Oral Health Education Program on Dental Caries Incidence for School Children.

OBJECTIVE This 3-year retrospective controlled clinical trial assessed the effect of a school-based oral health education program on caries incidence in children. STUDY DESIGN A total of 240 students, aged 5 to 7 years, from two public schools in Monte Sião, Brazil, were included in this study. A school-based oral health education program was developed in one of the schools (experimental group), including 120 students, while the 120 students from the other school did not participate in the program (control group). All children were initially examined for dental caries (dmf-t), and after 3 years, 98 children from the experimental group and 96 from the control group were again examined and answered a questionnaire on oral health issues. The between-groups difference in caries incidence on permanent teeth was calculated using Poisson regression analyses. Logistic regression was used to observe the association between caries incidence and other variables. RESULTS More students from the experimental group stated knowing what was dental caries and declared that they use dental floss daily, but no significant differences in caries incidence was observed between the experimental and control groups. CONCLUSION The school-based oral health education program is not adequately efficient to decrease caries incidence after three years, but some issues about oral health knowledge could be slightly improved.

Comparison Of Different Transfer Impression Techniques Accuracy For Osseointegrated Implants.

Abstract The aim of this study was to evaluate three transfer techniques used to obtain working casts of implant-supported prostheses through the marginal misfit and strain induced to metallic framework. Thirty working casts were obtained from a metallic master cast, each one containing two implant analogues simulating a clinical situation of three-unit implant-supported fixed prostheses, according to the following transfer impression techniques: Group A, squared transfers splinted with dental floss and acrylic resin, sectioned and re-splinted; Group B, squared transfers splinted with dental floss and bis-acrylic resin; and Group N, squared transfers not splinted. A metallic framework was made for marginal misfit and strain measurements from the metallic master cast. The misfit between metallic framework and the working casts was evaluated with an optical microscope following the single-screw test protocol. In the same conditions, the strain was evaluated using strain gauges placed on the metallic framework. The data was submitted to one-way ANOVA followed by the Tukey's test (α=5%). For both marginal misfit and strain, there were statistically significant differences between Groups A and N (p<0.01) and Groups B and N (p<0.01), with greater values for the Group N. According to the Pearson's test, there was a positive correlation between the variables misfit and strain (r=0.5642). The results of this study showed that the impression techniques with splinted transfers promoted better accuracy than non-splinted one, regardless of the splinting material utilized.

Effectiveness of sealing active proximal caries lesions with an adhesive system: 1-year clinical evaluation

The objective of this study was to evaluate the effectiveness of a therapeutic sealant to arrest non-cavitated proximal carious lesion progression. The study population comprised 44 adolescents who had bitewing radiographs taken for caries diagnosis. Non-cavitated lesions extending up to half of dentin thickness were included in the sample. In the experimental group (n = 33), the proximal caries-lesion surfaces were sealed with an adhesive (OptiBond Solo, Kerr) after tooth separation. The control group (n = 11) received no treatment, except for oral hygiene instructions including use of dental floss. Follow-up radiographs were taken after one year and were analyzed in comparison with baseline radiographs. In a blind study setting, visual readings were performed by two examiners, blinded to whether the examined radiograph was baseline or follow-up, and whether it concerned a test or control lesion. The efficacy of sealing treatment was evaluated by the McNemar test (0.05). About 22% of the sealed lesions showed reduction, 61% showed no change and 16% showed progression. For the control lesions, the corresponding values were 27%, 36% and 36% respectively. The number of lesions that showed reduction and no changes were merged and therefore 83.3% of the sealed lesions and 63.6% of the control lesions were considered clinically successful. No statistical significance was detected (p > 0.05). In the course of 1 year, sealing proximal caries lesions was not shown to be superior to lesion monitoring.

A comparison of profilometer and AutoCAD software techniques in evaluation of implant angulation in vitro

