The effect of thermal cycle profiles on solder joint damage

The relationship between the damage caused at different thermal cycles is very important. The whole of accelerated thermal cycle testing is based on the premise that damage at one cycle is representative of damage at a different cycle. In this paper, the relative damage caused by six thermal cycle profiles are predicted using Finite Element (FE) modelling and the results validated against experiments. Both creep strain and strain energy density were used as damage indicators and creep strain was found to correlate better with experiment. The validated FE model is then used to investigate the effect of altering each of the thermal profile parameters (ramp and swell times, hot and cold temperatures). The components used for testing are surface mount resistors - 1206, 0805 and 0603. The solders investigated are eutectic SnAgCu and eutectic SnAg.

Comparative wetting behavior of Sn-0.7Cu and Sn-0.7Cu-0.3Ni solders on Cu and Ni substrates

Electronic packaging industries are now in great challenge to find a suitable lead-free solder as an interconnection material to replace the conventional SnPb solders. Many solders such as SnCu, SnAg, SnAgCu, SnZn, SnBi have already been proposed as the replacement but none of them has reached the physical and metallurgical properties similar to the SnPb solder. However, wetting is one of the basic problems that make the lead-free solder inferior as compared to the SnPb solder. Therefore, alloying with the help of third, fourth or fifth element is the researchers' interest to improve the wetting behavior of lead-free solders. This paper describes the comparative wetting behavior of Sn-0.7Cu and Sn-0.7Cu-0.3Ni solders on Cu and Ni substrates. Wetting balance tests were performed to assess the wetting behaviors. Three different commercial fluxes namely no-clean (NC), non-activated (R) and water soluble organic acid (WS)fluxes were used to assess the wettability for three solder bath temperatures. It was found that Sn0.7Cu-03Ni solder exhibits better wettability on Cu substrate for NC and WS fluxes whereas reverse results were found for R-type flux. In the case of Ni substrate, Sn-0.7Cu-0.3Ni solder showed better wetting behavior compared to the well-known Sn-0.7Cu solder. Among the three fluxes, R-type flux showed the worst performance. Very large contact angles were documented for both solders with this flux. Higher solder bath temperature lowered the contact angles, increased the wetting forces and enhanced the wettability. Computer modeling of wetting balance test revealed that both the wetting force and meniscus height are inversely proportional to the contact angles. Modeling results also reveal that increase in solder bath depths and radiuses do not affect significantly on the wetting behavior.

Effect of 0.5 wt % Cu addition in Sn–3.5% Ag solder on the dissolution rate of Cu metallization

The dissolution of thin film under-bump-metallization (UBM) by molten solder has been one of the most serious processing problems in electronic packaging technology. Due to a higher melting temperature and a greater Sn content, a molten lead-free solder such as eutectic SnAg has a faster dissolution rate of thin film UBM than the eutectic SnPb. The work presented in this paper focuses on the role of 0.5 wt % Cu in the base Sn–3.5%Ag solder to reduce the dissolution of the Cu bond pad in ball grid array applications. We found that after 0.5 wt % Cu addition, the rate of dissolution of Cu in the molten Sn–3.5%Ag solder slows down dramatically. Systematic experimental work was carried out to understand the dissolution behavior of Cu by the molten Sn–3.5%Ag and Sn–3.5%Ag–0.5%Cu solders at 230–250 °C, for different time periods ranging from 1 to 10 min. From the curves of consumed Cu thickness, it was concluded that 0.5 wt % Cu addition actually reduces the concentration gradient at the Cu metallization/molten solder interface which reduces the driving force of dissolution. During the dissolution, excess Cu was found to precipitate out due to heterogeneous nucleation and growth of Cu6Sn5 at the solder melt/oxide interface. In turn, more Cu can be dissolved again. This process continues with time and leads to more dissolution of Cu from the bond pad than the amount expected from the solubility limit, but it occurs at a slower rate for the molten Sn–3.5%Ag–0.5%Cu solder. © 2003 American Institute of Physics.

