Interazioni piante - insetti: ruolo delle formiche in un sistema multitrofico. Aspetti ecoetologici ed applicativi

Le formiche svolgono un importante ruolo all’interno degli ecosistemi ed alcune specie sono considerate keystone in quanto in grado di modificare la componente biotica e/o abiotica dell’ecosistema stesso. Sono animali ubiquitari che hanno colonizzato molteplici ambienti, compresi gli agroecosistemi. Negli agroecosistemi spesso svolgono un ruolo impattante determinando la diffusione o il regresso di specie di artropodi, alcune delle quali dannose alle colture. La presente ricerca tiene conto di un’ampia visione dei rapporti ecoetologici intercorrenti tra le formiche e la componente biotica di un ecosistema, utilizzando il concetto di rete multitrofica. In quest’ottica, si è pensato di costruire un sistema multitrofico costituito da una specie vegetale di interesse agrario (Cucumis sativus), dai suoi fitofagi naturali, divisi in fitomizi (afidi) (Aphis gossypii e Myzus persicae) e fitofagi masticatori (bruchi del lepidottero Mamestra brassicae), formiche (Formica pratensis) e predatori afidofagi (Aphidolets aphidimyza). Il sistema multitrofico è stato utilizzato sia per studiare l’aggressività delle formiche, sia per verificare l’esistenza di una comunicazione interspecifica tra le formiche e le piante (allelochimici). Gli studi sull’aggressività sono consistiti nel: • Verificare il livello di aggressività delle formiche nei confronti di un fitofago masticatore, competitore degli afidi nello sfruttare la pianta ospite. • Verificare se la presenza di afidi mutualisti fa variare il livello di aggressività delle formiche verso il competitore. • Verificare se esiste aggressività verso un predatore di afidi, i quali, secondo il paradigma della trofobiosi, dovrebbero essere difesi dalle formiche in cambio della melata. • Verificare se il predatore ha evoluto strategie volte ad eludere il controllo delle formiche sugli insetti che si approcciano alla colonia di afidi. Gli studi sui rapporti piante-formiche sono stati effettuati mediante olfattometro, osservando la risposta delle formiche alle sostanze volatili provenienti da piante infestate in modo differente con i fitofagi del sistema. Attraverso il trappolaggio e l’analisi gas-cromatografica delle sostanze prodotte dalle piante oggetto di studio abbiamo quindi individuato tipo e quantità di ogni composto volatile. Oltre alle piante di cetriolo, per questi esperimenti sono state utilizzate anche piante di patata (Solanum tuberosum). Dagli esperimenti sull’aggressività è risultato che le formiche manifestano un elevato potenziale predatorio, eradicando completamente la presenza dei bruchi sulle piante. Questo livello di aggressività tuttavia non cresce con la presenza degli afidi mutualisti che dovrebbero essere difesi dai competitori. Le formiche inoltre non sono in grado di sopprimere i predatori afidofagi che ipotizziamo riescano ad effettuare un camuffamento chimico, assumendo gli odori degli afidi dei quali si nutrono. I risultati degli esperimenti in olfattometro mostrano una chiara risposta positiva delle formiche verso gli odori di alcune delle piante infestate. Vi sono delle differenze nella risposta in funzione della specie di fitofago presente e della specie di pianta utilizzata. Nei trattamenti in cui erano presenti le piante di C. sativus, gli esperimenti in olfattometro hanno mostrato che le formiche rispondono in modo significativo agli odori emessi dalle piante in cui vi era la presenza del fitofago masticatore M. brassicae, solo o in associazione con A. gossypii. La presenza dei soli afidi, sia mutualisti (A. gossypii) sia non mutualisti (M. persicae), non ha invece indotto una risposta significativa nelle formiche rispetto agli odori delle piante non infestate. Nei trattamenti in cui erano presenti le piante di S. tuberosum la scelta delle formiche è stata significativa verso gli odori emessi dalle piante infestate con ciascuna delle singole specie di erbivori rispetto alle piante non infestate. Gli esperimenti sull’analisi delle sostanze volatili emesse dalle piante hanno confermato che gli organismi vegetali sono una vera centrale di produzione biochimica, infatti ben 91 composti volatili diversi sono stati individuati dall’analisi gas-cromatografica delle piante di cetriolo e 85 in quelle di patata. Dalle elaborazioni effettuate, rispettivamente 27 e 4 di essi sono prodotti esclusivamente dalle piante attaccate dai fitofagi. In generale, il cambiamento più consistente è dato dalla quantità di alcune sostanze volatili emesse dalle piante infestate rispetto a quelle integre che determina un cambiamento nei rapporti tra le sostanze che compongono i volatiles. E’ probabile che l’effetto attrattivo esercitato sulle formiche sia dato da un Blend di sostanze più che dai singoli composti presenti

Optimization of long rural feeders using a genetic algorithm

This paper describes the optimization of conductor size and the voltage regulator location & magnitude of long rural distribution lines. The optimization minimizes the lifetime cost of the lines, including capital costs and losses while observing voltage drop and operational constraints using a Genetic Algorithm (GA). The GA optimization is applied to a real Single Wire Earth Return (SWER) network in regional Queensland and results are presented.

