离子钨钼共渗的扩散机制

对双层辉光离子钨钼共渗在离子轰击条件下形成的渗层和无离子轰击时形成的渗层进行了对比，计算了溶质原子钨和钼与空位的结合能。据溶质-空位复合体扩散的能量条件，提出溶质-空位复合体扩散机制在双层辉光离子钨钼共渗中起重要作用。由此解释了双层辉光离子钨钼共渗的W和Mo原子快速扩散现象和渗后冷却中大量金属间化合物在晶界的析出。

激光加工系统平面方程生成与误差分析补偿

研究了在三维曲面工件上进行激光加工时平面坐标及方程的生成方法、所生成的平面方程与曲面方程之间的误差及其补偿措施。平面生成方法有算术平均法、加权平均法和人工智能神经网络法，后2种方法计算精度高而被采用。

Statistical Simulation of Thin-Film Bearings

The information preservation (IP) method and the direct simulation Monte Carlo (DSMC) method are used to simulate the gas flows between the write/read head and the platter of the disk drive (the slider bearing problem). The results of both methods are in good agreement with numerical solution of the Reynolds equation in the cases studied. However, the DSMC method owing to the problem of large sample size demand and the difficulty in regulating boundary conditions at the inlet and outlet was able to simulate only short bearings, while IP simulates the bearing of authentic length ~1000 m ? and can provide more detailed flow information.

燃烧物理学基础

Conical emission of Ti : sapphire femtosecond laser pulses propagating in water

Conical emission is investigated for Ti:sapphire femtosecond laser pulses propagating in water. The colored rings can be observed in the forward direction due to the constructive and destructive interference of transverse wavevector, which are induced by the spatio-temporal gradient of the free-electron density. With increasing input laser energy, due to filamentation and pulse splitting induced by the plasma created by multiphoton excitation of electrons from the valence band to the conduction band, the on-axis spectrum of the conical emission is widely broadened and strongly modulated with respect to input laser spectrum, and finally remains fairly constant at higher laser energy due to intensity clamping in the filaments.

LiNbO3：Fe晶体光栅擦除特性

在光折变过程中，光波对掺杂中心的激发系数S是一个重要的物理量。为了求出光激发系数S对波长A的依赖，研究了在不同的擦除波长条件下，记录在光折变晶体LiNbO3：Fe中的光栅衰减特性。实验结果表明lnP（P为光擦除灵敏度）与擦除波长λ呈线性关系，即波长越短，光栅擦除越快，光擦除灵敏度越高。在单中心电子带传输模型的基础上，理论计算也证实了实验结果。利用带传输模型，给出了理论上光激发系数S对波长的指数依赖关系。同时微观量φμγ（φ为量子效率）也可由光栅擦除实验求出。

高激光损伤阈值溶胶-凝胶ZrO2薄膜

采用醇热法水解氧氯化锆（ZrOCl2·8H2O）制备ZrO2溶胶，提拉法涂膜。采用粘度、粒度分布、折射率、IR、DSC、AFM等测试手段对溶胶和薄膜性能进行表征。结果表明，ZrO2溶胶颗粒的平均粒径为18．9nm，薄膜经300℃热处理后折射率可高达1．95，膜层表面均匀平整，表面平均粗糙度仅为0．561nm，膜层的激光损伤阈值为14J／cm^2（1064nm，1ns）。

Analysis on the spin reorientation of GdFeCo/DyFeCo exchange-coupled double-layer films

In this paper, GdFeCo/DyFeCo exchange-coupled double-layer films used for center aperture type magnetically induced super resolution were investigated through experiments and theoretical calculation. The samples were prepared by magnetron sputtering method. The polar Kerr effect was measured to prove the spin reorientation of the readout layer. Theoretical study of magnetization profiles was performed on the basis of the mean-field theory and the continuum model. The theoretical results showed that the magnetization orientation of the readout layer changed gradually from in-plane to out-of-plane with the rise of the temperature. Theoretical analysis explained the experimental results successfully. (c) 2005 Elsevier B.V. All rights reserved.

