204 resultados para 153
Resumo:
辽河三角洲有丰富的地上和地下资源,是农业综合开发和油田建设的重点地区。其区域资源开发以油田、稻田、苇田和虾田开发为核心,在土地利用主要做到全面规划与统筹兼顾;对淡水资源不足的问题要从开源与节流两方面来进行解决;对河口湿地景观生态系统要注意保护,发挥业已建立的自然保护区的功能;对河口湾水产资源更要加强保护与培育。
Resumo:
分析球形水窖空间结构的应力分布情况并进行几何尺寸优化,避免建设者根据经验来确定球形水窖的厚度、构造及混凝土标号,以节省建窖材料,同时防止应力不足而发生破坏。【方法】利用基于ANSYS平台新开发的窖体有限元分析软件,对实际中窖壁厚度为4和11 cm的混凝土薄壳球形水窖进行空间结构应力分析,同时以水窖耗材量最小为目标函数,以许用应力和变形量为约束条件,对其进行几何尺寸优化。【结果】计算得出窖壁厚度为4和11 cm的水窖最大拉应力分别为1 380.00和447.31 kPa,最大压应力分别为5 153.20和1 896.70 kPa;优化出空窖不利工况下容积为20,30和40 m3的球形水窖窖壁最佳厚度,即栗钙土地区分别为0.051,0.061和0.065m,黄土地区分别为0.050,0.059和0.062 m。【结论】经软件优化计算后的球形水窖结构,既能满足强度和刚度的要求,同时也最大限度地节约了材料用量;利用新开发的窖体结构优化分析软件,能够对球形水窖进行空间应力分析与结构优化,可以作为球形水窖设计软件。
Resumo:
综述了螺旋藻的营养价值、保健功效、生产及应用,并展望了开发前景。
Resumo:
比较分析了杉木 桤木和杉木 刺楸混交林中杉木、桤木和刺楸活细根、死细根的N、P、K含量 .结果表明 ,桤木细根N迁移能力较强 ,刺楸较弱 ,杉木细根N不迁移 ;P在桤木和刺楸细根中迁移能力较强 ,而在杉木细根中基本不迁移 ;3个树种细根脱落前都将K迁移回树体内 .比较分析 2个混交林中活细根N、P、K在树种间的差异 ,发现在杉木 桤木混交林中桤木根部N可能向杉木迁移 ,而在杉木 刺楸混交林中刺楸根部K可能向杉木根部迁移 ,但迁移机制还有待于从根 土界面生态过程进行研究
Resumo:
为诱导无芽黄精根状茎产生不定芽,选择不同的化学物质进行诱导处理。结果表明,GA3处理效果明显,选用0.4 mg/L的GA3浸泡25 min对黄精根状茎不定芽的产生和须根生长有明显促进作用,高浓度抑制其生长;1%硫脲浸泡处理对黄精无顶芽根状茎萌发新芽和须根有明显的抑制作用。
Resumo:
本文阐述了将有机废弃物无害化处理后对土壤、作物、化肥利用率、禽流感防治及对环境的综合效应。
Resumo:
<正>2009年12月召开的联合国哥本哈根气候变化会议上围绕如何应对气候变化问题的争论实质上是关于未来发展道路和发展权力的争论。哥本哈根会议再次显示,发达国家通过把对气候变化的科学认识转变为政治共识而在国际气候变化事务中占有更多的话语权。但作为政治共识的气
Resumo:
A capillary electrophoresis with electrochemical detection(CE-ED) method was developed for the quality analysis of herbal medicine products prepared from the same herb of Herba Sarcandrae: Fufang Caoshanhu tablets, Qingrexiaoyanning capsules, and Xuekang oral liquids. Under the optimal analysis conditions, the low detection limit[1.0x10(-7) mol/L(S/N=3)] and the wide linear range(1.0x10(-7)-1.0x10(-4) mol/L) were obtained for quality standard compound of isofraxidin. The precisions of the peak current and the migration time(as RSDs) for the real sample analysis were 2.0%-2.6%, and 1.2%-1.8% for isofraxidin, respectively.
Resumo:
Crystallization kinetics of syndiotactic polypropylene ( sPP) was observed by light attenuation measurements. The initial stages of temperature dependent sPP crystallization fall in the range of Rayleigh scattering and Rayleigh-Debye-Gans scattering. Initial time and growth time of crystallization were obtained, and the trend of crystallization temperature dependent linear attenuation coefficient on the radius and the index of the refraction of the spherulite were evaluated.
