Molecular dynamics studies on the local disordering of σ3 and σ11 grain boundaries in aluminium bicrystal

Molecular dynamics (MD) simulations using Morse interaction potential are performed in studies of [110] symmetrical tilt grain boundary (GB) structures with mis-orientation angles 50.5 degrees(Sigma 11), 129.5 degrees(Sigma 11), 70.5 degrees(Sigma 3) and 109.5 degrees(Sigma 3) at various tempratures. The GB structures are found to start local disordering at about 0.5T(m)(T-m is the melting point of aluminium) for 50.5 degrees(Sigma 11), 0.32T(m) for 129.5 degrees(Sigma 11) and 0.38T(m) for 70.5 degrees(Sigma 3), respectively. These results agree with conclusions deduced from the anelastic measurements. But, for twin-boundary structure 109.5 degrees(Sigma 3), this disordering has not been found even when temperature increases up to 0.9T(m).

Intense room temperature near infrared emission from Al (3+) and Yb3+ ions

Intense near infrared emission was observed from Al3+ and Yb3+ ions co-implanted SiO2 film on silicon. It was found that the addition of Al3+ ions could remarkably improve the photoluminescence efficiency of Yb3+-implanted SiO2 film. No excitation power saturation was observed and trivial temperature quenching factor of 2 was achieved.

delta C-13 variation of C-3 and C-4 plants across an Asian monsoon rainfall gradient in arid northwestern China

IEECAS SKLLQG

Two-electron-one-photon M1 and E2 transitions between the states of the 2p(3) and 2s(2)2p odd configurations for B-like ions with 18 <= Z <= 92

Two-electron-one-photon (TEOP) M1 and E2 transition energies, line strengths and transition probabilities between the states of the 2p(3) and 2s(2)2p odd configurations for B-like ions with 18 <= Z <= 92 have been calculated using the GRASP2K package based on the multiconfiguration Dirac-Hartree-Fock (MCDHF) method. Employing active-space techniques to expand the configuration list, we have systematically considered the valence, core-valence and core-core electron correlation effects. Breit interaction and quantum electrodynamical (QED) effects were also included to correct atomic state wavefunctions and the corresponding energies. Influences of electron correlation, Breit interaction and QED effects on transition energies and line strengths of the TEOP M1 and E2 transitions were analysed in detail. The present results were also compared with other theoretical and experimental values.

Microstructures and mechanical properties of the Mg-4.5Zn-xGd (x = 0, 2, 3 and 5) alloys

Microstructures and mechanical properties of the peak-aged Mg-4.5Zn-xGd (x = 0, 2, 3 and 5 wt.%) alloys have been investigated. The results showed that grain size increased with increasing Gd. Phase analysis showed that MgZn2 phase was observed in the Mg-4.5Zn alloy. While with Gd additions, Mg3Gd and Mg3Gd2Zn3 phases formed, and the volume fraction of the Mg3Gd2Zn3 phase increased with increasing Gd. Tensile test results indicated that the optimal mechanical properties were obtained in the Mg-4.5Zn-2Gd alloy, and the ultimate tensile strength and yield strength were 215 MPa and 121 MPa, respectively.

Controllable Synthesis and Luminescence Properties of La(OH)(3) and La(OH)(3):Tb3+ Nanocrystals with Multiform Morphologies

One-dimensional La(OH)(3) nanocrystals with multiform morphologies have been successfully synthesized by a facile bydrothermal process without using any surfactant, catalyst, or template. It can be found that the pH values of the initial solutions and the alkaline sources play a crucial role in controlling the morphologies of the products. The possible formation process of the 1D samples was investigated in detail, Furthermore, the as-prepared Tb3+-doped La(OH)(3) samples show a strong green emission corresponding to D-5(4)-F-7(5) transition of the Tb3+ ions under ultraviolet or low-voltage excitation.

Uniform Ln(OH)(3) and Ln(2)O(3) (Ln = Eu, Sm) Submicrospindles: Facile Synthesis and Characterization

Monodisperse hexagonal Ln(OH)(3) (Ln = Eu, Sm) submicrospindles with uniform morphology and size have been Successfully synthesized in a large scale via a Facile aqueous solution route from the mixture of aqueous solutions or LnCl(3) and NaOH at 5 degrees C without using any surfactant or template. The as-synthesized products are characterized by X-ray diffraction (XRD), thermogravimetric analysis (TGA), energy-dispersive X-ray (EDX) spectra, scanning electron microscopy (SEM), transmission electron microscopy (TEM), and high-resolution transmission electron microscopy (HRTEM). The SEM and TEM images show that the as-formed Ln(OH)(3) samples have a spindlelike shape with an equatorial diameter of 80-200 nm and a length of 500-900 nm, which are aggregates of even smaller nanoparticles.

Highly Uniform Gd(OH)(3) and Gd2O3:Eu3+ Nanotubes: Facile Synthesis and Luminescence Properties

Uniform Gd(OH)(3) nanotubes have been prepared via a simple wet-chemical route at ambient pressure and low temperature, without any catalysts, templates, or substrates, in which Gd(NO3)(3) was used as the gallium source and ammonia as the alkali. SEM and TEM images indicate that the as-obtained Gd(OH)3 entirely consists of uniform nanotubes in high yield with diameters of about 40 nm and lengths of 200-300 nm. The temperature-dependent morphological evolution and the formation mechanism of the Gd(OH)(3) nanotubes were investigated in detail. Furthermore, the Gd2O3 and Eu3+-doped Gd2O3 nanotubes, which inherit their parents' morphology, were obtained during a direct annealing process in air. The corresponding Gd2O3:Eu3+ nanotubes exhibit the strong red emission corresponding to the D-5(0)-F-7(2), transition of the Eu3+ ions under UV light or low-voltage electron beam excitation, which might find potential applications in the fields such as light-emitting phosphors, advanced flat panel displays, or biological labeling.