Purpose: The aim of this study was to compare 2 different methods of assessment of implants at different inclinations (90 degrees and 65 degrees)-with a profilometer and AutoCAD software. Materials and Methods: Impressions (n = 5) of a metal matrix containing 2 implants, 1 at 90 degrees to the surface and 1 at 65 degrees to the surface, were obtained with square impression copings joined together with dental floss splinting covered with autopolymerizing acrylic resin, an open custom tray, and vinyl polysiloxane impression material. Measurement of the angles (in degrees) of the implant analogs were assessed by the same blinded operator with a profilometer and through analysis of digitized images by AutoCAD software. For each implant analog, 3 readings were performed with each method. The results were subjected to a nonparametric Kruskal-Wallis test, with P <= .05 considered significant. Results: For implants perpendicular to the horizontal surface of the specimen (90 degrees), there were no significant differences between the mean measurements obtained with the profilometer (90.04 degrees) and AutoCAD (89.95 degrees; P=.9142). In the analyses of the angled implants at 65 degrees in relation to the horizontal surface of the specimen, significant differences were observed (P=.0472) between the mean readings with the profilometer (65.73 degrees) and AutoCAD (66.25 degrees). Conclusions: The degrees of accuracy of implant angulation recording vary among the techniques available and may vary depending on the angle of the implant. Further investigation is needed to determine the best test conditions and the best measuring technique for determination of the angle of the implant in vitro.

Accuracy of Impression Techniques for Impants. Part 2-Comparison of Splinting Techniques

Purpose: The aim of this study was to compare splinting techniques for impression copings of osseointegrated implants with different angulations.Materials and Methods: Replicas (N = 24) of a metal matrix (control) containing two implants at 90 degrees and 65 degrees in relation to the horizontal surface were obtained by using four impression techniques: Technique 1 (T1), direct technique with square copings without union in open trays; Technique 2 (T2), square copings splinted with dental floss and autopolymerizing acrylic resin; Technique 3 (T3), square copings splinted with dental floss and autopolymerizing acrylic resin, sectioned and splinted again with autopolymerizing acrylic resin; Technique 4 (T4), square copings splinted with prefabricated acrylic resin bar. The impression material was polyether. The replicas were individually scanned to capture the images, which were assessed in a graphic computation program. The program allowed the angulation between the bases of the replicas and the reading screws to be measured. The images of the replicas were compared with the matrix image (control), and the differences in angulations from the control image were calculated. The analysis of variance and the Tukey test for comparisons (p < 0.05) were used for statistical analysis.Results: All groups showed significant differences in the implant angulations in comparison with the control group (p < 0.05). Group T1 showed the highest difference (1.019 degrees) followed by groups T2 (0.747 degrees), T3 (0.516 degrees), and T4 (0.325 degrees), which showed the lowest angular alteration compared to the control group. There were significant differences between inclined and straight implants in all the groups, except in group T4.Conclusions: Based on the results, the splinting of pick-up impression copings is indicated for osseointegrated implant impressions. The square copings splinted with a prefabricated acrylic resin bar presented the best results among the pick-up impression techniques evaluated in this study.

Postsurgical Care for Rehabilitation With Implant-Retained Extraoral Prostheses

The health of a peri-implant tissue is a critical factor for the long-term success of treatment with extraoral implants. However, infection and inflammation may occur and lead to implant loss and prostheses failure. Therefore, some postsurgical care as hygiene with soap and water, soft toothbrush, and Superfloss type dental floss and medication with anti-inflammatory and antibiotic are suggested to avoid complications. In addition, a thin and smooth layer of subcutaneous tissue in the peri-implant area should be preserved during implant insertion to favor the assistance recommended in this phase.

Reprodutibilidade de uma escala odontológica proposta como indicador de saúde bucal em crianças e adolescentes HIV+/SIDA

O objetivo deste trabalho foi estimar a reprodutibilidade de uma escala odontológica para avaliação da saúde bucal de crianças e adolescentes HIV+. A amostra, com delineamento não probabilístico, constituiu-se de 27 crianças e adolescentes HIV+. A escala foi aplicada, em duas ocasiões, com intervalo de sete dias. Estimou-se a reprodutibilidade intraexaminador pela estatística Kappa. Nas questões relativas à mãe, houve concordância máxima nos itens referentes à importância da saúde bucal, hábito de escovação diária e utilização de escova dental. A procura de atendimento odontológico motivado por estética e para manutenção de hálito puro apresentou concordância boa. Nas questões relativas à criança, observou-se concordância regular nos itens referentes ao fio dental. Com relação à organização do sistema de saúde, chama atenção a dificuldade dos respondentes em relatar o local e o profissional que realizou orientações educativas preventivas. A reprodutibilidade dos domínios percepção, cuidado e promoção foi de 0,48, 0,21 e 0,64, respectivamente. Sugere-se a necessidade de reestruturação das questões componentes dos algoritmos propostos pela escala para as dimensões de percepção e cuidado, a par da necessidade da saúde bucal ser inserida em programas de atendimento a portadores HIV+.

