氮磷营养对小麦水分关系的影响

比较研究了氮磷营养对春小麦水分关系影响的差异。结果表明 ,土壤干旱情况下 ,氮磷营养虽然皆增强了春小麦的渗透调节能力 ,但由于氮磷营养对作物地上地下部生长的不同进促作用而对作物的水分状况产生了完全相反的影响。氮营养增强了作物对干旱的敏感性 ,使其水势和相对含水量大幅度下降 ,蒸腾失水减少 ,自由水含量增加而束缚水含量减少 ,并使膜稳定性降低 ;而磷营养则明显改善了植株的水分状况 ,增大了气孔导度 ,降低了其对干旱的敏感性 ,增加了束缚水含量 ,并使膜稳定性增强

抗氧化剂对渗透胁迫下沙棘叶片膜脂过氧化的保护作用

以沙棘叶片为材料 ,研究了外源抗氧化物质 Vc、VE、β-胡萝卜素等对 PEG渗透胁迫下细胞膜的保护作用。结果表明 :加入外源 Vc、β-胡萝卜素能有效保护膜系统 ,使膜透性和丙二醛在胁迫条件下增加小于对照 ,尤其在胁迫前期作用明显 ,而对叶绿素的保护作用在后期表现更突出 ,使叶绿素含量维持在较高水平 ;外源 VE 对防止膜透性增加作用不大 ,对减低丙二醛含量与保护叶绿素方面有所贡献。同时也证明沙棘叶片内 Vc在渗透胁迫下含量下降 ,而 Pro含量显著升高。证明这些物质是构成沙棘抗旱性的重要基础。

Assembly of the subcellular parts of Bryopsis hypnoides Lamouroux into new protoplasts

The chloroplasts, mitochondria, and protoplasm devoid of mature chloroplasts (PMC) of Bryopsis hypnoides Lamouroux were isolated by low-speed and sucrose density centrifugation. The PMC aggregated in artificial seawater, and then protoplasts without mature chloroplasts (PtMCs) were formed. Transmission electron microscopy and cytochemical studies indicated that there were mitochondria, nuclei, vesicles, and other small cell organelles in the PtMCs. Scanning electron microscopy showed that there were holes on the surface of 1-h PtMCs and then fewer holes on the surface of 24-h PtMCs, suggesting that a healing process occurred. The plasma membrane was formed over the surface of the PtMCs. However, the cell wall was not regenerated, and the newly formed PtMCs were ruptured and died in 3 days. Light intensity during alga maintenance before use influenced significantly (one-way ANOVA, P < 0.0001) on the number of PtMCs formed; the highest number of PtMCs was formed at 20A mu mol/(m(2) s). When isolated chloroplasts were transferred into seawater, there were only two or three chloroplasts aggregated together. However, isolated mitochondria and the mixed six layers of cell organelles (separated by sucrose density centrifugation) could not aggregate in the artificial seawater. This indicates that the conjunction of cell organelles is important for their aggregation.

Cryopreservation of flounder (Paralichthys olivaceus) sperm with a practical methodology

A simple and convenient protocol for the cryopreservation of the flounder (Paralichthys olivaceus) sperm was established for "on the spot" cryopreservation of large quantities of semen. The use of three cryoprotectants, dimethyl sulphoxide (DMSO), glycerol (Gly) and methanol was tested in the method. The percentage of motile sperm present in semen after it had been frozen and thawed in the presence of DMSO, Gly or methanol was 60.5 +/- 3.6, 79.17 +/- 4.5 and 13.25 +/- 4.7%, respectively. The fertilization rates of this sperm were 67.06 +/- 15.1, 76.20 +/- 10.0 and 44.93 +/- 22.6%, while the hatching rates of eggs fertilized with this sperm were 37.40 +/- 8.3, 48.18 +/- 25.7 and 23.35 +/- 10.8%, respectively. It was found that Gly and DMSO were better cryoprotectants than methanol, with Gly giving the best overall results. Under scanning electron microscopy, it could be seen that while the majority of the frozen-thawed sperm remained morphologically normal, some exhibited lost or dilated mitochondria, swollen mid-pieces, broken tails, or damaged cell membrane, which probably caused the decrease in motility and fertility of the frozen-thawed sperm. (C) 2003 Elsevier Science Inc. All rights reserved.

