Design and characterization of Chitin- Glucan polymeric structures for wound dressing materials

The main objective of this work was the development of polymeric structures, gel and films, generated from the dissolution of the Chitin-Glucan Complex (CGC) in biocompatible ionic liquids for biomedical applications. Similar as chitin, CGC is only soluble in some special solvents which are toxic and corrosive. Due to this fact and the urgent development of biomedical applications, the need to use biocompatible ionic liquids to dissolve the CGC is indispensable. For the dissolution of CGC, the biocompatible ionic liquid used was Choline acetate. Two different CGC’s, KiOnutrime from KitoZyme and biologically produced CGC from Faculdade de Ciencias e Tecnologia (FCT) - Universidade Nova de Lisboa, were characterized in order to develop biocompatible wound dressing materials. The similar result is shown in term of the ratio of chitin:glucan, which is 1:1.72 for CGC-FCT and 1:1.69 for CGC-Commercial. For the analysis of metal element content, water and inorganic salts content and protein content, both polymers showed some discrepancies, where the content in CGC-FCT is always higher compared to the commercial one. The different characterization results between CGC-FCT and CGC-Commercial could be addressed to differences in the purification method, and the difference of its original strain yeast, whereas CGC-FCT is derived from P.pastoris and the commercial CGC is from A.niger. This work also investigated the effect of biopolymers, temperature dissolution, non-solvent composition on the characteristics of generated polymeric structure with biocompatible ionic liquid. The films were prepared by casting a polymer mixture, immersion in a non-solvent, followed by drying at ambient temperature. Three different non-solvents were tested in phase inversion method, i.e. water, methanol, and glycerol. The results indicate that the composition of non-solvent in the coagulation bath has great influence in generated polymeric structure. Water was found to be the best coagulant for producing a CGC polymeric film structure. The characterizations that have been done include the analysis of viscosity and viscoelasticity measurement, as well as sugar composition in the membrane and total sugar that was released during the phase inversion method. The rheology test showed that both polymer mixtures exhibit a non- Newtonian shear thinning behaviour. Where the viscosity and viscoelasticity test reveal that CGCFCT mixture has a typical behaviour of a viscous solution with entangled polymer chains and CGCCommercial mixture has true gel behaviour. The experimental results show us that the generated CGC solution from choline acetate could be used to develop both polymeric film structure and gel. The generated structures are thermally stable at 100° C, and are hydrophilic. The produced films have dense structure and mechanical stabilities against puncture up to 60 kPa.

Development of lamellar gel phase emulsion containing marigold oil (Calendula officinalis) as a potential modern wound dressing

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Post-surgical scalp wounds with exposed bone treated with a plant-derived wound therapeutic

To evaluate the efficacy of a plant-derived wound dressing, a mixture of hypericum oil (Hypericum perforatum) and neem oil (Azadirachta indica), in scalp wounds with exposed bone.

Sulphonated biomaterials as glycosaminoglycan mimics in wound healing

This chapter considers the available evidence and underlying physicochemical principles that support the proposition that a biomimetic wound dressing based on glycosaminoglycan models offers a potential means of influencing wound bioactivity. Available evidence showing advantages in wound healing for experimental proteoglycanbased dressing materials is described, together with an overview of the bioactive role of sulphated macromolecules. This leads to an assessment of the analogies between the sulphonate group and the sulphate group and an explanation of their unique water binding behaviour. The available information suggests the desirability of an integrated physicochemical, biochemical and biological approach to the design and synthesis of new wound healing biomaterials.

Wound healing studies and interfacial phenomena:use and relevance of the corneal model

The interaction of the wound dressing as a biomaterial with the wound bed is the central issue of this chapter. The interfacial phenomenon that encompasses the biological and biochemical consequences that arise when a biomaterial is introduced to a host biological environment is discussed. A great deal can be learned from observations arising from the behaviour of biomaterials at other body sites; one particularly relevant body site in the context of wound healing is the anterior eye. The cornea, tear film and posterior surface of the contact lens provide an informative model of the parallel interface that exists between the chronic wound bed, wound fluid and the dressing biomaterial. © 2011 Woodhead Publishing Limited All rights reserved.

Silk Fibroin And Sodium Alginate Blend: Miscibility And Physical Characteristics.

