Certification of transportation engineering technicians.

National Highway Institute, Washington, D.C.

PBL and B-Learning for Civil Engineering Students in a Transportation Course

The results of a pedagogical strategy implemented at the University of Sao Paulo at Sao Carlos are presented and discussed. The initiative was conducted in a transportation course offered to Civil Engineering students. The approach is a combination of problem-based learning and project-based learning (PBL) and blended-learning (B-learning). Starting in 2006, a different problem was introduced every year. From 2009 on, however, the problem-based learning concept was expanded to project-based learning. The performance of the students was analyzed using the following elements: (1) grades in course activities; (2) answers from a questionnaire designed for course evaluation; and (3) cognitive maps made to assess the effects of PBL through the comparison of the responses provided by the students involved and those not involved in the experiment. The results showed positive aspects of the method, such as a strong involvement of several students with the subject. A gradual increase in the average scores obtained by the students in the project activities (from 6.77 in 2006 to 8.24 in 2009) was concomitant with a better evaluation of these activities and of the course as a whole (90 and 97% of options "Good" or "Very good" in 2009, respectively). A growing interest in the field of transportation engineering as an alternative for further studies was also noticed. DOI: 10.1061/(ASCE)EI.1943-5541.0000115. (C) 2012 American Society of Civil Engineers.

Engineering Study Iowa Highway Resarch Board Project HR-223 Maintaining Granular Surfaced Roads, February 1981

Approximately 65% of Iowa's roads are surfaced with aggregates composed of crushed limestone and/or gravel. Rural Iowan's regard these roads as a very important part of their lives. Therefore, the slide-tape presentation, "Maintaining Granular Surfaced Roads" was developed to aid the motor grader operator to better understand the procedures required t o maintain aggregate surfaced roads. A typical cross-section is presented with the proper nomenclature assigned to the roadway features to facilitate the operator's understanding of the basic terms used the program. The following areas are expanded: safety , dragging, cutting, intersections , superelevations, and reporting any discrepancies. The operator's attention to detail can enhance the economy of the state and contribute to the savings of lives on rural highways.

Engineering Study for Reducing Sign Vandalism Final Report Highway Research Advisory Board Projec HR 246, June 1992

Sign vandalism has traditionally been a vexing problem for Iowa counties. The extent of the cost and incidence of these acts have never been fully ascertained, but a 1990 survey indicated that they cost Iowa counties more than 1.5 million dollars annually. In 1990, the Iowa Legislature recognized the seriousness of the problem and strengthened the existing sign vandalism law by increasing the penalty for illegal possession of a traffic control device from a simple to a serious misdemeanor. However, the courts must be willing to prosecute vandals to the magnitude provided in the Iowa Code. An educational campaign begun in 1987 involving over 200 Iowa school districts to educate students on the seriousness of the problem evidently did not have the effect of dramatically reducing the overall cost of sign vandalism in Iowa. This study sought to define the scope of the problem and possibly offer some effective countermeasures to combat sign vandalism and theft in Iowa.

Vehicle Dynamic Safety in Measured Rough Pavement

Dynamic vehicle behavior is used to identify safe traffic speed limits. The proposed methodology is based on the vehicle vertical wheel contact force response excited by measured pavement irregularities on the frequency domain. A quarter-car model is used to identify vehicle dynamic behavior. The vertical elevation of an unpaved road surface has been measured. The roughness spectral density is quantified as ISO Level C. Calculations for the vehicle inertance function were derived by using the vertical contact force transfer function weighed by the pavement spectral density roughness function in the frequency domain. The statistical contact load variation is obtained from the vehicle inertance density function integration. The vehicle safety behavior concept is based on its handling ability properties. The ability to generate tangential forces on the wheel/road contact interface is the key to vehicle handling. This ability is related to tire/pavement contact forces. A contribution to establish a traffic safety speed limit is obtained from the likelihood of the loss of driveability. The results show that at speeds faster than 25 km/h the likelihood of tire contact loss is possible when traveling on the measured road type. DOI: 10.1061/(ASCE)TE.19435436.0000216. (C) 2011 American Society of Civil Engineers.