Voltage unbalance improvement in low voltage residential feeders with rooftop PVs using custom power devices

Voltage unbalance is a major power quality problem in low voltage residential feeders due to the random location and rating of single-phase rooftop photovoltaic cells (PV). In this paper, two different improvement methods based on the application of series (DVR) and parallel (DSTATCOM) custom power devices are investigated to improve the voltage unbalance problem in these feeders. First, based on the load flow analysis carried out in MATLAB, the effectiveness of these two custom power devices is studied vis-à-vis the voltage unbalance reduction in urban and semi-urban/rural feeders containing rooftop PVs. Their effectiveness is studied from the installation location and rating points of view. Later, a Monte Carlo based stochastic analysis is carried out to investigate their efficacy for different uncertainties of load and PV rating and location in the network. After the numerical analyses, a converter topology and control algorithm is proposed for the DSTATCOM and DVR for balancing the network voltage at their point of common coupling. A state feedback control, based on pole-shift technique, is developed to regulate the voltage in the output of the DSTATCOM and DVR converters such that the voltage balancing is achieved in the network. The dynamic feasibility of voltage unbalance and profile improvement in LV feeders, by the proposed structure and control algorithm for the DSTATCOM and DVR, is verified through detailed PSCAD/EMTDC simulations.

Voltage unbalance reduction in low voltage feeders by dynamic switching of residential customers among three phases

Low voltage distribution feeders with large numbers of single phase residential loads experience severe current unbalance that often causes voltage unbalance problems. The addition of intermittent generation and new loads in the form of roof top photovoltaic generation and electric vehicles makes these problems even more acute. In this paper, an intelligent dynamic residential load transfer scheme is proposed. Residential loads can be transferred from one phase to another phase to minimize the voltage unbalance along the feeder. Each house is supplied through a static transfer switch with three-phase input and single-phase output connection. The main controller, installed at the transformer will observe the power consumption in each load and determine which house(s) should be transferred from one phase to another in order to keep the voltage unbalance in the feeder at a minimum. The efficacy of the proposed load transfer scheme is verified through MATLAB and PSCAD/EMTDC simulations.

Smart Inter-Phase Switching of Residential Loads in Low Voltage Distribution Feeders

In order to dynamically reduce voltage unbalance along a low voltage distribution feeder, a smart residential load transfer system is discussed. In this scheme, residential loads can be transferred from one phase to another to minimize the voltage unbalance along the feeder. Each house is supplied through a static transfer switch and a controller. The master controller, installed at the transformer, observes the power consumption in each house and will determine which house(s) should be transferred from an initially connected phase to another in order to keep the voltage unbalance minimum. The performance of the smart load transfer scheme is demonstrated by simulations.

Impact of PV units in LV feeders on distribution system reliability

Re-supplying loads on outage through cross-connect from adjacent feeders in a distribution system may cause voltage drop and hence require load shedding. However, the surplus PV generated in some of the LV feeders can prevent load shedding, and improve reliability. In order to measure these effects, this paper proposes the application of Direct Load Flow method[1] in reliability evaluation of distribution systems with PV units. As part of this study, seasonal impacts on load consumption together with surplus PV output power injection to higher voltage networks are also considered. New indices are proposed to measure yearly expected energy export, from LV to MV and from MV to higher voltage network.

Psychiatric correlates of snuff and chewing tobacco use.

