Microstructure and characteristics in the organic matrix layers of nacre

The direct observation of a type of microstructure in the organic matrix layers of nacre was obtained with a transmission electron microscope. The microstructure, which is referred to as mineral bridge in the biomineralization, is nanoscale and randomly distributed in the layers. Statistical analysis gives the distribution laws and characteristics of mineral bridges in the organic matrix layers. The existence of mineral bridges in nacre was confirmed, and it was shown that the microarchitecture of nacre should be described as a "brick-bridge-mortar" arrangement rather than traditional "brick and mortar" one.

Formation Mechanism of Cracks in Saturated Sand

The formation mechanism of “water film” (or crack) in saturated sand is analyzed theoretically and numerically. The theoretical analysis shows that there will be no stable “water film” in the saturated sand if the strength of the skeleton is zero and no positions are choked. It is shown by numerical simulation that stable water films initiate and grow if the choking state keeps unchanged once the fluid velocities decrease to zero in the liquefied sand column. The developments of “water film” based on the model presented in this paper are compared with experimental results.

双掺杂LiNbO3：Fe：Ru晶体的全息读出特性

为了解决读出过程中全息数据的擦除问题，研究了新型双掺杂LiNbOa：Fe：Ru晶体的全息读出特性。分析了双中心和单中心记录方案光栅的读出特性，并联立双中心物质方程和耦合波方程进行了模拟计算。结果表明，双中心记录所得到的饱和全息的读出时间常数远低于LiNbO2：Fe：Mn晶体的读出时间常数；单色光记录可以实现有效的全息，且其读出时间常数远大于记录时间常数，表现为准态非挥发读出。分析表明，这可能由于Ru的能级比Mn更靠近Fe，更易被红光激发，从而使得双中心记录所得饱和光栅的存贮持久性降低；单色光记录中红光能够

Relay lens-free birefringence-customized stackable beam-steering modules for optical interconnects

A previously suggested birefringence-customized modular optical interconnect technique is extended for lens-free relay operation. Various lens-free relay imaging models are developed. We claim that the lens-free relay system is important in simplifying an optical interconnect system whenever the imaging conditions permit. To verify the validity of various proposed concepts, we experimentally implemented some 8 x 8 optical permutation modules. High-power efficiency and low channel cross talk were experimentally observed. In general, the larger the channel spacing, the less the cross talk. A quantitative cross-talk measurement of the lens-free relay system shows that, for a fixed channel width of 0.5 mm and channel spacings of 0.5, 1, and 2 mm, a less than -20-dB cross-talk performance can be guaranteed for lens-free relay distances of 40, 280, and 430 mm, respectively. (C) 1998 Optical Society of America.

Yb∶Y3Al5O12晶体晶格振动光谱的研究

采用提拉法生长Y3Al5O12(YAG)晶体和Yb3+掺杂原子数分数分别为5%, 10%, 15%, 20%, 25%, 50%和100%的Yb∶Y3Al5O12(Yb∶YAG)晶体。系统表征和分析了Yb3+掺杂浓度对拉曼光谱的影响。随着Yb3+掺杂浓度的增加,晶体的振动模式没有明显的变化,晶体结构没有改变;在370 cm-1和785 cm-1附近,振动吸收峰的半峰全宽逐渐增大。分析得出,Yb3+掺杂浓度对晶体的晶格、对称性、荧光寿命均有影响,从而可能影响到晶体的光谱和激光性能。

云南矮马和普通马的比较细胞遗传学观察

云南矮马和普通马的比较细胞遗传学观察中科院昆明动物研究所细胞与分子进化开放研究实验室刘爱华，林世英云南省畜牧兽医科学研究所解德文分布于云南、四川、广西、贵州等省（区）有关矮马的生理生化指标和近缘分布、生态特征以及细胞遗传学等资料已有报道。本实验采用细...

湖南产五步蛇蛇毒磷脂酶A_2的热稳定性

本文测定了湖南产五步蛇蛇毒磷脂酶Ａ２在不同温度保温后的酶活性，结果表明此酶具有一定的热稳定性。

微量营养物质对毛纺废水生物处理效果的影响

研究了Mg、Mo、Zn、维生素B1以及烟酸等微量营养物质对活性污泥降解CODCr活性的 影响,同时,对微量营养物质作用前后处理系统微生物群落结构进行了比较研究。试验结果表明:毛 纺废水缺乏生物处理系统所需足够的微量营养物质;不同种类和浓度的微量营养物质对活性污泥降 解CODCr活性的影响效果也不相同,Mg、Mo、Zn、雏生素B1和烟酸的最佳浓度分别为5 mg／L, 2 mg／L,1 mg／L,1 mg／L和1 mg／L;其最佳促进效果可使CODCr降解速率分别达到对照系统的 180％、140％、130％,

土壤硒污染对土壤酶的生态毒理效应

通过室内培养和盆栽试验,研究了Se对黄棕壤过氧化氢酶、脱氢酶、脲酶、碱性磷酸酶、转化酶的生态毒理效应.结果表明,土壤Se对脱氢酶、碱性磷酸酶、转化酶有“抗性酶活性”现象.土壤Se对土壤过氧化氢酶和脲酶活性有抑制作用,脲酶受Se的抑制作用最强.土壤Se含量与脲酶抑制率之间具有显著相关性,脲酶抑制率可作为Se生态风险评价的一项生物指示物.