Reviews on The Immunological Function of Tetraspanins

Tetraspanins belongs to the transmembrane 4 superfamily(TM4SF). They can be as a bridge to connect the proteins outside or inside the cell membrane. A tetraspanins web is formed by the tetraspnins-proteins complex, and the web is believed to involve in fundamental functions of immunity system, and consequnently, signaling between cells and inside cells, regulating cell activation and adhesion, participating in the identification and infection of some virus. As a family of conservative transmembrane proteins, tetraspanins play multiplex roles in invertebrate. It was described how tetraspanin microdomains might have functions in the immune system, and how they contact with virus. In addition, the important role of tetraspanins in the innate immune system of invertebrate were discussed.

Composite electrode for unitized regenerative proton exchange membrane fuel cell with improved cycle life

To improve the cycle life of unitized regenerative fuel cells (URFCs), an electrode with a composite structure has been developed. The cycle life and polarization curves for both fuel cell and electrolysis modes of URFC operation were investigated. The cycle life of URFCs was improved considerably and the performance was fairly constant during 25 cycles, which illustrates that the composite electrode is effective in sustaining the cyclic performance of URFCs. It shows the URFCs with such an electrode structure are promising for practical applications. (C) 2004 The Electrochemical Society.

Blends based on sulfonated poly[bis(benzimidazobenzisoquinolinones)] and poly(vinylidene fluoride) for polymer electrolyte membrane fuel cell

A new blend system consisting of an amorphous sulfonated poly[bis(benzimidazobenzisoquinolinones)] (SPBIBI) and the semi-crystalline poly(vinylidene fluoride) (PVDF) was prepared for proton exchange membranes. The miscibility behavior of a series of blends of SPBIBI with PVDF at various weight ratios was studied by WXRD, DSC and FTIR. The properties of the blend membranes were investigated, and it was found that the introduction of PVDF in the SPBIBI matrix altered the morphological structure of the blend membranes, which led to the formation of improved connectivity channels. For instance, the conductivity of the blend membrane containing 10 wt% PVDF displayed the highest proton conductivity (i.e., 0.086 S cm(-1)) at room temperature, a value almost twofold that of the pristine SPBIBI membranes (i.e., 0.054S cm(-1)) under identical conditions.

Effect of properties of active carbon supports on performance of Pt/C catalysts in polymer electrolyte membrane fuel cell

The Pt/C catalysts were prepared with pine active carbon and Vulcan XC-72 active carbon as the supports. The performances of the Pt/C catalysts in polymer electrolyte membrane fuel cell were compared. The result indicates that the performance of Pt/Vulcan XC-72 is better than that of Pt/pine. The physical and chemical properties of the two active carbons were measured using several analysis techniques. It was found that the pore size, specific conductivity and the surface function group significantly influence the performance of the electrocatalyst.

Improvement of direct methanol fuel cell performance by modifying catalyst coated membrane structure

A five-layer catalyst coated membrane (CCM) based upon Nation 115 membrane for direct methanol fuel cell (DMFC) was designed and fabricated by introducing a modified Nafion layer between the membrane and the catalyst layer. The properties of the CCM were determined by SEM, cyclic voltammetry, impedance spectroscopy, ruinous test and I-V curves. The characterizations show that the modified Nation layers provide increased interface contact area and enhanced interaction between the membrane and the catalyst layer. As a result, higher Pt utilization, lower contact resistance and superior durability of membrane electrode assembly was achieved. A 75% Pt utilization efficiency was obtained by using the novel CCM structure, whereas the conventional structure gave 60% efficiency. All these features greatly contribute to the increase in DMFC performance. The DMFC with new CCM structure presented a maximum power density of 260 MW cm(-2), but the DMFC with conventional structure gave only 200 mW cm(-2) under the same operation condition. (c) 2005 Elsevier B.V. All rights reserved.

Effects of Surface Microtopology and Membrane Stiffness on Kinetics of Selectin/Ligand interactions by a Modified BFP

More and more evidences come out to support that the functionality of adhesion molecules are influenced by the surface microtopology of cell carrier or substrate. Adhesive molecules usually express on the microvilli of a cell, providing a well-defined spatial configuration to mediate the adhesions to the counterpart molecules on the apposed surface.

