Effects of 2,3,7,8-TCDD and benzo[a]pyrene on modulating vitellogenin expression in primary culture of crucian carp (Carassius auratus) hepatocytes

Vitellogenin (Vtg) is the precursor of yolk protein. Its expression and secretion are estrogen-regulated and are crucial for oocyte maturation. An in vitro xenoestrogen screening model was established by measuring Vtg induction in cultured primary hepatocytes from crucian carp. Vtg production was detected by biotin-avidin sandwich ELISA method while Vtg and cytochrome P4501A1 (CYP1A1) mRNA induction were measured by semi- quantitative PCR-primer dropping technique. Vtg and Vtg mRNA were dose-dependently induced by diethylstilbestrol (DES, 0.2-200 ng/mL) in hepatocytes of crucian carp. Co-treatment of the DES-induced hepatocytes with either 2,3,7,8-TCDD (TCDD, 0.1-4 pg/mL) or benzo[a]pyrene (B[a]P, 5-1000 ng/mL) resulted in a reduction of Vtg production and an increment of CYP1A1 mRNA expression both in a dose dependent manner, indicating the anti-estrogenic effects of the compounds. However, at lower tested concentrations, TCDD (0.1, 0.2 pg/mL), B[a]P (5 ng/mL) seemed to have a potentiating effect on Vtg expression and secretion, although by their own these compounds had no observable estrogenic effect on Vtg induction. Tamoxifen (a selective estrogen receptor modulators, 1 nmol/L-1 mumol/L), and P-naphtho-flavone (beta-NF, an aryl hydrocarbon receptor inducing compounds, 2.5-1000 ng/mL) also were employed to study the possible interactions in DES-induced Vtg expression. In co-treatment of the DES-induced hepatocytes with beta-NF or tamoxifen, the decrease in Vtg production did parallel induction of CYP1A1 for beta-NF, but tamoxifen inhibited Vtg induction did not parallel induced CYP1A1 expression in all test concentrations. On the contrary, it was found that in co-treatment of the TCDD-induced hepatocytes with DES, TCDD induced CYP1A1 mRNA production was inhibited by DES also. These results implicated a possible cross talk between estrogen receptor- and aryl hydrocarbon receptor-mediated pathways in the hepatocytes.

Optimization of GaInNAs(Sb)/GaAs quantum wells at 1.3-1.55 mu m grown by molecular beam epitaxy

The InGaNAs(Sb)/(GaNAs)/GaAs quantum wells (QWs) emitting at 1.3-1.55 mu m have been grown by molecular beam epitaxy (MBE). The parameters of the radio frequency (RF) such as RF power and flow rate are optimized to reduce the damages from the ions or energetic species. The growth temperature is carefully controlled to prevent the phase segregation and strain relaxation. The effects of Sb on the wavelength and quality are investigated. The GaNAs barrier is used to extend the wavelength and reduce the strain. A 1.5865 mu m InGaNAs(Sb)/GaNAs SQW edge emitting laser lasing at room temperature at continuous wave operation mode is demonstrated. (c) 2006 Elsevier B.V. All rights reserved.

Application of rapid thermal annealing on 1.3-1.55 mu m GaInNAs(Sb) lasers grown by molecular beam epitaxy

Rapid thermal annealing (RTA) has been demonstrated as an effective way to improve the crystal quality of GaInNAs(Sb) quantum wells (QWs). However, few investigations have been made into its application in laser growth and fabrication. We have fabricated 1.3 mu m GaInNAs lasers, both as -grown and with post-growth RTA. Enhanced photoluminescence (PL) intensity and decreased threshold current are obtained with RTA, but the characteristic temperature T-o and slope efficiency deteriorate. Furthermore, T-o has an abnormal dependence on the cavity length. We attribute these problems to the deterioration of the wafer's surface. RTA with deposition Of SiO2 was performed to avoid this deterioration, T-o was improved over the samples that underwent RTA without SiO2. Post-growth and in situ annealing were also investigated in a 1.55 mu m GaInNAsSb system. Finally, continuous operation at room temperature of a GaAs-based dilute nitride laser with a wavelength over 1.55 mu m was realized by introducing an in situ annealing process. (c) 2007 Elsevier B.V. All rights reserved.

