Determination of glutathione transferase (GSTT1-1) activities in different tissues based on formation of radioactive metabolites using 35S-glutathione

A new system has been developed to determine enzyme activities of glutathione transferase θ (GSTT1-1) based on radiometric product detection resulting from the enzymic reaction of methyl chloride with 35S-labelled glutathione. In principle, the method is universally applicable for determination of glutathione transferase activities towards a multiplicity of substrates. The method distinguishes between erythrocyte GSTT1-1 activities of human 'non-conjugators', 'low conjugators' and 'high conjugators'. Application to cytosol preparations of livers and kidneys of male and female Fischer 344 and B6C3F1 mice reveals differential GSTT1-1 activities in hepatic and renal tissues. These ought to be considered in species-specific modellings of organ toxicities of chlorinated hydrocarbons.

Piperidinium tetrathiotungstate as sulfur transfer reagent: synthesis of cyclic disulfides

Piperidinium tetrathiotungstate has been found to react with a number of 1,n-dihalo compounds to afford the corresponding cyclic disulfides in good yields, under mild reaction conditions. This new methodology has been used as a key step in the synthesis of (+/-)-lipoic acid (35) and asparagusic acid (37).

I. Electronic processes in α-sulfur. II. Polaron motion in a D.C. electric field

Part I: The mobilities of photo-generated electrons and holes in orthorhombic sulfur are determined by drift mobility techniques. At room temperature electron mobilities between 0.4 cm²/V-sec and 4.8 cm²/V-sec and hole mobilities of about 5.0 cm²/V-sec are reported. The temperature dependence of the electron mobility is attributed to a level of traps whose effective depth is about 0.12 eV. This value is further supported by both the voltage dependence of the space-charge-limited, D.C. photocurrents and the photocurrent versus photon energy measurements.

As the field is increased from 10 kV/cm to 30 kV/cm a second mechanism for electron transport becomes appreciable and eventually dominates. Evidence that this is due to impurity band conduction at an appreciably lower mobility (4.10^-4 cm²/V-sec) is presented. No low mobility hole current could be detected. When fields exceeding 30 kV/cm for electron transport and 35 kV/cm for hole transport are applied, avalanche phenomena are observed. The results obtained are consistent with recent energy gap studies in sulfur.

The theory of the transport of photo-generated carriers is modified to include the case of appreciable thermos-regeneration from the traps in one transit time.

Part II: An explicit formula for the electric field E necessary to accelerate an electron to a steady-state velocity v in a polarizable crystal at arbitrary temperature is determined via two methods utilizing Feynman Path Integrals. No approximation is made regarding the magnitude of the velocity or the strength of the field. However, the actual electron-lattice Coulombic interaction is approximated by a distribution of harmonic oscillator potentials. One may be able to find the “best possible” distribution of oscillators using a variational principle, but we have not been able to find the expected criterion. However, our result is relatively insensitive to the actual distribution of oscillators used, and our E-v relationship exhibits the physical behavior expected for the polaron. Threshold fields for ejecting the electron for the polaron state are calculated for several substances using numerical results for a simple oscillator distribution.

A new dinuclear molybdenum(V)-sulfur complex containing citrate ligand: synthesis and characterization of K2.5Na2NH4[Mo2O2S2(cit)(2)].5H(2)O

The complex, K2.5Na2NH4[Mo2O2S2(cit)(2)]. 5H(2)O (1), was obtained by crystallization from a solution of (NH4)(2)MoS4, potassium citrate (K(3)cit) and hydroxyl sodium in methanol and water under an atmosphere of pure nitrogen at ambient temperature. The crystals are triclinic, space group , a = 7.376 (3)Angstrom, b = 14.620 (2) Angstrom, c = 14.661 (1) Angstrom, alpha = 71.10 (1)degrees, beta = 81.77 (1)degrees, gamma = 78.27(2)degrees, R = 0.0584 for 2545 observed (I > 2 sigma (I)) reflections. Single crystal structure analysis reveals that citrate ligand coordinated to molybdenum atom through two carboxylato oxygens and one deprotonated hydroxyl oxygen together with two bridging sulfur atoms and a terminal oxygen atom completes distorted coordination octahedron around each molybdenum atom. Principal dimensions are: Mo = O-t, 1.707 Angstrom (av); Mo-S-b, 2.341 Angstrom (av); Mo-O-(hydroxyl), 2.021 Angstrom (av); Mo-O(alpha-carboxyl), 2.1290 Angstrom (av) and Mo-O(beta-carboxyl), 2.268(av) Angstrom. IR spectrum is in agreement with the structure.