Nonlinear Mechanical Modeling Of Cell Adhesion

Cell adhesion, which is mediated by the receptor-ligand bonds, plays an essential role in various biological processes. Previous studies often described the force-extension relationship of receptor-ligand bond with linear assumption. However, the force-extension relationship of the bond is intrinsically nonlinear, which should have significant influence on the mechanical behavior of cell adhesion. In this work, a nonlinear mechanical model for cell adhesion is developed, and the adhesive strength was studied at various bond distributions. We find that the nonlinear mechanical behavior of the receptor-ligand bonds is crucial to the adhesive strength and stability. This nonlinear behavior allows more bonds to achieve large bond force simultaneously, and therefore the adhesive strength becomes less sensitive to the change of bond density at the outmost periphery of the adhesive area. In this way, the strength and stability of cell adhesion are soundly enhanced. The nonlinear model describes the cell detachment behavior better than the linear model. (C) 2007 Elsevier Ltd. All rights reserved.

Developing A Microfluidic-Based System To Quantify Cell Capture Efficiency

Micro-fabrication technology has substantial potential for identifying molecular markers expressed on the surfaces of tissue cells and viruses. It has been found in several conceptual prototypes that cells with such markers are able to be captured by their antibodies immobilized on microchannel substrates and unbound cells are flushed out by a driven flow. The feasibility and reliability of such a microfluidic-based assay, however, remains to be further tested. In the current work, we developed a microfluidic-based system consisting of a microfluidic chip, an image grabbing unit, data acquisition and analysis software, as well as a supporting base. Specific binding of CD59-expressed or BSA-coupled human red blood cells (RBCs) to anti-CD59 or anti-BSA antibody-immobilized chip surfaces was quantified by capture efficiency and by the fraction of bound cells. Impacts of respective flow rate, cell concentration, antibody concentration and site density were tested systematically. The measured data indicated that the assay was robust. The robustness was further confirmed by capture efficiencies measured from an independent ELISA-based cell binding assay. These results demonstrated that the system developed provided a new platform to effectively quantify cellular surface markers effectively, which promoted the potential applications in both biological studies and clinical diagnoses.

Deletion of yeast CWP genes enhances cell permeability to genotoxic agents

We have previously reported the development of a novel genotoxic testing system based on the transcriptional response of the yeast RNR3-lacZ reporter gene to DNA damage. This system appears to be more sensitive than other similar tests in microorganisms, and is comparable with the Ames test. In an effort to further enhance detection sensitivity, we examined the effects of altering major cell wall components on cell permeability and subsequent RNR3-lacZ sensitivity to genotoxic agents. Although inactivation of single CWP genes encoding cell wall mannoproteins had little effect, the simultaneous inactivation of both CWP1 and CWP2 had profound effects on the cell wall structure and permeability. Consequently, the RNR3-lacZ detection sensitivity is markedly enhanced, especially to high molecular weight compounds such as 4-nitroquinoline-N-oxide (> sevenfold) and phleomycin (> 13-fold). In contrast, deletion of genes encoding representative membrane components or membrane transporters had minor effects on cell permeability. We conclude that the yeast cell wall mannoproteins constitute the major barrier to environmental genotoxic agents and that their removal will significantly enhance the sensitivity of RNR-lacZ as well as other yeast-based genotoxic tests.

Proteomic analysis of the sarcosine-insoluble outer membrane fraction of Flavobacterium columnare

Outer membrane proteins (OMPs) of bacteria are key molecules interacting with the host environment. Flavobacterium columnare, a pathogen-causing columnaris disease of fish worldwide, was studied in order to understand the composition of its OMPs. The sarcosine-insoluble membrane fraction of the OMPs was analysed using sodium dodecyl sulphate polyacrylamide gel electrophoresis (SDS-PAGE) in combination with reverse-phase high-performance liquid chromatography-tandem mass spectrometry (RP-HPLC MS/MS). Thirty-six proteins were identified, including proteins involved in cell wall/membrane biogenesis, specific transport of various nutrients and in essential metabolism. The present study is the first report on the OMPs of F. columnare, and may serve as the basis for understanding the pathogenesis of the bacterium.