC COMPOUND LAYER IN MOLTEN CHLORIDE

The reduction of Y(III) ions in molten chloride is known to be a one-step three electron reaction [1, 2, 3], but a voltammogram of YCl3 in molten LiCl-KCl-NaCl at a nickel electrode shows at least two reduction peaks of Y(III) ions, indicating the possibility of formation of Ni-Y intermetallic compounds. Using a galvanostatic electrolysis method, samples were prepared at several current densities at 450, 500, 600 and 700-degrees-C, respectively, and were identified with X-ray diffraction (XRD) and electron probe microanalysis (EPMA) methods. The results show that Ni2Y, Ni2Y3 and NiY can be produced by electrolysis and Ni2Y is found to be the predominant Ni-Y intermetallic compound under the experimental conditions. Nickel appears to diffuse in Ni2Y faster than yttrium, and the diffusion process is the rate determining step during Ni2Y formation.

FLOW-INJECTION ANALYSIS OF GLUCOSE AT AN AMPEROMETRIC GLUCOSE SENSOR-BASED ON ELECTROCHEMICAL CODEPOSITION OF PALLADIUM AND GLUCOSE-OXIDASE ON A GLASSY-CARBON ELECTRODE

A glassy carbon electrode (GCE) modified with palladium provides excellent electrocatalytic oxidation of hydrogen peroxide. When the electrolyte contains palladium chloride and glucose oxidase, the GCE can be modified by electrochemical codeposition at a given potential. The resulting modified surface was coated with a thin film of Nation to form a glucose sensor. Such a glucose sensor was successfully used in the flow-injection analysis of glucose with high stability and anti-poisoning ability. It gave a detection limit of 1 X 10(-7) M injected glucose, with a linear concentration range of 0.001-8 mM. There is no obvious interference from substances such as ascorbate and saccharides.

AN INFRARED SPECTROSCOPIC CHARACTERIZATION OF THE SOLID SOLID BEHAVIOR OF DODECYLAMMONIUM CHLORIDE

The infrared spectra of the bilayer system dodecylammonium chloride has been studied as a function of temperature. Unusual splitting of some vibrational modes helps us to characterize the structure of different solid states. This study provided the evidence for the occurrence of an order-disorder phase transition whose onset occurs at 327 K and its completion ends at 339 K. In the low temperature phase below 327 K, the virgin crystals form a well-ordered phase with all-transhydrocarbon chains. In the intermediate state between 327 and 339 K, the data demonstrate the introduction of intramolecular as well as intermolecular disorder. The coexistence of solid and liquid-crystal-like states is shown by the persistence of factor group splittings together with the existence of defect bands in the wide intermediate temperature range. In the high temperature phase over 339 K the crystals convert to a liquid-crystal-like system with extensive motional and conformational disorder, but still show characteristics in their infrared spectra which indicate the presence of ordered segments in the hexagonal solid phase.

THE COMPATIBILITY AND CRYSTALLIZATION OF THE MIXTURES OF POLY (TETRAHYDROFURAN-b-METHYL METHACRYLATE) DIBLOCK COPOLYMER WITH POLYVINYL CHLORIDE HOMOPOLYMER

The compatibility and crystallization behaviour of the mixtures of poly (tetrahydrofuran-methyl methacrylate) diblock copolymer (PTHF-b-PMMA) with polyvinyl chloride has been studied. We found that the compatibility of these blends, in which there is special interaction between the homopolymer and the PMMA block of the copolymer, is much better than that of the AB/A type blends; and that the crystallization rate and crystallinity of PTHF microdomain changed greatly due to the swollen by PVC homopolymer. In this paper, these changes in cryatallization are well explained according to the theories of block copolymer blends and the density gradient model presented by JIANG Ming.

SYNTHESES AND X-RAY STRUCTURES OF BIS(T-BUTYLCYCLOPENTADIENYL)LANTHANIDE CHLORIDE COMPLEXES [(BU(T)CP)2LNCL]2 (LN = PR, GD, ER)

Reaction of lanthanide trichlorides with two equivalents of sodium t-butylcyclopentadienide in THF gave rise to the bis(t-butylcyclopentadienyl)lanthanide chloride complexes [(Bu(t)Cp)2LnCl]2 (Ln = Pr, Gd, Er), which were characterized by elemental analysis, IR and H-1 NMR spectroscopy. In addition, the crystal structures of [(ButCp)2PrCl]2 (1) and [(ButCp)2GdCl]2 (2) were determined by single crystal X-ray diffraction at room temperature. The coordination number for Pr3+ and Gd3+ is 8 and the bond lengths Pr-Cl and Gd-Cl are 2.864(2) and 2.771(3) angstrom, respectively. The structural studies showed the complexes to have C2h symmetry.

ELECTROCHEMICAL AND INSITU SPECTROELECTROCHEMICAL STUDY OF (TETRAPHENYLPORPHINATO)MANGANESE (III) PERCHLORATE IN THE PRESENCE OF CHLORIDE ANIONS .1. REDUCTION PROCESSES

The mechanism of electrochemical redox reactions of (tetra-phenylporphinato) managanese(III) perchlorate, (TPP)Mn(III)ClO4, was studied In the presence of chloride anions in dichloroethane solution. It was demonstrated that Mn(II) or Mn (III) centre can be coordinated with only one chloride anion, this result makes an about 100 mV negative shift of half-wave potential of Mn (III)/Mn (II) reduction. An equilibrium constant of 2.2 x 10(4) was determined for the complexation reaction of Cl- and Mn(III) centre.

A NEW HYDROGEN SENSOR WITH RARE-EARTH COMPLEX FLUORIDE

A new type of solid-state galvanic cell for detecting a small amount of hydrogen in air at room temperature is proposed. The sensor cell is a potentiometric cell using Ce0.95Ca0.05F2.95 as solid-state electrolyte. The cell exhibits good sensing properties to hydrogen in air at room temperature.

