Influence of an upstream building on the wind-induced mean suction on the flat roof of a low-rise building

The effect of an upstream building on the suction forces on the flat roof of a low-rise building placed in the wake of the former is analyzed. The analysis has been performed by wind tunnel testing of a flat roof, low-rise building model equipped with pressure taps on the roof and different block-type buildings (only configurations where the upstream building is as high or higher than the downstream one are considered in this paper). The influence of the distance between both buildings on the wind loads on the downstream building roof is analyzed, as well as the height of the upstream one and the wind angle of incidence. Experimental results reveal that the wind load increases as the relative height of the upstream building increases, the wind load being highest for intermediate distances between buildings, when a passage between them is formed.

An Online Course on the History of Algorithms.

This paper describes the objectives, content, learning methodology and results of an online course on the History of Algorithms for engineering students at Polytechnic University of Madrid (UPM). This course is conducted in a virtual environment based on Moodle, with a student-centred educational model which includes a detailed planning of learning activities. Our experience indicates that this subject is highly motivating for students and the virtual environment facilitates competencies development

Effects of diet and exercise on metabolic syndrome and the underlying factors = Efectos de la dieta y el ejercicio sobre el síndrome metabólico y sus factores

Introducción. El número de personas que padecen síndrome metabólico ha incrementado a nivel mundial durante las últimas dos décadas. Existen numerosos estudios que tratan de comparar prevalencias según los diferentes criterios y estimaciones del riesgo metabólico. De ellos se puede concluir que el principal hallazgo ha sido recalcar la necesidad de una definición estándar universal. A pesar de estas discrepancias no hay lugar a duda sobre el problema de salud pública que esto conlleva. Se necesitan medidas y estrategias urgentes para prevenir y controlar esta emergente epidemia global y para ello se debe prestar especial atención a los cambios en el estilo de vida, fundamentalmente dieta y ejercicio. A pesar de todo, existe a día de hoy una importante controversia sobre el tipo de ejercicio más efectivo y su combinación con la dieta para conseguir mejoras en la salud. Objetivos. Estudiar los índices de riesgo metabólico empleados en la literatura científica y las terapias basadas en dieta y ejercicio para el tratamiento de los factores del síndrome metabólico en adultos con sobrepeso. Diseño de investigación. Los datos empleados en el análisis de esta tesis son, primeramente un estudio piloto, y posteriormente parte del estudio “Programas de Nutrición y Actividad Física para el tratamiento de la obesidad” (PRONAF). El estudio PRONAF es un proyecto consistente en un estudio clínico sobre programas de nutrición y actividad física para el sobrepeso y la obesidad, desarrollado en España durante varios años de intervenciones. Fue diseñado, en parte, para tratar de comparar protocolos de entrenamiento de resistencia, cargas y combinado en igualdad de volumen e intensidad, con el objetivo de evaluar su impacto en los factores de riesgo y la prevalencia del síndrome metabólico en personas con sobrepeso y obesidad. El diseño experimental es un control aleatorio y el protocolo incluye 3 modos de ejercicio (entrenamiento de resistencia, con cargas y combinado) y restricción dietética sobre diversas variables determinantes del estado de salud. Las principales variables para la investigación que comprende esta tesis fueron: actividad física habitual, marcadores de grasa corporal, niveles de insulina, glucosa, triglicéridos, colesterol total, colesterol HDL, colesterol LDL, presión arterial y parámetros relacionados con el ejercicio. Conclusiones. A) Los índices de riesgo metabólico estudiados presentan resultados contradictorios en relación al riesgo metabólico en un individuo, dependiendo de los métodos matemáticos empleados para el cálculo y de las variables introducidas, tanto en mujeres sanas como en adultos en sobrepeso. B) El protocolo de entrenamiento combinado (de cargas y de resistencia) junto con la dieta equilibrada propuesto en este estudio fue la mejor estrategia para la mejora del riesgo de síndrome metabólico en adultos con sobrepeso. C) Los protocolos de entrenamiento supervisado de resistencia, con cargas y combinado junto con la restricción nutricional, no obtuvieron mejoras sobre el perfil lipídico, más allá de los cambios conseguidos con el protocolo de dieta y recomendaciones generales de actividad física habitual en clínica, en adultos con sobrepeso. Background. Over the past two decades, a striking increase in the number of people with the MetS worldwide has taken place. Many studies compare prevalences using different criteria and metabolic risk estimation formulas, and perhaps their main achievement is to reinforce the need for a standardized international definition. Although these discrepancies, there is no doubt it is a public health problem. There is urgent need for strategies to prevent and manage the emerging global epidemic, special consideration should be given to behavioral and lifestyle, mainly diet and exercise. However, there is still controversy about the most effective type of exercise and diet combination to achieve improvements. Objectives. To study the metabolic risk scores used in the literature and the diet and exercise therapies for the treatment of the MetS factors in overweight adults. Research design. The data used in the analysis was collected firstly in a pilot study and lately, as a part of the “Programas de Nutrición y Actividad física para el tratamiento de la obesidad” study (PRONAF). The PRONAF Study is a clinical research project in nutrition and physical activity programs for overweight and obesity, carried out in Spain (2008-2011). Was designed, in part, to attempt to match the volume and intensity of endurance, strength and combined training protocols in order to evaluate their impact on risk factors and MetS prevalence in overweight and obese people. The design and protocol included three exercise modes (endurance, strength and combined training) and diet restriction, in a randomized controlled trial concerning diverse health status variables. The main variables under investigation were habitual physical activity, markers of body fat, fasting serum levels of insulin, glucose, triglycerides, total, LDL and HDL cholesterol, blood pressure and diet and exercise parameters. Main outcomes. A) The metabolic risk scores studied presented contradictory results in relation to the metabolic risk of an individual, depending on the mathematical method used and the variables included, both in healthy women and overweight adults. B) The protocol proposed for combination of strength and endurance training combined with a balance diet was the optimal strategy for the improvement of MetS risk in overweight adults. C) The intervention program of endurance, strength or combined supervised training protocol with diet restriction did not achieved further improvements in lipid profile than a habitual clinical practice protocol including dietary advice and standard physical activity recommendations, in overweight adults.