In(OH)(3) and In2O3 nanorod bundles and spheres: Microemulsion-mediated hydrothermal synthesis and luminescence properties

Indium hydroxide, In(OH)(3), nano-microstructures with two kinds of morphology, nanorod bundles (around 500 nm in length and 200 nm in diameter) and caddice spherelike agglomerates (around 750 - 1000 nm in diameter), were successfully prepared by the cetyltrimethylammonium bromide (CTAB)/water/cyclohexane/n-pentanol microemulsion-mediated hydrothermal process. Calcination of the In(OH)(3) crystals with different morphologies (nanorod bundles and spheres) at 600 degrees C in air yielded In2O3 crystals with the same morphology. X-ray diffraction, scanning electron microscopy, transmission electron microscopy, and photoluminescence (PL) spectra as well as kinetic decays were used to characterize the samples. The pH values of microemulsion play an important role in the morphological control of the as-formed In(OH)(3) nano-microstructures from the hydrothermal process. The formation mechanisms for the In( OH) 3 nano- microstructures have been proposed on an aggregation mechanism. In2O3 nanorod bundles and spheres show a similar blue emission peaking around 416 and 439 nm under the 383-nm UV excitation, which is mainly attributed to the oxygen vacancies in the In2O3 nano-microstructures.

Synthesis and characterization of tris(cyclopentylcyclopentadienyl)lanthanide complexes (C5H9C5H4)(3)NdBrLi(THF)(3) and (C5H9C5H4)(3)SmTHF

(C5H9C5H4)(3)NdBrLi(THF)(4)(1)(C5H9=cyclopentyl) was obtained from the reaction of NdCl3 with C5H9C5H4Na and LiBr (Nd:Na:Li=1:2:1 molar ratio) in THE X-ray crystallography showed that the ten-coordinated neodymium atom is bonded to three cyclopentylcyclopentadienyl(eta(5)) rings and a single bromine atom bridging a lithium which is bonded to three THF molecules. Complex 1 is triclinic, P1 space group with unit dimensions of a= 12.048(2), b= 13.498(3), c= 13.831(3)Angstrom, a = 104.16(3), beta = 104.07(3), gamma =95.96(3)degrees, V=2083.3(7)Angstrom(3), Z=2, D-c=1.35Mg/m(3) and F(000)=874. (C5H9C5H4)(3)SmTHF (2) was synthesized by reaction of anhydrous SmCl3 with C5H9C5H4Na at a molar ratio of 1:3. The structure was determined by X-ray crystallography. The ten-coordinated samarium atom is bonded to three cycloperrtylcyclopentadienyl rings and one oxygen of THF molecule to form a pseudo-tetrahedron. Complex 2 is orthorhombic, Fdd2 space group with unit cell dimensions of a =28.175(5)Angstrom, b =46.24(2) Angstrom, c =9.167(4) Angstrom(3), V=11943(8)Angstrom(3), Z= 16, D-c = 1.38Mg/m(3) and F(000)=5136.

Metal ion and anion coordination in the thiamine-[Pt-II(NO2)(4)](2-) system. Structures of a metal complex, Pt(thiamine)(NO2)(3), and two salts, (H-thiamine)[Pt(NO2)(4)]center dot 2H(2)O and (thiamine monophosphate)(2)[Pt(NO2)(4)]center dot 2H(2)O

Reaction of thiamine or thiamine monophosphate (TMP) with K2Pt(NO2)(4) afforded a metal complex, Pt(thiamine)(NO2)(3) (1), and two salt-type compounds, (H-thiamine)[Pt(NO2)(4)]. 2H(2)O (2) and (TMP)(2)[Pt(NO2)(4)]. 2H(2)O (3), which were structurally characterized by X-ray diffraction. In 1, the square-planar Pt2+ ion is coordinated to the pyrimidine N(1'), a usual metal-binding site, and three NO2- groups. The thiamine molecule exists as a monovalent cation in 1 and a divalent cation in 2 while the TMP molecule is a monovalent cation in 3. In each compound, thiamine or TMP adopts the usual F conformation and forms two types of host-guest-like interactions with anions, which are of the bridging forms, C(2)-H . . . anion . . . pyrimidine-ring and N(4'1)-H(...)anion(...)thiazolium-ring. In 3, there is an additional anion-bridging interaction between the pyrimidine and thiazolium rings of TMP, being of the form C(6')-H . . . anion . . . thiazolium-ring. The salts 2 and 3 show similar hydrogen-bonded cyclic dimers of thiamine or TMP between which the anions are held. Results are compared with those of the other thiamine-platinum complexes. (C) 2001 Elsevier Science B.V. All rights reserved.

Partial oxidation of methane to syngas over Pt/A(2)O(3) and Pt/CeO2/Al2O3

The catalytic oxidation of methane to syngas has been carried out over Pt/Al2O3 and Pt/CeO2/Al2O3. It was found that the catalysts with ceria exhibit a higher activity and selectivity than those without ceria. The catalysts were characterized by means of TPR, TPD, SEM-EDX and XRD. There is a strong interaction between ceria and platinum under the reaction condition, which increase the dispersion of platinum over catalysts, preventing the sinter of the Pt particles. As a result of the synergistic;effect between Pt and ceria, the activity of Pt/Al2O3 for combustion reaction was suppressed, the activity and selectivity :For partial oxidation were improved greatly. Another role of ceria in the catalyst is the enhancing of the WGSR, which leads to the increase of the selectivity of catalyst for hydrogen and accelerating the equilibrium of the reaction.