Swine deep bedding ashes as a mineral additive for cement based mortar

The sustainability of intensive swine production demands alternative destinations for the generated residues. Ashes from swine rice husk-based deep bedding were tested as a mineral addition for cement mortars. The ashes were obtained at 400 to 600ºC, ground and sieved through a 325 mesh sieve (# 0.045 mm). The characterization of the ashes included the determination of the index of pozzolanic activity with lime. The ashes were also tested as partial substitutes of Portland cement. The mortars were prepared using a cement:sand proportion of 1:1.5, and with water/cement ratio of 0.4. Three percentages of mass substitution of the cement were tested: 10, 20 and 30%. Mortar performances were assessed at 7 and 28 days determining their compressive strength. The chosen condition for calcinations at the laboratory scale was related to the maximum temperature of 600ºC since the resulting ashes contained vitreous materials and presented satisfactory values for the pozzolanic index under analysis. The pozzolanic activity indicated promising results for ashes produced at 600ºC as a replacement of up to 30% in cement masses.

Improving the environmental performance of bedding products by using life cycle assessment at the design stage

Improvement of the environmental performance of processes and products is a common objective in industry, and has been receiving increased attention in recent years. The main objective of this work is to evaluate the potential environmental impact of two bedding products, a polyurethane foam mattress (PFM) and a pocket spring mattress (PSM). These two types are the most common mattresses used in Europe. A Life Cycle Assessment (LCA) shows that the PFM has a higher environmental impact than the PSM. For both products the main cause of environmental impact is the manufacturing process, respectively the polyurethane foam block moulding process for the PFM, and the pocket spring nucleus process for the PSM. A scenario analysis shows the possibility of reducing the environmental impact of the products’ life cycle using an alternative End-of-Life scenario, resorting to incineration rather than landfill. Two strategies were also studied in order to reduce the environmental impact of the PFM: (1) reutilization of foam that was sent to the waste system management, and (2) a 20% weight reduction of the polyurethane foam. The second strategy has proven to be the most effective.

Production of fungal volatile organic compounds in bedding materials

Selostus: Haihtuvien orgaanisten yhdisteiden muodostuminen kuivikkeissa

Behavior, performance and physiological parameters of pigs reared in deep bedding

An experiment was conducted to evaluate the behavior, performance and physiological parameters of pigs in different production systems. Twenty four animals in the growth phase were distributed in a randomized block design in three treatments: T1 - concrete floor, T2 - deep bedding with wood shaving, and T3 - deep bedding with coffee husks. The behavioral study was carried out by observing the animal behavior for an uninterrupted period of eight hours throughout seven weeks. The proportions of time spent in each behavior were characterized using the frequency histogram composition. Environmental (IBGTH), physiological (rectal and skin temperature and respiratory rate) and performance (weight gain, feed intake and feed conversion) parameters were measured in animals during the period. The production systems of deep bedding showed higher values of IBGTH. There was no effect of production systems evaluated on the performance parameters. Rectal temperature was higher in animals reared on deep bedding with coffee husks in relation to the concrete floor. The use of deep bedding benefited the behavior of piglets in the growth phase and it reduced the agonistic behavior among individuals.

Nitrogen fertilization by deep-bedding swine production and its effects on the properties of a Quartzarenic Neosol

The objective of this study was to evaluate the effects of the nitrogen fertilization in the form of swine deep bed in the properties of a quartz-sand neosol. The organic compound used was the deep bed made with rice hulls, from a commercial swine finishing system farm. Deep bed samples have been collected at various points in the installation in order to obtain a representative composite sample which has been fractionated in a 2.0 mm sieve and submitted to a 50-day maturation period. Then, agronomic value analyses were done. The experimental design was completely randomized. The treatments consisted of 0; 75; 150 and 300 mg dm-3 of N doses of deep bed as well as an additional treatment with ammonium sulfate at a 150 mg dm-3 of N. The experimental period in the greenhouse was 45 days, where the soil was cultivated with maize. After the experiment completion, further soil properties analyses were done. From the results, it was noted that the organic fertilization with deep bed provided a significant increase in the levels of potassium, in the sum of the bases, in the effective CEC, in the CEC at pH 7.0 and in the percentage of saturation.