Using non-invasive techniques to examine black bear (Ursus americanus) abundance in the North Cascades Ecosystem, Washington State

Thesis (Master's)--University of Washington, 2013

Efeitos imediatos de um Sustained Natural Apophyseal Glide na atividade muscular dos eretores espinhais, na dor e na amplitude de flexão, em indivíduos com dor lombar crónica não específica

Introdução: O Sustained Natural Apophyseal Glide tem sido sugerido como uma técnica com potenciais benefícios na redução da dor e no aumento da amplitude de flexão lombar em indivíduos com dor lombar. Contudo, não existe evidência sobre esta técnica na atividade muscular dos eretores espinhais. Objetivo: Avaliar os efeitos imediatos de um Sustained Natural Apophyseal Glide na atividade muscular dos eretores espinhais, na intensidade da dor e na amplitude real de flexão lombar, em indivíduos com dor lombar crónica não específica. Métodos: Estudo experimental com uma amostra de 20 estudantes universitários, com dor lombar crónica não específica e com dor à flexão da coluna lombar, que foram aleatoriamente distribuídos em dois grupos: experimental - Sustained Natural Apophyseal Glide e placebo – intervenção placebo. Foram avaliadas a atividade muscular dos eretores espinhais recorrendo à eletromiografia de superfície (bioPLUX research®), a intensidade da dor através da Escala Visual Analógica e a amplitude real de flexão lombar pelo método de duplo inclinómetro (Universal Inclinometer®), antes e após a intervenção, pela análise do movimento de flexão-extensão do tronco. O nível de significância foi de 0,05. Resultados: Foram encontradas diferenças significativas, em ambos os grupos, para a fase de relaxamento (Grupo experimental: p=0,013 e Grupo placebo: p=0,047), assim como para a fase de extensão, no grupo experimental (p=0,037), verificando-se uma diminuição da atividade muscular da baseline para a avaliação final. A Análise da Covariância revelou que, relativamente à intensidade da dor, verificaram-se diferenças significativas entre os dois grupos (p=0,002), sendo que o grupo experimental diminuiu mais 2cm na Escala Visual Analógica do que o grupo placebo. Pela análise da amplitude real de flexão lombar, embora o aumento não fosse significativamente diferente entre os grupos (p=0,086), o grupo experimental teve mais 1,7º de aumento do que o grupo placebo. Conclusão: Os resultados sugerem que, a curto prazo, o Sustained Natural Apophyseal Glide parece produzir um efeito significativo na diminuição da atividade muscular dos eretores espinhais, durante o movimento dinâmico de extensão do tronco, assim como no alívio da dor. Embora não se tenham observado alterações significativas no aumento da amplitude articular, os resultados no grupo experimental foram superiores à diferença mínima detetável, sugerindo um efeito positivo da técnica aplicada.

Investigating Targets of Avian Habitat Management to Eliminate an Ecological Trap

Ecological traps are attractive population sinks created when anthropogenic habitat alteration inadvertently creates a mismatch between the attractiveness of a habitat based upon its settlement cues, and its current value for survival or reproduction. Traps represent a new threat to the conservation of native species, yet little attention has been given to developing practical approaches to eliminating them. In the northern Rocky Mountains of Montana, Olive-sided Flycatchers (Contopus cooperi) prefer to settle in patches of selectively harvested forest versus burned forest despite the lower reproductive success and higher nest predation risk associated with the former habitat. I investigated characteristics of preferred perch sites for this species and how these preferences varied between habitats and sexes. I then built on previous research to develop a range of management prescriptions for reducing the attractiveness of selectively harvested forest, thereby disarming the ecological trap. Female flycatchers preferred to forage from shorter perch trees than males, and females’ perches were shorter than other available perch trees. Both sexes preferred standing dead perch trees (snags) and these preferences were most obvious in harvested forest where snags are rarer. Because previous research shows that snag density is linked to habitat preference and spruce/fir trees are preferred nest substrate, my results suggest these two habitat components are focal habitat selection cues. I suggest alternative and complementary strategies for eliminating the ecological trap for Olive-sided Flycatchers including: (1) reduced retention and creation of snags, (2) avoiding selective harvest in spruce, fir, and larch stands, (3) avoiding retention of these tree species, and (4) selecting only even-aged canopy height trees for retention so as to reduce perch availability for female flycatchers. Because these strategies also have potential to negatively impact habitat suitability for other forest species or even create new ecological traps, we urge caution in the application of our management recommendations.