Logística para agregados (brita e areia) em grandes centros urbanos

One of the human being`s basic needs is housing. In Brazil, the basic element for this is concrete, artificial stone, which demands a great amount of aggregates, such as sand and gravel. The sand and rocks are abundant in nature and gravel can be produced at low cost. However, transportation to the area of product utilization can be an incremental factor in the final cost logistics. Both sand and gravel have expressive price variations, which are not necessarily related to mining activities, but to logistic activities, mainly their distribution. Restrictive measures adopted in large urban centers, such as prohibition of hauling trucks in certain areas or during certain hours, alternate license plate end number system (even number plate ending can circulate on even-numbered days and visa versa), and axle-control, generate a need for a larger and more diversified fleet, not to mention more employees.

Alterações de geometria e sinalização rodoviária em zonas consolidadas no contexto da gestão da mobilidade urbana

Relatório de Estágio para obtenção do grau de Mestre em Engenharia Civil na Área de Especialização de Vias de Comunicação e Transportes

Highway "Firsts" - State of Iowa, 1971

Brief summaries of achievement and important events of the Iowa State Highway Commission and transportation engineering in Iowa, between 1904 and 1971.

Evaluation of Corrosion Resistance of Different Steel Reinforcement Types, 2006

The corrosion of steel reinforcement in an aging highway infrastructure is a major problem currently facing the transportation engineering community. In the United States alone, maintenance and replacement costs for deficient bridges are measured in billions of dollars. The application of corrosion-resistant steel reinforcement as an alternative reinforcement to existing mild steel reinforced concrete bridge decks has potential to mitigate corrosion problems, due to the fundamental properties associated with the materials. To investigate corrosion prevention through the use of corrosion-resistant alloys, the performance of corrosion resistance of MMFX microcomposite steel reinforcement, a high-strength, high-chromium steel reinforcement, was evaluated. The study consisted of both field and laboratory components conducted at the Iowa State University Bridge Engineering Center to determine whether MMFX reinforcement provides superior corrosion resistance to epoxy-coated mild steel reinforcement in bridge decks. Because definitive field evidence of the corrosion resistance of MMFX reinforcement may require several years of monitoring, strict attention was given to investigating reinforcement under accelerated conditions in the laboratory, based on typical ASTM and Rapid Macrocell accelerated corrosion tests. After 40 weeks of laboratory testing, the ASTM ACT corrosion potentials indicate that corrosion had not initiated for either MMFX or the as-delivered epoxy-coated reinforcement. Conversely, uncoated mild steel specimens underwent corrosion within the fifth week, while epoxy-coated reinforcement specimens with induced holidays underwent corrosion between 15 and 30 weeks. Within the fifth week of testing, the Rapid Macrocell ACT produced corrosion risk potentials that indicate active corrosion for all reinforcement types tested. While the limited results from the 40 weeks of laboratory testing may not constitute a prediction of life expectancy and life-cycle cost, a procedure is presented herein to determine life expectancy and associated life-cycle costs.

Caratterizzazione dinamica sperimentale del rinforzo di pavimentazioni stradali con geogriglie tramite box test

Nella presente tesi viene affrontato il comportamento di materiali granulari sotto carico dinamico. In particolare, viene presentata la sperimentazione di laboratorio seguita presso il Nottingham Transportation Engineering Centre dell'Università di Nottingham, la costruzione del box test e le prove dinamiche eseguite sul materiale granulare rinforzato e non.

La qualità erogata da un'azienda di trasporto collettivo in ambito urbano: calcolo del livello di servizio delle principali linee di ATC (BO)

