Heat tolerance, behavioural temperature selection and temperature-dependent respiration in larval Octopus huttoni

This study reports temperature effects on paralarvae from a benthic octopus species, Octopus huttoni, found throughout New Zealand and temperate Australia. We quantified the thermal tolerance, thermal preference and temperature-dependent respiration rates in 1-5 days old paralarvae. Thermal stress (1°C increase h^-1) and thermal selection (~10-24°C vertical gradient) experiments were conducted with paralarvae reared for 4 days at 16°C. In addition, measurement of oxygen consumption at 10, 15, 20 and 25°C was made for paralarvae aged 1, 4 and 5 days using microrespirometry. Onset of spasms, rigour (CT_max) and mortality (upper lethal limit) occurred for 50% of experimental animals at, respectively, 26.0±0.2°C, 27.8±0.2°C and 31.4±0.1°C. The upper, 23.1±0.2°C, and lower, 15.0±1.7°C, temperatures actively avoided by paralarvae correspond with the temperature range over which normal behaviours were observed in the thermal stress experiments. Over the temperature range of 10°C-25°C, respiration rates, standardized for an individual larva, increased with age, from 54.0 to 165.2nmol larvae^-1h^-1 in one-day old larvae to 40.1-99.4nmol h^-1 at five days. Older larvae showed a lesser response to increased temperature: the effect of increasing temperature from 20 to 25°C (Q₁₀) on 5 days old larvae (Q₁₀=1.35) was lower when compared with the 1 day old larvae (Q₁₀=1.68). The lower Q₁₀ in older larvae may reflect age-related changes in metabolic processes or a greater scope of older larvae to respond to thermal stress such as by reducing activity. Collectively, our data indicate that temperatures >25°C may be a critical temperature. Further studies on the population-level variation in thermal tolerance in this species are warranted to predict how continued increases in ocean temperature will limit O. huttoni at early larval stages across the range of this species.

Experimental and field record of preferred temperature in the neotropical amphisbaenid Amphisbaena mertensi stauch (reptilia, amphisbaenidae)

1. 1. Temperature preference in experimental thermal gradient in the laboratory was determined and field preferred temperature was recorded, for Amphisbaena mertensi. 2. 2. Mean preferred temperature in 52 experiments averaged 21.4°C which was close to those recorded in 16 specimens measured in the field (21.1°C). 3. 3. Selected temperature varied from 12 to 27°C in the laboratory, and data taken in the field ranged from 18 to 26°C. © 1984.

Effect of the temperature, strain rate and microstructure on flow and fracture characteristics of Ti-45Al-2Nb-2Mn+0.8vol.% TiB2 XD alloy

A series of quasi-static and dynamic tensile tests at varying temperatures were carried out to determine the mechanical behaviour of Ti-45Al-2Nb-2Mn+0.8vol.% TiB2 XD as-HIPed alloy. The temperature for the tests ranged from room temperature to 850  ∘C. The effect of the temperature on the ultimate tensile strength, as expected, was almost negligible within the selected temperature range. Nevertheless, the plastic flow suffered some softening because of the temperature. This alloy presents a relatively low ductility; thus, a low tensile strain to failure. The dynamic tests were performed in a Split Hopkinson Tension Bar, showing an increase of the ultimate tensile strength due to the strain rate hardening effect. Johnson-Cook constitutive relation was used to model the plastic flow. A post-testing microstructural of the specimens revealed an inhomogeneous structure, consisting of lamellar α2 + γ structure and γ phase equiaxed grains in the centre, and a fully lamellar structure on the rest. The assessment of the duplex-fully lamellar area ratio showed a clear relationship between the microstructure and the fracture behaviour.