Metamorphic InGaAs quantum wells for light emission at 1.3-1.6 mu m

Metamorphic InGaAs quantum well structures grown on GaAs reveal strong light emission at 1.3-1.6 mu m, smooth surface with an average roughness below 2 nm. and good rectifying I-V characteristics. Dark line defects are found in the QW Post growth thermal annealing further improves the luminescence efficiency but does not remove those dark line defects. Some challenges of epitaxial growth using this method for laser applications are discussed. (c) 2006 Elsevier B.V. All rights reserved.

Analytical method of predicating the instabilities of a micro arch-shaped beam under electrostatic loading

An arch-shaped beam with different configurations under electrostatic loading experiences either the direct pull-in instability or the snap-through first and then the pull-in instability. When the pull-in instability occurs, the system collides with the electrode and adheres to it, which usually causes the system failure. When the snap-through instability occurs, the system experiences a discontinuous displacement to flip over without colliding with the electrode. The snap-through instability is an ideal actuation mechanism because of the following reasons: (1) after snap-through the system regains the stability and capability of withstanding further loading; (2) the system flips back when the loading is reduced, i.e. the system can be used repetitively; and (3) when approaching snap-through instability the system effective stiffness reduces toward zero, which leads to a fast flipping-over response. To differentiate these two types of instability responses for an arch-shaped beam is vital for the actuator design. For an arch-shaped beam under electrostatic loading, the nonlinear terms of the mid-plane stretching and the electrostatic loading make the analytical solution extremely difficult if not impossible and the related numerical solution is rather complex. Using the one mode expansion approximation and the truncation of the higher-order terms of the Taylor series, we present an analytical solution here. However, the one mode approximation and the truncation error of the Taylor series can cause serious error in the solution. Therefore, an error-compensating mechanism is also proposed. The analytical results are compared with both the experimental data and the numerical multi-mode analysis. The analytical method presented here offers a simple yet efficient solution approach by retaining good accuracy to analyze the instability of an arch-shaped beam under electrostatic loading.

Doubly excited 2s2p P-1,3(1) resonances in photoionization of helium

The multi-configuration Dirac Fock (MCDF) method is implemented to study doubly excited 2s2p P-1,3(1) resonances of the helium atom and the interference between photoionization and photo excitation autoionization processes. In order to reproduce the total photoionization sprectra, the excited energies from the ground 1s(2) S-1(0) state to the doubly excited 2s2p P-1,3(1) states and the relevant Auger decay rates and widths are calculated in detail. Further more, the interference profile determined by the so-called Fano parameters q and rho(2) is also reproduced. Good agreement is found between the present results and other available theoretical and experimental results. This indeed shows a promising way to investigate the Fano resonances in photoionization of atoms within the MCDF scheme, although there are some discrepancies in the present calculations of the 2s2p P-3(1) state.

One-Dimensional Ce3+- and/or Tb3+-Doped X-1-Y2SiO5 Nanofibers and Microbelts: Electrospinning Preparation and Luminescent Properties

One-dimensional X-1-Y2SiO5:Ce3+ and -Tb3+ nanofibers and quasi-one-dimensional X-1-Y2SiO5:Ce3+ and -Tb3+ microbelts have been prepared by a simple and cost-effective electrospinning process. X-ray powder diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy (SEM), energy-dispersive X-ray spectrometry, transmission electron microscopy, high-resolution transmission electron microscopy, photoluminescence (PL), and cathodoluminescence spectra were used to characterize the samples. SEM results indicate that the as-prepared fibers and belts are smooth and uniform with a length of several tens to hundreds of micrometers, whose diameters decrease after being annealed at 1000 degrees C for 3 h. Under ultraviolet excitation and low-voltage electron beam excitation, the doped rare earth ions show their characteristic emission, that is, Ce3+ 5d-4f and Tb3+ D-5(4)-F-7(J) (J = 6, 5 4, 3) transitions, respectively.

