355 resultados para attosecond pulses
Resumo:
通过数值求解三维电场传播方程,理论模拟了飞秒强激光脉冲(50fs,10^16w/cm^2)在氩气和中等尺寸氩团簇中的传播效应.结果表明,飞秒强激光脉冲经氩气传播将发生频谱蓝移展宽和光束发散;而经中等尺寸氩团簇传播,则存在一定程度的自聚焦效应.
Resumo:
远场光学显微镜受衍射极限分辩率的限制,而近场光学显微镜由于缺乏层析能力,则无法实现超分辨的三维成像,研究了既可突破远场光学显微术的衍射极限分辨率又可实现三维成像的成像技术——受激发射损耗(STED),综述了STED的分辨率与STED光的光强,延迟时间、光斑空间分布等主要参数的关系,以及该技术的最新进展和应用前景。
Resumo:
采用单电子模型研究了圆偏振飞秒脉冲激光作用下电子振荡导致的谐波辐射频谱的特性。研究发现随着激光强度的增加,电子在激光场中运动的相对论效应可以导致谐波辐射,并且发现谐波辐射频谱随着激光强度的增加发生了展宽和红移。电子与强激光脉冲相互作用,电子除了在激光场的作用下做横向振荡运动之外,激光脉冲的纵向有质动力对电子还有推动作用,这是产生谐波频谱红移的原因,而谐波辐射频谱展宽是由电子纵向速度的变化引起的。分析激光场中电子在不同方向的辐射频谱表明:随着谐波阶数的升高,红移在有规律地变大;在θ=3π/4方向上电子频谱的
Resumo:
本文研究了在被飞秒脉冲波列激发的半导体量子阱中再发射场的相位性质。再发射场的相位演化受入射脉冲波列的相对相位控制。对于所有的奇数次入射脉冲激发,再发射场与入射场相位演化是:反相到同相再到反相;但是对于所有的偶数次入射脉冲激发,情况发生了反转,即再发射场与入射场相位演化是:同相到反相再到同相。
Resumo:
本文研究了飞秒激光脉冲在水中的传输情况.通过改变不同的激光输入功率进行模拟,我们发现从输入功率略高于到远远高于发生自聚焦的临界功率,分别是群速度色散和多光子电离多光子吸收阻止了自聚焦导致的脉冲塌陷,当多光子电离和多光子吸收主导传输时,脉冲能被压缩到几个光学周期.在频域,多光子电离能引起很强的蓝移,而多光子吸收能对这种蓝移起到抑制作用。
Resumo:
通过对飞秒激光在空气中产生的等离子体通道两端外加高压,来研究通道的寿命变化情况。实验得到,当在等离子体通道两端外加高压时(350 kV/m),等离子体通道寿命延长了近3倍。理论模拟和分析结果表明在外加电场条件下,碰撞电离得到增强,吸附作用相对减弱,解离复合系数随着电子平均能量的增加而下降的趋势更为剧烈,这进一步引起了等离子体通道寿命的延长。实验结果与理论分析共同表明了利用外加电场对空气中激光等离子体通道寿命进行延长的可行性。
Resumo:
当红外强激光和极紫外(XUV)阿秒脉冲共同作用于原子分子时,电离出去的电子通常会吸收和辐射激光光子而发生能量扩展.讨论了由于XUV阿秒脉冲的短波长与扩展后的电子波包尺度可相比拟时在高次谐波产生过程中引起的非偶极效应.采用彤作为模型分子,并把分子轴置于激光场的传播方向,通过解二维含时薛定谔方程并比较考虑非偶极效应和采用偶极近似两种方法计算得到的结果,两者相比,前者的谐波强度降低,谐波频率向低级次稍有移动,电子能谱的能带内出现了更多的光电子峰.在相同的光电子能量处,两种方法计算得到的信号强度相差2—5倍.并且
Resumo:
针对啁啾脉冲放大技术建成的钛宝石激光装置,提出一种获得高重复率激光脉冲列的方法.通过改变钛宝石再生放大器中泡克耳斯盒电光开关的传统工作模式,使得腔内放大的脉冲从某特定时刻起,每当在腔内往返一次就以一定的倒出比例(倒出率)倒出腔内脉冲能量的一部分,从而可以在有限的时间段内产生高重复率的啁啾激光脉冲列.基于Franz-Nodvik放大理论,建立了该高重复率再生放大器的理论模型,通过数值计算,系统地分析了初始增益、倒出时刻、倒出率对输出的脉冲序列的影响.在抽运功率为35mJ、倒出率为1/2的实验条件下,通过腔外
Resumo:
Temperature controlled filamentation is experimentally demonstrated in a temperature gradient gas-filled tube. The proper position of the tube is heated by a furnace and two ends of the tube are cooled by air. The experimental results show that multiple filaments are shrunken into a single filament or no filament only by increasing the temperature at the beginning of the filament. This technique offers another degree of freedom of controlling the filamentation and opens a new way for intense monocycle pulse generation through gradient temperature in a noble gas.
