997 resultados para SMPS-APS


Relevância:

60.00% 60.00%

Publicador:

Resumo:

The effects of particulate matter on environment and public health have been widely studied in recent years. A number of studies in the medical field have tried to identify the specific effect on human health of particulate exposure, but agreement amongst these studies on the relative importance of the particles’ size and its origin with respect to health effects is still lacking. Nevertheless, air quality standards are moving, as the epidemiological attention, towards greater focus on the smaller particles. Current air quality standards only regulate the mass of particulate matter less than 10 μm in aerodynamic diameter (PM10) and less than 2.5 μm (PM2.5). The most reliable method used in measuring Total Suspended Particles (TSP), PM10, PM2.5 and PM1 is the gravimetric method since it directly measures PM concentration, guaranteeing an effective traceability to international standards. This technique however, neglects the possibility to correlate short term intra-day variations of atmospheric parameters that can influence ambient particle concentration and size distribution (emission strengths of particle sources, temperature, relative humidity, wind direction and speed and mixing height) as well as human activity patterns that may also vary over time periods considerably shorter than 24 hours. A continuous method to measure the number size distribution and total number concentration in the range 0.014 – 20 μm is the tandem system constituted by a Scanning Mobility Particle Sizer (SMPS) and an Aerodynamic Particle Sizer (APS). In this paper, an uncertainty budget model of the measurement of airborne particle number, surface area and mass size distributions is proposed and applied for several typical aerosol size distributions. The estimation of such an uncertainty budget presents several difficulties due to i) the complexity of the measurement chain, ii) the fact that SMPS and APS can properly guarantee the traceability to the International System of Measurements only in terms of number concentration. In fact, the surface area and mass concentration must be estimated on the basis of separately determined average density and particle morphology. Keywords: SMPS-APS tandem system, gravimetric reference method, uncertainty budget, ultrafine particles.

Relevância:

60.00% 60.00%

Publicador:

Resumo:

The aim of this work was to quantify exposure to particles emitted by wood-fired ovens in pizzerias. Overall, 15 microenvironments were chosen and analyzed in a 14-month experimental campaign. Particle number concentration and distribution were measured simultaneously using a Condensation Particle Counter (CPC), a Scanning Mobility Particle Sizer (SMPS), an Aerodynamic Particle Sizer (APS). The surface area and mass distributions and concentrations, as well as the estimation of lung deposition surface area and PM1 were evaluated using the SMPS-APS system with dosimetric models, by taking into account the presence of aggregates on the basis of the Idealized Aggregate (IA) theory. The fraction of inhaled particles deposited in the respiratory system and different fractions of particulate matter were also measured by means of a Nanoparticle Surface Area Monitor (NSAM) and a photometer (DustTrak DRX), respectively. In this way, supplementary data were obtained during the monitoring of trends inside the pizzerias. We found that surface area and PM1 particle concentrations in pizzerias can be very high, especially when compared to other critical microenvironments, such as the transport hubs. During pizza cooking under normal ventilation conditions, concentrations were found up to 74, 70 and 23 times higher than background levels for number, surface area and PM1, respectively. A key parameter is the oven shape factor, defined as the ratio between the size of the face opening in respect