Dry deposition and heavy acid loading in the vicinity of Masaya Volcano, a major sulfur and chlorine source in Nicaragua

info:eu-repo/semantics/published

The Determination of Total Hydrogen, Carbon, Nitrogen and Sulfur in Silicates, Silicate Rocks, Soils and Sediments

Determinations of the volatile elements carbon, hydrogen, sulfur and nitrogen in many geological RM, performed with the LECO CHN and SC analysers, are presented. The method allowed the determination of S in concentrations from a few % m/m to 0.001% m/m or less, of C from % m/m to 0.01% m/m and of H from % m/m to 0.004% m/m. Accuracy was usually better than the XRF method (for S). All obtained values passed the Sutarno-Steger test, which establishes that vertical bar(mean(analysed) - mean(certified))vertical bar/ S(certified) < 2, for the cases with an appropriate number of determinations (n > 10 for each element). It was possible to perform routine determination of C, H and S with the instrumentation, coupled with the determination of major and minor elements in geological materials. Determination of nitrogen could also be performed on an exploratory basis, with improvements in the method dependent on the future availability of more reference materials with reliable composition of this element.

Optical properties of polydisperse submicrometer aggregates of sulfur-containing zinc oxide consisting of spherical nanocrystallites

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The distribution of sulfur in oceanic crust with respect to oxidative diagenesis (Table 1)

A detailed geochemical-petrological examination of layer 2 basalts recovered during Leg 37 of the DSDP has revealed that the original distribution, form and abundance of igneous sulfide have been profoundly altered during low-grade oxidative diagenesis. The net result appears to have been a rather pervasive remobilization of igneous sulfide to form secondary pyrite accompanied by a bulk loss of sulfur equivalent to about 50-60% of the original igneous value, assuming initial saturation. It is suggested that during infiltration of seawater into the massive crystalline rock, igneous sulfide has experienced pervasive oxidation, under conditions of limited oxidation potential, to form a series of unstable, soluble sulfur species, primarily in the form of SO3[2-] and S2O3[2-]. Spontaneous decomposition of these intermediate compounds through disproportionation has resulted in partial reconstitution of the sulfur as secondary pyrite and the generation of SO4[2-] ion, which, due to its kinetic stability, has been lost from the basalt system and ultimately transferred to the ocean. This model not only satisfies the geochemical and petrological observations but also provides a suitable explanation for the highly variable delta34S values which characterize secondary sulfides in deep ocean floor basalts.

Description and chemical composition of manganese nodules sampled during the R/V "Vityaz" Expedition Vityaz-35

This paper presents data on the chemical composition of iron-manganese nodules and associated sediments collected during the 35th voyage of the R/V "Vityaz" in 1962. The samples were made available to the author by Prof, P. L. Bezrukov. Data on the general distribution of manganese nodules at the bottom of the Indian Ocean were already given by P. L. Bezrukov (1962, 1963). Here the author analyzed the geochemistry of nodules samples from seven stations and four samples from the associated sediments. The analysis separates the outer layer of nodules from their apparent internal core.

Contencentrations of reduced inorganic sulfur forms in Mediterranean Sea waters

The first data on content of inorganic reduced sulfur compounds [H2S, S°, S2O3(2-), SO3(2-)] were obtained at two stations in the northeastern Levant Sea (Mediterranean Basin). With lower detection limit for the mentioned sulfur forms of 30 nM, sulfide forms were not found, while thiosulfate concentration varied from 178 to 890 nM (from 24 to 78 % of total reduced S), and S° varied from 156 to 1090 nM. Vertical distribution of these compounds showed irregular character; correlation between total reduced S maxima, fluorescence, and increase of nutrient element content near the lower pycnocline boundary was observed. The maximum total sulfur concentration in the surface layer was likely due an anthropogenic influence. The ''starting'' mechanism that controls appearance and distribution of sulfur compounds in oxygen-containing water is the process of bacterial sulfate reduction in micropatches of fresh organic detritus. Reduced sulfur forms participate further in a series of chemical and biochemical processes. Contribution of hydrolysis of organic sulfur-containing compounds is insignificant for the region in study.

Sulfur speciation and isotopic composition in waters and sediments from river and seawater mixing zones

Studies of sulfur behavior in the water column and in sediments in river and seawater mixing zone were conducted in three areas of the Black and Azov Seas. These investigations showed constancy of sulfate concentrations versus chlorinity. Sulfur isotope composition in sulfates of surface, bottom, and pore waters depended on sulfate contents and salinity. The dependence was complicated by partial sulfate depletion in pore water due to bacterial sulfate reduction and also by alteration of isotope composition. Surface sediments in mixing zones are characterized by intensive sulfate reduction, great variability of content and isotopic composition of reduced sulfur, and a low mean isotopic fractionation factor of sulfur.