Resumo:
Pulse compression through filamentation in an argon-filled cell was experimentally demonstrated by using circularly and linearly polarized pulses. A 53 fs circularly polarized pulse was successfully compressed to 15 fs. By using circularly polarized pulse input, the broadened spectrum was much wider and the incident energy in the gas cell can be increased by more than 3/2 times. Much shorter pulse could be compressed by using circularly polarized pulse input. [GRAPHICS] The temporal profile of the compressed pulse (C) 2008 by Astro Ltd. Published exclusively by WILEY-VCH Verlag GmbH & Co. KGaA.
Resumo:
By solving numerically the full Maxwell-Bloch equations without the slowly varying envelope approximation and the rotating-wave approximation, we investigate the effects of Lorentz local field correction (LFC) on the propagation properties of few-cycle laser pulse in a dense A-type three-level atomic medium. We find that: when the area of the input pulse is larger, split of pulse occurs and the number of the sub-pulses with LFC is larger than that without LFC; at the same distance, the time interval between the first sub-pulse and the second sub-pulse in the case without LFC is longer than that with LFC, the time of pulse appearing in the case without LFC is later than that in the case with LFC, and the two phenomena are more obvious with propagation distance increasing; time evolution rules of the populations of levels vertical bar 1 >, vertical bar 2 > and vertical bar 3 > in the two cases with and without LFC are much different. When the area of the input pulse is smaller, effects of LFC on time evolutions of the pulse and populations are remarkably smaller than those in the case of larger area pulse. (c) 2008 Elsevier B.V. All rights reserved.
Resumo:
Acceleration of an initially moving electron by a copropagation ultra-short ultra-intense laser pulse in vacuum is studied. It is shown that when appropriate laser pulse parameters and focusing conditions are imposed, the acceleration of electron by ascending front of laser pulse can be much stronger compared to the deceleration by descending part. Consequently, the electron can obtain significantly high net energy gain. We also report the results of the new scheme that enables a second-step acceleration of electron using laser pulses of peak intensity in the range of 10(19)-10(20) W mu m(2)/cm(2). In the first step the electron acceleration from rest is limited to energies of a few MeV, while in the second step the electron acceleration can be considerably enhanced to about 100 MeV energy.
Resumo:
We build a compact high-conversion-efficiency and broadband tunable noncollinear optical parametric amplifier (OPA) in the infra-red (IR) pumped by a femtosecond Ti:sapphire CPA laser. The OPA consists of an internal seed of white-light continuum generator (WLG) and two noncollinear optical parametric amplifiers. The tunable wavelength range is from 1.2 mu m to 2.4 mu m for both signal and idle pulses. The total OPA efficiency in the last OPA stage reaches about 40% in a wider tunable spectral range (from 1.3 mu m to 1.7 mu m for signal pulse, from 1.5 mu m to 2.0 mu m for idle pulse respectively).
Resumo:
Ultrashort light-matter interactions between a linear chirped pulse and a biased semiconductor thin film GaAs are investigated. Using different chirped pulses, the dependence of infrared spectra on chirp rate is demonstrated for a 5 fs pulse. It is found that the infrared spectra can be controlled by the linear chirp of the pulse. Furthermore, the infrared spectral intensity could be enhanced by two orders of magnitude via appropriately choosing values of the linear chirp rates. Our results suggest a possible scheme to control the infrared signal.
Resumo:
An acoustic-optics programmable dispersive filter (AOPDF) was first employed to actively control the linearly polarized femtosecond pump pulse frequency chirp for supercontinuum (SC) generation in a high birefringence photonic crystal fiber (PCF). By accurately controlling the second order phase distortion and polarization direction of incident pulses, the output SC spectrum can be tuned to various spectral energy distributions and bandwidths. The pump pulse energy and bandwidth are preserved in our experiment. It is found that SC with broader bandwidth can be generated with positive chirped pump pulses except when the chirp value is larger than the optimal value, and the same optimal value exists for the pump pulses polarized along the two principal axes. With optimal positive chirp, more than 78% of the pump energy can be transferred to below 750 nm. Otherwise, negative chirp will weaken the blue-shift broadening and the SC bandwidth. (C) 2007 Elsevier B.V. All rights reserved.