Oggetto di questa tesi è lo studio della qualità del servizio di trasporto erogato che condiziona la qualità percepita dall’utente, poiché spesso proprio a causa di un errato processo di pianificazione e gestione della rete, molte aziende non sono in grado di consolidare un alto livello di efficienza che permetta loro di attrarre e servire la crescente domanda. Per questo motivo, si è deciso di indagare sugli aspetti che determinano la qualità erogata e sui fattori che la influenzano, anche attraverso la definizione di alcuni indicatori rappresentativi del servizio erogato. L’area di studio considerata è stata quella urbana di Bologna, e sono state prese in esame due linee di ATC, la 19 e la 27, caratterizzate entrambe da una domanda di trasporto molto elevata. L’interesse è ricaduto in modo particolare sugli aspetti legati alla regolarità del servizio, ovvero al rispetto della cadenza programmata delle corse e alla puntualità, ossia il rispetto dell’orario programmato delle stesse. Proprio da questi due aspetti, infatti, dipende in larga misura la percezione della qualità che gli utenti hanno del servizio di trasporto collettivo. Lo studio è stato condotto sulla base di dati raccolti attraverso due campagne di rilevamento, una effettuata nel mese di maggio dell’anno 2008 e l’altra nel mese di settembre dello stesso anno. La scelta del periodo, della zona e delle modalità di rilevamento è strettamente connessa all’obiettivo prefissato. Il servizio è influenzato dalle caratteristiche del sistema di trasporto: sia da quelle legate alla domanda che da quelle legate all’offerta. Nel caso della domanda di trasporto si considera l’influenza sul servizio del numero di passeggeri saliti e del tempo di sosta alle fermate. Nel caso dell’offerta di trasporto si osservano soprattutto gli aspetti legati alla rete di trasporto su cui si muovono gli autobus, analizzando quindi i tempi di movimento e le velocità dei mezzi, per vedere come le caratteristiche dell’infrastruttura possano condizionare il servizio. A tale proposito è opportuno dire che, mentre i dati della prima analisi ci sono utili per lo studio dell’influenza del tempo di sosta sull’intertempo, nella seconda analisi si vuole cercare di effettuare ulteriori osservazioni sull’influenza del tempo di movimento sulla cadenza, prendendo in esame altri elementi, come ad esempio tratti di linea differenti rispetto al caso precedente. Un’attenzione particolare, inoltre, verrà riservata alla verifica del rispetto della cadenza, dalla quale scaturisce la definizione del livello di servizio per ciò che riguarda la regolarità. Per quest’ultima verrà, inoltre, determinato anche il LOS relativo alla puntualità. Collegato al problema del rispetto della cadenza è il fenomeno dell’accodamento: questo si verifica quando i mezzi di una stessa linea arrivano contemporaneamente ad una fermata uno dietro l’altro. L’accodamento ha, infatti, origine dal mancato rispetto della cadenza programmata tra i mezzi ed è un’evidente manifestazione del mal funzionamento di un servizio di trasporto. Verrà infine condotta un’analisi dei fattori che possono influenzare le prestazioni del servizio di trasporto pubblico, così da collocare i dati ottenuti dalle operazioni di rilevamento in un quadro più preciso, capace di sottolineare alcuni elementi di criticità e possibili rapporti di causalità.

Effect of Cognitive Impairment on Driving-Relevant Cognition in Older Persons

Intact cognitive abilities are fundamental for driving. Driving-relevant cognition may be affected in older drivers due to aging or cognitive impairment. The aim of this study was to investigate the effects of cognitive impairment on driving-relevant cognition in older persons. Performance in selective and divided attention, eye-hand-coordination, executive functions and the ability to regulate distance and speed of 18 older persons with CI-Group (cognitive impairment group) was compared to performance of older control group (18 age and gender-matched cognitively normal subjects) and young control group (18 gender-matched young subjects). The CI-Group showed poorer performance than the other two control groups in all cognitive tasks (significance level (p) < 0.001, effect size (partial η2) = 0.63). Differences between cognitively impaired and cognitively normal subjects were still significant after controlling for age (effect sizes from 0.14 to 0.28). Dual tasking affected performance of cognitively impaired subjects more than performance of the other two groups (p = 0.016, partial η2 = 0.14). Results show that cognitive impairment has age-independent detrimental effects on selective and divided attention, eye-hand-coordination, executive functions and the ability to regulate distance and speed. Largest effect sizes are found for reaction times in attention tasks.

Development of proposed height standards and tolerances for light-post traffic barriers. Interim report.

Federal Highway Administration, Office of Research, Development and Technology, Washington, D.C.

Reflectivity and durability of epoxy pavement markings. Interim report.

Federal Highway Administration, Office of Research, Development and Technology, Washington, D.C.

Evaluation of an end treatment for heavy-post median barriers. Final report.

Federal Highway Administration, Washington, D.C.