13 resultados para bipolaron
Resumo:
High resolution TEM images of boron carbide (B13C2) have been recorded and compared with images calculated using the multislice method as implemented by M. A. O'Keefe in the SHRLI programs. Images calculated for the [010] zone, using machine parameters for the JEOL 2000FX AEM operating at 200 keV, indicate that for the structure model of Will et al., the optimum defocus image can be interpreted such that white spots correspond to B12 icosahedra for thin specimens and to low density channels through the structure adjacent to the direct inter-icosahedral bonds for specimens of intermediate thickness (-40 > t > -100 nm). With this information, and from the symmetry observed in the TEM images, it is likely that the (101) twin plane passes through the center of icosahedron located at the origin. This model was tested using the method of periodic continuation. Resulting images compare favorably with experimental images, thus supporting the structural model. The introduction of a (101) twin plane through the origin creates distortions to the icosahedral linkages as well as to the intra-icosahedral bonding. This increases the inequivalence of adjacent icosahedral sites along the twin plane, and thereby increases the likelihood of bipolaron hopping.
Resumo:
The correlation between magnetic and transport properties is examined by studying poly(4,4'-methylenedianiline)(PMDA) salts and their bases using EPR and conductivity measurements. Five different PMDA salts (doped polymers)were prepared by chemical polymerization of 4,4'-methylenedianiline using different protonic acids. The PMDA bases were obtained by dedoping the salts using ammonium hydroxide. Ambient temperature electrical conductivity measurements show evidence for the doped PMDA system to be highly disordered. The EPR spectra of the samples were recorded in the range 20-200 "C, and the results were analyzed on the basis of the polaron-bipolaron model, which is typical of nondegenerate systems. Both PMDA salts and their bases consist of self-trapped, highly mobile polarons or radical cations. EPR studies on PMDA salts show evidence for the presence of thermally activated and temperature independent (or Pauli type) paramagnetism while the bases show thermally activated, Pauli and Curie-Weiss types of paramagnetism. The paramagnetism arises due to polarons.It is proposed that charge transport takes place through both polarons and bipolarons.
Resumo:
The π-electronic excitations and excited-state geometries of trans-stilbene (tS) are found by combining exact solutions of the Pariser-Parr-Pople (PPP) model and semiempirical Parametric Method 3 (PM3) calculations. Comprehensive comparisons with tS spectra are obtained and related to the fluorescence and topological alternation of poly(paraphenylenevinylene) (PPV). The one-photon absorption and triplet of tS correspond, respectively, to singlet and triplet bipolarons confined to two phenyls, while the tS2- ground state is a confined charged bipolaron. Independent estimates of the relaxation energy between vertical and adiabatic excitation show the bipolaron binding energy to depend on both charge and spin, as expected for interacting π electrons in correlated or molecular states. Complete configuration interaction within the PPP model of tS accounts for the singlet-triplet gap, for the fine-structure constants and triplet-triplet spectra, for two-photon transitions and intensities, and for one-photon spectra and the radiative lifetime, although the relative position of nearly degenerate covalent and ionic singlets is not resolved. The planar PM3 geometry and low rotational barrier of tS agree with resolved rotational and vibrational spectra in molecular beams. PM3 excitation and relaxation energies for tS bipolarons are consistent with experiment and with PPP results. Instead of the exciton model, we interpret tS excitations in terms of states that are localized on each ring or extended over an alternating chain, as found exactly in Hückel theory, and find nearly degenerate transitions between extended and localized states in the singlet, triplet, and dianion manifolds. The large topological alternation of the extended system increases the ionicity and interchanges the order of the lowest one- and two-photon absorption of PPV relative to polyenes.