STUDY ON LOW-FREQUENCY RAMAN SPECTRA OF n-DECYLAMMONIUM CHLORIDE

The low-frequency Raman spectrum of n-decylammonium chloride was measured as a function of temperature in the temperature range from 290 to 340K, and the longitudinal acoustical mode vibration band was assigned. The results showed that there are two phase transitions at 313K and 321K, respectively. The phase transition at 313K is mainly induced by change of hydrocarbon chain conformations, while that at 321K is mainly induced by change of order degree of molecular packing. The results suggest low-frequency Raman spectroscopy is a useful probe of structural phase transition for long-chain compounds.

A NOVEL METAL THIAMINE COMPLEX WITH A CYCLIC DIMER FORMED BY METAL-BRIDGED 2 THIAMINE LIGANDS - CRYSTAL-STRUCTURE OF [MN(THIAMINE)CL2(H2O)]2[THIAMINE]2CL4.2H2O

The crystal structure of [Mn(thiamine)Cl2(H2O)]2[thiamine]2Cl4.2H2O has been determined by X-ray diffraction methods. The compound contains a cyclic dimer of a complex cation with two thiamine ligands bridged by two Mn(II) ions across a crystallographic center of symmetry. Each Mn(II) is coordinated by two chloride atoms, a water molecule, a N(1') atom of the pyrimidine from a thiamine and an O(53) atom of the hydroxyethyl side chain from another thiamine. There are two free-base thiamine molecules related by a center of symmetry in the unit cell, which form a base-pair through the hydrogen bonds. Both the independent thiamine molecules in the asymmetric unit assume the common F conformation with phi-T = 10.0(9) and 3.6(10) and phi-P = 85.6(7) and 79.6(7), respectively. The compound provides a possible model for a metal-bridged enzyme-coenzyme complex in thiamine catalysis. Crystallographic data: triclinic, space group P1BAR, a = 12.441(4), b = 13.572(4), c = 11.267(3) angstrom, alpha = 103.15(2), beta 89.03(3), gamma = 115.64(2)-degrees, Z = 1, D(calc) = 1.524 g cm-3, and R = 0.050 for 3019 observed reflections with I > 3-sigma(I).

STUDY ON DEPOSITION POTENTIALS OF LITHIUM AND SODIUM-IONS AND DEPOLARIZATION IN BINARY CHLORIDE

Deposition potentials of Lithium and Sodium ions have been measured in binary chloride systems (LiCl-KCl, NaCl-KCl) by I-V curve method, to provide a theoretical base for preparing high purity Al-Li alloy by electrolysis in molten salt. The changes of free energy and enthalpy were calculated in terms of depolarization values on Al cathode. Thermodynamic meaning of depolarization was discussed in details and the empirical relation between binary alloy type and depolarization type was proposed. It is shown for the first time that the presence of a third element in Al-Li alloy can strengthen depolarization of Li ion at Al alloy cathode and give foundation for preparing high purity Al-Li-M ternary alloy. The effect of LiCl concentration on deposition potentials of Li ion at Al cathode in KCl-LiCl melt was studied and average active coefficient of LiCl was obtained.

SYNTHESES OF BIS(TERT-BUTYLCYCLOPENTADIENYL)LANTHANOID CHLORIDE COMPLEXES AND CRYSTAL-STRUCTURES OF BIS(TERT-BUTYLCYCLOPENTADIENYL)CHLORO(BISTETRAHYDROFURAN)-PRASEODYMIUM AND BIS(TERT-BUTYLCYCLOPENTADIENYL)-CHLOROTETRAHYDROFURANYTTERBIUM

Reaction of lanthanoid trichloride with two equivalents of sodium t-butylcyclopentadienide in tetrahydrofuran affords bis(t-butylcyclopentadienyl)lanthanoid chloride complexes (t-BuCp)2LnCl. nTHF (Ln = Pr, Nd, n = 2; Ln = Gd, Yb, n = 1). The compound (t-BuCp)2PrCl.2THF (1) crystallizes from THF in monoclinic space group P2(1)/c with unit cell dimensions a = 15.080(3), b = 8.855(2), c = 21.196(5) angstrom, beta = 110.34(2)degrees, V = 2653.9 angstrom-3 and D(calcd) = 1.41 g/cm3 for Z = 4. The central metal Pr is coordinated to two t-BuCp ring centroids, one chlorine atom and two THF forming a distorted trigonal bipyramid. The crystal of (t-BuCp)2YbCl.THF (2) belongs to the monoclinic crystal system, space group P2(1)/n with a = 7.726(1), b = 12.554(2), c = 23.200(6) angstrom, beta = 97.77(2)degrees, V = 2229.56 angstrom-3, D(calcd) = 1.50 g/cm3 and Z = 4. The t-BuCp ring centroids, the chlorine atom and the oxygen atom of the THF describe a distorted tetrahedron around the central ion of ytterbium.

AN ELECTROCHEMICAL MICROSENSOR FOR CHLORIDE

The potential-response of a microdisk electrode made with a chloride-doped polypyrrole (PPY) film on a carbon fibre (CF) has been examined. The effect of the polymerization conditions on the response characteristics is discussed. The optimum conditions for preparing the electrode are: cycling potential from +0.8 to +1.0 V in 0.1-0.2M pyrrole (Py) containing 0.1M LiCl, electropolymerization time 15-20 min. The electrode gives a Nernstian response of 56-58 mV/pCl and a detection limit of 3.6 x 10(-5)M chloride. It has the advantages of low resistance, short conditioning time and fast response. It has been used satisfactorily for detection of chloride in serum.