Embryos refrozen-thawed by vitrification lead to live births: Case report

Objective: To describe two successful cases of utilizing refrozen blastocysts by vitrification derived from supernumerary embryos. Design: Case report. Setting: Private fertility clinic. Subjects: Two infertility couple. Interventions: Refrozen blastocysts by vitrification derived from supernumerary embryos. Main outcome measures: Obstetric and pediatric results. Results: Two pregnancies obtained from refrozen-warmed blastocysts led to two healthy babies being born without clinical or genetic problems. Conclusion: These case reports support the notion of safely repeating cryopreservation. However, despite these favorable results, there is still a need for prospective controlled studies on the obstetric and neonatal repercussions of refreezing and of vitrification in particular. © 2010 Middle East Fertility Society.

At what price? A cost-effectiveness analysis comparing trial of labour after previous caesarean versus elective repeat caesarean delivery

Background: Elective repeat caesarean delivery (ERCD) rates have been increasing worldwide, thus prompting obstetric discourse on the risks and benefits for the mother and infant. Yet, these increasing rates also have major economic implications for the health care system. Given the dearth of information on the cost-effectiveness related to mode of delivery, the aim of this paper was to perform an economic evaluation on the costs and short-term maternal health consequences associated with a trial of labour after one previous caesarean delivery compared with ERCD for low risk women in Ireland.Methods: Using a decision analytic model, a cost-effectiveness analysis (CEA) was performed where the measure of health gain was quality-adjusted life years (QALYs) over a six-week time horizon. A review of international literature was conducted to derive representative estimates of adverse maternal health outcomes following a trial of labour after caesarean (TOLAC) and ERCD. Delivery/procedure costs derived from primary data collection and combined both "bottom-up" and "top-down" costing estimations.Results: Maternal morbidities emerged in twice as many cases in the TOLAC group than the ERCD group. However, a TOLAC was found to be the most-effective method of delivery because it was substantially less expensive than ERCD ((sic)1,835.06 versus (sic)4,039.87 per women, respectively), and QALYs were modestly higher (0.84 versus 0.70). Our findings were supported by probabilistic sensitivity analysis.Conclusions: Clinicians need to be well informed of the benefits and risks of TOLAC among low risk women. Ideally, clinician-patient discourse would address differences in length of hospital stay and postpartum recovery time. While it is premature advocate a policy of TOLAC across maternity units, the results of the study prompt further analysis and repeat iterations, encouraging future studies to synthesis previous research and new and relevant evidence under a single comprehensive decision model.

The health profile of football/soccer players in Northern Ireland - a review of the uefa pre-participation medical screening procedure.

BACKGROUND:
It is compulsory that domestic football/soccer teams in UEFA competitions organise players' pre-participation medicals. Although screening guidelines have been established, these remain controversial. The findings of medical examinations can have lasting consequences for athletes and doctors. No previous studies have reported UEFA pre-participation screening results in semi-professional footballers. This study aims to further knowledge regarding 'normal' data in this population.

METHOD:
Retrospective audit and analysis of records of pre-season medicals for all male first-team players at one semi-professional Northern Ireland Premiership team between 2009-2012. Medicals were conducted by the club doctor following the UEFA proforma. Height, weight, blood pressure (BP), full blood count (FBC), dipstick urinalysis and resting electrocardiogram (ECG) were conducted by an independent nurse. Only one ECG must be documented during a player's career; other tests are repeated yearly.

RESULTS:
89 medicals from 47 players (6 goalkeepers, 11 defenders, 22 midfielders and 8 attackers; mean age 25.0 years (SD 4.86)) were reviewed. Mean height of the players was 179.3 cm (SD 5.90) with a mean weight of 77.6 kg (SD 10.5). Of 89 urine dipsticks, 7 were positive for protein; all 7 were normal on repeat testing following 48 hours of rest. Of 40 ECGs (mean ventricular rate 61.2 bpm (SD 11.6)), one was referred to cardiology (right bundle branch block; prolonged Q-T interval). No players were excluded from participation.

CONCLUSIONS:
This study provides important information about 'normal' values in a population of semi-professional footballers. Urinalysis showing protein is not uncommon but is likely to be normal on repeat testing.