Land-atmosphere coupling over North America in CRCM5

Land-atmosphere coupling and its impact on extreme precipitation and temperature events over North America are studied using the fifth generation of the Canadian Regional Climate Model (CRCM5). To this effect, two 30 year long simulations, spanning the 1981–2010 period, with and without land-atmosphere coupling, have been performed with CRCM5, driven by the European Centre for Medium-Range Weather Forecasts reanalysis at the boundaries. In the coupled simulation, the soil moisture interacts freely with the atmosphere at each time step, while in the uncoupled simulation, soil moisture is replaced with its climatological value computed from the coupled simulation, thus suppressing the soil moisture-atmosphere interactions. Analyses of the coupled and uncoupled simulations, for the summer period, show strong soil moisture-temperature coupling over the Great Plains, consistent with previous studies. The maxima of soil moisture-precipitation coupling is more spread out and covers the semiarid regions of the western U.S. and parts of the Great Plains. However, the strength of soil moisture-precipitation coupling is found to be generally weaker than that of soil moisture-temperature coupling. The study clearly indicates that land-atmosphere coupling increases the interannual variability of the seasonal mean daily maximum temperature in the Great Plains. Land-atmosphere coupling is found to significantly modulate selected temperature extremes such as the number of hot days, frequency, and maximum duration of hot spells over the Great Plains. Results also suggest additional hot spots, where soil moisture modulates extreme events. These hot spots are located in the southeast U.S. for the hot days/hot spells and in the semiarid regions of the western U.S. for extreme wet spells. This study thus demonstrates that climatologically wet/dry regions can become hot spots of land-atmosphere coupling when the soil moisture decreases/increases to an intermediate transitional level where evapotranspiration becomes moisture sensitive and large enough to affect the climate.

Temperature effects on pathogenicity of selected Edwardsiella tarda strain to Japanese eel, Anguilla japonica

Temperature effect on the pathogenicity of selected Edwardsiella tarda V-1 strain to Japanese eel, Anguilla japonica was investigated. To evaluate the effects of both pathogen incubation temperature and fish cultivation temperature on pathogen pathogenicity a two-factor design was conducted. E. tarda was incubated at 15, 20, 25, 30 and 37±1°C, and the fish (mean weight: 100g) were reared at 15, 20, 25 and 28±1°C respectively. The fish reared at different temperatures were infected with the E. tarda incubated at different temperatures. The results of a 4-day LD50 test showed that temperature significantly affected the pathogenicity of E. tarda (p<0.01) and the interaction between the two factors was also significant (p<0.01). For fish reared at 20°C the pathogenicity of E. tarda was the highest at 30°C of pathogen incubation. When the fish rearing temperature was raised to 25 and 28°C, the pathogenicity of E. tarda incubated at all temperatures increased. Isolation testing demonstrated results similar to those of LD50. The selected isolate was virulent to eel, but pathogenicity varied with temperature.

Temperature modelling of an homogeneous medium using genetically selected RBF (LIC)

Temperature modelling of human tissue subjected to ultrasound for therapeutic use is essencial for an accurate instrumental assessment and calibration. In this paper punctual temperature modeling of a homogeneous medium, radiated by therapeutic ultrasound, is presented.

THERMOTOLERANCE BEHAVIOR IN SUGAR-CANE SYRUP FERMENTATIONS OF WILD-TYPE YEAST STRAINS SELECTED UNDER PRESSURES OF TEMPERATURE, HIGH SUGAR AND ADDED ETHANOL

The selected yeast strains were examined for their ability lo grow, to retain cell viability and to ferment diluted sugar cane juice (15% total sugar, w/v) to ethanol at 40-degrees-C. The degree of agitation (aeration) affects the thermotolerance while the method used for isolation of the strains appears to have no significant effect. The yeast isolated are aerobically fermentative with increased levels of fermentation and growth resulting from agitation (aeration), the exact level of these increases being dependent on the strain used.

The hydrogen sulfide dual-temperature process : a bibliography of selected report literature /

Cover title.

An investigation of the relationship of hot-hardness to the elevated temperature extrusion behavior of selected arc-cast molybdenum base alloys.

"Project no. 7351."