Films of silk fibroin (SF) and sodium alginate (SA) blends were prepared by solution casting technique. The miscibility of SF and SA in those blends was evaluated and scanning electron microscopy (SEM) revealed that SF/SA 25/75 wt.% blends underwent microscopic phase separation, resulting in globular structures composed mainly of SF. X-ray diffraction indicated the amorphous nature of these blends, even after a treatment with ethanol that turned them insoluble in water. Thermal analyses of blends showed the peaks of degradation of pristine SF and SA shifted to intermediate temperatures. Water vapor permeability, swelling capacity and tensile strength of SF films could be enhanced by blending with SA. Cell viability remained between 90 and 100%, as indicated by in vitro cytotoxicity test. The SF/SA blend with self-assembled SF globules can be used to modulate structural and mechanical properties of the final material and may be used in designing high performance wound dressing.

Control Of The Properties Of Porous Chitosan-alginate Membranes Through The Addition Of Different Proportions Of Pluronic F68.

This work addresses the development and characterization of porous chitosan-alginate based polyelectrolyte complexes, obtained by using two different proportions of the biocompatible surfactant Pluronic F68. These biomaterials are proposed for applications as biodegradable and biocompatible wound dressing and/or scaffolds. The results indicate that thickness, roughness, porosity and liquid uptake of the membranes increase with the amount of surfactant used, while their mechanical properties and stability in aqueous media decrease. Other important properties such as color and surface hydrophilicity (water contact angle) are not significantly altered or did not present a clear tendency of variation with the increase of the amount of surfactant added to the polyelectrolyte complexes, such as real density, average pore diameter, total pore volume and surface area. The prepared biomaterials were not cytotoxic to L929 cells. In conclusion, it is possible to tune the physicochemical properties of chitosan-alginate polyelectrolyte complexes, through the variation of the proportion of surfactant (Pluronic F68) added to the mixture, so as to enable the desired application of these biomaterials.

Preparation and characterization of ethanol-treated silk fibroin dense membranes for biomaterials application using waste silk fibers as raw material

The possibility of producing valued devices from low cost natural resources is a subject of broad interest. The present study explores the preparation and characterization of silk fibroin dense membranes using waste silk fibers from textile processing. Morphology, crystallinity, thermal resistance and cytotoxicity of membranes as well as the changes on the secondary structure of silk fibroin were analyzed after undergoing treatment with ethanol. Membranes presented amorphous patterns as determined via X-ray diffraction. The secondary structure of silk fibroin on dense membranes was either random coil (silk I) or p-sheet (silk II), before and after ethanol treatment, respectively. The sterilized membranes presented no cytotoxicity to endothelial cells during in vitro assays. This fact stresses the material potential to be used in the fabrication of biomaterials, as coatings of cardiovascular devices and as membranes for wound dressing or drug delivery systems. (C) 2010 Elsevier Ltd. All rights reserved.

Residues of spinosad in the tissues of sheep after aerosol treatment of blowfly myiasis

Objective To measure the residues of spinosad and chlorhexidine in the tissues of sheep after treatment of blowfly strike. Procedure Fourteen sheep with natural myiasis and 12 with artificial infestations of Lucilia cuprina larvae had the wool removed over their infestations and were treated with an aerosol wound dressing containing spinosad and chlorhexidine. Sheep were killed up to 14 days after treatment and residues of the chemicals measured in tissues. Results Chlorhexidine was not detected in any tissue. Residues of spinosad were highest in fat, lowest in muscle and intermediate in liver and kidney. The highest residue detected was 0.2 mg/kg spinosad in perirenal fat 7 days after generous treatment of a sheep with a large fly strike. Residues of spinosad in fat peaked 3 to 7 days after treatment and 1 to 3 days after treatment in liver and kidney. Conclusion These studies present a realistic worst-case in struck sheep and at the highest dose studied, equivalent to 5.8 mg spinosad per kg body weight, the maximum residue detected of 0.2 mg/kg in peri-renal fat was 20% of the Australian maximum residue limit. Muscle, liver and kidney residues of spinosad were also below the Australian maximum residue limits at all times.