The unstable (CTG)$\sb{\rm n}$ trinucleotide repeat associated with myotonic dystrophy: What it does and where it came from

Myotonic dystrophy (DM), an autosomal dominant disorder mapping to human chromosome 19q13.3, is the most common neuromuscular disease in human adults.^ Following the identification of the mutation underlying the DM phenotype, an unstable (CTG)$\sb{n}$ trinucleotide repeat in the 3$\prime$ untranslated region (UTR) of a gene encoding a ser/thr protein kinase named DM protein kinase (DMPK), the study was targeted at two questions: (1) the identification of the disease-causing mechanism(s) of the unstable repeat, and at a more basic level, (2) the identification of the origin and the mechanism(s) involved in repeat instability. The first goal was to identify the pathophysiological mechanisms of the (CTG)$\sb{n}$ repeat.^ The normal repeat is transcribed but not translated; therefore, initial studies centered on the effect on RNA transcript levels. The vast majority of DM affecteds are heterozygous for the mutant expansion, so that the normal allele interferes with the analysis of the mutant allele. A quantitative allele-specific RT-PCR procedure was developed and applied to a spectrum of patient tissue samples and cell lines. Equal levels of unprocessed pre-mRNA were determined for the wild type (+) and disease (DM) alleles in skeletal muscle and cell lines of heterozygous DM patients, indicating that any nucleosome binding has no effect at the level of transcriptional initiation and transcription of the mutant DMPK locus. In contrast, processed mRNA levels from the DM allele were reduced relative to the + allele as the size of the expansion increased. The unstable repeat, therefore, impairs post-transcriptional processing of DM allele transcripts. This phenomenon has profound effects on overall DMPK locus steady-state transcript levels in cells missing a wild type allele and does not appear to be mediated by imprinting, decreased mRNA stability, generation of aberrant splice forms, or absence of polyadenylation of the mutant allele.^ In Caucasian DM subjects, the unstable repeat is in complete linkage disequlibrium with a single haplotype composed of nine alleles within and flanking DMPK over a physical distance of 30 kb. A detailed haplotype analysis of the DM region was conducted on a Nigerian (Yoruba) DM family, the only indigenous sub-Saharan DM case reported to date. Each affected member of this family had an expanded (CTG)$\sb{n}$ repeat in one of their DMPK alleles. However, unlike all other DM populations studied thus far, disassociation of the (CTG)$\sb{n}$ repeat expansion from other alleles of the putative predisposing haplotype was found. Thus, the expanded (CTG)$\sb{n}$ repeat in this family was the result of an independent mutational event. Consequently, the origin of DM is unlikely the result of a single mutational event, and the hypothesis that a single ancestral haplotype predisposes to repeat expansion is not compelling. (Abstract shortened by UMI.) ^

The development of a testing procedure for dry friction brakes

A description of the background to testing friction materials for automotive brakes explains the need for a rapid, inexpensive means of assessing their behaviour in a way which is both accurate and meaningful. Various methods of controlling inertia dynamometers to simulate road vehicles are rejected in favour of programming by means of a commercially available XY plotter. Investigation of brake service conditions is used to set up test schedules, and a dynamometer programming unit built to enable service conditions on vehicles to be simulated on a full scale dynamometer. A technique is developed by which accelerated testing can be achieved without operating under overload conditions, saving time and cost without sacrificing validity. The development of programming by XY plotter is described, with a method of operating one XY plotter to programme the machine, monitor its own behaviour, and plot its own results in logical sequence. Commissioning trials are described and the generation of reproducible results in frictional behaviour and material durability is discussed. Teclmiques are developed to cross check the operation of the machine in retrospect, and retrospectively correct results in the event of malfunctions. Sensitivity errors in the measuring circuits are displayed between calibrations, whilst leaving the recorded results almost unaffected by error. Typical results of brake lining tests are used to demonstrate the range of performance parameters which can be studied by use of the machine. Successful test investigations completed on the machine are reported, including comments on behaviour of cast iron drums and discs. The machine shows that materials can repeat their complex friction/ temperature/speed/pressure relationships at a reproducibility of the order of +-0.003u and +~ 0.0002 in. thickness loss during wear tests. Discussion of practical and academic implications completes the report with recommendations for further work in both fields.

