Preparation, photo and electroluminescence properties of novel rare earth aromatic carboxylates

Novel soluble rare earth aromatic carboxylates were prepared. The triplet energy level of organic ligand was measured. The photoluminescence properties of the Tb3+ and EU3+ aromatic carboxylates and lifetimes were investigated, which indicated that these rare earth complexes have high quantum efficiency. Because of their excellent solubility, polymer-doping rare earth carboxylates were fabricated as thin Films by spin-coating method and their luminescence properties were studied. Some rare earth organic light-emitting diodes were successfully fabricated which performed high pure color. The maximum luminance of the device of ITO/PVK/PVK :Th (AS)(3)Phen: PBD/PBD/Al is 32 cd(.)m(-2) at 28 V.

Studies of perchlorate triggered ion-gate behavior of sBLM by electrochemiluminescence and its application to a sensor for perchlorate

Ru(bpy)(3)(2+) electrochemiluminescence (ECL) method and electrocatalysis method were first used to study the ion-gate behavior of supported lipid bilayer membrane (sBLM). We found that sBLM, made of dimethyldioctadecylammonium bromide (a kind of synthetic lipid), showed ion-gate behavior for the permeation of Ru(bpy)(3)(2+) in the presence of perchlorate anion. There existed a threshold concentration (0.1 muM) of perchlorate anion for ion-gate opening. Below the threshold the ion-gate was closed. Above the threshold, the number of opened ion-gate sites increased with the increase of perchlorate anion concentration and leveled off at concentrations higher than 1200 muM. Based on it, a new sensor for perchlorate was developed. Furthermore, the opening and closing of the ion-gate behavior was reversible, which means the sensor can repeatedly be used.

Hydrothermal synthesis and crystal structure of a novel compound: [Ni(phen)(3)](2)[(SiMo10V2O40)-O-IV((VO)-O-IV)2]center dot 2H(2)O

A novel compound [Ni(phen)(3)](2)[(SiMo10V1/2O40)-O-V((VO)-O-IV)(2)] . 2H(2)O has been hydrothermally synthesized and structurally characterized by single-crystal X-ray diffraction. The compound crystallizes in the triclinic, system, space group P-1, a = 12.378(4) Angstrom, b = 14.148(5) Angstrom, c = 14.316(2) Angstrom, alpha = 105.91(2)degrees, beta = 95.31(2)degrees, gamma = 96.89(3)degrees, V = 2373.0(12) Angstrom(3), Z = 1, (lambdaMo(Kalpha)) = 0.71073 Angstrom, R1 (wR2) = 0.0869(0.2174). Data were collected on a Siemens P4 four-circle diffractometer at 293 K in the range of 1.51 < theta < 22.50degrees using the omega-scan technique. Empirical absorption correction (psi scan) was applied. The structure was solved by the direct method and refined by the Full-matrix least-squares on F-2 using the SHELXL-97 software. X-ray crystallographic study showed that the title compound contained a bi-capped alpha-Kegin-type [(SiMo10V2O40)-O-IV((VO)-O-IV)(2)](4-) polyoxoanion.

Hydrothermal synthesis and crystal structure of an unusual compound: [Cu(en)(2)](4)[(SiMo8V4O40)-O-V((VO)-O-IV)(2)][MoO4](2)center dot 5H(2)O

A novel compound [Cu(en)(2)](4)[(SiMo8V4O40)-O-v(V-IV O)(2)] [MoO4](2) . 5H(2)O has been hydrothermally synthesized and structurally characterized by single-crystal X-ray diffraction. Black crystals crystallize in the tetragonal. system, space group 14/m, a = b = 14.019(2) Angstrom, c = 20.341(4) Angstrom, V = 3997.9(11) Angstrom(3), Z = 2, lambda(MoKalpha) = 0.71073 Angstrom (R(F) = 0.0443 for 1819 reflections). Data were collected on a Siemens P4 four-circle diffractometer at 293 K in the range of 1.76 < theta < 24.98degrees using the omega-scan technique. The structure was solved by the direct method and refined by the full-matrix least squares on F-2 method using the SHELXL-97 software. X-ray crystallographic study showed that the title compound contained a bicapped alpha-Keggin fragment [SiMo8 (V4O40)-O-v((VO)-O-IV)(2)](4-) polyoxoanion.