Isotope composition of sulfur, oxygen and carbon in Black Sea sediments

Inversion of isotopic composition in the SO4(2-)-H2S system is shown to be universal in Neoeuxine sediments and an explanation of its occurrence is proposed. Change in isotopic composition of sulfate sulfur in Black Sea waters over last 10-15 thousand years is reconstructed. Periods of alteration between aerobic and anaerobic situations are identified, the beginning of entry of Mediterranean waters into the basin is dated, presence of authigenic carbonates in sediments of the sea is established and amounts are determined. Methane generation from carbon dioxide is shown to have been replaced by its generation from acetate in the paleo-Black Sea period.

Sulfur concentrations and isotope ratios in sediments from Kiel Bay, western Baltic Sea

The isotope-ratios of sulfur-components in several sedimentologically different cores of recent marine sediments from Kiel Bay (Baltic Sea) were investigated. In addition, quantitative determinations were made on total sulfur, sulfate, sulfide, chloride, organic carbon, iron and watercontent in the sediment or in the pore-water solution. The investigations gave the following results: 1. The sulfur in the sediment (about 0.3 -2 % of the dry sample) was for the most part introduced into the sediment after sedimentation. This confirms the results of Kaplan et al. (1963, doi:10.1016/0016-7037(63)90074-7). The yield of Sulfur from organic material is very small (in our samples about 5-10% of the total sulfur in the sediment). 2. The sulfur bound in the sediment is taken from the sulfate of the interstitial water. During normal sedimentation, the exchange of sulfate by diffusion significant for changes in the sulfur-content goes down to a sediment depth of 4-6 cm. In this way the sulfate consumed by reduction and formation of sulfide or pyrite is mostly replaced. The uppermost layer of the sediment is an partly open system for the sulfur. The diagenesis of the sulfur is allochemical. 3. The isotope-values of the sediment-sulfur are largely influenced by the sulfur coming into the sediment by diffusion and being bound by bacteriological reduction. Due to the prevailing reduction of 32S and reverse-diffusion of sulfate into the open sea-water, an 32S enrichment takes place in the uppermost layer of the sediment. delta34S-values in the sediment range between -15 and -35 ? while seawater-sulfate has +20 ?. No relationship could be established between sedimentological or chemical changes and isotope-ratios. In the cores, successive sandy and clayly layers showed no change in the delta-values. The sedimentation rate, however, seems to influence isotope-ratios. In one core with low sedimentationrates the delta34S-values varied between -29 and -33 ?, while cores with higher sedimentationrates showed values between -17 and -24 ?. 4. As sediment depth increases, the pore-water sulfate shows decreasing concentrations (in a depth of 30-40 cm we found between 20 and 70 % of the seawater-values), and increasing delta 34S-values (in one case reaching more than +60 ?). The concentration of sulfide in the pore-water increases with sediment-depth (reaching 80 mg S/l in one case). The (delta34S-values of the pore-water-sulfide in all cores show increases paralleling the sulfate sulfur, with a nearly constant delta-distance of 50-60 ? in all cores. This seems to confirm the genetic relationship between the two components.

Sulfur isotopic variations in nodular and disseminated pyrite at DSDP Hole 93-603B

Analyses of modern marine sediments have suggested that availability and type of organic matter, sedimentation rate, and openness of the sulfate system influence the degree of isotopic fractionation between seawater sulfate and sedimentary iron sulfides. Isotopic studies of ancient sulfides should, therefore, provide insights into conditions of deposition and early diagenesis. Analysis of d34S of disseminated pyrite from Cretaceous sediments of Hole 603B yielded fractionations relative to coeval seawater sulfate ranging from 40 to 55 per mil, which are within the range for modern oxic marine sediments reported by others. Sulfur/carbon ratios are similar to those found from modern marine sediments and suggest that disseminated pyrite formation was dependent upon available organic carbon. These results imply that depositional and early diagenetic conditions during the Cretaceous in Hole 603B were similar to those occurring in initially oxic marine environments today. Macroscopic (nodular) pyrite from Hole 603B is isotopically variable (d34S values = - 48 to + 33 per mil), but generally more positive than disseminated pyrite. The isotopic evidence suggests that macroscopic pyrite formed during late stages of sulfate reduction in a system closed with respect to sulfate. However, detailed analyses of large pyrite nodules did not yield a consistent pattern of isotopic variation from center to rim.