Kinetic model of continuous-wave flow chemical lasers

In this paper an analysis of the kinetic theory of the continuous-wave flow chemical lasers(CWFCL) is presented with emphasis being laid on the effects of inhomogeneous broadeningon CWFCL's performance. The results obtained are applicable to the case where laser fre-quency is either coincident or incoincident with that of the eenter of the line shape. This rela-tion has been,compared with that of the rate model in common use. These two models are almostidentical as the broadening parameter η is larger than 1. The smaller the value of η, thegreater the difference between the results of these two models will be. For fixed η, the dif-ferences between fhe results of the two models increase with the increase of the frequencyshift parameter ξ. When η is about less than 0.2. the kinetic model can predict exactly the in-homogeneous broadening effects,while the rate model cannot.

空间电动绳系推进中导电系绳动态特性分析

通过建立空间电动绳系系统动力学模型,研究了通有电流的导电系绳高速运动切割地球磁力线时系绳的振荡和变形特性。通过数值计算,分别给出了导电系绳在不同长度和不同主子星质量比下对系绳动态特性的影响,得到了一些规律性认识和结果。

离子钨钼共渗的扩散机制

对双层辉光离子钨钼共渗在离子轰击条件下形成的渗层和无离子轰击时形成的渗层进行了对比，计算了溶质原子钨和钼与空位的结合能。据溶质-空位复合体扩散的能量条件，提出溶质-空位复合体扩散机制在双层辉光离子钨钼共渗中起重要作用。由此解释了双层辉光离子钨钼共渗的W和Mo原子快速扩散现象和渗后冷却中大量金属间化合物在晶界的析出。

激光加工系统平面方程生成与误差分析补偿

研究了在三维曲面工件上进行激光加工时平面坐标及方程的生成方法、所生成的平面方程与曲面方程之间的误差及其补偿措施。平面生成方法有算术平均法、加权平均法和人工智能神经网络法，后2种方法计算精度高而被采用。

Statistical Simulation of Thin-Film Bearings

The information preservation (IP) method and the direct simulation Monte Carlo (DSMC) method are used to simulate the gas flows between the write/read head and the platter of the disk drive (the slider bearing problem). The results of both methods are in good agreement with numerical solution of the Reynolds equation in the cases studied. However, the DSMC method owing to the problem of large sample size demand and the difficulty in regulating boundary conditions at the inlet and outlet was able to simulate only short bearings, while IP simulates the bearing of authentic length ~1000 m ? and can provide more detailed flow information.

燃烧物理学基础

Near-field x-ray phase contrast imaging and phase retrieval algorithm

Theoretical analyses of x-ray diffraction phase contrast imaging and near field phase retrieval method are presented. A new variant of the near field intensity distribution is derived with the optimal phase imaging distance and spatial frequency of object taken into account. Numerical examples of phase retrieval using simulated data are also given. On the above basis, the influence of detecting distance and polychroism of radiation on the phase contrast image and the retrieved phase distribution are discussed. The present results should be useful in the practical application of in-line phase contrast imaging.

Conical emission of Ti : sapphire femtosecond laser pulses propagating in water

Conical emission is investigated for Ti:sapphire femtosecond laser pulses propagating in water. The colored rings can be observed in the forward direction due to the constructive and destructive interference of transverse wavevector, which are induced by the spatio-temporal gradient of the free-electron density. With increasing input laser energy, due to filamentation and pulse splitting induced by the plasma created by multiphoton excitation of electrons from the valence band to the conduction band, the on-axis spectrum of the conical emission is widely broadened and strongly modulated with respect to input laser spectrum, and finally remains fairly constant at higher laser energy due to intensity clamping in the filaments.

LiNbO3：Fe晶体光栅擦除特性

在光折变过程中，光波对掺杂中心的激发系数S是一个重要的物理量。为了求出光激发系数S对波长A的依赖，研究了在不同的擦除波长条件下，记录在光折变晶体LiNbO3：Fe中的光栅衰减特性。实验结果表明lnP（P为光擦除灵敏度）与擦除波长λ呈线性关系，即波长越短，光栅擦除越快，光擦除灵敏度越高。在单中心电子带传输模型的基础上，理论计算也证实了实验结果。利用带传输模型，给出了理论上光激发系数S对波长的指数依赖关系。同时微观量φμγ（φ为量子效率）也可由光栅擦除实验求出。

透射型光折变体全息光栅对超短脉冲激光光束衍射的特性

在Kogelnik耦合波理论的基础上，考虑光栅记录介质的色散效应的影响，研究了光折变体全息光栅对不同偏振状态的超短脉冲激光光束衍射的性质，讨论了高斯型入射脉冲激光光束的谱宽与光栅的有效衍射谱宽之比不同时，衍射和透射光束的光谱宽度、时间宽度、波形和衍射效率的变化。结果表明，光栅的有效衍射谱宽受光栅参量及入射条件的影响，对衍射性质的影响很大，且在考虑光栅记录介质的色散效应时减小。当入射脉冲的偏振方向垂直于入射面时，光栅的有效衍射谱宽大于偏振方向平行于入射面的情形，衍射效率在入射脉冲宽度较大时小于偏振方向平行于

高激光损伤阈值溶胶-凝胶ZrO2薄膜

采用醇热法水解氧氯化锆（ZrOCl2·8H2O）制备ZrO2溶胶，提拉法涂膜。采用粘度、粒度分布、折射率、IR、DSC、AFM等测试手段对溶胶和薄膜性能进行表征。结果表明，ZrO2溶胶颗粒的平均粒径为18．9nm，薄膜经300℃热处理后折射率可高达1．95，膜层表面均匀平整，表面平均粗糙度仅为0．561nm，膜层的激光损伤阈值为14J／cm^2（1064nm，1ns）。

Analysis on the spin reorientation of GdFeCo/DyFeCo exchange-coupled double-layer films

In this paper, GdFeCo/DyFeCo exchange-coupled double-layer films used for center aperture type magnetically induced super resolution were investigated through experiments and theoretical calculation. The samples were prepared by magnetron sputtering method. The polar Kerr effect was measured to prove the spin reorientation of the readout layer. Theoretical study of magnetization profiles was performed on the basis of the mean-field theory and the continuum model. The theoretical results showed that the magnetization orientation of the readout layer changed gradually from in-plane to out-of-plane with the rise of the temperature. Theoretical analysis explained the experimental results successfully. (c) 2005 Elsevier B.V. All rights reserved.

空间碎片的激光雷达探测

为了利用激光雷达对空间碎片进行探测,根据空间环境和空间碎片的特性,给出了空间中的激光雷达作用距离的具体表现形式,并详细分析了空间的背景辐射并给出了处理后的结果,从而推导出最小可探测光功率的计算公式,进而给出了系统所需最小发射光功率和探测系统的信噪比。结果表明,利用激光雷达可以对几十千米范围内的较大空间碎片进行探测。

板料激光斜冲击下受力变形数学分析

金属板材的激光冲击成形通常采用激光束垂直作用于工件表面，产生垂直于表面的冲击波作用力使板料变形，但在曲面零件成形时很难满足法向垂直冲击。因此有必要对斜冲击下板料力学变形特性进行研究。本文研究了激光斜冲击受力变形模型，对板料深度方向（Z轴）变形公式、板料短轴（y轴）在水平方向上变形公式进行了理论推导计算，通过把两变形合成，得到短轴（y轴）在空间内总变形公式，最后把实验测量结果与理论计算结果进行了比较，得出两者相符的结论。