Comparação de parâmetros periodontais após utilização de contenção ortodôntica com fio trançado e contenção modificada

OBJETIVO: o presente estudo teve como objetivo comparar dois tipos de contenções ortodônticas fixas, em relação a parâmetros periodontais estabelecidos. A contenção com fio trançado é a mais comumente utilizada e a contenção modificada apresenta dobras que têm a finalidade de permitir o livre acesso do fio dental às áreas interproximais. MÉTODOS: para esse estudo cruzado, foram selecionados 12 voluntários que utilizaram, por 6 meses, A) Contenção com fio trançado e B) Contenção modificada - sendo essas fixadas em todos os dentes do segmento anterior. Após esse período experimental, foram feitas as seguintes avaliações: Índice de Placa Dentária, Índice Gengival, Índice de Cálculo Dentário e Índice de Cálculo ao longo do fio de contenção. Os voluntários também responderam a um questionário com relação à utilização, conforto e higienização das contenções. RESULTADOS: foi observado que o índice de placa e o índice gengival foram maiores nas faces linguais (p<0,05) para a contenção modificada. Além disso, o índice de cálculo foi estatisticamente maior (p<0,05) considerando-se as faces linguais e proximais na utilização da contenção modificada. O índice de cálculo ao longo do fio também apresentou valores significativamente maiores (p<0,05) na contenção modificada. em relação ao questionário, 58% dos voluntários consideraram que a contenção modificada é mais desconfortável; e 54% deles preferiram a contenção com fio trançado. CONCLUSÃO: a partir dos resultados obtidos, pode-se concluir que a contenção com fio trançado apresentou melhores resultados do que a contenção modificada, de acordo com os parâmetros periodontais avaliados, além de apresentar maior conforto e preferência na sua utilização.

Accuracy of impression techniques for implants. Part 1 - Influence of transfer copings surface abrasion

Purpose: This study evaluated the influence of surface abrasion of transfer copings to obtain a precise master cast for a partially edentulous restoration with different inclinations. Materials and Methods: Replicas (N = 30) of a metal matrix (control group) containing two implants at 90° and 65° in relation to the benchtop were obtained using a polyether impression material and three impression techniques: square impression copings splint with dental floss and autopolymerizing acrylic resin (TRS), square impression copings abraded with aluminum oxide (TA), and square impression copings abraded with aluminum oxide and adhesive-coated (TAA). The replicas obtained in type V stone were digitalized, and the images were exported to AutoCAD software to perform the readings of possible degree alterations in implant inclinations. The results were submitted to analysis of variance (ANOVA) and Tukey test (α < 0.05). Results: Comparing the techniques with regard to the 90° implant inclination, no statistical difference was observed between the three techniques and the control group. Analyzing the three techniques with regard to the 65° implant inclination, no significant difference was seen between technique TA and the control group. Conclusions: Technique TA presented more accurate master casts than TRS and TAA techniques. The angulated implant (65°) tended to generate more imprecise master casts than implants perpendicular to the surface. © 2008 by The American College of Prosthodontists.

Técnica do grupo focal como método de avaliação do conhecimento de adolescentes sobre saúde bucal

This study aims to the understanding of adolescents regarding oral health, using the Focus Group technique. The study was conducted at three public schools in the city of Araçatuba, São Paulo State, Brazil, with ten students in each. In order to conduct the focus groups, the following words, which featured high error levels, were addressed in survey questions on oral health: oral health; plaque, permanent teeth; fluoride; gum bleeds?; dental floss; transmission of cavities. During the discussions in the focus groups, it was observed that many teenagers were surprised at the situation to which they were submitted and at the topic they were discussing. The word 'oral health' was associated with the condition of cleanliness of the oral cavity, not identifying oral health as part of general health. The term 'transmission of cavities' did not have a sufficient understanding. The term 'permanent tooth' was well understood and was associated with a type of tooth that would not be replaced. The word 'fluoride' had more association with the task of cleaning than protection of the teeth. It is concluded that the use of the focus group technique is of great importance in the interpretation of the knowledge of adolescents on oral health and the appropriateness of the terminology of questionnaires on the same subject.

Educação em saúde bucal na escola: uma análise dos sujeitos envolvidos no processo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Fatores associados com a experiência de cárie em crianças de 4 e de 6 anos de idade atendidas em um programa educativo-preventivo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Avaliação de escova ultrassônica em pacientes sob terapia ortodôntica. Estudo in vitro, clínico e microbiológico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)