Resumo:
Colloidal gold was prepared by UV light irradiation of the mixture of HAuCl4 aqueous solution and poly(vinyl pyrrolidone) (PVP) ethanol solution in the presence of silver ions. The resulting sheet-like nanoparticles were found to self-assemble into nanoflowers by a centrifuging process. The results of control experiments reflected that only suitable size sheet-like nanoparticles could assemble into the flower-like structures. The presence of Ag ions and PVP are essential for the formation process of nanoflowers.
Resumo:
The Mg-8Gd-2Y-1Nd-0.3Zn-0.6Zr (wt.%) alloy sheet was prepared by hot extrusion technique, and the structure and mechanical properties of the extruded alloy were investigated. The results show that the alloy in different states is mainly composed of alpha-Mg solid solution and secondary phases of Mg5RE and Mg24RE5 (RE = Gd, Y and Nd). At aging temperatures from 200 degrees C to 300 degrees C the alloy exhibits obvious age-hardening response. Great improvement of mechanical properties is observed in the peak-aged state alloy (aged at 200 degrees C for 60 h), the ultimate tensile strength (sigma(b)), tensile yield strength (sigma(0.2)) and elongation (epsilon) are 376 MPa, 270 MPa and 14.2% at room temperature (RT), and 206 MPa. 153 MPa and 25.4% at 300 degrees C, respectively, the alloy exhibits high thermal stability.
Resumo:
A trivalent neodymium ion (Nd3+) complex Nd(PM)(3)(TP)(2) was synthesized, and its optical properties was studied by introducing Judd-Ofelt theory to calculate the radiative transition rate and the radiative decay time of the F-4(3/2) -> (4)l(J), transitions in this Nd(III) complex. The strong emissions of this complex at near-infrared region were owing to the efficient energy transfer from ligands to center metal ion. The potential application of this complex in NIR electroluminescence was studied by fabricating several devices. The maximum NIR irradiance was obtained as 2.1 mW/m(2) at 16.5 V.
Resumo:
通过Stille偶联反应合成了5,5″-二辛基-2,2′∶5′2″-三联[3,2-b]并二噻吩,并对该化合物的物理化学性质以及真空蒸镀薄膜的结构和形貌进行了详细表征.以这一化合物作为半导体层、采用顶电极结构制备了有机薄膜晶体管,并对薄膜生长基底温度做了优化,发现基底温度为100℃时器件性能最好,迁移率达到0.13 cm2/V.s,开关比为7×103,阈值电压为-19V.
Resumo:
Strontium hydroxyapatite (Sr-5(PO4)(3)OH, SrHAp) microspheres with 3D architectures have been successfully prepared through a efficient and facile solvothermal process. The experimental results indicate that the SrHAP microspheres are composed of a large amount of nanosheets, which are assembled in a radial form from the center to the surface of the microspheres. The as-obtained SrHAp samples show an intense and bright blue emission from 350 to 570 nm centered at 427 nm (CIE coordinates: x = 0.153, y = 0.081; lifetime: 9.2 ns; quantum efficiency: 31%) under long-wavelength UV light excitation (344 nm). This blue emission might result from the CO2 center dot- radical impurities in the crystal lattice. Furthermore, the surfactants CTAB and trisodium citrate have an obvious impact on the morphologies and the luminescence properties of the products, respectively.
Resumo:
A facile and wet-chemical approach was employed to control synthesis of self-organizing, hyperbranched nanoporous Au microsheet with high quality in bulk quantity. This method produced nanoporous Au microsheets with a thickness of 7-15 nm. The microsheets were composed of irregularly interconnected planar Au nanoplates with interstices, i.e. nanopores of 10-50 nm. And the nanoporous Au microsheets were enveloped in 10-30 nm thick polyaniline (PANI) sheaths. The morphology of the nanostructured Au composites could also be easily tuned by changing the concentration of aniline and chlorauric acid. The dendritic and epitaxial growth of nanoporous Au microsheet was believed as the diffusion-limited process confined in the lamellar emulsion phase through self-assembly of aniline and dodecylsulfate. The solution reaction proceeded at a mild condition (room temperature and aqueous solutions), and less toxic reagents were employed instead of extreme toxic and corrosive chemicals.