WEFTA interlaboratory comparison on nitrogen determination by Kjeldahl digestion in fishery products and standard substances

14 Laboratorien aus 12 europäischen Ländern nahmen an einer Laborvergleichsuntersuchung zur Stickstoffbestimmung in Fischerzeugnissen und Standardsubstanzen nach Kjeldahl teil. 13 Laboratorien erzielten dabei Ergebnisse, die alle in engen Grenzen um die gefundenen Mittelwerte streuten. Der von den einzelnen Teilnehmern erzielte Variationskoeffizient war mit etwa 0,5 % gering. Auch die Standardsubstanzen mit bekanntem Stickstoffgehalt konnten überwiegend mit hinreichender Genauigkeit (98 % der vom Hertsteller angegebenen Gehalte) analysiert werden. Der ideale Kjeldahlaufschluß ist durch kurze Aufschlußzeiten (ca. 120 min), eine Aufschlußtemperatur bei 430° C und durch die Wahl des für die jeweilige Matrix geeigneten Katalysators gekennzeichnet.

Aspects of the washout of salmonid eggs. 4. Effects of a standard mechanical shock, applied at different stage of development, upon survival and development of eggs of brown trout (Salmo trutta L.)

It is generally accepted by fish culturists that salmonid eggs are sensitive to mechanical shock and that the sensitivity varies with the stage of development of the eggs. In general, the period of greatest sensitivity is thought to occur between fertilization and ”eyeing”. However, it is reasonable to expect that, during a period (perhaps of several hours) following fertilization, sensitivity will be low because in nature during this period the eggs may be subject to some mechanical shock caused by the parent fish covering them with gravel. In 1983-4 and 1984-5 experiments were performed on brown trout (Salmo trutta L.) eggs to examine the effect of a standard mechanical shock (c. 2,500 eggs in 1983-4 and c. 8,400 eggs in 1984-5) at various stages of development upon survival to hatching and time of hatching.The results of these experiments are reported in this study.

Standard and routine metabolic rates of juvenile sandbar sharks (Carcharhinus plumbeus), including the effects of body mass and acute temperature change*

Standard and routine metabolic rates (SMRs and RMRs, respectively) of juvenile sandbar sharks (Carcharhinus plumbeus) were measured over a range of body sizes (n=34) and temperatures normally associated with western Atlantic coastal nursery areas. The mean SMR Q10 (increase in metabolic rate with temperature) was 2.9 ±0.2. Heart rate decreased with increasing body mass but increased with temperature at a Q10 of 1.8−2.2. Self-paired measures of SMR and RMR were obtained for 15 individuals. Routine metabolic rate averaged 1.8 ±0.1 times the SMR and was not correlated with body mass. Assuming the maximum metabolic rate of sandbar sharks is 1.8−2.75 times the SMR (as is observed in other elasmobranch species), sandbar sharks are using between 34% and 100% of their metabolic scope just to sustain their routine continuous activity. This limitation may help to explain their slow individual and population growth rates, as well as the slow recoveries from overfishing of many shark stocks worl

Analyzing standard curves in the chemistry of waters used for aquaculture

A practical guide is given to help aquaculture researchers identify and correct common problems associated with the colorimetric analysis of water. Hints in making standard solutions, choosing standard concentrations for making a standard curve and making measurements are included. Various types of standard curves and some problems are outlined and details provided regarding the evaluation of standard curves.

A standard format for design and evaluation of pond experiments

Details are given of a standard format used by the Pond Dynamics/Aquaculture Collaborative Research Support Program of the US Agency for International Development for the communication of experimental ideas. An example is given of the "Preliminary Proposal Format," which contains a list of information categories or headings as follows: Title; Objectives: Significance; Experimental design; Pond facilities; Stocking rate; Other inputs; Sampling plan; Hypotheses; Statistical methods; Duration; Water management; and Schedule.

