780nm InGaAsP/InGaP/AlGaAs高功率半导体激光器

采用MOCVD生长了InGaAsP/InGaP/AlGaAs材料系分别限制异质结构(SCH) 的高功率半导体激光器.对于厚度为10nm 的单量子阱,通过计算量子阱增益谱优化了器件的激射波长. 在室温下外延材料的荧光峰值波长为764nm,由于In原子的记忆效应(In carry-over effect)和As/P的替换作用使材料的InGaP/AlGaAs界面不陡峭,通过在InGaP/AlGaAs间长一层5nm的GaAsP大大改善了界面质量. 器件的阈值电流从界面改善前的560mA 减小到改善后的450mA, 斜率效率也从0.61W/A提高到了0.7W/A, 特别是单面最大输出功率已经从370mW 增加到了940mW,发生灾变性光学损伤时的工作电流已经由原来的1100mA 上升为1820mA.

1,2,4-三氯苯胁迫对萌发大豆种子中活性氧的影响

以盆栽法研究了不同浓度 1,2 ,4 三氯苯 (TCB)胁迫对萌发大豆种子中活性氧代谢的影响 .结果表明 ,10 0～ 30 0 μg·g-1TCB胁迫初期 (1～ 3天 )促使萌发大豆种子呼吸强度升高及其峰值提前出现 ,超氧阴离子自由基 (O2 - )及过氧化氢 (H2 O2 )的积累显著增加 ,同时伴随丙二醛 (MDA)含量升高 ,显示发生膜脂质过氧化作用 .TCB胁迫 1～ 6天使活性氧清除酶功能紊乱 ,其中过氧化物酶 (POD)活性升高 ,超氧化物岐化酶 (SOD)活性开始上升后转为下降 .在萌发大豆种子受TCB胁迫伤害过程中 ,活性氧代谢失衡造成的膜脂质过氧化将起着重要作用 .

A 2-kW COIL with a square pipe-array JSOG and nitrogen buffer gas

A 2-kW-class chemical oxygen-iodine laser (COIL) using nitrogen buffer gas has been developed and tested since industrial applications of COIL devices will require the use of nitrogen as the buffer gas. The laser, with a gain length of 11.7 cm, is energized by a square pipe-array jet-type singlet oxygen generator (SPJSOG) and employs a nozzle bank with a designed Mach number of 2.5. The SPJSOG has advantages over the traditional plate-type JSOG in that it has less requirements on basic hydrogen peroxide (BHP) pump, and more important, it has much better operational stability. The SPJSOG without a cold trap and a gas-liquid separator could provide reliable operations for a total gas flow rate up to 450 mmol/s and with a low liquid driving pressure of around 0.7 atm or even lower. The nozzle bank was specially designed for a COIL using nitrogen as the buffer gas. The cavity was designed for a Mach number of 2.5, in order to provide a gas speed and static temperature in the cavity similar to that for a traditional COIL with helium buffer gas and a Mach 2 nozzle. An output power of 2.6 kW was obtained for a chlorine flow rate of 140 mmol/s, corresponding to a chemical efficiency of 20.4%. When the chlorine flow rate was reduced to 115 mmol/s, a higher chemical efficiency of 22.7% was attained. Measurements showed that the SPJSOG during normal operation could provide a singlet oxygen yield Y greater than or equal to 55%, a chlorine utilization U greater than or equal to 85%, and a relative water vapor concentration w = [H2O]/([O-2] + [Cl-2]) less than or equal to 0.1.

四氯乙烯和对二氯苯对草鱼的联合毒性

采用水生污染暴露试验和水生毒理联合效应相加指数法,研究了四氯乙烯(PCE)和对二氯苯(P-DCB)对草鱼(Ctenopharyngodon idellus)的单一毒性与联合毒性.结果表明,PCE和P-DCB的单一毒性均为高毒,且P-DCB的毒性大于PCE.PCE和P-DCB对草鱼的联合染毒在浓度1:1时,暴露时间为24,48,72,96h的相加指数(AI)分别为0.26,0.37,0.78,0.98,联合毒性为相加作用.PCE与P-DCB对草鱼的联合染毒在毒性1:1时,暴露时间为24,48,72,96h的AI分别为-0.15,0.24,0.83,1.30,联合毒性主要是相加作用,但是随着染毒时间的延长,联合毒性由相加作用向协同作用转变.

Influence of Polyelectrolyte on DNA-RecA Nucleoprotein Filaments: Poly-L-Lysine Used as a Model

RecA of Escherichia coli and its active nucleoprotein filaments with DNA are important for the genomic integrity and the genetic diversity. The formation of the DNA-RecA nucleoprotein filaments is a complex multiple-step process and can be affected by many factors. In this work, the effects of poly-L-lysine (PLL) on the DNA-RecA nucleoprotein filaments are investigated in vitro by agarose gel electrophoresis and atomic force microscopy (AFM). The observed morphologies vary with the concentration, the length, and the addition order of PLL. These distinctions provide information for the conformation change of DNA and the binding sites of RecA protein in the formation process of nucleoprotein filaments.

Thermal analysis of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) irradiated under vacuum

Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) was irradiated by Co-60 gamma-rays (doses of 50, 100 and 200kGy) under vacuum. The thermal analysis of control and irradiated PHBV, under vacuum was carried out by thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). The tensile properties of control and irradiated PHBV were examined by using an Instron tensile testing machine. In the thermal degradation of control and irradiated PHBV, a one-step weight loss was observed. The derivative thermogravimetric curves of control and irradiated PHBV confirmed only one weight-loss step change. The onset degradation temperature (T-o) and the temperature of maximum weight-loss rate (T-p) of control and irradiated PHBV were in line with the heating rate (degreesC min(-1)). T-o and T-p of PHBV decreased with increasing radiation dose at the same heating rate. The DSC results showed that Co-60 gamma-radiation significantly affected the thermal properties of PHBV. With increasing radiation dose, the melting temperature (T-m) of PHBV shifted to a lower value, due to the decrease in crystal size. The tensile strength and fracture strain of the irradiated PHBV decreased, hence indicating an increased brittleness.