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Exposure to particles emitted by cooking activities may be responsible for a variety of respiratory health effects. However, the relationship between these exposures and their subsequent effects on health cannot be evaluated without understanding the properties of the emitted aerosol or the main parameters that influence particle emissions during cooking. Whilst traffic-related emissions, stack emissions and ultrafine particle concentrations (UFP, diameter < 100 nm) in urban ambient air have been widely investigated for many years, indoor exposure to UFPs is a relatively new field and in order to evaluate indoor UFP emissions accurately, it is vital to improve scientific understanding of the main parameters that influence particle number, surface area and mass emissions. The main purpose of this study was to characterise the particle emissions produced during grilling and frying as a function of the food, source, cooking temperature and type of oil. Emission factors, along with particle number concentrations and size distributions were determined in the size range 0.006-20 m using a Scanning Mobility Particle Sizer (SMPS) and an Aerodynamic Particle Sizer (APS). An infrared camera was used to measure the temperature field. Overall, increased emission factors were observed to be a function of increased cooking temperatures. Cooking fatty foods also produced higher particle emission factors than vegetables, mainly in terms of mass concentration, and particle emission factors also varied significantly according to the type of oil used.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The APS Grant for Intercultural and/or International Projects of up to $10,000 supports innovative projects that have an intercultural and/or international focus, particularly in countries where psychology is an emerging discipline. Associate Professors Linda Gilmore MAPS and Marilyn Campbell MAPS from Queensland University of Technology were awarded the APS Grant in 2010-11. Their project aimed to promote and advance the profession of psychology in Bangladesh by supporting the newly introduced specialisation of educational psychology. With a population of 159 million in a country only twice the size of Tasmania, Bangladesh is one of the poorest and most densely populated countries in the world. Yet at the time this project commenced, there was only one school psychologist in the entire country. Linda Gilmore shared her experiences and insights about the project with InPsych.

Relevância:

20.00% 20.00%

Publicador:

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The surface area of inhaled particles deposited in the alveolar region, as reported by the TSI nanoparticle surface area monitor (NSAM), was compared with the corresponding value estimated by a TSI scanning mobility particle sizer (SMPS) for a range of environmentally relevant aerosols, including petrol emissions, ETS, laser printer emissions, cooking emissions and ambient aerosols. The SMPS values were based on a mobility size distribution assuming spherical particles using the appropriate size-dependent alveolar-deposition factors provided by the ICRP. In most cases, the two instruments showed good linear agreement. With petrol emissions and ETS, the linearity extended to over 103 μm2 cm-3. With printer emissions, there was good linearity up to about 300 μm2 cm-3 while the NSAM increasingly overestimated the surface area at higher concentrations. The presence of a nucleation event in ambient air caused the NSAM to over-estimate the surface area by a factor of 2. We summarize these results and conclude that the maximum number concentration up to which the NSAM is accurate clearly depends on the type of aerosol being sampled and provide guidance for the use of the instrument.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

A nanoparticles size is one of their key physical characteristics that can affect their fate in a human’s respiratory tract (in case of inhalation) and also in the environment. Hence, measuring the size distribution of nanoparticles is absolutely essential and contributes greatly to their characterization. For years, Scanning Mobility Particle Sizers (SMPS), which rely on measuring the electrical mobility diameter of particles, have been used as one of the most reliable real-time instruments for the size distribution measurement of nanoparticles. Despite its benefits, this instrument has some drawbacks, including equivalency problems for non-spherical particles (i.e. assuming a non-spherical particle is equal to a spherical particle of diameter d due to the same electrical mobility), as well as limitations in terms of its use in workplaces, because of its large size and the complexity of its operation...

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área VII - Sistema financeiro, Direito Comercial, Direito Econômico, Defesa do Consumidor.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área XX - Redação e Discurso Parlamentar - Área XI - Meio Ambiente e Direito Ambiental, Organização Territorial, Desenvolvimento Urbano e Regional.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Propõe analisar a situação das relações jurídicas decorrentes de medida provisória que foi rejeitada ou caducou. Observou-se a história do surgimento da medida provisória no ordenamento jurídico brasileiro e foi feita a análise da medida provisória no texto original da Constituição Federal e no texto constitucional modificado pela Emenda Constitucional nº 32 de 2001. Além disso, fez-se o estudo do caso específico da Medida Provisória nº 82/2002, que não foi convertida em lei. A metodologia utilizada foi a corrente de pensamento dialética e o método monográfico de pesquisa com a análise do artigo 62 da CF, de registros e posicionamentos do Supremo Tribunal Federal, o estudo de artigos de revistas, e, especialmente, de material doutrinário de juristas e especialistas em processo legislativo.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

