961 resultados para bottom mud
Resumo:
A rapid and sensitive method for separation and determination of Cr(VI) and Cr(III) in bottom mud of lake by flow injection on-line preconcentrtion system and GFAAS was developed. The available Cr(VI) and Cr(III) were extracted by HOAc or EDTA + NH4 NO3 and adsorbed simultaneously by an anion and a cation resin microclummn and then eluted simultaneously by 2 mol/L NH4 NO3 + 0.05 mol/L ascorbate and 2 mol/L H2SO4, respectively. The elution was performed for 50 s after adsorption for 2 min, and the efficiencies of elution were 85.4% - 94.8% and 96.7% - 106% for Cr(VI) and Cr(M) respectively. The detection limits of the method were 0.9 mu g/L and 2.7 mu g/L with relative standard deviations of 3.5% and 6.4% for the determination of Cr(VI) and Cr(III) in sample, respectively.
Resumo:
The manganese nodules occur in greater or less quantity all over the ocean-bed, and most abundantly in the Pacific. They occur in all sizes, from minute grains to masses of a pound weight, and even greater, and form nodular concretions of concentric shells, round a nucleus, which is very frequently a piece of pumice or a shark's tooth. Their outside has a peculiar and very characteristic mammillated surface, which enables them to be identified at a glance. When freshly brought up they are very soft, being easily scraped to powder with a knife. They gradually get harder on exposure to the air. The powder, heated in a closed tube, gives out water which re-acts alkaline, and has an empyreumatic odour. Heated with strong hydrochloric acid, it liberates abundance of chlorine, and the residue which remains is white, consisting of silica, clay, and sand, the sand being the same as is found in the bottom mud from the same locality. Their composition varies greatly, different nodules containing different quantities of mechanically admixed mud, and the number of different elements found in them is very large. Copper, iron, cobalt, nickel, manganese, alumina, lime, magnesia, silica, and phosphoric acid have been detected in a large number; but I have not as yet been able to make a complete analysis of any of them. I have, however, made a few determinations of the most important component substances. For this purpose the outside and densest layers of the nodules were selected, and portions of them were pulverised and dried for ten or twelve hours at 140° C. The amount of chlorine liberated on treatment with hydrochloric acid was determined by Bunsen's method, and the iron was determined by titration with stannous chloride. The samples analysed were from four different localities.
Resumo:
On the base of data of Cruise 40 of R/V Akademik Keldysh features of formation of saline composition of interstitial waters from sediments containing free hydrocarbons (methane) and gas hydrates (CH4 x 6H2O) were considered. Chemical composition of the interstitial waters is presented for three zones of sediments from the Haakon Mosby submarine mud volcano: (1) zone of kettles containing free hydrocarbons, (2) gas hydrate sediments, and (3) periphery of the volcano. Abnormally high concentrations of bromine and especially iodine characteristic of the interstitial and particularly of the oil-field waters were found. Because of a great interest in natural gas hydrates found in marine sediments, we obtained a possibility to supplement scarce of available published data with some new information.
Resumo:
To investigate the use of benthic foraminifera as a means to document ancient methane release, we determined the stable isotopic composition of tests of live (Rose Bengal stained) and dead specimens of epibenthic Fontbotia wuellerstorfi, preferentially used in paleoceanographic reconstructions, and of endobenthic high-latitude Cassidulina neoteretis and Cassidulina reniforme from a cold methane-venting seep off northern Norway. We collected foraminiferal tests from three push cores and nine multiple cores obtained with a remotely operated vehicle and a video-guided multiple corer, respectively. All sampled sites except one control site are situated at the Håkon Mosby mud volcano (HMMV) on the Barents Sea continental slope in 1250 m water depth. At the HMMV in areas densely populated by pogonophoran tube worms, d13C values of cytoplasm-containing epibenthic F. wuellerstorfi are by up to 4.4 per mil lower than at control site, thus representing the lowest values hitherto reported for this species. Live C. neoteretis and C. reniforme reach d13C values of -7.5 and -5.5 per mil Vienna Pee Dee Belemnite (VPDB), respectively, whereas d13C values of their empty tests are higher by 4 per mil and 3 per mil. However, d13C values of empty tests are never lower than those of stained specimens, although they are still lower than empty tests from the control site. This indicates that authigenic calcite precipitates at or below the sediment surface are not significantly influencing the stable isotopic composition of foraminiferal shells. The comparatively high d13C results rather from upward convection of pore water and fluid mud during active methane venting phases at these sites. These processes mingle tests just recently calcified with older ones secreted at intermittent times of less or no methane discharge. Since cytoplasm-containing specimens of suspension feeder F. wuellerstorfi are almost exclusively found attached to pogonophores, which protrude up to 3 cm above the sediment, and d13C values of bottom-water-dissolved inorganic carbon (DIC) are not significantly depleted, we conclude that low test d13C values of F. wuellerstorfi are the result of incorporation of heavily 13C-depleted methanotrophic biomass that these specimens feed on rather than because of low bottom water d13CDIC. Alternatively, the pogonophores, which are rooted at depth in the upper sediment column, may serve as a conduit for depleted d13CDIC that ultimately influences the calcification process of F. wuellerstorfi attached to the pogonophoran tube well above the sediment/water interface. The lowest d13C of live specimens of the endobenthic C. neoteretis and C. reniforme are within the range of pore water d13CDIC values, which exceed those that could be due to organic matter decomposition, and thus, in fact, document active methane release in the sediment.