Preparation of polymer/silica nanoscale hybrids through sol-gel method involving emulsion polymers (PMMA/SiO2)

The different poly (methyl methacrylate) (PMMA) /SiO2 hybrids were prepared through sol-gel method involving PMMA emulsion (emulsion method) and PMMA/THF solution (solution method). The samples were characterized by differential scanning calorimetry(DSC), thermogravimetry analysis(TGA), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The results showed that PMMA/SiO2 composites in nanoscale were prepared by emulsion method, and its size of phase heterogeneity was less than that of solution method. Meanwhile, the polymer emulsion as the reactive medium was more suitable for the formation of SiO2 network.

Crystal growth and structural analysis of PrMnO3 and TbMnO3

Single crystals of PrMnO3 and TbMnO3 were grown by floating zone method and the crystal structure was determined by single crystal X-ray diffractometry. The structure of these compounds belongs to the orthorhombic system (space group is Pnma, No. 62) with the lattice parameters alpha approximate to root (.) - a(p), b approximate to 2 (.) a(p) , c approximate to root 2.a(p) and Z = 4, where a(p) is ideal cubic perovskite cell parameter.

PMo12-doped carbon ceramic composite electrode based on sol-gel chemistry and its electrocatalytic reduction of bromate

A conductive carbon ceramic composite electrode (CCE) comprised of cc-type 1:12 phosphomolybdic acid (PMo12) and carbon powder in an organically modified silicate matrix was fabricated using a sol-gel method and characterized by scanning electron microscopy, cyclic voltammetry, and Osteryoung square-wave voltammetry. Osteryoung square-wave voltammograms of the modified electrode immersed in different acidic aqueous solutions present the dependence of current and redox potential on pH. The PMo12-doped CCE shows more reversible reaction kinetics, good stability and reproducibility, especially the renewal repeatability by simple polishing in the event of surface fouling or dopant leaching. Moreover, the modified electrode shows good catalytic activity for the electrochemical reduction of bromate.

Displacement and luminescence of Eu3+ in CaYBO4

CaY1-xBO4: xEu was synthesied by solid state reaction method, and the displacement and luminescence of the Eu3+ in CaYBO4 host were studied. Two luminescent centers could be observed at certain Eu3+-concentration, indicating that the Eu3+ occupies two different crystallographic sites. This result shows that the Eu3+ occupies two different Y3+ sites in CaYBO4. The investigation on Eu-O charge transfer bands indicates that the larger distortion or the lower symmetry of Eu3+ site is,the shorter wavelength of the Eu-O charge transfer band is. When the Eu3+-concentration is high (x > 0.10), Eu3+ occupies the sites of Ca2+ and is reduced to Eu2+.

Effects of rubber content and temperature on dynamic fracture toughness of ABS materials

The effects of rubber content and temperature on dynamic fracture toughness of ABS materials have been investigated based on the J-integral and crack opening displacement (COD, delta) concepts by an instrumented Charpy impact test. A multiple specimens R-curve method and stop block technique are used. It is shown that the materials exhibit a different toughness behavior, depending on rubber content and temperature. The resistance against stable crack initiation (J(0.2) or delta(0.2)) increases with increasing rubber content. However, J(0.2) first increased with increasing temperature until reaching the maximum value; after that, it decreases with further increasing the temperature. (C) 2000 John Wiley & Sons, Inc.

Preparation, structure and luminescence of BaMAl10O17 : Eu2+ (M = Be, Mg, Ca, Zn, Cd, Mn, Co, Li) system

The BaMA(10)O(17) (M = Be, Mg, Ca, Zn, Cd, Mn, Co, Li) system has been synthesized by solid state method and characterized by XRD. The results show that when M is Mg, Zn, Mn, Co, Li, there exists the structure of beta-Al2O3 for BaMAl10O17 system, and when M indicates Cd, beta-Al2O3 structure is formed accompanying alpha-Al2O3 phase, and when M represents Be and Ca, beta-Al2O3 structure cannot be formed. This demonstrates that the condition forming beta-Al2O3 structure compounds for the system BaMAl10O17 is 0.05nm < R-M < 0.09nm (R-M represents the radius of M). The thought that if a M ion can form a stable spinel structure there exsits a corresponding magnetoplumbite and beta-alumina structure is proposed for BaMAl10O17 system according to the experimental results. When M is Li, Be, Zn, Eu2+ activator produces an emission of nearly 450 nm with half height width about 50 nm, when M is Mn, there are simultaneously the emissions of Eu2+ and Mn2+ and the excitation energy of Eu2+ can transfer to Mn2+ in the host, when M is Cd, Eu2+ displays a double-emission band, which can be explained by the Jahn-Teller's effect. It is possible for the system BaMAl10O17 with M being Li, Be, Zn to become blue-emitting component in three colour lamp through further study.

