高精度GPS,三维激光扫描和测针板三种测量技术监测沟蚀过程的对比研究

采用连续模拟降雨试验,对坡沟系统概化模型进行坡面沟蚀发育过程模拟,再现坡面片蚀—细沟侵蚀—切沟侵蚀演变过程。结合3种测量技术从测量精度、测量人员要求、数据处理、数据通用性、配套软件使用、前期投入、测量条件等几个方面入手,对比分析高精度GPS(Trimble 5700)、三维激光扫描仪(Leica HDS 3000)和测针板的3种测量方法的优缺点,同时对3种测量方法在沟蚀过程监测和侵蚀量估算方面进行对比研究。结果表明,激光扫描仪能很好地监测沟蚀演变过程,且对侵蚀量估算精度较高,误差仅为4.5%。高精度GPS也能很好地监测沟蚀演变过程,对侵蚀量估算精度误差为7.38%。测针板法不能很好的反映沟蚀演变过程,但是对于侵蚀量的估算可以满足日常要求,误差为-12.78%。

Conformal irradiation to moving targets in heavy ion radiotherapy with raster-scanning beam delivery system: (II) feasibility experiments

Within the framework of the pilot heavy-ion therapy facility at GSI equipped with an active beam delivery system of advanced raster scanning technique, a feasibility study on actively conformal heavy-ion irradiation to moving tumors has been experimentally conducted. Laterally, real-time corrections to the beam scanning parameters by the raster scanner, leading to an active beam tracing, compensate for the lateral motion of a target volume. Longitudinally, a mechanically driven wedge energy degrader (called depth scanner) is applied to adjust the beam energy so as to locate the high-dose Bragg peak of heavy ion beam to the slice under treatment for the moving target volume. It has been experimentally shown that compensations for lateral target motion by the raster scanner and longitudinal target shift by the depth scanner are feasible.

A TOF-PET prototype with position sensitive PMT readout

A prototype of time-of-flight positron emission computed tomography (TOF-PET) has been developed for acquiring the coincident detection of 511 keV gamma-rays produced from positron annihilation. It consists of two 80.5 mmx80.5 mm LYSO scintillator arrays (composed of 35 x35 pixel finger crystals) with the position sensitive photomultiplier tubes R2487 as the readout. Each array is composed of 2 mm x2 mm x 15 mm finger crystals and the average pixel pitch is 2.30 mm. The measured results indicate that the TOF information has the potential to significantly enhance the image quality by improving the noise variance in the image reconstruction. The best spatial resolution (FWHM) of the prototype for the pairs of 511 keV gamma-rays is 1.98 mm and 2.16 mm in the x and y directions, respectively, which are smaller than the average pixel pitch of 2.30 mm.

ECR离子源发射度探测器的研制

成功研制一套适合于ECR离子源引出束流发射度测量的探测器ESS（Electric-SweeP Scanner）。该探测器主要由测量探头、机械驱动装置、计算机控制及数据获取系统组成。ESS探测器所采用的测量方法是双狭缝加电扫描法，具有速度快、精度高，能够比较直观的反映束流的发射度相图、相空间密度分布等特点，是目前ECR离子源引出束流发射度测量的有效手段。本论文对发射度探测器ESS的原理、结构及物理和技术设计作了较详细的描述，并给出了相应的设计图纸及数值模拟结果。最后，利用Ess探测器对LECR3（Lanzhou No.3）离子源引出的04＋离子束的发射度作了初步测量。当04＋引出束流为343μA日寸，初步测量所得水平方向的发射度为227mm·mrad（约90％束流），并给出了相应的束流发射度相图和束流相空间密度分布。

激光微地貌扫描仪的开发研制及在坡面侵蚀研究应用初步

利用光线的反射与聚焦成象原理 ,将地表高程转换成不同物象点位置的电信号 ,再经计算机处理成数字高程模型 ,即形成用于获取地表糙度数字高程模型的激光微地貌扫描仪。实验测量得到 :在相同初始条件下 ,不同坡度土槽放水和降雨实验后地表形态的数字地形模型。通过对侵蚀地表形态的分析 ,得出坡度对坡面侵蚀及沟蚀影响的某些初步规律。