The effects of topographic variation and the fire regime on coarse woody debris: insights from a large wildfire

Coarse woody debris (CWD) is a common structural component of terrestrial ecosystems, and provides important habitat for biota. Fires modify the distribution of CWD, both spatially and temporally. Changes in fire regimes, such as those arising from prescribed burning and changing climatic conditions, make it critical to understand the response of this resource to fire. We created a conceptual model of the effects of fire on logs and dead trees in topographically diverse forests in which trees often survive severe fire. We then surveyed paired sites, in a damp gully and adjacent drier slope, ~3.5. years after a large wildfire in south-eastern Australia. Sites were stratified by fire severity (unburnt, understorey burnt and severely burnt), and fire history (burnt ≤3. years or ≥20. years prior to the wildfire). Both components of the fire regime influenced CWD availability in gullies. Severe wildfire and fire history ≤3. years reduced the volume of small logs (10-30. cm diameter) in gullies, while severe wildfire increased the number of large dead trees in gullies. CWD on slopes was not affected by fire severity or history at ~3.5. years post-fire. Log volumes on slopes may recover more quickly after wildfire through rapid collapse of branches and trees. Gullies generally supported more logs than slopes, but longer inter-fire intervals in gullies may allow fuel loads to accumulate and lead to comparatively larger fire impacts. Given that fire severity and fire interval are predicted to change in many fire-prone ecosystems in coming decades, this study highlights the importance of understanding the interacting effects of multiple components of the fire regime with landscape structure. In particular, variation in fire interval and fire severity in relation to topographic position will influence the pattern of accumulation of coarse woody debris across the landscape, and therefore the structure and quality of habitats for biota.

Poly-N-acetyl glucosamine nanofibers for negative-pressure wound therapies

The wound healing promoting effect of negative wound pressure therapies (NPWT) takes place at the wound interface. The use of bioactive substances at this site represents a major research area for the development of future NPWT therapies. To assess wound healing kinetics in pressure ulcers treated by NPWT with or without the use of a thin interface membrane consisting of poly-N-acetyl glucosamine nanofibers (sNAG) a prospective randomized clinical trial was performed. The safety of the combination of NPWT and sNAG was also assessed in patients treated with antiplatelet drugs. In the performed study, the combination of NPWT and sNAG in 10 patients compared to NPWT alone in 10 patients promoted wound healing due to an improved contraction of the wound margins (p = 0.05) without a change in wound epithelization. In 6 patients treated with antiplatelet drugs no increased wound bleeding was observed in patients treated by NPWT and sNAG. In conclusion, the application of thin membranes of sNAG nanofibers at the wound interface using NPWT was safe and augmented the action of NPWT leading to improved wound healing due to a stimulation of wound contraction.

The Gfi-1 protooncoprotein represses Bax expression and inhibits T-cell death

The Gfi-1 protooncogene encodes a nuclear zinc-finger protein that carries a novel repressor domain, SNAG, and functions as a position- and orientation-independent active transcriptional repressor. The Gfi-1 repressor allows interleukin 2 (IL-2)-dependent T cells to escape G1 arrest induced by IL-2 withdrawal in culture and collaborates with c-myc and pim-1 for the induction of retrovirus-induced lymphomas in animals. Here we show that overexpression of Gfi-1 also inhibits cell death induced by cultivation of IL-2-dependent T-cell lines in IL-2-deficient media. Similarly, induction of Gfi-1 in primary thymocytes from mice carrying a metal-inducible Gfi-1 transgene inhibits cell death induced by cultivation in vitro. The protein and mRNA levels of the proapoptotic regulator Bax are down-regulated by Gfi-1 in both immortalized T-cell lines and primary transgenic thymocytes. The repression is direct and depends on several Gfi-1-binding sites in the p53-inducible Bax promoter. In addition to Bax, Gfi-1 also represses Bak, another apoptosis-promoting member of the Bcl-2 gene family. Therefore, Gfi-1 may inhibit apoptosis by means of its repression of multiple proapoptotic regulators. The antiapoptotic properties of Gfi-1 provide a potential explanation for its strong collaboration with c-myc during oncogenesis.

Peter Pilgrim: or, A rambler's recollections.

v. 1. Chapter introductory. Merry the miner. Tale of a snag. My friends in the madhouse. The extra lodger. Arkansas emigrants. Fascinating power of reptiles.-- v. 2. A night on the Terrapin rocks. The Mammoth cave. The bloody broad-horn.