Hydrothermal synthesis and crystal structure of [{Cu(2,2 '-bpy)(2)}(2)Mo8O26]: a beta-octamolybdate cluster covalently bonded to two {Cu(2,2 '-bpy)(2)}(2+) coordination complexes via bridging oxo groups

An organic-inorganic hybrid solid, (Cu(2,2'-bpy)(2))(2)Mo8O26, has been hydrothermally synthesized and structurally characterized by single-crystal X-ray diffraction. Dark green crystals crystallize in the orthorhombic system, space group Pna21, a = 24.164(5), b = 18.281(4), c = 11.877(2) Angstrom, alpha = 90 degrees, beta = 90 degrees, gamma = 90 degrees, V= 5247(2) Angstrom (3), Z = 4, lambda (MoK alpha) = 0.71073 Angstrom (R(F) = 0.0331 for 5353 reflections). Data were collected on a Siemens P4 four-circle diffractometer at 293 K in the range 1.69 degrees < theta < 25.04 degrees using the omega -scan technique. The structure was solved by the direct method and refined by full-matrix least squares on F-2 using SHELXL-93. The structure of this compound consists of discrete (Cu(2,2'-bpy)(2))(2)Mo8O26 clusters, constructed from beta -octamolybdate subunits ((Mo8O26)(4-)) covalently bonded to two (Cu(2,2'-bpy)(2))(2+) coordination complexes via bridging oxo groups that connect two adjacent molybdenum sites. (C) 2001 Academic Press.

Circular dichroism spectro electrochemical and voltammetric studies of vitamin B-2

Electroreduction of vitamin B-2 (VB2) was studied by in situ circular dichroism (CD) spectroelectrochemistry (SEC) with a long optical path length thin layer cell (LOPLTLC). The results showed that the electroreduction of VB2 in phosphate buffer solution (PBS) (PH 6.8) was a two-electron electrochemical process with weak adsorption of the reactant at the glassy carbon (GC) electrode surface. The CD spectra change of VB2 in the reduction process was explained with the theory of electronic states. We also treated the CD spectra with a singular value decomposition least square (SVDLS) method, and have found not only the number of components and their spectra, but also the fraction distribution of each component in the electroreduction process of VB2.

Variable selection by orthogonal descriptors and prediction of R-f value of phenol and aniline derivatives

Orthogonal descriptors is a viable method for variable selection, but this method strongly depend on the orthogonalisation ordering of the descriptors. In this paper, we compared the different methods used for order the descriptors. It showed that better results could be achieved with the use of backward elimination ordering. We predicted R-f value of phenol and aniline derivatives by this method, and compared it with classical algorithms such as forward selection, backward elimination, and stepwise procedure. Some interesting hints were obtained.

Preparation and spectra study of TiO2 gel doped with fluorescein

TiO2 gel doped with fluorescein was prepared by a sol-gel method, and the fluorescence of fluorescein and its effect on formation of the: gel were investigated with absorption, fluorescence, IR spectroscopies and TG-DTA analysis. The results indicated that FL incorporated into TiO2 gel had exhibited big changes compared to that in ethanol solution both in the absorption and the emission spectra, and the formation of TiO2 gel was influenced greatly by FL.

Synthesis, crystal structure and properties of H-8[P4W14O58Na4 (H2O)(20)] center dot 16H(2)O

A novel heteropoly tungstophosphates, H-8[P4W14O58Na4(H2O)(20)] . 16H(2)O, was synthesized by hydrothermal method and characterized by elemental analysis, IR spectrum and single-crystal X-ray structure analysis. The thermal stability of the compound was investigated by using TG-DTA. The crystal is triclinic system with space group P (1) over bar, a = 1. 137 9(2) nm, b=1. 363 2(3) nm, c=1. 627 1(3) nm; alpha=78. 20(3)degrees, beta=71, 20(3)degrees, gamma= 71. 62(3)degrees; V = 2. 252 5(8) nm(3), Z=1, M-r= 4 374. 38, D-c = 3. 225 mg/cm(3), mu = 18. 007 mm(-1), F(000)=1 972, R=0. 074 2, R-w=0. 200 4. The result of structure analysis shows that the anion of the compound consists of two PW7O29Na2(H2O)(10) subunits and two linked phosphorous atoms. A kind of microporous with size of 0. 661 4 nm X 0. 318 9 nm was formed in the crystal structure.