Compared to the association between cigarette smoking and psychiatric disorders, relatively little is known about the relationship between smokeless tobacco use and psychiatric disorders. To identify the psychiatric correlates of smokeless tobacco use, the analysis used a national representative sample from the National Epidemiologic Survey on Alcohol and Related Conditions (NESARC) wave 1. Smokeless tobacco use was classified as exclusive snuff use, exclusive chewing tobacco, and dual use of both snuff and chewing tobacco at some time in the smokeless tobacco user's life. Lifetime psychiatric disorders were obtained via structured diagnostic interviews. The results show that the prevalence of lifetime exclusive snuff use, exclusive chewing tobacco, and dual use of both snuff and chewing tobacco was 2.16%, 2.52%, and 2.79%, respectively. After controlling for sociodemographic variables and cigarette smoking, the odds of exclusive chewing tobacco in persons with panic disorder and specific phobia were 1.53 and 1.41 times the odds in persons without those disorders, respectively. The odds of exclusive snuff use, exclusive chewing tobacco, and dual use of both products for individuals with alcohol use disorder were 1.97, 2.01, and 2.99 times the odds for those without alcohol use disorder, respectively. Respondents with cannabis use disorder were 1.44 times more likely to use snuff exclusively than those without cannabis use disorder. Respondents with inhalant/solvent use disorder were associated with 3.33 times the odds of exclusive chewing tobacco. In conclusion, this study highlights the specific links of anxiety disorder, alcohol, cannabis, and inhalant/solvent use disorders with different types of smokeless tobacco use.

Start-up and running forces on bulk solids feeders: experimental findings versus available models

Many different models have been postulated over the years for sizing of feeder drives; these models have different bases, some rationally based and others more rule-of-thumb. Experience of Jenike & Johanson and likewise of The Wolfson Centre in trouble-shooting feeder drives has shown that drive powers are often poorly matched, so there is clearly still some way to go towards establishing a universally-used reliable approach. This paper presents an on-going programme of work designed to measure feeder forces experimentally on a purpose designed testing rig, and to compare these against some of the best known available models, and also against a full size installation. One aspect which is novel is the monitoring of the transition between the “filling stress field” load on the feeder and the “flowing stress field” load.

Impact of prosthodontic rehabilitation on the chewing efficiency of partially dentate older patients

Objectives: This study compared two tooth replacement strategies for partially dentate older patients namely; removable partial dentures (RPDs) and functionally orientated treatment based on the shortened dental arch (SDA) concept. Patients were compared in terms of chewing efficiency after prosthodontic rehabilitation. Methods: Chewing efficiency was assessed electronically by a two-colour gum-mixing test. Specimens were assembled from two different colours of chewing gums with a size of 30 x 18 x 3 mm. After participants chewed for 20 cycles, the gum was retrieved, flattened to a 1-mm-thick wafer, and digitized with a flatbed image scanner. The pixels of unmixed colour in the specimen were counted by means of Adobe Photoshop 2.0R software (Adobe Systems, San Jose, CA, USA), and the ratio to the pixels of the entire frame was computed. This ratio is called the Unmixed Fraction (UF). The more efficiently the specimen is chewed, the less unmixed colour remains, and the smaller the gum becomes. Consequently, a low unmixed fraction corresponds to good chewing efficiency. Results: 32 patients completed the chewing efficiency test (17 RPDs and 15 SDA). The mean UF recorded for the SDA group was not significantly different to that recorded for the RPD group (p>0.05, unpaired t-test). Conclusion: These results indicate that prosthodontic rehabilitation according to the principles of the SDA is equivalent to RPDs in terms of restoration of chewing ability for partially dentate older patients.

Sensor-based Control of Chewing and Rumination Behavior of Dairy Cows

The measurement of feed intake, feeding time and rumination time, summarized by the term feeding behavior, are helpful indicators for early recognition of animals which show deviations in their behavior. The overall objective of this work was the development of an early warning system for inadequate feeding rations and digestive and metabolic disorders, which prevention constitutes the basis for health, performance, and reproduction. In a literature review, the current state of the art and the suitability of different measurement tools to determine feeding behavior of ruminants was discussed. Five measurement methods based on different methodological approaches (visual observance, pressure transducer, electrical switches, electrical deformation sensors and acoustic biotelemetry), and three selected measurement techniques (the IGER Behavior Recorder, the Hi-Tag rumination monitoring system and RumiWatchSystem) were described, assessed and compared to each other within this review. In the second study, the new system for measuring feeding behavior of dairy cows was evaluated. The measurement of feeding behavior ensues through electromyography (EMG). For validation, the feeding behavior of 14 cows was determined by both the EMG system and by visual observation. The high correlation coefficients indicate that the current system is a reliable and suitable tool for monitoring the feeding behavior of dairy cows. The aim of a further study was to compare the DairyCheck (DC) system and two additional measurement systems for measuring rumination behavior in relation to efficiency, reliability and reproducibility, with respect to each other. The two additional systems were labeled as the Lely Qwes HR (HR) sensor, and the RumiWatchSystem (RW). Results of accordance of RW and DC to each other were high. The last study examined whether rumination time (RT) is affected by the onset of calving and if it might be a useful indicator for the prediction of imminent birth. Data analysis referred to the final 72h before the onset of calving, which were divided into twelve 6h-blocks. The results showed that RT was significantly reduced in the final 6h before imminent birth.