利用自组装技术及氨基与羧基之间的酰胺化反应,成功地在单晶硅表面制备了3-氨基丙基-三乙氧基硅烷(APS)和硬脂酸(STA)的自组装双层膜。双层膜表面水接触角约98°,APS单层膜厚约0.5nm,STA单层膜厚约1.7nm。摩擦、磨损性能测试结果表明,STA-APS双层膜具有优异的摩擦特性,摩擦系数约0.06-0.08,在0.5N的载荷下,其抗磨寿命大于10000次;在1N的载荷下,其抗磨寿命也可达到6800多次,有望用作微型机械的润滑和防护材料。

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Apresenta as linhas gerais do sistema eleitoral alemão, incluídas as recentes alterações de 2013, e avalia a possibilidade de sua adoção no Brasil, no contexto de uma Reforma Política.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Não tem sido frequentes no Brasil estudos de avaliação da qualidade dos serviços de saúde. Tem sido adotado entendimento de qualidade como o grau em que processo de assistência aumenta a probabilidade de resultados favoráveis e diminui a probabilidade de resultados desfavoráveis, dado o estado do conhecimento médico. Indicadores de resultados de efeitos adversos do processo de assistência costumam ser empregados e, entre eles, para aquelas condições e procedimentos onde óbitos ocorrem com frequência, estão as taxas de mortalidade hospitalar. Entre esses procedimentos inclui-se a cirurgia de revascularizaçäo do miocárdio. Apesar de frequentes na literatura, particularmente norte-americana, não há estudos de escala realizados no Brasil. Para estudos deste tipo bases de dados administrativas tem sido empregadas. No Brasil recentemente tem sido exploradas as potencialidades dos bancos de dados do Sistema de Informações Hospitalares do Sistema Único de Saúde do Ministério da Saúde (SIH-SUS) em diversos estudos. Como há registro de óbitos hospitalares no sistema é possível utilizá-lo para a obtenção de dados sobre mortalidade hospitalar. Os bancos de dados do SIH-SUS de 1996 a 1998 foram integrados e as variáveis disponíveis no banco obtido examinadas quanto a possibilidade de inclusão do estudo descritivo de características da cirurgia coronária no país. Foram identificadas aquelas variáveis que poderiam ser utilizadas para proceder algum grau de ajuste de risco para os casos atendidos pelos diferentes hospitais. Para que se obtivesse uma comparação do comportamento do ajuste obtido com essas variáveis com modelos mais completos que incorporassern mais variáveis, inclusive variáveis clínicas, foram estudadas para o mesmo período, as internações realizadas no Hospital Universitário Pedro Ernesto da Universidade do Estado do Rio de Janeiro, utilizando dados de banco específico do Serviço de Cirurgia Cardíaca. Além do estudo descritivo foram desenvolvidos para os casos deste hospital modelos de regressão logística incorporando variáveis pré-operatórias e com as variáveis disponíveis no SIH-SUS para avaliar as diferentes capacidades de ajuste de risco. Após a escolha de um modelo de risco com maior capacidade de ajuste, foram calculadas as taxas de mortalidade hospitalar e obtidos os valores de taxas esperadas após o ajuste de risco. Os hospitais forma ordenados de acordo com as razões entre as taxas observadas e esperadas e identificados aqueles hospitais que apresentavam razões estatisticamente significativas superiores e inferiores a média nacional. Estudou-se também o efeito do volume de casos sobre a mortalidade hospitalar. Foram obtidas informações de 41.989 cirurgias codificadas como cirurgia coronária com circulação extracorpórea realizadas em 131 hospitais brasileiros, em 22 unidades da federaçâo. A taxa anual por 100000 habitantes foi de 8,7 para o Brasil, com São Paulo apresentando taxa de 16,6. Para efeitos de comparação a taxa em anos em torno de 1997 foi de 144,5 nos EUA, 54,4 no Canadá, 90,0 na Austrália e 31,5 em Portugal. A taxa de mortalidade no período foi de 7,2 % (EUA, 2,8%; Canadá, 2,5%: França, 3,2%). A maioria de pacientes operados foi do sexo masculino (67,5%) e a idade média foi de 59,9 anos.