A Study of the Dissolution of Pyrolusite in Sulphuric Acid

With an eye to the future development of its re­sources, the large deposits of low-grade manganese ore within Montana's boundaries show great promise of developing an important industry. With the pre­sent war demands and the possibility of a future mar­ket it is essential that work expended to utilize this important mineral.

Geologia e Caracterização Tecnológica do Minério de Manganês da Mina Córrego do Cocho, Itapira (SP)

The objects of this study are three manganese ore deposits and one mine derived from lateritic weathering of gondites (spessartine quartzites). These deposits are associated with Mn-rich garnet metasediments of the Itapira Group (Paleoproterozoic) and the reserves were estimated at approximately 2.0 × 10 6 tons with an average grade of 23% MnO 2. The ore minerals are cryptomelane, pyrolusite, lithiophorite, spessartine and psilomelane. Several crystal shapes and textural characteristics were identifi ed in this study, which are related to the degree of liberation, as confi rmed by heavy media separation method. In this study, we determined the main characteristics of the liberation of manganese, which is concentrated in the fi ne grain-size fraction and is lost during ore dressing. Therefore, the low average content of MnO 2 (28%) is due to this loss, whereas at grain size of minus 0.074 mm, contents near 40% MnO 2 were observed. This suggests that the ore can be used for manufacturing manganese sulphate fertilizers. A comparative study with the ore deposits located at Ouro Fino (MG), mainly with the Caneleiras mine, showed that higher degree of liberation occurs in the coarse grain-size fractions (0.84 to 0.074 mm with MnO 2 content of 38%). As a consequence, the ore can be used for manufacturing Fe-Si-Mn alloys.

Disintegration on heating of a Brazilian manganese lump ore

This pioneering study characterized the chemical, physical and mineralogical aspects of the Urucum Standard manganese ore typology, and evaluated some of its metallurgical characteristics, such as the main mineral heat decompositions, and the particle disintegration at room temperature and under continuous heating. A one-ton sample of ore was received, homogenized and quartered. Representative samples were collected and characterized with the aid of techniques, such as ICP-AES, XRD, SEM-EDS, BET and OM. Representative samples with particle sizes between 9.5 mm and 15.9 mm were separated to perform tumbling tests at room temperature, and thermogravimetry tests for both air and nitrogen constant flow at different temperatures. After each heating cycle, the mechanical strength of the orewas evaluated by means of screening and tumbling procedures. The Urucum Standard typology was classified as an oxidized anhydrous ore, with a high manganese content (~47%). This typology ismainly composed of cryptomelane and pyrolusite; however there is a significantamount of hematite. The Urucum Standard particles presented low susceptibility to disintegration at room temperature, but as temperature increased, susceptibility increased. No significant differences were observed between the tests done with the air or nitrogen injections.

Some Leaching Characteristics of the Butte Rhodochrosite

With the increasing importance of manganese in the metallurgical fields of today and tomorrow, ex­tensive work along the lines of its successful ex­ploitation has been accomplished by many investiga­tors. Since tie current world situation has shut off most of our supply of high-grade manganese ores from foreign sources, the low-grade domestic deposits have entered the fields of investigation very rapidly.

Minerals, native metals, and intermetallides in bottom sediments of the Markov Deep, Mid-Atlantic Ridge

Bottom sediments of the Markov Deep contain rather large (>0.1 mm) grains of native minerals and intermetallides of noble and nonferrous metals that can be concentrated in placers. Intermetallides of Pt and Fe are likely to be derivates of the gold-hematite-barite assemblage that forms at late (low-depth) stages of hydrothermal massive sulfide formation. Mineral association of native forms of lead, tin, and copper with Zn-bearing copper may be related to hydrothermal transformation of ultrabasic and basic rocks accompanied by massive sulfide copper mineralization. The association of these minerals of native elements in bottom sediments can also serve as a prospecting guide for sulfide mineralization both at the Sierra Leone site, in particular, and on the seafloor, in general.