SELECTED CHEMOAUTOTROPHIC PROCESSES IN WASTEWATER TREATMENT: LOW TEMPERATURE NITRIFICATION INHIBITION BY AN AZO DYE AND BIOFILTRATION FOR ODOR CONTROL OF HYDROGEN SULFIDE

Biochemical processes by chemoautotrophs such as nitrifiers and sulfide and iron oxidizers are used extensively in wastewater treatment. The research described in this dissertation involved the study of two selected biological processes utilized in wastewater treatment mediated by chemoautotrophic bacteria: nitrification (biological removal of ammonia and nitrogen) and hydrogen sulfide (H2S) removal from odorous air using biofiltration. A municipal wastewater treatment plant (WWTP) receiving industrial dyeing discharge containing the azo dye, acid black 1 (AB1) failed to meet discharge limits, especially during the winter. Dyeing discharge mixed with domestic sewage was fed to sequencing batch reactors at 22oC and 7oC. Complete nitrification failure occurred at 7oC with more rapid nitrification failure as the dye concentration increased; slight nitrification inhibition occurred at 22oC. Dye-bearing wastewater reduced chemical oxygen demand (COD) removal at 7oC and 22oC, increased i effluent total suspended solids (TSS) at 7oC, and reduced activated sludge quality at 7oC. Decreasing AB1 loading resulted in partial nitrification recovery. Eliminating the dye-bearing discharge to the full-scale WWTP led to improved performance bringing the WWTP into regulatory compliance. BiofilterTM, a dynamic model describing the biofiltration processes for hydrogen sulfide removal from odorous air emissions, was calibrated and validated using pilot- and full-scale biofilter data. In addition, the model predicted the trend of the measured data under field conditions of changing input concentration and low effluent concentrations. The model demonstrated that increasing gas residence time and temperature and decreasing influent concentration decreases effluent concentration. Model simulations also showed that longer residence times are required to treat loading spikes. BiofilterTM was also used in the preliminary design of a full-scale biofilter for the removal of H2S from odorous air. Model simulations illustrated that plots of effluent concentration as a function of residence time or bed area were useful to characterize and design biofilters. Also, decreasing temperature significantly increased the effluent concentration. Model simulations showed that at a given temperature, a biofilter cannot reduce H2S emissions below a minimum value, no matter how large the biofilter.

Thermogravimetric analysis-mass spectrometry (TG-MS) of selected Chinese kaolinites

Thermogravimetric analysis-mass spectrometry, X-ray diffraction and scanning electron microscopy (SEM) were used to characterize eight kaolinite samples from China. The results show that the thermal decomposition occurs in three main steps (a) desorption of water below 100 °C, (b) dehydration at about 225 °C, (c) well defined dehydroxylation at around 450 °C. It is also found that decarbonization took place at 710 °C due to the decomposition of calcite impurity in kaolin. The temperature of dehydroxylation of kaolinite is found to be influenced by the degree of disorder of the kaolinite structure and the gases evolved in the decomposition process can be various because of the different amount and kinds of impurities. It is evident by the mass spectra that the interlayer carbonate from impurity of calcite and organic carbon is released as CO2 around 225, 350 and 710 °C in the kaolinite samples.

Infrared transmission and emission spectroscopic study of selected Chinese palygorskites

Infrared and infrared emission spectroscopy were used to analyze the difference in structure and thermal behavior of two Chinese palygorskites. The position of the main bands identified in the infrared spectra of the palygorskites studied is similar for these two Chinese samples, but there are some differences in their intensity, which is significant. This discrepancy is attributed to various geological environments in different regions and the existence of impurities. The infrared emission spectra clearly show the structural changes and dehydroxylation of the palygorskites when the temperature is raised. The dehydration of the palygorskites is followed by the loss of intensity of the OH stretching vibration bands in the region 3600-3200 cm-1. Dehydroxylation is followed by the decrease in intensity in the bands between 3700 and 3550 cm-1. Dehydration of pure palygorskite was completed by 600 °C. Partial loss of coordinated water was observed at 400 °C. Infrared emission spectroscopy is an effective method to determine the stability of the mineral.