Trawling pull exerted by a trawler: a method of estimation from propeller dimensions and its comparison with sea measurements

The proper matching of the pull exerted by a trawler and the size of trawl is important for maximizing the catching efficiency. The available pull is more dependent on the propeller and its working conditions than the installed engine power. The normal practice is to directly connect net size to the installed power in the boat by formulae without reference to the prope1ler dimensions or the available trawling pull and this is not adequate to find out the optimum combination. By the method outlined in this paper, the accurate calculation of trawling pull is possible by taking into account only the propeller diameter, pitch and r. p. m. The predictions by the method are compared for trawlers with powers between 30 and 60 hp and agreement is found to be within + 5%. The power absorbed by the propeller in trawling condition can also be calculated by this method for checking whether the engine is being overloaded.

On a method of determination of chlorophyll in cells of algae collected on a membrane filter. [Translation from: Trudy Instituta Biologii Vnutrennykh Vodnany 11(14), 198-202, 1966.]

The original method, proposed by Yentsch (1957), of determination of chlorophyll directly in the cells, attracts attention by its simplicity. In order to measure the content of chlorophyll by this method, a determined volume of suspension of algae is filtered through a membrane filter. The latter is dried a little, clarified by immersion oil, clamped between two glasses, and spectrophotometrized. Extinction is read off at , wavelengths equal to 670 millimicrons (around the maximum absorption of chlorophyll a in the cell) and 750 millimicrons (correction for non- specific absorption and dispersion of light by particles of the preparation). The method of Yentsch was employed by the authors for determination of chlorophyll-a in samples of phytoplankton. They conclude that in spite of the simplicity and convenience of determination the method must be applied sufficiently carefully. It is more suitable for analysis of cultures of algae, where, non-specific absorption of light is insignificant.

Radioautographic method of determination of number of bacteria in water-bodies [Translation from: Informatsionnyi Byulleten Biologiya Vnutrennikh Vod No.26, 65-67, 1975]

The radioautographic method of determination of the number of autotrophic microorganisms was initially suggested for counting methane-oxidizing bacteria. With the help of this method colonies of hydrogen-oxidizing bacteria are differentiated even more clearly from heterotrophic. Under laboratory conditions it was shown that colonies grown on membrane filters from a pure culture of thionic bacteria on a nutrient medium with radio- active carbonate, give better prints on film. This method was tested by the authors for determining the number of these bacteria in the meromictic Lake Vae de San Juan during the expedition to Cuba in the summer of 1973. The study showed that that the thionic bacteria are found throughout the pelagial. It proved that the thionic bacteria can be well considered in water-bodies by the radioautographic method.

An accelerated method of hot air drying of fish

The effects of temperature and relative humidity on the rate of drying of split open fish and salted fish in a tunnel dryer have been studied at a constant air velocity. By a judicious combination of these two, the rate of drying could be considerably accelerated, 10 to 12 hours only being required for drying to moisture levels below 30% in the case of mackerel, lactarius, otolithes and kilimeen (Nemipterus japonicus)

A simple method of tagging prawns

The recognition of individual animals is crucial to many aspects of research. Prawns (Penaeus monodon) present unique difficulties in this respect since they molt regularly. Thus, almost all tagging and marking methods developed for prawns so far have proven inadequate. Some tags or marks are lost during molting; others cause injury to the prawns. A new and efficient method has been developed at the Igang Seafarming Station of the Aquaculture Department. Rectangular brass tags measuring 5 mm by 20 mm and numbered consecutively are used. The prawn is held gently but firmly at the base of the carapace with the left hand while the right hand slips the brass tag around the stalk of the unablated eye and presses the tag gently. All tagging must be made under water to avoid stress. From May 29 to September 7 1977 to a total of 348 unilaterally-ablated adult female prawns were tagged on the unablated eyestalk in 5 batches to enable individual observations on gonadal maturation, molting, and growth. Periodic examinations were made four times a month to coincide with the different phases of the lunar cycle. On each examination, survival and recovery rates were recorded. The data included death due to immediate mortality during ablation and loss to cannibalism for the duration of the experiments. In all five tagging experiments, most of the prawns recovered had their tags intact. These included even dead and molting animals. The eyestalk tagging method is suitable for prawns because the tags can be attached without causing injury and has no effect on the rate of growth, maturity, molting and behavior of the animal. The tags are identifiable and permanent; they remain attached to the animal even after death.

A method of immersion of panels for ecological studies on marine fouling and boring organisms

The importance of studies on the biology of marine foulers and borers needs no emphasis since they cause damage to submerged wooden structures resulting in considerable economic loss. In order to study their occurrence, settlement and to assess the rate of destruction to timber, several immersion techniques using iron racks, cages and rafts have been adopted. On the east and west coasts of India, at the Marine Centres of Forest Research Institute (Waltair, Madras, Cohin and Bombay) investigations have so far been carried out employing the first two methods.

A Method for siting and prioritizing the removal of derelict vessels in Florida Coastal Waters: test applications in the Florida Keys

Increased boating activities and new waterfront developments have contributed an estimated 3,000 dismantled, abandoned, junked, wrecked, derelict vessels to Florida coastal waters. This report outlines a method of siting and prioritizing derelict vessel removal using the Florida Keys as a test area. The data base was information on 240 vessels, obtained from Florida Marine Patrol files. Vessel location was plotted on 1:250,000 regional and 1:5,000 and 1:12,000 site maps. Type of vessel, length, hull material, engine, fuel tanks, overall condition, afloat and submerged characteristics, and accessibility, were used to derive parametric site indices of removal priority and removal difficulty. Results indicate 59 top priority cases which should be the focus of immediate clean up efforts in the Florida Keys. Half of these cases are rated low to moderate in removal difficulty; the remainder are difficult to remove. Removal difficulty is a surrogate for removal cost: low difficulty -low cost, high difficulty - high cost. The rating scheme offers coastal planners options of focusing removal operations either on (1) specific areas with clusters of high priority derelict vessels or on (2) selected targeted derelicts at various, specific locations. (PDF has 59 pages.)

The distribution of Corixidae in relation to the water quality of British lakes: A monitoring model

This article is an attempt to devise a method of using certain species of Corixidae as a basis for the assessment of general water quality in lakes. An empirical graphical representation of the distribution of populations or communities of Corixidae in relation to conductivity, based mainly on English and Welsh lakes, is used as a predictive monitoring model to establish the "expected" normal community at a given conductivity, representing the total ionic concentration of the water body. A test sample from another lake of known conductivity is then compared with "expected" community. The "goodness of fit" is examined visually or by calculation of indices of similarity based on the relative proportions of the constituent species of each community. A computer programme has been devised for this purpose.

The influence of blue-green algae on development of the zooplankton. [Translation of: Byull.mosk.Obshch.Ispyt.Prir.(Biol.) 67, 128-131, 1962]

Many have observed the reduction of the quantity of zooplankton in the presence of water blooms. It is known that in seas zooplankton as it were avoids places of accumulation of blue-green algae. By observations on one of the tributaries of the Rybinsk reservoir - the River Shumorovka - the authors tried by simultaneous collections to trace the changes in numbers, not only of zoo- and phytoplankton but also of bacteria. The plankton was collected by quantitative nets with suitable numbers of gauze and bacteria were taken account of by the method of direct calculation on membrane filters. It can be seen that the development of blue-green algae appears as an important factor, determining not only the intensity but also the direction of the process of production of zooplankton.