899 resultados para redox indicators
Resumo:
Smart inks as a redox indicators of photocatalytic activity were applied on several paints with acrylic and silicate binder exposed to accelerated weathering test. The results show, that self-cleaning paints need some weathering to develop full photocatalytic activity. On the other side weathering may negatively influence the durability of the paint as shown for a silicate based exterior paint, which was significantly degraded after 350 h of weathering test. Smart inks proved to be suitable and rapid indicators of paint photoactivity. Resazurin ink is convenient only for unexposed paint with low photocatalytic activity while an Acid Violet 7 ink was appropriate for most of the paints, especially those that were weathered
Resumo:
No Brasil, a contaminação do solo por derramamentos de combustíveis representa um dos mais graves problemas ambientais e o impacto da introdução de novas misturas como diesel/biodiesel na matriz energética requer investigação quanto a tecnologias apropriadas de remediação. O presente estudo teve por objetivo avaliar diferentes estratégias de biorremediação no tratamento de solo contaminado experimentalmente com óleo diesel B5. Foram conduzidos três experimentos. No primeiro, quatro microcosmos em duplicata, contendo 500 g de solo e 5% (p/p) de óleo diesel B5, todos suplementados com oxigênio através de revolvimento manual e com ajuste de umidade, tiveram como tratamentos: bioestímulo com ajuste de pH (BE1); bioestímulo com ajuste de pH e nutrientes (BE2); bioaumento com ajuste de pH, nutrientes e adição de consórcio microbiano comercial KMA (BAM) e; controle abiótico, com ajuste de pH e solo esterilizado em autoclave (PA). Paralelamente, foi conduzido tratamento por bioaumento com ajuste de pH e nutrientes, suplementação de oxigênio e consórcio KMA, em solo contaminado apenas por diesel a 5% (BAD). A população microbiana foi monitorada através da contagem de UFC e os tratamentos, avaliados pela remoção de carbono orgânico e de hidrocarbonetos de petróleo (n-alcanos C10-C36). No segundo experimento, o metabolismo microbiano aeróbio foi avaliado através da produção de CO2 em respirômetros de Bartha (triplicatas), em solo contaminado com 5% (p/p) de óleo diesel B5, ajustado para pH e umidade, nas seguintes condições: solo com adição do consórcio KMA; solo com adição de cultura microbiana obtida a partir de outro solo proveniente de um posto de combustível com histórico de vazamento de tanques (RES) e; solo esterilizado por adição de azida de sódio a 0,3% (p/p). Como controle, solo sem contaminação, com sua população microbiana autóctone. No terceiro experimento, a capacidade da microbiota autóctone (EX), assim como do consórcio KMA e da cultura RES, em biodegradar óleo diesel B5, diesel e biodiesel de soja foi testada através do uso de indicadores de oxirredução DCPIP e TTC. Os experimentos em microcosmos indicam que houve uma complementaridade metabólica entre a população nativa e o consórcio comercial de microorganismos KMA, cuja presença promoveu um decaimento mais rápido de n-alcanos nas primeiras semanas do experimento. No entanto, após 63 dias de experimento, os tratamentos BAM, BAD e BE2 apresentaram, respectivamente, em média, 92,7%, 89,4% e 81,7% de remoção dos hidrocarbonetos n-alcanos C10-C36, sendo tais diferenças, sem significância estatística. Nos respirômetros, o bioaumento com cultura microbiana RES apresentou a maior produção de CO2 e a maior remoção de hidrocarbonetos (46,2%) após 29 dias. Tanto nos ensaios em microcosmos quanto nos respirométricos, não foi possível estimar a contribuição dos processos abióticos, tendo em vista evidências da existência de atividade microbiana no solo esterilizado térmica ou quimicamente. Os ensaios com os dois indicadores redox mostraram que apenas a microbiota nativa do solo em estudo e a cultura microbiana RES apresentaram potencial para degradar óleo diesel B5, biodiesel de soja ou diesel, quando colocadas em meio mineral contendo tais combustíveis como única fonte de carbono.
Resumo:
The mineralogy and geochemistry of a suite of nine manganese nodules from the South Atlantic have been determined. The Ce/La ratios of the nodules were investigated to see if they could be used as redox indicators to trace the oxygen content of the ambient water mass and the flow path of the Antarctic Bottom Water as has previously been successfully carried out in the Pacific Ocean. The Ce/La ratios of the nodules decrease in the sequence Lazarev Sea, Weddell Sea (10.4 and 9.7)>East Georgia Basin (6.5 and 7.1)>Argentine Basin (5.0), but then increase in the Brazil Basin (6.2) and Angola Basin (9.8 and 15.1). A further decrease was observed in the Cape Basin (7.6). An extremely high Ce/La ratio of 24.4 had already been determined for nodules sampled north of the Nares Abyssal Plain in the western North Atlantic. These data reflect the more complicated pattern of bottom water flow in the South Atlantic than in the South Pacific. The penetration of more oxygenated North Atlantic Deep Water into the South Atlantic accounts for the higher Ce/La ratios in the nodules from the Angola and Brazil basins. Based on this study, the flow path of the Antarctic Bottom Water could only be traced as far north as the Argentine Basin. The unique geochemistry of nodules from the central Angola Basin (high Mn/Fe and Ce/La ratios, high contents of Ni, Cu, Zn and Mo) appears to be a function of the nature of the overlying water mass and of the multiple diagenetic sources of metals to the nodules.