Experimental measurement of polyethylene chain modulus by scanning force microscopy

Nanoindentation technique and scanning force microscopy have been used to measure directly the polyethylene modulus along the chain axis. Single crystals of polyethylene were employed in order to obtain well-aligned chain segments. To minimize effects of scanner creep, a Z scan rate of 3 Hz was employed. The "X Rotate" value of 25 degrees was selected to eliminate effects of lateral tip motion. The results were analyzed by the Oliver -Pharr method for which direct observation and measurement of the contact area are not required. Considering the influence of tip roundness on the projected contact area, the nanoindentation results were analyzed by the Sawa method. The chain modulus obtained from the thinner polyethylene single crystal sample was 204 +/- 21 GPa by the Oliver-Pharr method and 168 +/- 17 GPa by the Sawa method. The lower values than expected were due to substrate effects and anisotropy of chain deformation during nanoindentation. An extrapolation of the chain modulus obtained by various strains to zero nanoindentation eliminated the effect of substrate and anisotropy of chain deformation. The corresponding chain modulus obtained from the thicker sample was 278 GPa by the Oliver-Pharr method and 267 GPa by the Sawa method, respectively, in better agreement with the value of 340 Cpa determined theoretically. (C) 2001 Elsevier Science Ltd. All rights reserved.

档案自动录入及管理系统的研究

将用特定的表格形式填写的档案信息用扫描仪扫入计算机中,通过模式识别技术进行识别处理,形成文本文件,并转换成数据库文件。用VB程序设计语言编写灵活高效的档案管理系统,从而实现档案信息高效、快速、准确地录入计算机中,消除了工作中由于人的主观因素造成的错误。

一种使用GPS、罗盘和激光测距仪测定南极冰川运动的方法

南极冰川运动,是研究南极冰雪物质平衡、环境变化等的重要因素,对其的监测具有重大意义。本文提出了一种配合使用GPS、罗盘和激光测距仪实现测定冰川运动的方法。该方法在完成标定和在冰川上放置标志杆后,无需靠近冰川,只根据远处工作站的GPS、罗盘读数和激光测距仪的测量值就能给出标志杆的GPS数值,从而监测冰川的运动。

原子力显微镜管式扫描器运动学建模与误差分析

针对样本扫描模式原子力显微镜,对其管式扫描器-样本-探针系统进行了运动学分析,建立了该系统的运动学模型,该模型表明:对于给定原子力显微镜扫描器,样本上与探针接触点的横向和纵向位移取决于探针尖端相对于扫描管轴心的偏置量、所加电压(或名义扫描范围)及样本厚度。据此模型,对由于弯曲运动模式所产生的两种重要误差—交叉耦合误差及扫描范围误差进行了定量分析,分析表明:扫描范围误差主要受样本厚度及名义扫描范围影响,而Z向交叉耦合误差主要受探针偏置量及名义扫描范围影响,实验验证了所建立的运动学模型和误差计算公式的正确性;另外,还提出了相应的减小误差的方法。

一种高智能化的通用自动胶片判读仪

自动通用胶片判读仪是一种高智能化的精密光学测试设备,采用了计算机控制飞点扫描技术、精密光学测量技术、图象跟踪测量与信息处理技术。飞点管分辨率达4096×4096象元,通过光学系统胶片上获得6.55μm高分辨率,飞点扫描方式灵活多样且可随意控制,通用于目前我国靶场所有的电影经纬仪和高速摄影机35mm胶片的数据判读。具有自动判读和半自动判读两种工作模式,自动判读的速度为5帧/秒,自动判读的精度为σ=±0.011mm,半自动判读的精度为σ=±0.009mm,测量数据可以记录、打印和显示。