Visitor Relationship Management (VRM) - Repeat Visitation Opportunities for Destination Marketing Organisations

In competitive tourism markets the consumer-traveller is spoilt by choice of available destinations. Successfully differentiating a destination and getting noticed at decision time is arguably the focus of activities by destination marketing organisations (DMOs). In pursuit of differentiation, three emergent themes in the marketing literature during the past decade have been branding, integrated marketing communications (IMC), and customer relationship management (CRM) a fundamental goal of each being stimulating customer loyalty. However there has been little attention given to destination loyalty in the tourism literature. The purpose of this paper is to report an exploratory investigation of visitor relationship management (VRM) by DMOs. Based on interviews with the management of 11 regional tourism organisations (RTO) in Queensland, Australia, the opportunities for, and immediate challenges of, VRM are discussed. While each RTO recognised the potential for VRM, none had yet been able to develop a formal approach to engage in meaningful dialogue with previous visitors from their largest market.

Osteryoung square wave voltammetric determination of lactose in food samples by a derivative procedure

A method for determination of lactose in food samples by Osteryoung square wave voltammetry (OSWV) was developed. It was based on the nucleophilic addition reaction between lactose and aqua ammonia. The carbonyl group of lactose can be changed into imido group, and this increases the electrochemical activity in reduction and the sensitivity. The optimal condition for the nucleophilic addition reaction was investigated and it was found that in NH4Cl–NH3 buffer of pH 10.1, the linear range between the peak current and the concentration of lactose was 0.6–8.4 mg L−1, and the detection limits was 0.44 mg L−1. The proposed method was applied to the determination of lactose in food samples and satisfactory results were obtained.

Automated symbolic and numeric procedure for manipulator rigid-body dynamic significance analysis and simplification

This paper describes an automated procedure for analysing the significance of each of the many terms in the equations of motion for a serial-link robot manipulator. Significance analysis provides insight into the rigid-body dynamic effects that are significant locally or globally in the manipulator's state space. Deleting those terms that do not contribute significantly to the total joint torque can greatly reduce the computational burden for online control, and a Monte-Carlo style simulation is used to investigate the errors thus introduced. The procedures described are a hybrid of symbolic and numeric techniques, and can be readily implemented using standard computer algebra packages.

Is it possible to dissociate ‘liking’ and ‘wanting’ for foods in humans? A novel experimental procedure

Berridge's model (e.g. [Berridge KC. Food reward: Brain substrates of wanting and liking. Neurosci Biobehav Rev 1996;20:1–25.; Berridge KC, Robinson T E. Parsing reward. Trends Neurosci 2003;26:507–513.; Berridge KC. Motivation concepts in behavioral neuroscience. Physiol Behav 2004;81:179–209]) outlines the brain substrates thought to mediate food reward with distinct ‘liking’ (hedonic/affective) and ‘wanting’ (incentive salience/motivation) components. Understanding the dual aspects of food reward could throw light on food choice, appetite control and overconsumption. The present study reports the development of a procedure to measure these processes in humans. A computer-based paradigm was used to assess ‘liking’ (through pleasantness ratings) and ‘wanting’ (through forced-choice photographic procedure) for foods that varied in fat (high or low) and taste (savoury or sweet). 60 participants completed the program when hungry and after an ad libitum meal. Findings indicate a state (hungry–satiated)-dependent, partial dissociation between ‘liking’ and ‘wanting’ for generic food categories. In the hungry state, participants ‘wanted’ high-fat savoury > low-fat savoury with no corresponding difference in ‘liking’, and ‘liked’ high-fat sweet > low-fat sweet but did not differ in ‘wanting’ for these foods. In the satiated state, participants ‘liked’, but did not ‘want’, high-fat savoury > low-fat savoury, and ‘wanted’ but did not ‘like’ low-fat sweet > high-fat sweet. More differences in ‘liking’ and ‘wanting’ were observed when hungry than when satiated. This procedure provides the first step in proof of concept that ‘liking’ and ‘wanting’ can be dissociated in humans and can be further developed for foods varying along different dimensions. Other experimental procedures may also be devised to separate ‘liking’ and ‘wanting’.