Use of camera trapping in determining Iberian lynx population parameters: The use area and its limitations

Below are the results of the survey of the Iberian lynx obtained with camera-trapping between 2000 and 2007 in Sierra Morena. Two very important aspects of camera-trapping concerning its efficiency are also analyzed. The first is the evolution along years according to the camera-trapping type used of two efficiency indicators. The results obtained demonstrate that the most efficient lure is rabbit, though it is the less proven (92 trap-nights), followed by camera-trapping in the most frequent marking places (latrines). And, we propose as a novel the concept of use area as a spatial reference unit for the camera-trapping monitoring of non radio-marked animals is proposed, and its validity discussed.

Identifying Moderator Variables Through Requirements Elicitation Experiments Limitations

Interviews are the most widely used elicitation technique in Requirements Engineering (RE). Despite its importance, research in interviews is quite limited, in particular from an experimental perspective. We have performed a series of experiments exploring the relative effectiveness of structured and unstructured interviews. This line of research has been active in Information Systems in the past years, so that our experiments can be aggregated together with existing ones to obtain guidelines for practice. Experimental aggregation is a demanding task. It requires not only a large number of experiments, but also considering the influence of the existing moderators. However, in the current state of the practice in RE, those moderators are unknown. We believe that analyzing the threats to validity in interviewing experiments may give insight about how to improve further replications and the corresponding aggregations. It is likely that this strategy may be applied in other Software Engineering areas as well.

Plasmonic nanoparticles for the protection of the final optics in inertial confinement fusion facilities: capabilities and limitations

Final lenses in laser fusion plants. Challenges for the protection of the final lenses. Plasmonic nanoparticles. Radiation resistance

Physical characterization of growing media using standard methods (CEN)- Limitations of Applicability for pine bark and vermiculite

CEN standards have helped to harmonize analytical methods for substrate analysis.Though, for special substrates or constituents the applicability might be Iimited. In this paper a comparative study of implementation of CEN standards to samples of pine bark and vermiculite has been carried out. For composted pine bark, an elongation of the equilibrium period up to 72 instead of 48 hours might increase the accuracy of determinations physical parameters according to EN 13041. For vermiculite, we suggest pycnometry as a feasible technique for the determination of particle density (PD), as the determination of organic matter (OM) as requested by EN 13041 for the calculation of the PD seems not to be applicable for this kind of material.

Typological/Placement possibilities and limitations of ductile behavior of bridges in seismic areas

Consideraciones sobre la ductilidad en zonas sísmicas. This paper analyses the ductile behavior of a highway overpass located in a seismic zone. The paper presents the results of a pushover analysis that enables the design engineer to estimate the behavior of the bridge’s columns in two directions in an independent manner. The differences with the theoretical bilinear behavior are described and explained. Indications are given on the need and possibilities of taking advantage of ductility in different seismic events scenarios.

Environmental impact indicators estimation in European rural devlopment programs. Limitations of evaluators and financial institutions? Expectatios

The European Commission established Mid-term evaluation for the period 2007-2013 on Rural Development Programs as part of a continuous evaluation system. Mid-term evaluations are important for the Commission because they help measuring the success of a program, as well as giving advice and pointing out good practices for the current and consecutive programming periods. One of the main elements used to achieve these objectives is the impact indicators estimation of the program. This paper will focus on how impact indicators estimation is done for just the environmental indicators. To do this the 88 Mid-term evaluations of Rural Development Programs for 2007-2013 period, were analyzed. This study shows how far the actual methodologies to obtain impact indicators? values are from what the European Commission expects when demanding this task to be done.

Consideration of tip speed limitations in preliminary analysis of minimum COE wind turbines

A relation between Cost Of Energy, COE, maximum allowed tip speed, and rated wind speed, is obtained for wind turbines with a given goal rated power. The wind regime is characterised by the corresponding parameters of the probability density function of wind speed. The non-dimensional characteristics of the rotor: number of blades, the blade radial distributions of local solidity, twist angle, and airfoil type, play the role of parameters in the mentioned relation. The COE is estimated using a cost model commonly used by the designers. This cost model requires basic design data such as the rotor radius and the ratio between the hub height and the rotor radius. Certain design options, DO, related to the technology of the power plant, tower and blades are also required as inputs. The function obtained for the COE can be explored to �nd those values of rotor radius that give rise to minimum cost of energy for a given wind regime as the tip speed limitation changes. The analysis reveals that iso-COE lines evolve parallel to iso-radius lines for large values of limit tip speed but that this is not the case for small values of the tip speed limits. It is concluded that, as the tip speed limit decreases, the optimum decision for keeping minimum COE values can be: a) reducing the rotor radius for places with high weibull scale parameter or b) increasing the rotor radius for places with low weibull scale parameter

Heterojunction Band Offset Limitations on Open-Circuit Voltage in p-ZnTe/n-ZnSe Solar Cells

Limitations on the open-circuit voltage of p-ZnTe/n-ZnSe heterojunction solar cells are studied via current-voltage (I-V) measurements under solar concentration and at variable temperature. The open-circuit voltage reaches a maximum value of 1.95 V at 77 K and 199 suns. The open-circuit voltage shows good agreement with the calculated built-in potential of 2.00 V at 77 K. These results suggest that the open-circuit voltage is limited by heterojunction band offsets associated with the type-II heterojunction band lineup, rather than the bandgap energy of the ZnTe absorber material.