Application of Ru(bpy)(3)(2+) in control and formation of gold surface nanostructure through oxidation-reduction cycling

It was studied that the nanostructure formed on a gold surface via a simple oxidation-reduction cycles (ORC) in 0.1 M KCl containing Ru(bpy)(3)(2+) with different concentrations. Atomic force microscopy (AFM) and energy-dispersed spectroscopy (EDS) were used to characterize the nanostructure formed on the gold surface. Sweep-step voltammetry and corresponding electroluminescence (ECL) response, in situ electrochemical quartz crystal microbalance (EQCM) measurement were used to monitor the ORC. procedure. It was found that the surface structure became more uniform in the presence of Ru(bpy)(3)(2+), and the surface roughness was decreasing with the increasing of Ru(bpY)(3)(2+) concentration, suggesting a simple and effective method to control the formation of nanostructure on the gold surface.

Lanthanide metal complexes for the hydrolysis of ribonucleoside 3',5'-cyclic phosphate and deoxyribonucleoside 3',5'-cyclic phosphate

Ytterbium(III) and praseodymium(III) complexes of 2-carboxyethylgermanium sesquioxide (Ge-132) can hydrolyze the phosphodiester linkage of 3',5'-cyclic adenosine monophosphate (cAMP) and 3',5'-cyclic deoxyadenosine monophosphate (dcAMP). Both cAMP and dcAMP are hydrolyzed with high selectivity, yielding predominantly 3'-monophosphates. The selectivity and activity for hydrolyzing cAMP and dcAMP by lanthanide metal(III) complexes and lanthanide metal ions are compared.

Efficient cleavage of ribonucleoside 3',5'-cyclic phosphates and deoxyribonucleoside 3',5'-cyclic phosphate by lanthanides

The cleavage of 3',5'-cAMP, 3',5'-cGMP and 3',5'-dcAMP by lanthanides has been investigated by HPLC and H-1 NMR. Rapid cleavage of cAMP, cGMP and dcAMP by Ce(III) under air at pH 8 and 37 degrees C has been observed. Regioselective cleavage of P-O(5') bond in cAMP, cGMP and dc;aMP tu give the corresponding 3'-AMP, 3'-GMP and 3'-dAMP by lanthanide chlorides has been achieved, and 3'-AMP and 3'-GMP are cleaved to adenosine(A) and guanosine(CT) more slowly, respectively, The notable difference in reactivity between Ce(III) and the other lanthanide ions under air has also been studied. The cleavage is enhanced with the increase in the molar fraction of Ce(IV). The fast cleavage of cAMP by Ce(III) under air at pH 8 is ascribed to the resultant Ce(IV) in the reaction mixture.

LIFETIMES OF RYDBERG LEVELS IN THE PERTURBED 6SNP P-1,3(1) SERIES OF YBI

Using two methods: (1) three-step excitation and (2) single UV photon excitation in an atomic beam with direct observation of the decay of the fluorescence light, we have measured the lifetimes of the Rydberg levels of YbI belonging to the perturbed series 6snp J = 1 levels. The measured values have been interpreted by the multichannel quantum defect theory (MQDT).

STUDIES OF ELECTROCHEMICAL CATALYTIC REDUCTION REACTIONS OF TETRAPHENYLPORPHINATOCOBALT 1,2-DIBROMOETHANE AND 1,2-DICHLOROETHANE SYSTEMS IN NONAQUEOUS MEDIA

Electrochemical catalytic reactions of tetraphenylporphinatocobalt were studied in DMF and EtCl2 solutions in the presence of 1,2-dibromoethane and 1, 2-dichloroethane utilizing cyclic voltammetry, thin-layer electrochemistry, in situ UV-visible spectroel