Resumo:
We have carried out symmetrized density-matrix renormalization-group calculations to study the nature of excited states of long polyacene oligomers within a Pariser-Parr-Pople Hamiltonian. We have used the C-2 symmetry, the electron-hole symmetry, and the spin parity of the system in our calculations. We find that there is a crossover in the lowest dipole forbidden two-photon state and the lowest dipole allowed excited state with size of the oligomer. In the long system limit, the two-photon state lies below the lowest dipole allowed excited state. The triplet state lies well below the two-photon state and energetically does not correspond to its description as being made up of two triplets. These results are in agreement with the general trends in linear conjugated polymers. However, unlike in linear polyenes wherein the two-photon state is a localized excitation, we find that in polyacenes, the two-photon excitation is spread out over the system. We have doped the systems with a hole and an electron and have calculated the charge excitation gap. Using the charge gap and the optical gap, we estimate the binding energy of the 1(1)B(-) exciton to be 2.09 eV. We have also studied doubly doped polyacenes and find that the bipolaron in these systems, to be composed of two separated polarons, as indicated by the calculated charge-density profile and charge-charge correlation function. We have studied bond orders in various states in order to get an idea of the excited state geometry of the system. We find that the ground state, the triplet state, the dipole allowed state, and the polaron excitations correspond to lengthening of the rung bonds in the interior of the oligomer while the two-photon excitation corresponds to the rung bond lengths having two maxima in the system.
Resumo:
The quality of a thermoelectric material is judged by the size of its temperature de- pendent thermoeletric-figure-of-merit (zT ). Superionic materials, particularly Zn4Sb3 and Cu2Se, are of current interest for the high zT and low thermal conductivity of their disordered, superionic phase. In this work it is reported that the super-ionic materials Ag2Se, Cu2Se and Cu1.97Ag0.03Se show enhanced zT in their ordered, normal ion-conducting phases. The zT of Ag2Se is increased by 30% in its ordered phase as compared to its disordered phase, as measured just below and above its first order phase transition. The zT ’s of Cu2Se and Cu1.97Ag0.03Se both increase by more than 100% over a 30 K temperatures range just below their super-ionic phase transitions. The peak zT of Cu2Se is 0.7 at 406 K and of Cu1.97Ag0.03Se is 1.0 at 400 K. In all three materials these enhancements are due to anomalous increases in their Seebeck coefficients, beyond that predicted by carrier concentration measurements and band structure modeling. As the Seebeck coefficient is the entropy transported per carrier, this suggests that there is an additional quantity of entropy co-transported with charge carriers. Such co-transport has been previously observed via co-transport of vibrational entropy in bipolaron conductors and spin-state entropy in NaxCo2O4. The correlation of the temperature profile of the increases in each material with the nature of their phase transitions indicates that the entropy is associated with the thermodynamcis of ion-ordering. This suggests a new mechanism by which high thermoelectric performance may be understood and engineered.
Resumo:
The C=C stretching Raman shifts and photoluminescence (PL) for poly(3-methylthiophene) (P3MT) are measured at various doping levels by in situ electrochemical Raman and PL spectroscopic techniques. It is found that the doping for P3MT induces the nonlinear excitations (soliton, Polaron, bipolaron), but also affects the polymer-chain structure, including the conjugated length and the interchain distance.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
In the present work, the electronic structure of polythiophene at several doping levels is investigated by the use of the Huckel Hamiltonian with sigma-bond compressibility. Excess charges are assumed to be stored in conformational defects of the bipolaron type. The Hamiltonian matrix elements representative of a bipolaron are obtained from a previous thiophene oligomer calculation, and then transferred to very long chains. Negative factor counting and inverse iteration techniques have been used to evaluate densities of states and wave functions, respectively. Several types of defect distributions were analyzed. Our results are consistent with the following: (i) the bipolaron lattice does not present a finite density of states at the Fermi energy at any doping level; (ii) bipolaron clusters show an insulator-to-metal transition at 8 mol% doping level; (iii) segregation disorder shows an insulator-to-metal transition for doping levels in the range 20-30 mor %.