Characterization and use of swine deep bedding ashes in cementitious composites

The deep bedding is a swine alternative production, especially in the finishing phase, whose byproduct can be recycled, reducing the environmental impact. The objectives of this study were to characterize the ash coming from the controlled burning of the swine deep bedding (SDBA) based on rice husk, and to evaluate their performance in composites as a partial substitute for Portland cement (PC). To measure the differences between SDBA and rice husk ash (RHA) as a reference, we have characterized: particle size distribution, real specific density, x-ray diffraction, electrical conductivity, scanning electron microscopy, chemical analysis and loss on ignition. Samples were prepared for two experimental series: control, and another one with the partial replacement of 30% of SDBA in relation to the mass of the Portland cement. According to the results obtained for physical and mechanical characterization, the composites with SDBA can be used as a constructive element in the rural construction.

Nitrogen fertilization by deep bedding swine production and its effects on dry matter production and accumulation of nutrients by maize

The goal of this study was to evaluate the nitrogen fertilization as deep litter for pigs in order to produce biomass and accumulate nutrients by the corn. A deep litter made of rice husk as organic compound, from a commercial pig farm during finishing phase, was used. After three consecutive batches of pigs, the deep litter was subjected to a maturation period of 50 days, and samples of this material were taken for analysis of agronomic value. The experimental design was completely randomized with five replicates. The treatments consisted of doses of 0, 75, 150 and 300mg dm-3 of N of deep litter, as well as an additional treatment with ammonium sulfate, with a dosage of 150mg dm-3 of N. After 45 days, corn plants were harvested in order to evaluate the total dry weight and nutrient concentrations of their aerial parts. Dry matter increases were found with more application of deep litter. Regarding control fertilization, the use of increasing dosages of deep litter allowed accumulation of K, reduced the availability of P, Ca, Mg, Zn and B and did not alter the concentrations of N, Cu, Fe and Mn.

Physiological evaluation of heat stress in gestating sows under different housing systems in bedding and concrete floor

The purpose of this paper was to observe the use of bedding (wood shavings) in physiological variables that indicate thermal stress in gestating sows. The experiment was conducted in order to evaluate the effect of two types of floor (concrete and wood shavings). Worse microclimatic conditions were observed in bedding systems (P<0.05), with an increase in temperature and enthalpy of 1.14 ºC and 2.37 kJ.kg dry air-1, respectively. The floor temperature at the dirty area was higher in the bedding presence in comparison to its absence. In spite of the worse microclimatic conditions in the bedding, the rectal temperature did not differ significantly (P>0.05) but the skin surface temperature was higher in the bedding systems. The same occurred with the respiratory rates. The physical characteristics of the floor material influenced the rate of heat loss by conductance. Estimated values were 35.04 and 7.99 W m-2 for the conductive heat loss between the animal and floor for treatments with or without bedding, respectively. The use of bedding in sow rearing has a negative impact on microclimatic conditions, what implies in thermoregulatory damages.