Resumo:
Groundwater is routinely analyzed for fecal indicators but direct comparisons of fecal indicators to the presence of bacterial and viral pathogens are rare. This study was conducted in rural Bangladesh where the human population density is high, sanitation is poor, and groundwater pumped from shallow tubewells is often contaminated with fecal bacteria. Five indicator microorganisms (E. coli, total coliform, F+RNA coliphage, Bacteroides and human-associated Bacteroides (HuBacteroides)) and various environmental parameters were compared to the direct detection of waterborne pathogens by quantitative PCR in groundwater pumped from 50 tubewells. Rotavirus was detected in groundwater filtrate from the largest proportion of tubewells (40%), followed by Shigella (10%), Vibrio (10%), and pathogenic E. coli (8%). Spearman rank correlations and sensitivity-specificity calculations indicate that some, but not all, combinations of indicators and environmental parameters can predict the presence of pathogens. Culture-dependent fecal indicator bacteria measured on a single date did not predict bacterial pathogens, but annually averaged monthly measurements of culturable E. coli did improve prediction for total bacterial pathogens. F+RNA coliphage were neither correlated nor sufficiently sensitive towards rotavirus, but were predictive of bacterial pathogens. A qPCR-based E. coli assay was the best indicator for the bacterial pathogens, rotavirus and all pathogens combined. Since groundwater cannot be excluded as a significant source of diarrheal disease in Bangladesh and neighboring countries with similar characteristics, the need to develop more effective methods for screening tubewells with respect to microbial contamination is necessary.
Resumo:
Brucite [Mg(OH)2] microbialites occur in vacated interseptal spaces of living scleractinian coral colonies (Acropora, Pocillopora, Porites) from subtidal and intertidal settings in the Great Barrier Reef, Australia, and subtidal Montastraea from the Florida Keys, United States. Brucite encrusts microbial filaments of endobionts (i.e., fungi, green algae, cyanobacteria) growing under organic biofilms; the brucite distribution is patchy both within interseptal spaces and within coralla. Although brucite is undersaturated in seawater, its precipitation was apparently induced in the corals by lowered pCO2 and increased pH within microenvironments protected by microbial biofilms. The occurrence of brucite in shallow-marine settings highlights the importance of microenvironments in the formation and early diagenesis of marine carbonates. Significantly, the brucite precipitates discovered in microenvironments in these corals show that early diagenetic products do not necessarily reflect ambient seawater chemistry. Errors in environmental interpretation may arise where unidentified precipitates occur in microenvironments in skeletal carbonates that are subsequently utilized as geochemical seawater proxies.
Resumo:
The construction industry is dynamic in nature. The concept of project success has remained ambiguously defined in the construction industry. Project success is almost the ultimate goal for every project. However, it means different things to different people. While some writers consider time, cost and quality as predominant criteria, others suggest that success is something more complex. The aim of this paper is to develop a framework for measuring success of construction projects. In this paper, a set of key performance indicators (KPIs), measured both objectively and subjectively are developed through a comprehensive literature review. The validity of the proposed KPIs is also tested by three case studies. Then, the limitations of the suggested KPIs are discussed. With the development of KPIs, a benchmark for measuring the performance of a construction project can be set. It also provides significant insights into developing a general and comprehensive base for further research.
Resumo:
Construction sector application of Lead Indicators generally and Positive Performance Indicators (PPIs) particularly, are largely seen by the sector as not providing generalizable indicators of safety effectiveness. Similarly, safety culture is often cited as an essential factor in improving safety performance, yet there is no known reliable way of measuring safety culture. This paper proposes that the accurate measurement of safety effectiveness and safety culture is a requirement for assessing safe behaviours, safety knowledge, effective communication and safety performance. Currently there are no standard national or international safety effectiveness indicators (SEIs) that are accepted by the construction industry. The challenge is that quantitative survey instruments developed for measuring safety culture and/ or safety climate are inherently flawed methodologically and do not produce reliable and representative data concerning attitudes to safety. Measures that combine quantitative and qualitative components are needed to provide a clear utility for safety effectiveness indicators.
Resumo:
This feasibility study was established to investigate the application of the concept of ‘best value’ in construction procurement in Australia. In the case of ‘best value’ in the business enterprise, ‘best value’ is that which returns greatest value to the business enterprise’s shareholders. However, in the case of the public sector, ‘best value’ is more complex. For that reason, this research project focuses mainly on public sector construction project procurement.
Resumo:
This study aimed to develop and validate an instrument to be used by teachers to measure the frequency of behaviors indicative of self-esteem and then to evaluate the instruments' reliability and concurrent validity. The Behavioral Indicators of Self-Esteem (BIOS) Scale proved to be a reliable and valid measure.