Actinomycetes and earthy-musty odorous compounds in brackish fishponds in Tianjin, China

The presence of the odorous compounds, 2-methylisoborneol (MIB) and geosmin, as well as causative microorganisms in brackish intensive cultivation fishponds in Tianjin, China that had a severe earthy-musty odor were evaluated. The results revealed that MIB was the primary odorous compound present in the Tianjin fishponds, with a concentration ranging from 0.53-5302.7 ng.L-1. Furthermore, the concentration of MIB was found to be closely correlated with the gross biomass of actinomycetes in the water, which ranged from 10.67-1528.24 x 10(6) cfu.ml(-1). Therefore, the sequences of the 16 SrRNA and morphological characteristics of the actinomycetes in the brackish fishponds were investigated. The results revealed that the actinomycetes in the brackish fishponds included 9 species of common and dominant actinomycetes belonging to 4 genera. Of these genera, Streptomyces were the dominant species, and Streptomyces, Nocardioides and Micromonospora were the most common species in the fishponds evaluated. Next, the ability of each of the isolated Streptomyces to produce MIB was measured under laboratory culture conditions. Streptomyces Sp2 was found to have a strong ability to produce MIB, which indicates that this strain may be the primary source of the earthy-musty odor reported in brackish intensive cultivation fishponds in Tianjin, China.

New type of multimode-interference-type thermo-optic variable optical attenuator

A thermo-optic variable optical attenuator (VOA) based on a Mach-Zehnder interferometer and multimode-interference coupler is fabricated. Not a single-mode but a multimode waveguide is used as the input and output structures of the optical field, which greatly reduces the coupling loss of the VOA with a normal single-mode fiber. The insertion loss of the fabricated VOA is 2.52 to 2.82 dB at the wavelength of 1520 to 1570 nm. The polarization dependent loss is 0.28 to 0.45 dB at the same wavelength range. Its maximum attenuation range is up to 26.3 dB when its power consumption is 369 mW. The response frequency of the fabricated VOA is about 10 kHz. (C) 2004 Society of Photo-Optical Instrumentation Engineers.

Effect of rapid thermal annealing and hydrogen plasma treatment on the microstructure and light-emission of silicon-rich oxide film

Silicon-rich silicon oxide (SRSO) films are prepared by plasma-enhanced chemical vapor deposition method at the substrate temperature of 200degreesC. The effect of rapid thermal annealing and hydrogen plasma treatment on tire microstructure and light-emission of SRSO films are investigated in detail using micro-Raman spectroscopy, Fourier transform infrared (FTIR) spectroscopy and photoluminescence (PL) spectra. It is found that the phase-separation degree of the films decreases with increasing annealing temperature from 300 to 600degreesC, while it increases with increasing annealing temperature from 600 to 900degreesC. The light-emission of the films are enhanced with increasing annealing temperature up to 500degreesC, while it is rapidly reduced when the annealing temperature exceeds 600degreesC. The peak position of the PL spectrum blueshifts by annealing at the temperature of 300degreesC, then it red-shifts with further raising annealing temperature. The following hydrogen plasma treatment results in a disproportionate increase of the PL intensity and a blueshift or redshift of the peak positions, depending on the pristine annealing temperature. It is thought that the size of amorphous silicon clusters, surface structure of the clusters and the distribution of hydrogen in the films can be changed during the annealing procedure. The results indicate that not only cluster size but also surface state of the clusters plays an important role in the determination of electronic structure of the amorphous silicon cluster and recombination process of light-generated carriers.

A Smart Frequency Presetting Technique for Fast Lock-in LC-PLL Frequency Synthesizer

This paper proposes a smart frequency presetting technique for fast lock-in LC-PLL frequency synthesizer. The technique accurately presets the frequency of VCO with small initial frequency error and greatly reduces the lock-in time. It can automatically compensate preset frequency variation with process and temperature. A 2.4GHz synthesizer with 1MHz reference input was implemented in 0.35 mu m CMOS process. The chip core area is 0.4mm(2). Output frequency of VCO ranges from 2390 to 2600MHz. The measured results show that the typical lock-in time is 3 mu s. The phase noise is -112dBc/Hz at 600KHz offset from center frequency. The test chip consumes current of 22mA that includes the consumption of the I/O buffers.