Incorporation of antimicrobial peptides on functionalized cotton gauzes for medical applications

A large group of low molecular weight natural compounds that exhibit antimicrobial activity has been isolated from animals and plants during the past two decades. Among them, peptides are the most widespread resulting in a new generation of antimicrobial agents with higher specific activity. In the present study we have developed a new strategy to obtain antimicrobial wound-dressings based on the incorporation of antimicrobial peptides into polyelectrolyte multilayer films built by the alternate deposition of polycation (chitosan) and polyanion (alginic acid sodium salt) over cotton gauzes. Energy dispersive X ray microanalysis technique was used to determine if antimicrobial peptides penetrated within the films. FTIR analysis was performed to assess the chemical linkages, and antimicrobial assays were performed with two strains: Staphylococcus aureus (Gram-positive bacterium) and Klebsiella pneumonia (Gram-negative bacterium). Results showed that all antimicrobial peptides used in this work have provided a higher antimicrobial effect (in the range of 4 log–6 log reduction) for both microorganisms, in comparison with the controls, and are non-cytotoxic to normal human dermal fibroblasts at the concentrations tested.

Laccase immobilization on bacterial nanocellulose membranes: antimicrobial, kinetic and stability properties

This work studied the physical immobilization of a commercial laccase on bacterial nanocellulose (BNC) aiming to identify the laccase antibacterial properties suitable for wound dressings. Physico-chemical analysis demonstrates that the BNC structure is manly formed by pure crystalline I cellulose. The pH optimum and activation energy of free laccase depends on the substrate employed corresponding to pH 6, 7, 3 and 57, 22, 48 kJ mol1 for 2,6-dimethylphenol (DMP), catechol and 2,2 -azino-bis-(3-ethylbenzothiazoline-6-sulfonic acid) (ABTS), respectively. The Michaelis-Menten constant (Km) value for the immobilized laccase (0.77 mM) was found to be almost double of that of the free enzyme (0.42 mM). However, the specific activities of immobilized and free laccase are similar suggesting that the cage-like structure of BNC allows entrapped laccase to maintain some flexibility and favour substrate accessibility. The results clearly show the antimicrobial effect of laccase in Gram-positive (92%) and Gram-negative (26%) bacteria and cytotoxicity acceptable for wound dressing applications.

Comportamiento del orificio de implantación del catéter en pacientes en diálisis peritoneal en relación a los cuidados

Infections of the catheter wound in peritoneal dialysis are the most frequent cause of morbility in patients who undergo this technique. There are a number of procedures for the care of the wound and it is not easy to define a single method that will guarantee good condition of the wound. In order to evaluate the behaviour of the wound related to the procedure used in their care, we studied 306 patients over 24 months, compiling socio-demographic and clinical variables. We found a high incidence of infections caused by gram-positive skin and mucous germs, with a strong correlation with the fact that the patient/family carer is a nasal carrier of staphylococcus aureus and that they appear more frequently in patients who do not remove the wound dressing in the shower. We also detected an increase in pseudomonas infections when the patient does not dry the wound with a hair-dryer

Acerca do impacto da oclusão na reparação in vivo da integridade cutânea

A grande diversidade de apósitos disponível para a recuperação da integridade cutânea torna complexa e difícil a sua escolha. Torna-se pois fundamental, aprofundar o conhecimento sobre o impacto específico dos diferentes materiais de penso. O presente estudo pretende ilustrar o impacto da oclusão na recuperação da função de “barreira” da pele e envolveu 8 mulheres saudáveis ( = 22,6±1,1) em cujos antebraços foram marcados 3 sítios experimentais sujeitos a biopsia superficial cutânea (BSC) com cianoacrilato, mantendo integro um quarto local, assim utilizado como controlo negativo (CN). Dois dos locais experimentais sujeitos a BSC foram aleatoriamente ocludidos com o apósito de hidroxipoliuretano (PermaFoam®, Hartmann)(sitio A) ou com parafilm (sitio B) e o terceiro local (sitio C) deixado sem oclusão, funcionando como controlo positivo (CP). As variáveis em estudo foram a Perda Transepidérmica de água (PTEA, Tewameter TM300), o eritrema (Minolta CR3000) e a microcirculação local (LDF Periflux). Os resultados sugerem uma mais rápida recuperação da integridade cutânea nos sítios ocludidos, quando comparados com o respectivo controle, salientando-se nestes, o local tratado com o apósito de hidroxipoliuretano. Conclui-se que, nas presentes condições experimentais, a oclusão determina uma maior e mais rápida recuperação da integridade cutânea in vivo.