空间碎片的激光雷达探测

为了利用激光雷达对空间碎片进行探测,根据空间环境和空间碎片的特性,给出了空间中的激光雷达作用距离的具体表现形式,并详细分析了空间的背景辐射并给出了处理后的结果,从而推导出最小可探测光功率的计算公式,进而给出了系统所需最小发射光功率和探测系统的信噪比。结果表明,利用激光雷达可以对几十千米范围内的较大空间碎片进行探测。

板料激光斜冲击下受力变形数学分析

金属板材的激光冲击成形通常采用激光束垂直作用于工件表面，产生垂直于表面的冲击波作用力使板料变形，但在曲面零件成形时很难满足法向垂直冲击。因此有必要对斜冲击下板料力学变形特性进行研究。本文研究了激光斜冲击受力变形模型，对板料深度方向（Z轴）变形公式、板料短轴（y轴）在水平方向上变形公式进行了理论推导计算，通过把两变形合成，得到短轴（y轴）在空间内总变形公式，最后把实验测量结果与理论计算结果进行了比较，得出两者相符的结论。

TeO2-AlF3氟碲酸盐玻璃的性质和结构

制备了不同氟化物含量的（1-x）TeO2-AlF3（x=10％，20％，30％，按摩尔计）透明氟碲酸盐玻璃。利用差热分析和Raman光谱对玻璃的性质和结构进行研究。结果显示：当x达到30％时，氟化铝以Al-F多面体的形式进入玻璃网络结构。随着氟化物含量增加，玻璃在中红外区的透过率提高，玻璃结构单元从[Te（O，F）4]三方双锥向[Te（O，F）3]三方锥转变。Raman光谱显示：1个宽的强峰出现在750～840cm^-1，表明玻璃中Te-O键长介于0．185-0．196nm之间。

Investigation of the effect of fluoride ions introduction on structural, OH- content and up-conversion luminescence properties in Er3+-doped heavy metal oxide glasses

Effect of fluoride ions introduction on structural, OH- content and up-conversion luminescence properties in Er3+-doped heavy metal oxide glasses have been investigated. Structure was investigated, indicating that fluoride has an important influence on the phonon density, maximum phonon energy of host glasses. With increasing fluoride content, the up-conversion luminescence intensity and quantum efficiencies increase notably, which could not be explained only by the maximum phonon energy change of host glasses. Our results show that, with the introduction of PbF2, the decrease of phonon density and OH- content contributes more to the enhanced up-conversion emissions than that of maximum phonon energy. (c) 2005 Elsevier B.V. All rights reserved.

Structural, optical and electrical properties of ZnO films grown on c-plane sapphire and (100)gamma-LiAlO2 by pulse laser deposition

ZnO thin films were grown on single-crystal gamma-LiAlO2 (LAO) and sapphire (0001) substrate by pulsed laser deposition (PLD). The structural, optical and electrical properties of ZnO films were investigated. The results show that LAO is more suitable for fabricating ZnO films than sapphire substrate and the highest-quality ZnO film was attained on LAO at the substrate temperature of 550 degrees C. However, when the substrate temperature rises to 700 degrees C, lithium would diffuse from the substrate (LAO) into ZnO film which makes ZnO film on LAO becomes polycrystalline without preferred orientation, the stress in ZnO film increases dominantly and the resistivity of the film decreases exponentially. (c) 2005 Elsevier B.V. All rights reserved.

Crystal growth and properties of Yb : FAP laser crystal

A large and transparent Yb:FAP crystal with dimensions up to circle divide 30 mm x 85 mm has been grown by the Czochralski method. The preparation of the raw material has been investigated. X-ray power diffraction studies of Yb:FAP crystal confirm that the as-grown crystal is isostructural with the FAP crystal. The crystalline quality has been studied using X-ray rocking curve analysis. The segregation coefficient of Yb3+ in the Yb:FAP crystal has been also determined. Linear thermal expansion coefficients in [001] and [100] directions have been measured in the 30-800 degrees C temperature range. (c) 2005 Elsevier B.V. All rights reserved.