Foraminiferal assemblages and stable isotopes across the early Paleogene carbonate facies of Perth Abyssal Plain off Western Australia

Bulk carbonate content, planktic and benthic foraminiferal assemblages, stable isotope compositions of bulk carbonate and Nuttallides truempyi (benthic foraminifera), and non-carbonate mineralogy were examined across ~30 m of carbonate-rich Paleogene sediment at Deep Sea Drilling Project (DSDP) Site 259, on Perth Abyssal Plain off Western Australia. Carbonate content, mostly reflecting nannofossil abundance, ranges from 3 to 80% and generally exceeds 50% between 35 and 57 mbsf. A clay-rich horizon with a carbonate content of about 37% occurs between 55.17 and 55.37 mbsf. The carbonate-rich interval spans planktic foraminiferal zones P4c to P6b (~57-52 Ma), with the clay-rich horizon near the base of our Zone P5 (upper)-P6b. Throughout the studied interval, benthic species dominate foraminiferal assemblages, with scarce planktic foraminifera usually of poor preservation and limited species diversity. A prominent Benthic Foraminiferal Extinction Event (BFEE) occurs across the clay-rich horizon, with an influx of large Acarinina immediately above. The delta13C records of bulk carbonate and N. truempyi exhibit trends similar to those observed in upper Paleocene-lower Eocene (~57-52 Ma) sediment from other locations. Two successive decreases in bulk carbonate and N. truempyi delta13C of 0.5 and 1.0? characterize the interval at and immediately above the BFEE. Despite major changes in carbonate content, foraminiferal assemblages and carbon isotopes, the mineralogy of the non-carbonate fraction consistently comprises expanding clay, heulandite (zeolite), quartz, feldspar (sodic or calcic), minor mica, and pyrolusite (MnO2). The uniformity of this mineral assemblage suggests that Site 259 received similar non-carbonate sediment before, during and after pelagic carbonate deposition. The carbonate plug at Site 259 probably represents a drop in the CCD from ~57 to 52-51 Ma, as also recognized at other locations.

(Table 1) Heavy fraction minerals in bottom sediments of the Markov Deep, Mid-Atlantic Ridge

An additional ore field in the central part of the MARhas been discovered. Together with previously discovered Logachev (14°45'N) and Ashadze (12°58'N) ore fields, the new ore field constitutes a cluster with preliminarily estimated total ore reserve of >10 Mt, which is comparable with large continental massive sulfide deposits.

(Table 4) Mineralogy at DSDP Leg 55 Holes

On Leg 55, cores were takenfrom three seamounts in the Emperor Seamount chain: Ojin, Nintoku, and Suiko Seamounts. At the drilling sites the water depth was 1300 to 1700 meters; the maximum thickness of the sediment column was 180 meters at Site 433.

Composition of fossil manganese nodules from Costa Rica

Horizons of several types of Upper Jurassic to Lower Cretaceous manganese nodules occur locally in sequences of radiolarian cherts within the Nicoya Ophiolite Complex (NW Costa Rica). Field studies, X-ray diffraction analysis, petrographic, chemical and experimental studies give evidence of a sedimentary, early diagenetic origin of the nodules, in contrast to earlier suggestions. Smooth, discoidal, compact and very dense nodules with diameters of some mm to 9 cm dominate. They are characterized by braunite, hollandite, pyrolusite and quartz as well as 39-61% Mn, 0.9-1.6% Fe, 5-26% SiO2, 1.3-1.9% Al2O3, 1.5-3.0% Ba, 460-5400 ppm Cu, 85-340 ppm Ni and 40-130 ppm Co, among others. It is suggested that the original mineralogy (todorokite?) was altered during thermometamorphic (braunite) and hydrothermal (hollandite. pyrolusite) events. Petrographic similarities between the fossil nodules and modern deep-sea nodules are striking. Using standard hydrothermal techniques in an experimental study it is shown that under special conditions, braunite can be produced from modern nodule material.