Resumo:
In this work we study the electronic structure associated to a disordered distribution of bipolarons in polythiophene. The polymer chain is modelled by a tight-binding Hamiltonian with explicit treatment of electron-phonon coupling and the elastic energy of the sigma framework. The model also includes the electrostatic interaction due to the counterions. The density of states of the disordered system is obtained by the use of the Negative Factor Counting technique. Our results show that ion-induced conformational disorder can account for the closure of the gap and that the states around the Fermi level are extended. © 1993.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Neste trabalho é apresentado um estudo teórico da base neutro e bipolaron e estados excitados de moléculas a partir de polímeros isoeletrônicos compostos pelo Poliacetileno, Poliazina e Poliazoeteno. Os resultados obtidos, utilizando metodologia DFT e ab initio, revelam que uma boa descrição dos defeitos pode ser importante na investigação da transição isolante-metal de polímeros quase-unidimensional indicando um comportamento metálico em torno do nível de Fermi, como mecanismo de condutividade dos polímeros. Este resultado é consistente com dados experimentais e não faz menção a metodologia Su-Schrieffer-Heeger (SSH). E mais, os resultados são consistentes com características importantes como nanodispositivo e podem ser resumidos como: (i) poderia ser usado como retificador molecular uni-direcional com uma geometria conformacional com vantagem de pequeno acoplamento, (ii) a função de Green de não-equilíbrio presente na simulação poderia corrigir de tal maneira os Poliacetileno, Poliazina e Poliazoeteno sem corrente de porta, (iii) com base nas propriedades das ligações tipo, pode ser utilizada para projetar dispositivos com aplicações em eletrônica molecular.
Resumo:
Apresentamos neste trabalho um estudo teórico sobre polímeros orgânicos conjugados. É conhecido que estes sistemas, em geral semicondutores ou isolantes, sob dopagem química podem vir a adquirir propriedades elétricas de material condutor. E ainda, sob ação de campo elétrico, pequenos oligômeros podem apresentar comportamento equivalente ao de dispositivos usuais, mas com inúmeras vantagens como, por exemplo, tamanho extremamente reduzido (alguns nanômetros). Dessa forma no primeiro capítulo faremos uma breve introdução sobre polímeros orgânicos conjugados mostrando alguns resultados experimentais obtidos para o polímero 4-dicianometileno-4,4-ciclopenta [2,1-b: 3,4b’] ditiofeno – CDM, que é o objeto central de estudo desta dissertação. O capítulo 2 trata dos métodos quânticos utilizados. Citaremos a Teoria de Hartre-Fock (HF) e suas derivações semi-empíricas. A técnica de Interação de configuração (CI) e a Teoria do Funcional da Densidade (DFT) também serão tratadas neste capítulo. O capítulo 3 é dedicado a descrever as características de alguns dispositivos usuais como diodos e transistores. Aqui o fundamental é entender a composição, o funcionamento e principalmente, como se comportam suas curvas características corrente versus voltagem (IxV). Citaremos ainda alguns dispositivos eletrônicos extremamente pequenos. No capítulo 4 começa nossos resultados e discussões referentes a análise da transição isolante-metal em CDM sob ação de dopagem. Primeiramente a nível semiempírico, obtivemos a caracterização ótica de oligômeros de CDM neutro e na presença de defeitos conformacionais do tipo bipólarons negativo e positivo. Partindo de geometrias otimizadas via métodos AM1 e PM3 obtivemos o espectro de absorção para sistemas com e sem carga. A nível Hartree-Fock calculamos a Estrutura de Bandas e a Densidade de Estados (DOS) para o PCDM no estado neutro e dopado. O cálculo da DOS e da Dispersão foram realizados através de programas computacionais desenvolvidos aqui no Grupo de Física de Materiais da Amazônia (GFMA). Apresentamos ainda neste capítulo o espectro de absorção teórico para oligômeros de CDM com diversas configurações com geometrias totalmente otimizadas pelo DFT. No capítulo 5 temos os resultados relativos à análise de nanodispositivos baseados em tetrâmeros de CDM com e sem carga. As curvas do deslocamento de carga versus voltagem apresentam características de curvas de dispositivos usuais. Analisamos também o espectro de absorção teórico dos nanodispositivos para valores de tensão nula e em pontos de saturação de corrente nas regiões direta e reversa.
Resumo:
This work presents experimental results of some physical properties of antimony phosphate glasses with compositions (x) Sb2O3 - (1-x) P2O5 (x = 0.75, 0.85, 0.90). Mechanical, thermal, optical and electrical properties were investigated: density, elastic moduli (Young's moduli and Poisson's ratio), Vickers microhardness, coefficient of thermal expansion, glass transition temperature, refractive index and electrical conductivity (for x = 0.75). There was no evidence of electronic conductivity by bipolaron hopping. Measurements of energy dispersive spectroscopy (EDS) showed that volatilization of Sb2O3 takes place during the glass melting