Effectiveness for Ddtecting faults within and outside the scope of testing techniques: an independent replication

The verification and validation activity plays a fundamental role in improving software quality. Determining which the most effective techniques for carrying out this activity are has been an aspiration of experimental software engineering researchers for years. This paper reports a controlled experiment evaluating the effectiveness of two unit testing techniques (the functional testing technique known as equivalence partitioning (EP) and the control-flow structural testing technique known as branch testing (BT)). This experiment is a literal replication of Juristo et al. (2013).Both experiments serve the purpose of determining whether the effectiveness of BT and EP varies depending on whether or not the faults are visible for the technique (InScope or OutScope, respectively). We have used the materials, design and procedures of the original experiment, but in order to adapt the experiment to the context we have: (1) reduced the number of studied techniques from 3 to 2; (2) assigned subjects to experimental groups by means of stratified randomization to balance the influence of programming experience; (3) localized the experimental materials and (4) adapted the training duration. We ran the replication at the Escuela Politécnica del Ejército Sede Latacunga (ESPEL) as part of a software verification & validation course. The experimental subjects were 23 master?s degree students. EP is more effective than BT at detecting InScope faults. The session/program andgroup variables are found to have significant effects. BT is more effective than EP at detecting OutScope faults. The session/program and group variables have no effect in this case. The results of the replication and the original experiment are similar with respect to testing techniques. There are some inconsistencies with respect to the group factor. They can be explained by small sample effects. The results for the session/program factor are inconsistent for InScope faults.We believe that these differences are due to a combination of the fatigue effect and a technique x program interaction. Although we were able to reproduce the main effects, the changes to the design of the original experiment make it impossible to identify the causes of the discrepancies for sure. We believe that further replications closely resembling the original experiment should be conducted to improve our understanding of the phenomena under study.

Effectiveness for detecting faults within and outside the scope of testing techniques: an independent replication

The verification and validation activity plays a fundamental role in improving software quality. Determining which the most effective techniques for carrying out this activity are has been an aspiration of experimental software engineering researchers for years. This paper reports a controlled experiment evaluating the effectiveness of two unit testing techniques (the functional testing technique known as equivalence partitioning (EP) and the control-flow structural testing technique known as branch testing (BT)). This experiment is a literal replication of Juristo et al. (2013). Both experiments serve the purpose of determining whether the effectiveness of BT and EP varies depending on whether or not the faults are visible for the technique (InScope or OutScope, respectively). We have used the materials, design and procedures of the original experiment, but in order to adapt the experiment to the context we have: (1) reduced the number of studied techniques from 3 to 2; (2) assigned subjects to experimental groups by means of stratified randomization to balance the influence of programming experience; (3) localized the experimental materials and (4) adapted the training duration. We ran the replication at the Escuela Polite?cnica del Eje?rcito Sede Latacunga (ESPEL) as part of a software verification & validation course. The experimental subjects were 23 master?s degree students. EP is more effective than BT at detecting InScope faults. The session/program and group variables are found to have significant effects. BT is more effective than EP at detecting OutScope faults. The session/program and group variables have no effect in this case. The results of the replication and the original experiment are similar with respect to testing techniques. There are some inconsistencies with respect to the group factor. They can be explained by small sample effects. The results for the session/program factor are inconsistent for InScope faults. We believe that these differences are due to a combination of the fatigue effect and a technique x program interaction. Although we were able to reproduce the main effects, the changes to the design of the original experiment make it impossible to identify the causes of the discrepancies for sure. We believe that further replications closely resembling the original experiment should be conducted to improve our understanding of the phenomena under study.