Comparison of Standard Length, Fork Length, and Total Length for Measuring West Coast Marine Fishes

Measurements of adult marine fishes on the U.S. west coast are usually made using one of three methods: standard length, fork length, or total length. Each method has advantages and disadvantages. In this paper we attempt to determine whether one method is faster and/or more reliable than the other methods. We found that all three methods were comparable. There was no appreciable difference in the time it took to measure fish using the different methods. Fork length had the most reproducible results; however, it had the highest level of bias between researchers. We therefore suggest that selection of measurement type be based on what other researchers have used for the species under study. The best improvement in measurement reliability probably occurs by adequate training of personnel and not type of measurement used.

The early life history of swordfish (Xiphias gladius) in the western North Atlantic

Lengths and ages of sword-fish (Xiphias gladius) estimated from increments on otoliths of larvae collected in the Caribbean Sea, Florida Straits, and off the southeastern United States, indicated two growth phases. Larvae complete yolk and oil globule absorption 5 to 6 days after hatching (DAH). Larvae <13 mm preserved standard length (PSL) grow slowly (~0.3 mm/d); larvae from 13 to 115 mm PSL grow rapidly (~6 mm/d). The acceleration in growth rate at 13 days follows an abrupt (within 3 days) change in diet, and in jaw and alimentary canal structure. The diet of swordfish larvae is limited. Larvae <8 mm PSL from the Caribbean, Gulf of Mexico, and off the southeastern United States eat exclusively copepods, primarily of one genus, Corycaeus. Larvae 9 to 11 mm eat copepods and chaetognaths; larvae >11 mm eat exclusively neustonic fish larvae. This diet indicates that young larvae <11 mm occupy the near-surface pelagia, whereas, older and longer larvae are neustonic. Spawning dates for larvae collected in various regions of the western North Atlantic, along with the abundance and spatial distribution of the youngest larvae, indicate that spawning peaks in three seasons and in five regions. Swordfish spawn in the Caribbean Sea, or possibly to the east, in winter, and in the western Gulf of Mexico in spring. Elsewhere swordfish spawn year-round, but spawning peaks in the spring in the north-central Gulf of Mexico, in the summer off southern Florida, and in the spring and early summer off the southeastern United States. The western Gulf Stream frontal zone is the focus of spawning off the southeastern coast of the United States, whereas spawning in the Gulf of Mexico seems to be focused in the vicinity of the Gulf Loop Current. Larvae may use the Gulf of Mexico and the outer continental shelf off the east coast of the United States as nursery areas. Some larvae may be transported northward, but trans-Atlantic transport of larvae is unlikely.

Sequential analysis for testing quality standard of fish ham and sausage

Fish sausages are finely ground fish flesh, either of a single species or mixed, homogenised with starch, sugar, fat, spices and preservatives, generally filled in cylindrical synthetic or natural casings and pasteurised. Similar products containing small pieces of quality fish and lard are termed "fish ham". They are highly relished products in Japan, annual consumption exceeding 2 lakh tones. Preliminary studies have shown that they can catch a lucrative market in our country. However, being a pasteurised product which is often consumed as such without any further cooking, strict quality control measures have to be enforced so as to avoid food poisoning hazards. Besides physical characteristics like absence of damages, pin-holes, curliness and air pockets as well as jelly strength, texture and flavour, chemical characteristics like pH and acid values, moisture, carbohydrate and fat contents and volatile bases have to be assessed. A very important test that has to be carried out along with the above, before passing a lot for free distribution is the bacteriological examination to avoid the presence of pathogenic organisms.

Import substitution of combination wire rope. Part 3: Comparison of standard Cift-CWR and imported combination wire rope

Tensile and extension properties of standard Cift-CWR and imported combination wire ropes from Japan, Norway and Denmark are studied and the analysis is presented in the paper. Tensile and chemical properties of steel wire, tensile and abrasive properties of PP covering, effect of twist on material at different stages are worked out and reported.