Stair builders' guide; a treatise on the construction of straight flight, platform, cylindrical and eliptical [!] stairs, explaining the theory and practice so the average building mechanic may understand it, with examples of work ranging from the simplest to the most complex forms,

Mode of access: Internet.

Cyclopedia of architecture, carpentry, and building : a general reference work ... /

"Authorities consulted" at beginning of each volume.

Investigating the representation of merging behavior at the floor–stair interface in computer simulations of multi-floor building evacuations

In this article, the representation of the merging process at the floor— stair interface is examined within a comprehensive evacuation model and trends found in experimental data are compared with model predictions. The analysis suggests that the representation of floor—stair merging within the comprehensive model appears to be consistent with trends observed within several published experiments of the merging process. In particular: (a) The floor flow rate onto the stairs decreases as the stair population density increases. (b) For a given stair population density, the floor population's flow rate onto the stairs can be maximized by connecting the floor to the landing adjacent to the incoming stair. (c) In situations where the floor is connected adjacent to the incoming stair, the merging process appears to be biased in favor of the floor population. It is further conjectured that when the floor is connected opposite the incoming stair, the merging process between the stair and floor streams is almost in balance for high stair population densities, with a slight bias in favor of the floor stream at low population densities. A key practical finding of this analysis is that the speed at which a floor can be emptied onto a stair can be enhanced simply by connecting the floor to the landing at a location adjacent to the incoming stair rather than opposite the stair. Configuring the stair in this way, while reducing the floor emptying time, results in a corresponding decrease in the descent flow rate of those already on the stairs. While this is expected to have a negligible impact on the overall time to evacuate the building, the evacuation time for those higher up in the building is extended while those on the lower flows is reduced. It is thus suggested that in high-rise buildings, floors should be connected to the landing on the opposite side to the incoming stair. Information of this type will allow engineers to better design stair—floor interfaces to meet specific design objectives.

The UK WTC 9/11 evacuation study: an overview of the methodologies employed and some analysis relating to fatigue, stair travel speeds and occupant response times

This paper briefly describes the methodologies employed in the collection and storage of first-hand accounts of evacuation experiences derived from face-to-face interviews with evacuees from the World Trade Center (WTC) Twin Towers complex on 11 September 2001 and the development of the High-rise Evacuation Evaluation Database (HEED). The main focus of the paper is to present an overview of preliminary analysis of data derived from the evacuation of the North Tower.

Investigating the use of elevators for high-rise building evacuation through computer simulation

This paper presents a description of a new agent based elevator sub-model developed as part of the buildingEXODUS software intended for both evacuation and circulation applications. A description of each component of the newly developed model is presented, including the elevator kinematics and associated pedestrian behaviour. The elevator model is then used to investigate a series of full building evacuation scenarios based on a hypothetical 50 floor building with four staircases and a population of 7,840 agents. The analysis explores the relative merits of using up to 32 elevators (arranged in four banks) and various egress strategies to evacuate the entire building population. Findings from the investigation suggest that the most efficient evacuation strategy utilises a combination of elevators and stairs to empty the building and clear the upper half of the building in minimum time. Combined stair elevator evacuation times have been shown to be as much as 50% faster than stair only evacuation times.

Point of decision signs and stair use in a university worksite setting: General versus specific messages

Point-of-decision signs to promote stair use have been found to be effective in various environments. However, these signs have been more consistently successful in public access settings that use escalators, such as shopping centers and transportation stations, compared to worksite settings, which are more likely to contain elevators that are not directly adjacent to the stairs. Therefore, this study tested the effectiveness of two point-of-decision sign prompts to increase stair use in a university worksite setting. Also, this study investigated the importance of the message content of the signs. One sign displayed a general health promotion message, while the other sign presented more specific information. Overall, this project examined whether the presence of the point-of-decision signs increases stair use. In addition, this research determined whether the general or specific sign promotes greater stair use. ^ Inconspicuous observers measured stair use both before the signs were present and while they were posted. The study setting was the University of Texas School of Nursing, and the target population was anyone who entered the building, including employees, students, and visitors. The study was conducted over six weeks and included two weeks of baseline measurement, two weeks with the general sign posted, and two weeks with the specific sign posted. Each sign was displayed on a stand in the decision point area near the stairs and the elevator. Logistic regression was used to analyze the data. ^ After adjustment for covariates, the odds of stair use were significantly greater during the intervention period than the baseline period. Furthermore, the specific sign period showed significantly greater odds of stair use than the general sign period. These results indicate that a point-of-decision sign intervention can be effective at promoting stair use in a university worksite setting and that a sign with a specific health information message may be more effective at promoting stair use than a sign with a general health promotion message. These findings can be considered when planning future worksite and university based stair promotion interventions.^

Peripherally η1-Platinated Organometallic Porphyrins as Building Blocks for Multiporphyrin Arrays

The modification of peripherally metalated meso-η1-platiniometalloporphyrins, such as trans-[PtBr(NiDAPP)(PPh3)2] (H2DAPP = 5-phenyl-10,20-bis(3‘,5‘-di-tert-butylphenyl)porphyrin), leads to the analogous platinum(II) nitrato and triflato electrophiles in almost quantitative yields. Self-assembly reactions of these meso-platinioporphyrin tectons with pyridine, 4,4‘-bipyridine, or various meso-4-pyridylporphyrins in chloroform generate new multicomponent organometallic porphyrin arrays containing up to five porphyrin units. These new types of supramolecular arrays are formed exclusively in high yields and are stable in solution or in the solid state for extended periods. They were characterized by multinuclear NMR and UV−visible spectroscopy as well as high-resolution electrospray ionization mass spectrometry.