Selecting appropriate bedding to reduce locomotion problems in broilers

Two experiments were carried out at the Poultry Sector of the School of Agrarian Sciences of the Federal University of Grande Dourados to evaluate the incidence of leg problems in broilers reared on two distinct types of bedding material: rice husks or wood shavings, both new and reused. In both trials, a randomized experimental design was applied in factorial arrangement (2 x 2 x 2) using two genetic strains (Cobb® or Ross®); two sexes (male or female), and two litter materials (rice husks or wood shavings). In each trial 1080 one day pullets were reared equally divided in the treatments. The birds were placed in 4.5 m² boxes at a density of 10 birds m-2. All birds were fed diets with equal nutritional density, and water was offered ad libitum. Feeds were divided in three phases: starter diet (1 - 21 days), grower diet (22 - 35 days), and finisher diet (36 - 45 days). on day 45, fifty birds were randomly selected in each experiment to evaluate flock leg problems. The following parameters were analyzed: gait score, incidence of valgus and varus disorder, footpad dermatitis, femoral degeneration, tibial dyschondroplasia, and spondylolisthesis. Ambient temperature during rearing and litter caking and moisture content were recorded in four boxes per treatment. The analytical hierarchy process was used to organize the data into specific criteria. Several criteria, related to the attributes that were determinant according to the statistical analysis, were chosen in order to provide the best input to the process. Results indicated that new wood-shavings bedding was the most appropriate bedding to prevent locomotion problems, followed by new rice husks, reused wood shavings, and reused rice husks. However, when leg problems were associated to sex and genetic strain, male Ross birds strain presented less problems when reared on new rice husks, followed by new wood shavings

Selecting the most adequate bedding material for broiler production in Brazil

Broiler chicken production is widely dispersed across the globe, and one important issue for growers is the selection of adequate bedding material, as the availability and price of substrates varies among countries and regions within a same country. This study aimed at applying a multiple criteria analysis approach for the selection of the most appropriate bedding material for broiler production. Based on field research data and growers' experience, the most desirable characteristics of a litter material were chosen as the main criteria. The selected materials were wood shavings, rice husks, chopped Napier grass (Pennisetum pupureum), 50% sugar cane bagasse (Saccharum L.) plus 50% wood shavings, 50% sugar cane bagasse (Saccharum L.) plus 50% rice husks, and pure sugar cane bagasse (Saccharum L.). The analytical hierarchy process (AHP) was applied for selecting the most suitable bedding material. Validation was performed using data from previous studies carried out in central-western Brazil on the effects of different types of bedding material on broiler carcass quality. Considering the selected criteria, several bedding materials were tested and ranked, and the results showed that wood-shavings litter was the best option (weight = 0.28), followed by rice husks (weight = 0.24). All other tested alternatives presented lower scores and were, therefore, not considered for use. The AHP approach was found to be an efficient tool to select the most appropriate litter material under specific scenarios.

Characterization and use of swine deep bedding ashes in cementitious composites

The deep bedding is a swine alternative production, especially in the finishing phase, whose byproduct can be recycled, reducing the environmental impact. The objectives of this study were to characterize the ash coming from the controlled burning of the swine deep bedding (SDBA) based on rice husk, and to evaluate their performance in composites as a partial substitute for Portland cement (PC). To measure the differences between SDBA and rice husk ash (RHA) as a reference, we have characterized: particle size distribution, real specific density, x-ray diffraction, electrical conductivity, scanning electron microscopy, chemical analysis and loss on ignition. Samples were prepared for two experimental series: control, and another one with the partial replacement of 30% of SDBA in relation to the mass of the Portland cement. According to the results obtained for physical and mechanical characterization, the composites with SDBA can be used as a constructive element in the rural construction.

Bedrock bedding, landsliding and erosional budgets in the Central European Alps

We explore the controls of the litho-tectonic architecture on the erosional flux in the 370-km2 Glogn basin (European Alps). In this basin, the bedding and schistosity of the bedrock dip parallel to the topographic slope on the NW valley flank, leading to a non-dip slope situation on the opposite SE valley side. While the dip slope condition has promoted the occurrence of landslides (e.g. the c. 30-km2 deep-seated Lumnezia landslide), the opposite non-dip slope side of the valley hosts >100-m-deeply incised tributary streams. 10Be concentrations of stream sediments yield catchment-averaged denudation rates that vary between 0.27 ± 0.03 and 2.19 ± 0.37 mm a−1, while the spatially averaged denudation rate of the entire basin is 1.99 ± 0.34 mm a−1. Our 10Be-based approach reveals that the Lumnezia landslide front contributes c. 30–65% of the entire sediment budget, although it covers <5% of the Glogn basin. This suggests a primary control of the bedrock bedding on erosion rates and processes.